Having problems with your Kenmore Ultra Dishwasher 665.1602 ?

How do I reset my Kenmore Ultra Dishwasher 665.1602

The normal wash has a red blinking light and the washer is not working.

Answers :

Repair Help & Product Troubleshooting for Kenmore Ultra Dishwasher 665.1602

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a kenmore ultra dishwasher 655.177779990 and the lock out light was flashing until I unplugged all connectors and plugged back in. Now light stays on and everything else has stopped working. Tried to reset but no luck what can I do to reset dishwasher?


Hello & Welcome to FixYa\015\012\015\012\015\012You\015\012are right, the unit needs a reset. To reset the control you can press and hold\015\012the AIR DRY/RINSE ONLY button for 15second ... Dishwashers

Kenmore model 16625691 ultra dishwasher I have this dishwasher and after changing another appliance in the kitchen it will not come on at all. I have looked at some of the help for the reset fix but it does not seem to work on this one. It does not have any lights at all? Thanks


... Hobart AM14-253 Free-standing Dishwasher

Kenmore Ultra Wash Dishwasher - no lights, won't reset


Check wire nuts that were used to install power cord/it is on the right hand side of toe kick if ok there is a fuse on the control that you can replace located top of door ... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

Reset control panel on Kenmore ultra wash dishwasher 665.17822


... Kenmore Dishwashers

I have a Kenmore Elite Ultra Wash dishwasher. Model #17572. All the lights on the control panel went out. Get no response at all. Circuit breaker is fine. Any reset tips? Or, do I need a new control panel?


... Kenmore 24 in. 17572 Built-in Dishwasher

Dishwasher: Kenmore ultra wash sensor quiet guard plus. I'm in a rental so I don't have the manual or model number. A few days ago it just wouldn't start the wash cycle. When you press normal wash then start the no heat dry and lock lights flash every other second or so but nothing happens. I can hit the cancel button and it will make sounds like its trying to drain, and after about 5 minutes stops. I've done the heated wash/ no heat dry sequence to try to reset but no luck. Also tried turn


... Kenmore Dishwashers

Dishwasher Kenmore Ultra Wash model #1777990 the 2 hour delay light is on and when I try to cancel the door lock button starts flashing I hit cancel and open the door and shut it and the 2 hour delaay button cmes on and will not go off. Is there a reset button anywhere.


... Dishwashers

The green clean light is flashing on my Kenmore Elite Ultra Wash dishwasher. After the reset sequence, the washer will run only 1 part of it's washing/drying cycle, then flash the clean light again... I have only owned it about 14 months, and this is the first problem I have had.


You may just need to reset your control board. Go to the link and it will explain how to reset the control board as well as explain what might cause the issue and how to fix it.http://www.appliancerepairlesson.com/dishwasher-2/dishwasher ... Kenmore 24 in. 17032 Built-in Dishwasher

What are the reset codes for Kenmore Ultra Wash 665.13442 dishwasher? I have lights flashing and a clicking noise.


... Kenmore Dishwashers

My Kenmore Ultra wash dishwasher will not cycle.....the green clean light keeps flashing. How do I reset the cycle?


Hello & Welcome to FixYaFlashing light is reset by pressing two buttons in sequence 3-4 times, to reset your dishwasher press these buttons in sequence:High ... Kenmore Dishwashers

I have a Sears Kenmore Elite Ultra dishwasher 665.1315 model. For the last 3 weeks, it keeps having the clean light blinking 6 times pause then 1 blink and pause and repeats cycle again. I have turned off the breaker...I have reset by pressing the heated dry and normal wash until all lights are flashing. It then completes some type of cycle and looks ok. When I opened the door, steam came out and all was hot inside. However, once I try any new wash cycle, it seems to wash but after 1-2 hours and


Call sears service and tell them you need service there is a service flash and will be no charge ... Kenmore 24 in. 15932 Built-in Dishwasher

I have a Kenmore ultra wash quiet guard 3 dishwasher with a Hi Temp Wash that won't stop flashing. I've tried shutting off the circuit breaker and every code button sequence I can find including pressing Hi temp wash, heated dry, hi temp wash, heated dry...but it won't stop blinking..always blinking...Anyone have any other suggestions to reset this?


... Kenmore 24 in. 17019 Built-in Dishwasher

Kenmore Ultra Wash Dishwasher LIghts are blinking....


I suspect for either of these units that the timer control boards are bad. ... Dishwashers

Kenmore Ultra Wash Dishwasher LIghts are blinking....


... Dishwashers

Kenmore Ultra Wash Dishwasher LIghts are blinking....


I just read this for the same problem: push sanitize, then heat and dry, sanitize, heat and dry, sanitize, heat and dry, cancel, then open and close the door. It worked. The dishwasher is running correctly even as I type this.  ... Kenmore 24 in. 17262 Built-in Dishwasher

Kenmore ultra dishwasher won't start


... Kenmore Dishwashers

Kenmore Ultra Wash 665 dishwasher: start button not lighing


It sounds like you have a bad control console, and the problem is that your START button (the most critical one!) is bad. You can't replace just that button or key; you have to replace the entire control console. ... Kenmore Dishwashers

Kenmore ultra wash quiet guard 3 dishwasher problem


Call sears, 1-800-4MY-HOME. They have a trouble-shooting department that will get rid of this problem. It is caused by water temperature being wrong at the start of the cycle.... blah, blah, blah. The representative will tell you to push a certa ... Kenmore 24 in. 15689 Built-in Dishwasher

Kenmore Ultra wash Dishwasher Model 665 15819992 - Lock Lite


... Kenmore 24 in. 15079 Built-in Dishwasher

I see the pressure tower for a Kenmore Ultra Wash Quiet Guard dishwasher laying in the bottom of the dishwasher. I've just rented the house and haven't used the dishwasher yet. Does this pie


No, the designers put it in there for a reason; it won't work as well without it, as it would with it in. Probably the mounting tabs are broken or sprung. A new tower isn't very expensive. You can probably get one from SearsPartsDirect.com, Repair ... Kenmore Dishwashers

Kenmore My dishwasher was in my home when I purchased my home. It is a Kenmore Ultra wash 2, I am not sure which settings to use for basic dishwashing. When I run it it runs for over 1 hour. I don't want it to run that long.


Make sure you run water in your sink until it is hot before you start the dishwasher. On the newer dishwashers they will fill and drain until the water is hot enough so it takes longer if it starts with cold water. Normal time for a basic wash coul ... Kenmore 15129 Built-in Dishwasher

Kenmore 13579 ultra wash dishwasher, stopped has some water,. mid cycle, won't start, fuses in house checked.


... Kenmore Dishwashers

My Kenmore dishwasher, about 5 years old, is not cleaning well any more. Glasses look cloudy,and I assume the bowls and plates are not clean also, but that's harder to detect unless I hold them up to light. I use a rinse agent. What's the problem? Is it worth having a service person look at it or should I just get a new one? It's a Kenmore Elite ultra wash dishwasher.


Although I used my credit card to pay for the live chat, it bounced me out before the service person could respond. So I tried another service and two people who do home repair told me what the problem was and what it would cost to fix it. Since the ... Kenmore Dishwashers

Kenmore dishwasher 15791 wont drain - Kenmore PRO 24 in BuiltIn Dishwasher with Ultra Wash HE Filtration 13173


There's a few things you can look into that won't cost you any money. \015\012\015\012First, manually remove as much water as possible and then check the\015\012sump area for paper or any other large object clogging the drain. A cup\015\0 ... Kenmore PRO 24 in BuiltIn Dishwasher with Ultra Wash HE Filtration 13173

How do you reset the kenmore elite dishwasher? I replaced the faucet in my sink and forgot to turn on the water to the dishwasher....when I started it it went half way through the cycle when I realized there was no water. How do I reset it so that it will start at the beginning of a cycle?


Turn off the breaker that powers it. If all else fails, take a jug, fill it in the sink and pour it into the bottom of the dishwashwer until it comes to the bottom of the heater, that's the round think suspended above the bottom, below the rack, and ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2047 seconds