Having problems with your KitchenAid 23 in. KUDD01DPPA Stainless Steel Dishwasher ?
Water in top drawer
\015 When i run the bottom drawer, the top drawer has excessive amount of dirty dishwater. the hoses were checked and were not kinked. this didn't always happen. what could be causing the water to back up into the top drawer? thanks for your help\015
I am not a repairman but have installed several duel drawer dishwashers. Most dishwashers have a check valve preventing backflow. Water under pressure will always follow the path of least resistance and in your case it is going into the upper drawer. Be sure the drain is open and flowing easily under your sink whether that be the disposal or a TEE. It may help if the drain line is elevated as high as it can go under the sink just before it reaches the drain. How often do you use the top drawer? Perhaps run a cycle on the hottest cycle without dishes to attemt to clean or force through any contaminants in the check valve through into the drain. Hope this helps, Ken
Repair Help & Product Troubleshooting for KitchenAid 23 in. KUDD01DPPA Stainless Steel Dishwasher
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
I have the two drawer dishwasher. It's about 10 years old. The top drawer continues to work OK but for the last three attempts when I run the bottom drawer water gets out into the drip pan below and gives the F1 signal. I can dry the drip pan out and clear the F1 signal so the top drawer works. But running the bottom drawer causes water to leak again with the resultant F1 signal. There is very little water in the bottom drawer (just a little in the filter bowl) so I think the pump is pumping
Hi,Unless you keep using the wrong detergent or keep putting dishes that \015\012are to tall in there. i would have to say your actuators ar bad and its \015\012not letting the lid go down to seal it all the time.There is no adjustment. Y ... Fisher and Paykel Dishwashers
Fisher paykel Hi I have a fisher paykel dd603 dishwasher. when I run the bottom drawer on its own ,,it also fill the top drawer with water ! so after the dishwashing cycle , im left with water in the top drawer. im guessing that a valve should close on the top drawer to stop this happening? is there a part I could order and replace myself? thanks [email protected]
Check your email ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher
Water is leaking from the top of the top drawer, mainly on the right side of the top drawer. Is there an adjustment to raise the tub so that it would have an even seal to prevent the water from leaking. I noticed that the top drawer has a bigger gap on the right side or has more give-in/movemenet when the tub is lifted compare to the left side. This casue the flooding error at the end of the washing cycle.
I have had similar problems with my DD603SS. The leakage leads to the water detection in the bottom of the unit and the resulting F1 error. The movement and height of the lid is controlled by the lid actuators. There is one on each sidewall. The draw ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
The dishwasher top drawer is leaking all over the floor during the cycle. When the top drawer is running, It fills up the the bottom of bottom drawer with water also and then neither drawer drains completely. The water is a light brown color after a wash and often half the soap is left in the dispenser.
Fisher and Paykel design a air gap kit to prevent the water back flowing to the other while one is running. it really works and worth of your money.\015\012You need to change the lid seal and a pair of actuators from the top drawer. Because of the ... Fisher and Paykel DD605SS Stainless Steel Dishwasher
F1 error code due to water coming over the top of the top drawer at beginning of cycle. Previously, I had this code and followed the instructions found here and resolved the problem (a foreign object had blocked the drain). This is different and I need to find out WHY the water is flowing over the top. Could the top drawer just not be sealing properly when closed?
Hello,\015\012\015\012Here a link to a F&P repair video.\015\012\015\012Dish Drawer Repair Video\015\012\015\012http://www.appliancerepairlesson.com/shop/dishwasher-videos/fisher-paykel-dishwasher-repair/ ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
I have the two drawer model dish-drawer system. In the past the top seal leaked and since has been replaced with a new seal. Worked well for several years after but then the top drawer quit running. So we started to use the bottom drawer. That was fine for awhile althought it would pump waste water into the top drawer. Now neither drawer will work. The bottom drawer starts up and shuts down. I pulled the lower drawer and it is dry.
If your model has got an LCD display are you able to record what shows up on the display when the bottom drawer shuts down. If no display then are you able to note down the LEDs which are on inside the top of the drawer lid. It is likely there is no ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
We have a Fisher& Paykel dishwasher with 2 drawers -- one on top of the other. Model DD603. The bottom drawer works fine. But the top drawer is not working properly -- it repeatedly stops in the middle of the cycle and there is water left in the drawer. Previously when this happened, we called a repairman; he removed the top drawer from the machine, said it was "off track", flipped some lever, and put the drawer back. He seemed a little embarrassed by having to charge for a service call for
Are you able to provide a bit more information on what you see when the dishwasher stops in the middle of the cycle -\015\0121 - is it displaying the time remaining in the cycle and is it always the same time?\015\0122- do you get any fau ... Dishwashers
The bottom drawer is filling with excess water after the top drawer cycles. It doesn't hamper the use of the bottom drawer as the excess water drains during the cycle, but I am concerned about rust, etc. from the excess water standing in the drawer. Please advise. Denise Arnold
Hi\015\012 \015\012This means that you have an overflow leak problem. You need to shut off circuit breaker or pull fuse. Next let it dry out for up to 4 days ,peak under dryer and feel metal drip pan and ... Fisher and Paykel Dishwashers
How do I adjust top drawer height? The seal around top drawer appears to be leaking and there is a lot of dried residue around the top edge of the drawer. Water appears to be leaking from the top.
Not sure if adjusting top drawer height will fix the leak. The only way to fix the drawer seal leak is to take the drawer out and check what is wrong with the seal which is located around the top edge of the cabinet from inside.\015\012\0 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
The lid of the top drawer leaks. I've examined the seal and it appears sound. Water is on the top edge of the drawer.
... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
Fisher & Paykel 2 drawer dishwasher: I too cannot get power to top drawer. 4 days ago we had an F1 code. My husband pulled out drawer, wiped up water, and dried it out. Put it back in overnight, and both drawers worked fine. Now the bottom drawer is okay, but no power to top. Help!
He might have unplugged something in the proccess of drying the bottom ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
We just purchased a used Fisher and Paykel DS 603-i. After installing and running the normal cycle there was a lot of water left on the bottom of each drawer. We ran the bottom drawer (water stil siiting on the bottom of the top drawer) and part way through the main wash cycle we got what I think was a F1 error code (we do not have the LCD version but the Rinse light was activated). I took out the bottom drawer, dried out the basin and then took out the washer and reattached the drainage pipes t
Hi\015\012\015\012\015\012Thanks for using FixYa. F1\015\012error means that the flood switch has been activated. You’ll need to reset it by poweri ... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher
I bought a used 7 1/2 year old fisher paykel dd603 for my tenant, it worked fine the first time. second time she got F1 code on both drawers. water was in lower pan, we sopped it up and dried it out. also drawer was not seating level but was lower on left side, and insulation had fallen off left wall. all now corrected. but now the top drawer leaks onto floor on left side. it did not leak before repairman came out, we checked thoroughly. repairman says top lid not seating properly and i need ne
I have the same model F&P and just experienced similar problems. My top drawer was leaking due to that "not important" thin white tube. It really sounds like you called a general appliance guy and not a trained F&P repairman. The guy who fixe ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher
On our double drawer dishwasher, we are getting a code--which illustrates no water--this is for the top drawer, the bottom drawer, works fine--and the water supply is on--please help.
Sorry to read about your problem, I hope this helps you out.you must have a defective water inlet valve, for the 2nd drawer. or a bad control relay for the valve.I tried to help you. Please help me and Rate/Vote on my response ... Fisher Dishwashers
Middle and top spinners do not spin The pump is pushing water up the back delivery tube. There are no dishes in the unit and I was able to trick the door into thinking it was closed so I could watch what was happening. Or Not Happening The spinners are completely free of calcium or soap build up and both top and middle are easily spun with a finger. While the pump and bottom spinner were working, I pulled the top drawer out partially and there appeared to be a good flow of water coming out of
Hi,\015\012 Remove each spray arm and check it is clear of food particlesat the jets. The next problem may occour at the rotating joint . If the seal is not good, you can loose a lot of water out of this point.. If both of these seem reasonable ... Dishwashers
The top drawer of my fisher paykel dishwasher stops during the cycle and shows an icon of a tap with a line threw it (assume that means no or low water pressure). the bottom works fine so I assume water pressure is not the issue; is there a sensor that could be bad? Also, I did switch the controllers between drawers (good instructions on the fisherpaykelparts.net website) but the problem stayed with the drawer, ruling out the controller.
Did it fill with water? could be 1 of your water valves is faulty, or the little filter for the inlet water is blocked. please reply 4 more help. i"m sure i can fix this problem for you. good luck. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
Top drawer of dishwaser has standing water when bottom runs
... KitchenAid KUDH03DT Dishwasher
The top drawer started getting very loud - maybe the water pump? Now it looks as if no water is getting into the drawer so dishes remain dirty. The bottom works fine, and is not loud when running.
Yes it is likely the pump rotor is seized. I am assuming the water goes in to the drawer but does not get moved around by the washer arm. This i ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher
Dishwasher not getting enough water in either drawer, although top drawer gets more. Dishwasher keeps beeping during cycle and reads not enough water and then stops running until you press the start button. Need Help, any ideas?
This sounds like a hard water deposit problem.Check your water inlet valve for a screen and see if its clogged. Also it may just be a water valve/solenoid problem. As in, it's too crusted up to float up and down.Some models have a water f ... Fisher and Paykel DD605FD Stainless Steel Built-in Dishwasher
Our Fisher Paykel dishwashers are 6 years old. The top drawer is shooting water from top left corner when door is closed and leaking water everywhere.
Unfortunately these models do not last this long and you're lucky that it has. This means the rubber casing needs to be replaced and it may be more cost effective to buy a new dishwasher for the cost of the part and labor. ... Fisher and Paykel Dishwashers
Fisher Paykel DD603 both drawers are leaking F1 code bottom drawer is not as bad as top. Can sometimes make it through a load with no F1. There is water underneath lid seal on both at end of cycles or in the case of the top half way through. Checked hoses not leaking.
Change your detergent, high foaming detergents leak through the overflow, highly unlikely that both drawers developed a leak at the same time. ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
Kitchenaid double drawer dishwasher won't drain water from top drawer
... KitchenAid Dishwashers
Water will not drain out of top drawer
To determine if your pump work, before attempting access from the bottom of the top drawer: You can manually pump the water out by doing the following:1- Press the Power button to turn off the display.2- Press the Lock button and then the ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
We have a Fisher & Paykel two drawer dishwasher, model DD603. The top drawer doesn't work - when you push the Start button, there is a series of 4 quick beeps, and there is some symbol of a dish with 3 drops of water, but it doesn't do a wash. The bottom drawer works fine. Though the unit is level, the drawers do not appear to be well aligned. Any ideas?
... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
Water in top drawer
I am not a repairman but have installed several duel drawer dishwashers. Most dishwashers have a check valve preventing backflow. Water under pressure will always follow the path of least resistance and in your case it is going into the upper draw ... KitchenAid 23 in. KUDD01DPPA Stainless Steel Dishwasher