Having problems with your KitchenAid 23 in. KUDD01DPPA Stainless Steel Dishwasher ?

KitchenAid Drawer Dishwasher/Model KUDD01DPPA bottom drawer won't shut. Help! we just installed and the bottomw drawer won't shut. it seems like the hoses are in the way.


Answers :

Repair Help & Product Troubleshooting for KitchenAid 23 in. KUDD01DPPA Stainless Steel Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

KitchenAid Drawer Dishwasher/Model KUDD01DPPA bottom drawer won't shut. Help! we just installed and the bottomw drawer won't shut. it seems like the hoses are in the way.


... KitchenAid 23 in. KUDD01DPPA Stainless Steel Dishwasher

I have a Honda GC160 5 horsepower power washer with 2400 psi. When its cold it is easy to start but after it has been running for a while the only way to start it is to have the water shooting out of the wand. Once it is hot and running if i stop the stream of water (release the trigger on the wand) then the machine shuts off. It seems like the only way to keep it running is to constantly have water running through the wand. Please help


... Pressure Washers

I have an older under the counter high temp dish washer not sure the model number but it has the three switches on the lower left, has both upper and lower wands and it is high temp. Not for sure but it seem like the homing cam switch is not working you can manually turn the came to get machine working but when it shuts off it wont restart when you close and latch the door could you please help!


The cam switch may be faulty and may be available for replacement.\015\012\015\012Hard to find replacement without model no. but for the current model it is available ... Moyer Diebel Dishwashers

Dishwasher wont fill with water. just before it stopped filling i was turning the dial (a lot) between the wash cycles back and forth to attempt to get it to fill and drain (I didn't let it go through a cycle). We also removed the hose from the machine as it had split and replaced it and we had the machine tilted on it's side. the dial still clicks round but it sounds like the pump is going and it doesn't seem to be filling with water. Help


Hi. I suspect that the timer mechanism will be the culprit here, but i recommended to inspect and test the water inlet valve, before replacing the timer. The valve is a known problem area, as well. Follow the valve inspection procedure below, careful ... Fisher DS603W / DS603B / DS603I Dishwasher

I have a Bosch SHU8805UC/14 dishwasher. I took the front door panel off to install it better but ended up with two extra pieces that look like either part 935400 Door Guard, or 935526 Support. I cannot seem to find any place on the inside of the door where these pieces would fit. The dishwasher works fine but seems like it got noisier after I put it back together without these two parts. Can you help me locate the proper place for these 2 plastic parts?


Hello, \015\012\015\012Welcome to FixYa.\015\012\015\012I believe the parts you are referring to are likely the blocks in each corner of the outer door panel. These have been a sticking point for many I tech over ... Bosch Dishwashers

I have a whirlpool gold model GU1500 diswasher. When the rinse cycle ends the water pumps out into the garbage disposal like it should, but then water backs-up from somewhere into the bottom of the dishwasher. The overfill protection drain seems OK...the water doesn't overflow. It doesn't have a air gap on the sink. The drain hose goes directly from the dishwasher to the inlet on the garbage disposal. It appears to be properly installed per the installation instructions. The washer is about 4 ye


Seems you answered your own question here. You need to make an air gap in the drain hose - take as much slack as possible and make a curve (upside down U) under you sink as high as you can go. Make sure you clip ot to back of the cabinet to stabili ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

My GE Adora wont get the close clean, as a matter of fact it wont even get all of the cloths in the load dry. We have already checked the hoses to make sure that the water is not being blocked in any way at least up to the machine. HELP!! We're starting to stink!


Slightly confused here. Do you have a washer, a dryer or a dishwasher.\015\012\015\012Please provide the full model number to help understand the problem so that I can provide a solution . ... GE Adora GHDA656LSS Stainless Steel Built-in Dishwasher

Bosch SHX45M05UC/48 I'm trying to install my dishwasher....but, the hose attached to the right side of the dishwasher looks like it should be connecting, at the other end, to another place within the dishwasher. I can't figure out where it connects and I'm sure I shouldn't have two drainage hoses. Help. mm


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Bottom unit does not always seal and causes water to collect in bottom pan which throw unit into f1 status. Sometimes it stays sealed and is difficult to pull drawer out. Is there a way to reset the unit properly? I know how to pull the drawer and fix the f1 problem but it seem like the seal issue is becoming more frequent. Thanks


These dishwashers are very sensitive to grime collecting around the drawer edges. Try cleaning with a damp cloth by rubbing along the top edges and the sides where the drawer door sits flush with the body.\015\012\015\012Also trun off pow ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

GE PDW7300 dishwasher - must slam the door shut to get a light on the panel and when the START button is pressed, it looks like the dishwasher is cycling thru a wash, but there is no water. When I press the START cycle again, it seems like it thinks its pumping the water out for a few minutes, then the light will go off. If I start it again and push really hard against the door, I can hear the water go on. But if I stop pushing the door, the water stops. The dishwasher was installed in 2001, but


... GE 24 in. Profile PDW7300G Built-in Dishwasher

Kude48fxbl - brand new out-of-the-box. When put through a test cycle after installing it, water poured out of the bottom left edge of the door. This was not associated with either the water input or the discharge hose, but rather seemed to come from the interior of the washer and out under the door. The door seemed well latched, and running it with some dishes in the bottom tray (not blocking the soap dispenser) didn't help.


... KitchenAid Dishwashers

THe door suddenly won't shut all the way. I made sure there was nothing physically in the way--duh--then realize it has to do with the door itself. I made sure the inside of the latch (I guess that it would be called the feamle side) wasn't gunked up. The male side is free of gunk, dose not seem to be damaged. HELP!!!


Hi,\015\012\015\012Usually the only reason a dishwasher door will not close is if either someone has fallen on the door and stretched the door hinges which would then require a service call to replace them or if the unit is not level. if ... Dishwashers

The Frigidaire Professional Series Dishwasher is leaking dishwasher detergent ( during the wash ) all over my tile floor and staining my grout. It seems like the door will not shut all the way. If I push on the door all little, you can really tell a difference in the noise level. Is there a way to adjust the closure to close the door more?


Hi linsley.\015\012\015\012I'm Harvey the Master Plumber.\015\012\015\012Your question is: Is there a way to adjust the closure to close the door more?\015\012\015\012First lets back up a little . You say it's le ... Frigidaire Dishwashers

Hello. my dishwasher leaves gunk on the inside of glasses that were wiped clean before washing. It seems like that would mean the drain to the disposal is clogged but the hose is clear and the impellar is free. I blew on the hose and got movement in the disposal. the impellar is clean and new looking. I thought it would be a little dirty? Any help would be greatly appreciated. I will answer any question you have in case i didn't explain it well.


There are many probable causes of failure .A dishwasher's water inlet valve is its most common part to fail. When \015\012your dishes are not being fully cleaned, quite often a faulty water \015\0 ... Dishwashers

I have a newly installed Kitchenaide dishwasher. The copper pipe is secure under the sink and appears connected properly to the dishwasher. When I turn the shut off valve on, water begans to run from underneath the dishwasher. There is no water under the sink. The plastic hose does not seem to be the problem.


You should be able to remove the panel below the door and see where water inlet hose is connected to the solenoid valve. I'd bet that's where it's leaking since you say it's newly installed. ... Dishwashers

Hi, My EdgeStar dishwasher suddenly started leaking during the draining process ... looks like a sprinkler down one bottom side. I've removed the hoses to check for a blockage, and checked the screws on the bottom, and those all seem OK. What else can I do? Any helpful suggestion is most appreciated. Liz


Www.edgestar.com/ownersmanuals/DWP40Sownersmanual.pdf - United States\015\012\015\012\015\012\015\012Above is your user manual, below, is the support website for Edgestar.\015\0 ... EdgeStar DWP40S Free-Standing Dishwasher

I just purchased and installed an Haier ESD 210 dishwasher. Everything seems to work fine except the machine will not shut off. Also, after selecting the "wash program" the LED blinks continually during all cycles. It takes some effort to latch the door but it does lock. Can you help? Thank you. Joel Miller ([email protected])


This can be caused by water temperature.\015\012Please Make sure that the water supplied to the unit is 120 degrees or higher.\015\012This can be checked on the hot water heater thermostat setting. ... Haier Dishwashers

I have just purchased a used 501HT model and had it installed by a plumber and electrician. It does not seem to work, when I close the door and push the start button. Can you help ? Also, there is a liquid soap hose from the back; is liquid the recommended soap ? Can you use powder in them or not ? Any assistance is appreciated. Alicia


Hello,\015\012 If your dishwasher has not worked since the intial set-up. It could be any number of problems. I would check and make sure your machine's electrical is hooked up properly. A common mistake during set-up of high temperature machin ... Moyer Diebel 24 in. 501HT Built-in Dishwasher

Hi - My Electrolux ESL63010 dishwasher seems to be stuck mid programme. It was part way through a programme when we had a pipe burst. Pipe all sorted now but the dishwasher just makes a noise like it is asking for water but nothing happens. When you open the door, it makes three short beeps and the light flashes on the programme menu. Any ideas how to solve? It definitely is not the pipes as the washing machine feeds from the same pipe and is working fine. Help!


... Dishwashers

Hi there, I have just installed my DX203SK. Conected water supply, waste hose and power supply. Turned it on and there is a noise like its trying. But stop cycle and it is dry. I have tested water and power supply. Please help. Thanks


... Dishwashers

I have a GE dishwasher with front control panel and at first the wash and dry lights stayed on and it was beeping every 30 sec. when I turned the breaker off for the required 30 sec. the lights started flashing and it is still beeping. The control panel seems to be frozen as it is not working and wont do anything.. everything was working fine before this. I bought it at Home Depot on 3/14/07 and had it installed by a licened electricion. Help


Call ge @ 800-386-1215 for service ... Dishwashers

It always seems like it never gets enough water to even make the spray arms work. I have even tried to make sure I am not running any hot water in the house. It is about 7 months old and has always acted this way. Could there be something wrong with the installation? My old Sears never had this problem.


Sounds to me as if there is a blockage in the water line supplying the dishwasher or a kink in the water line supplying the unit. Since the water is supplied from the angle stop under the sink there could be blockage at that point. What I would sug ... Dishwashers

Dishwasher Dilema Hi, Can someone help me solve this problem. Last time I had a problem with my dishwashers I was pretty successful in solving it on this site. I was running a reg wash on the top drawer of my Fisher&Paykel when I suddendly had to stop it in the middle of a wash to add more dishes (something I do all the time) suddenly both screens started beeping with an F1 along with a wrench. It sounds like both motors top and bottom are running full blast. I tried shutting the power for a few


You need to remove the bottom drawer and dry out the water with towels and a hair dryer when this is done it should operate normally. most likely when you pulled out the drawer the water sloshed back and out of the drawer making the dishdrawer think ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Our dishes smell like vomit after they have dried. We run them through the dishwasher, they seem to smell okay. Then when Dry, the smell returns. We have tried vinegar and tang rinses to no avail. We have turned up the heat of our water to scalding, that hasn't helped. We have disconnected drain hose and there is no smell there. What can we do to get rid of this awful smell? There is no food in any filters, heating element is clean except for some hard water stains. We have a whirlpool 575-0 qu


... Whirlpool Dishwashers

Hello, on my hja8630 dishwasher,seems like it is stuck on the drian cycle. if u stop the cycle it still runs the only way 2 stop it draining is 2 turn the power off. please help


Hi.The problem is the water level switch. It is stuck in high level and does not detect that water has finished draining.Most dishwashers have a floater switch located on one side at the bottom of the machine. In that ca ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1710 seconds