Having problems with your KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher ?

Water sitting in bottom of dishwasher

\015 Dishwasher has water sitting in the bottom after cycle is finished\015

Answers :

Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishlex Global 310 model. My dishwasher has water sitting on the bottom of it and it wont drain. I noticed it after I did a cycle of dirty dishes and the 'fast' light was flashing when I went to open it. Which shouldnt have been because it was on a normal wash. The water has been sitting at the bottom for 2 days now and still wont drain! I've taken out all the parts on the bottom which come out and cleaned them. Still no change however.


Just ran another cycle and it was fine ... Dishwashers

Dishwasher repair Dear Guru, I hope you are well this evening. I have a Whirlpool Quietwash Plus dishwasher (940 Series) that will randomly have water sitting in after running through a washing cycle. In addition, some mornings there will randomly be a couple inches of water sitting in the bottom without every running the washer. Need assistance. Any help will be appreciated. Thank you for your time. J


Without model unablr to look up exact unit, but in genreral, either ther is a blockage/clog in oyour drain line not alowing complete drain of cycle, as far as never really washing, i would look into perhaps a faulty/ sloppy door switch assembly. if f ... Dishwashers

Our dishwasher goes through the cycle and finishes fine without water in the bottom. Then within a couple hours, water comes up and sits at the bottom of the dishwasher. Handyman could not figure out why. No clog in place.


Hello Sandra, Welcome to Fixya ! You've come to the right place. The problem you're experiencing sounds like (unfortunately) a common one. The water inlet valve has been an issue with B/S/H built ( this includes bosch, thermador, seimens & gaggenau ) ... Siemens 24 in. SE25A266 ExtraKlasse Free-standing Dishwasher

I have a DU8000XX6 series Kenmore dishwasher that won't drain the water properly. There is about a half inch of water in the tub and the float is raised (not sitting on tub bottom). When I lift up the float a little more I can hear the float switch make. I would assume that when the water is high enough the float switch makes and energizes a solenoid valve in the drain to drain the water, but shouldn't it stay open until all the water drains? Lifting the float while the dishwasher is off wo


... Kenmore 24 in. 15142 Built-in Dishwasher

My bosch dishwasher runs fine, cleans fine, drains fine....but after it has been just sitting for a while, the bottom very slowly fills up with water. Each time we run the machine the water level drains back to the normal amount in the bottom of the washer after the cycle is complete. The problem is if we are away for a few days, the bottom fills up and overflows onto the floor.


Water inlet valve isn't closing all the way closed. Need a new one ... Bosch 24 in. SHU53 Built-in Dishwasher

Dishwasher turns on but blades don't move - water sits on bottom


... GE 25 in. Profile PDW8200J Built-in Dishwasher

Frigidaire FDB1502RGC0 dishwasher set for normal wash and heat dry option, both leds are on. dishwasher cycles through wash, but never makes it to dry cycle. After wash, the leds for OPTIONS high temp wash and dry cycle start blinking and do not stop blinking until I hit cancel - which cancels everything. Open unit and water sitting in bottom. Is it a bad operator panel? Water pump did seem to be working during wash cycle. NEED HELP.


... Frigidaire 24 in. FDBB540 Built-in Dishwasher

We purchased an expensive top of the line Fisher and Paykel 2 dryer dishwasher when we did a total Kitchen rehaul over 1 year ago. We have been noticing water sitting in the bottom of the bottom drawer that smells like sulfur dioxide and now see water is making its way through the maple cabinet to below the sink. None of the plumbing under the sink is leaking. We also purchased a Fisher Paykel gas oven/range at the same time. We notice the oven does not appear to close completely with a tigh


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If you have water leaks around the base of your dishwasher,\015\012you may be using a detergent that is ... Fisher and Paykel Dishwashers

Bad Smell I run my dishwasher at least every other day. I've noticed lately it smells....kind of like rotten eggs? Is there a filter that needs to be cleaned out? If so, where is it located and how can I do this? We have soft water running through the dishwasher and water doesn't sit in the bottom. Please help.


Start your dishwasher with no dishes in it.\015\012Let in run until it takes on water and start washing.\015\012Then open the door and pour in 8 oz of white vinegar and let it finish the cycle.\015\012If this does not correct the sm ... Kenmore 24 in. 15932 Built-in Dishwasher

BOSH DISHWASHER SHU5300: DOESN'T DRAIN COMPLETELY, WATER DOES NOT SIT ON THE BOTTOM BUT POOLS UNDER THE FINE FILTER. THE WATER HAS A BUILD UP AND THEN BEGINS TO SMELL. UCK!! I HAVE DONE ALL OF THE CARE & CLEANING POINTS FROM THE MANUAL. THE DRAIN HOSE DOES NOT HAVE AIR GAPS, THAT ISSUES WAS ADDRESSED. PLUS SEVERAL OF THE BUTTONS DO NOT WORK. THE BUTTONS DEPRESS BUT DO NOT FUNCTION. BEGINNING TO QUESTION IF I SHOULD REPLACE THE DISHWASHER? (10 YEARS OLD) THANKS FOR YOUR HELP!


Def replace .....time to put the old girl down ....whirlpool is a good choice ....or another bosh ... Bosch 24 in. SHU53 Built-in Dishwasher

My whirlpool dishwasher just stopped working the middle of the cycle with water still in the bottom and now nothing lights up or comes on and the water is just sitting in the bottom. Any suggestions?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. If the cycle doesn't\015\012complete, then the first thing that should be checked is the Timer and then the\015 ... Whirlpool 24 in. GU3200XTP Built-in Dishwasher

Our kenmore dishwasher is not draining, you can feel the hot water in the hose where it drains but cannot feel it where it goes into the drain and watere is sitting in the bottom of the dishwasher


You need a new askoll pump to drain the water.this must be installed by qualified person. ... Dishwashers

Dishwasher did not drain all the water - water sitting in bottom of dishwasher


Start and cancel cycle to drain the water out and check the position of your drain hose.....water is probably backwashing into the d/w, hose should leave the drain and go up to the height of the d/w ... Dishwashers

KUDS24SEBS5 Dishwasher. Sitting idle water slowly fills bottom of dishwasher. Have to run to rinse cycle to clear water. Please help?


Close water tap off overnight and see if water still comes into machine. If not, your water valve is defective. If it still does, it is comming from the drainage pipe.(water feeding back.)Need to raise pipe about half height of dishwasher.Some units ... KitchenAid Dishwashers

Maytag HDB8600AWW Dishwasher had been making noise (thought might be water valve, like previous DW), eventually stopped draining water, water now in bottom, I've let sit for couple weeks, looked inside, water was gone, I tried running again, it filled with water, but heard humming control panel noises for first time, then shuts itself off. Also, my handle needs replaced. Please let me know as soon as possible. Thanks in advance. David Weaver


Hi David\015\012\015\012The hum and all the noise that you have mentioned in your post states that the issue is with the pump and motor assembly. Please check the drain hose and try to clean the drain pump filter for any clogs, obstructions. Af ... Dishwashers

Hello, I have a Kitchen Aid (model # KUDMO1T JWHO) dishwasher that runs the motor in all cycles, with water fill & drain working fine, but the pump is not pumping water during any cycle, as the spinners and the inside of the washer are dry when I open the door, except for the water sitting in the bottom. Also, no normal swishing sound of water when the motor runs in any cycle. Looks to me like a mechanical break in the pump drive. How do I check the pump drive on this model? Do you have any


... KitchenAid Dishwashers

Motor problem?? The dishwasher takes in water then the water just sits in the bottom of the unit until the end of the cycle, there is no water going through the jets so the dishes are not getting cleaned. You can hear the motor but nothing is actually happening until the end of the cycle when it just pumps the water back out again


Have you checked the pump / motor belt? ... Tecnik TDW2677 Built-in Dishwasher

Water sitting on the bottom of the dishwasher


Disconnect it from you drain and put it into a bucket. Then start a program and then cancel it, the begining should start with a drain anyway. Then you will see if any water comes out. You can also take a shop vac after to get the water out to see ... Bosch 24 in. SHU53 Built-in Dishwasher

Water sitting in bottom of dishwasher


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I am not getting any water out of the bottom spray arm in my bosch SGS47E02GB35 dishwasher. I have cleaned out the plastic pipe assembly on the left hand side of the machine and the plastic tubes that sit to the right of the pipes. I have blown through many of the other pipes to and dislodged quite a lot of debris which has now been cleared out of the machine. The machine completes its cycle and water comes out of the upper spray arm (there may not be as much water coming out as there should be)


1. Check that water can flow from main pump,though hose to propellor,that there is no blockage. ... Bosch Dishwashers

Hi, I have a 3 year old Nemo F&P dishwasher which turns itself on and off for about 3 seconds each on/off continually.Eventually it does get enough water to wash but never goes into the wash cycle properly, ie the water just sits at the bottom. We dont think it's water pressure and it was working fine until recently.Could it be an electrical problem with the signal to fill properly not getting through? Thanks


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. If the cycle doesn't\015\012complete, then the first thing ... Fisher and Paykel Dishwashers

My Asko D1606 doesn't seem to be filling/retaining enough water to pump actively through the swing arms. When I add a litre or so of water in manually and hold in the door catch, I can see it appear to start working properly. The tablet is still sitting on the bottom of the dishwasher after the cycle has ended and the dishes are still dirty. The pump sounds all right and it is emptying fine. Also, probably due to the lack of water, the cutlery basket has melted right through, and I am sure any p


Check to see it the dishwasher has been pushed back ever so slightly. The water coming into dishwashers and exiting are on timers and if the hose is pinched this can affect it. Your dishwasher may appear to be in the same place but just pull it forw ... Dishwashers

We have just installed GE Model GLDL560NSS. It fills with water and it emptys the water but it doesn't actually wash or rinse. The water just sits at the bottom of the dishwasher tub


I had the same problem running the dishwasher the second time. The first time worked perfectly. I thought the problem was from the sensor not reading enough water to actually start the wash cycle. It sure uses less than any dishwasher I've had bef ... GE Dishwashers

Dishwasher is not draining during washing cycle. Water is always sitting at bottom of dishwasher pan. Also, when the draining cycle is going on the dishwasher (?) pump made a strange sound (not smooth running)


Locked rotor on the bottom of the machine. If you remove the bottom plate of the dishwasher where the water valve and electrical hook up is the motor is right there. If the rotor on the motor is locked up the dishwasher will not drain.. If you take ... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

Kenmore dishwasher model 665.17059400. How do you clean the filter? Water sitting in the bottom?


... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1918 seconds