Having problems with your KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher ?

KUDI01TJWH0 kitchen aid....the clean light is blinking and wont do anything else....how do we reset or do we just need to take it in for repair?????


Answers :

I have a kitchen aid 24" built in dishwasher that will not run and the clean light just keeps on blinking
To invoke the diagnostic cycle, perform the following key presses in less than 6 seconds while in standby.

Heated Dry -> Normal -> Heated Dry -> Normal

Invoking the diagnostic cycle clears all status and last run information from memory and restores defaults. It also forces the next cycle to be a sensor calibration cycle. (quoted from service diagnostic cycle notes in troubleshooting guide)
Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

KUDI01TJWH0 kitchen aid....the clean light is blinking and wont do anything else....how do we reset or do we just need to take it in for repair?????


I have a kitchen aid 24" built in dishwasher that will not run and the clean light just keeps on blinking ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

My bosch shu43c02uc wont work at all and i think i need to reset it, how would you reset it and can you think of anything else that will help with the problem?


Hello\015\012 \015\012Welcome to Fixya.Based on your post,"my bosch shu43c02uc wont work at all..."\015\012 ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

There is a symbol of a tap when i switch the dishwasher on..and it wont wash anything? It sounds like its draining? Ive tried resetting it and switching on and off but nothing. Does it need filling up with water?


Need to check your water supply from the house to the dishwasher, it won't operate properly if the water level in the washer is low. Check the water valve at the sink ands the water valve at the dishwasher.\015\012\015\012Good Luck on yo ... Dishwashers

I have a Kenmore Type 575-0 Dishwasher, model number 665.16033401, Style 16033. It runs trough the cycle, once the cycle is complete the clean mode light is on but most dishes are still dirty. I had someone here to repair this about a year ago. All he did was press alternating two buttons, which I have tried, it resets and lets you start a new cycle. However, the problem remains. Last time there was only button pressing involved, no need to replace anything. So, I would hate to have to pay ag


You need an electronic control and heating element ... Dishwashers

Brandt dishwasher my dishwasher has stopped working AGAIN!!! everytime i call a repair man out they say the temperature re-set needs doing and they fiddle about under the machine, its a built in dishwasher so they take the plinth out underneath, have a fiddle and hey presto it works but i am sick of paying 65 quid for the privilege, i hv asked them what to do but they obviously wont tell me, can you help???


The lights on my dishwasher are working but It doesn't do anything when I hit start. ... Dishwashers

Hello, I purchased a Kitchen Aid Architect II series KUDSO3FTPA3 ~ two years ago. It is deigned so you can put your own panel on it. Duw to a design issue with my cabinets I was not able to add my own panel and wanted to purchase the stainless panel to cover the front of the dishwasher. Kitchen aid was no help, they sold me a panel that would not fit and then would not take it back! Then they said I would need to replace the entire door for $389.00! I need to know if there is a stainless


There is a MUCH better way! go to www.applianceart.com, these guys have tons of panel options including stainless and fax stainless that was featured on HGTV and the Today Show. www.applianceart.com (Appliance Art) ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

My GE dishwasher will not turn on. The electronic touchpad will not do anything...I can't change the wash cycles or reset anything. Is there a reset button for the touchpad? Or do I need a new dishwasher?


... GE Tritonr XL GSD6260JCC Dishwasher

Bosch wont Hello i have a Bosch DLX Series dishwasher and i put it outside and covered it while i did my kitchen remodel.. 6 months later kitchen is done and i move the washer back in. It turns on and it sounds like its running but it wont take in water from the hose. which is on and connected. any suggestions thanks very much...Steve


Faulty inlet valve or water in the bottom tray which will activate the float swich and pump out any water. See that this moves up and down freely. Turn electrics off first. ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

My mother has cancer so needs me to research her problem with her dishwasher. My mother's sink drain water is emptying into the dishwasher. It has to be manually removed since she does not cook much and therefore no longer uses the dishwasher as much as she used to. Is there anything I can do without calling a repair man or plumber? And if I must call a repair man, which should I call, a Maytag repair man or a plumber?


Problems associated with water from the kitchen sink back filling into the dishwasher are caused by the drain line on the dishwasher not having a high end loop. In simple terms, the dishwasher line is too low and is providing a path for the water to ... Maytag Dishwashers

I need the steps to change the hose assembly on my Whirlpool portable dishwasher. When I got it someone had cut the sink connections off so my son connected it to the water and drain with my washing machine which was in the kitchen. However, I have moved and want to use it as portable. I purchased the new hose assembly for the sink faucet, I just need instructions on how to take the dishwasher apart and connect the new hoses.....HELP PLEASE!


... Whirlpool 24 in. Portable Dishwasher Dishwasher

Hi there I purchased a Simpson Riviera 966 Dishwasher about 10 years ago and was very happy with it. All of a sudden water was flooding the kitchen from somewhere under the dishwasher, and not having the money to repair it at the time, it has just been sitting, and possibly the seals may need replacing. All electronic funtions seem OK on it however. Would it be possible to give me a quote on repairing the dishwasher - I HATE washing up !!!! My name is Hartley Cowderoy, and I Live at 65 Rosemount


... Dishwashers

Dishwasher BFDW4 runs for part of a cycle then stops. had it repaired once and he said it was an overheat switch that needed resetting.i never found out where to reset this and the service guy has moved. do u know where to reset this thanks


... Dishwashers

My Frigidaire dishwasher keeps getting stuck on clean. We reset breaker, run the dishwasher just fine, and then once it hits clean, it wont do anything, so have to reset again. How can we fix this?


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Need the wiring diagram for the front panel/door of the dishwasher. The wiring diagram in the owners manual does not provide adequate description of which wires connect where. My problem is that, in taking off the door, two wires became disconnected and I cannot tell where they should be reconnected. I called Viking and they are unwilling to provide this (they prefer I call an authorized repair person). Does anyone know whether a repair manual exists for this and where I might get ahold of one.


This is all I could find go to this address www.specsserver.com/CACHE/FILE5412.PDF at the very end is wiring diagram but its not in detail ... Viking DFUD042 Built-in Dishwasher

The restart/start button wont work. i reset it and it started on dry and ran thru. the washer is 3 years old. what else do i need to do?


... Whirlpool Dishwashers

We haven't used the dishwasher for a while. Now we get no water to the tub. I know we have to take the bottom off and turn something, but what is "that" called and where can I find it. I still have the book for the dishwasher so I can find what needs to be repaired, if I knew what is was.


... Dishwashers

I turned on my Whirlpool dishwasher last night before I went to bed. It is a model number DU915PwP82. Sometime shortly after that, a water line broke in my neighborhood. The water was off and caused some sort of problem with my dishwasher. There is some water in the bottom of the dishwasher. It won't drain or start washing. Do I need to call a repair man or is there a reset button of some sort. Thanks for your help. Rina


Hi.\015\012Often there is a lot of grit in the water supply after a pipe has been repaired, and this may have clogged one or more of the valves in your line, or the gauze filter in the inlet port on your machine. I would first turn off the wate ... Whirlpool Dishwashers

I purchased a Bosch dishwasher and had it installed into my new kitchen. It is plumbed and it does not work, a reapair man said it needs a new motherboard. My issue is that Bosch can't seem to supply central Wi. with this part. The repair place put the order in two and onehalf months ago and still cannot give me a date about when the part will be in. I have owned this dishwasher for five months and have not been able to use it once!


... Bosch Dishwashers

KITCHEN AID STAINLESS DISHWASHER MODEL #kuds02frssWe just replaced both springs in the door and the latch mechanism and the soap dispenser that still does not work. Our door will not stay shut. MY HUSBAND NEEDS HELP.. PLEASE HELP. HE IS VERY GOOD AT REPAIRS AND IS STUMPED!!


Hi.Your husband must check wiring harness from electronic control to door lock solenoid.The solenoid should also be tested reading Ohms with a multimeter.Here parts and diagrams: ... KitchenAid 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

I have a dishwasher that hasn't been draining properly. For a while I could hit cancel drain cycle again and it would clear 1/2-1 of water out. But now that doesn't always do it. Someone told me to take filter out and see if it needs to be cleaned. Otherwise we have no other sink/plumbing problems with other kitchen areas. Please help! one handyman told me no use to work on dishwashers they are just throwaway with parts/service being so expensive.


The advise you recieved is correct. You will need to pull the unit out of the cabinet and disconnect the drain hose from the rear. Then remove the cover, There is a filter inside. If its clean then its time for a replacement unit. You could have a ... Whirlpool Dishwashers

My gas power washer will not start. I filled the gas, checked the oil, set the choke, made sure it was on, changed the spark plug, checked the air filter, and drained any water. When I pull the cord to start I don't even get a putter. Anything else I can try or do I need to take it to a service place.


Will it run if you pour a small amount of gas in the carb? If so, it's a fuel supply problem. Most likely a stuck closed float needle. ... Honda Maxus Pressure Washer MX5222

I am told the pump is defective and I was wanting to do the repair job myself. I need a manuel to take apart the machine to replace the pump assembly or clean it to see if that will do the trick. Is there a manuel so that I can do this maintance?


Usualy if pumps are difective are not worth repairing.\015\012log on to the manufacturar web site they should have a on line manual that might help you.\015\012good luck ... Frigidaire Dishwashers

When the wash cycle takes longer than the time stated on the display, and when the dishes are done, there is about three inches of dirty water in the bottom of the drawer . The repair technician replaced the rotor this week, and says he needs to replace the display, but its still not working right


A couple of things to confirm first\015\0121. is the second drawer working oK - i am assuming you have a double drawer model?\015\012\015\0122. Are you not seeing the wash cycle time on the display? why does the technician want to r ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Our two drawer dishwasher model 603dd was working - it showed the "flood button" and then the power cut out and now there is no power to it. Its two years old. Id it worth fixing?? id there anything we can do to fix it or do we need the Fand P repairer out? Thanks


I have a the F&P double drawer d/w. When I use only the top drawer, the bottom one fills with (dirty) water; and when I use only the bottom drawer, dirty water fills in the top drawer. When I use both at same time, there's no problem. Any sugg ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My dishwasher's lid is stuck down and won't retract. I have a Fisher and Paykel DD605 dishwasher, and I think I must have placed some dishes in there that were too big for it and the lid got stuck. It's now showing an F7 error and refuses to do anything other than beep at me. I've tried turning the power off and back on, but it persists with the error. Is there a way to get it to reset and retract the lid? I've read that in situations like this, when people get repair technicians to com


The error code f7 stating that "the communication time out error"this are all the reason for the error1.the motor control micro has crashed and is not responding to communication request.2.the hardware communication link from ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0879 seconds