Having problems with your KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher ?

The water stays in the bottom of the dishwasher .


Answers :

The drain pump is not working fully to discharge off all the water in the drain cycle. You must check the drain outlet for any blocks in the drain valve/pump. open and clean the unit. If ther pump is not effficiently pumping out in the ddrain cycle then the unit must be changed or serviced.
Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Bosch dishwasher SGS46E26GB/90 makes a knocking noise when started. the timer does not advance and the check water light comes on.There is water in the bottom (up to the bottom of the door) . If I reset the DW the water drains ok. If I mess with the buttons E3 shows on the display the 'quick' light stays on and the eco light flashes. I've checked the filter where the water hose is fastens to the rear. I've cleaned the filters at the bottom of the DW and cleaned out the pump area under them.


... Dishwashers

I have a DU8000XX6 series Kenmore dishwasher that won't drain the water properly. There is about a half inch of water in the tub and the float is raised (not sitting on tub bottom). When I lift up the float a little more I can hear the float switch make. I would assume that when the water is high enough the float switch makes and energizes a solenoid valve in the drain to drain the water, but shouldn't it stay open until all the water drains? Lifting the float while the dishwasher is off wo


... Kenmore 24 in. 15142 Built-in Dishwasher

When dishwasher drains the water not all the water is drained. Some stays standing at the bottom and starts getting an odor after awhile. This is a replacement dishwasher in a 35 year old house. How important is the air release part in the draining situation? I was told by someone that the newer dishwashers have the air release part which was not hooked up on this dishwasher when installed last year. Are there some other possibilities of things that can be checked. Model Number is DU


... Whirlpool DU1055XTS Built-in Dishwasher

I had a problem with my dishwasher popping the breaker. I opened the bottom and found burnt up wires. I fixed those and now the dishwasher stays on and begins its cycle (by draining) but the water is not flowing to the machine. It has supply, and I just now replaced the water inlet valve- no difference. The water was working before the breaker issue. I'm wondering if it is now something as simple as a clog somewhere since the washer sat unused for a month; or, if it is something more compli


I read your previous problem. This appears to be separate problems. The first was likely a loose wire. When a wire has a loose connection they build heat and can melt. The current issue would seem like the float switch is stuck. The float switch is ... Bosch SHU9925UC Built-in Dishwasher

I have a Kitchen Aid KUDS03CTSS3 dishwasher. Dirty water is staying at the bottom and nothing comes out the drain hose during the entire cycle. The drain hose is looped above the kitchen P-trap, although for a time it wasn't. I use a wet vac to get the water out but there is still water below the fine filter. I thought if I could get the fine filter off, I could clean out the bottom as I think that it's full of crud down there that may be blocking things. I can't figure out how to get the l


Hi,Thanks for the follow up. I am glad it worked out for you. If I can Help in the future let me know. http://www.fixya.com/support/c64627-kitchen_aid ... KitchenAid 24 in. KUDP02FR Built-in Dishwasher

Recently our GU1100XTLQ1 started having a problem. It barely cleans the bottom rack, and barely gets top rack wet. The soap stays stuck in the dispenser. I can't see inside as it runs, but my guess is that not enough water is being shot out of the various spinning arms. From looking at diagrams it would appear that this dishwasher uses a pump to circulate water from the bottom of the cavity through the spinning arms. Is my problem a dying pump?


... Whirlpool GU1100XTLB / GU1100XTLQ / GU1100XTLT Built-in Dishwasher

My Delonghi Dishwasher keeps turning off. The dishwasher is turned on at the power point. The water is turned on. Okay When I press the POWER botton on the front it wont stay on. I have to keep my finger on the POWER button and then press the START button for washer to work. If I do this it will then pump out any water in the bottom and start to work. ***BUT when you take your finger of the POWER button the washer just turns off and stops working. Do you have any idea what could be the problem p


Yes, the power button is faulty. by pressing the power button forcefully, you are in effect allowing the contacts to close. Replace it. ... Dishwashers

FDW60 dishwasher Hi My dishwasher is about 15 months old and the problem I have is that it seems to stay on pump and the Ecco45 light is flashing.  A repair company looked at the machine and said that the motor looked like it was leaking and water was getting in the bottom setting off the micro-switch.  He contacted Hotpoint who fitted a new motor today at a cost of £89.85.  Went to use dishwasher tonight and we still have the same problem.  The dishwasher started the washing programme for about


I've just (as of 10 minutes ago) had the same problem. I followed the advice given elsewhere in this forum and removed the bottom cover - water running out so needed a big towel to mop it up. I stood the machine upright and restarted it - no problem! ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Water stays in bottom of thermador dishwasher after wash


... Thermador 24 in. DWHD64CS Stainless Steel Built-in Dishwasher

Water stays in bottom of dishwasher after cycle is completed.


... GE Dishwashers

Won't drain dishwasher goes through all cycles like normal but when it's finished there is still water in bottom, tried to cancel cycle but water stays. I cleaned all the water out and try it again same thing happened. I cleaned the filter so i don't know what else to do!


Make sure the garbage disposal is clear so the water can exit. After that, you may have something caught in the drain hose or check valve. It would require removing the bottom kick plate to gain access to check. ... Kenmore 24 in. 15689 Built-in Dishwasher

Second new Samsung dishwasher. Water eill not completely drain out. Now is giving a blinking light error. Water stays in the very bottom of machine. We do have a water softener and garbage disposal hooked up. Is it possible that something is wrong with the hook-up?


... Samsung 24 in. DB3710D Dishwasher

Kitchenaid dishwasher Fills with water, goes through all cycles but doesn't wash. Water stays in the bottom not draining.


Motor bad. If you are getting power to the motor then the motor is bad. ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Whirlpool Dishwasher ADP 536 stopped washing, the safety fuse dropped, dishwasher restarted, detergent stays at the bottom, water is fed in and out, but no washing, may be spray motor pump?


... Dishwashers

Water stays in bottom of dishwasher? - Frigidaire PLD2855RFC Dishwasher


Check your drain hose for clogs. Bits of food can get caught in here and stop the water from draining. ... Frigidaire PLD2855RFC Dishwasher

After any dishwashing cycle, the water does not drain from the basin. This happens with both the top and bottom units. Even after a long time, the water stays there.


In the past I have found that fat has blocked the discharge hose. Push a curtain track (the stretchy ones) down the hose a little way to see if it is blocked, ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Kleenmaid dishwasher won't pump out all the water, some water always stays in the bottom and it hasn't been washing very well. I have cleaned all the screen's and there isn't any build up of scum


... GE Dishwashers

Bosch Model SHV46C03UC/14 Dishwasher won?t drain completely. The drain hose is not kinked or obstructed and it drains into the garbage disposal. If I push the combination of two buttons on the panel, I can pump out residual water, but if I don?t, it stays there. It will become foul smelling within a day if I do not manually remove the water. Bosch technical support won?t talk to me unless I am a service technician, but I can handle this as I do all my appliances. The screens at the bottom o


THE DISHWASHER DO NOIT DRY THE DISH ... Bosch Dishwashers

A inch of water stays in the bottom of my dishwasher before and after running the dishwasher


Check to see if you have an obstruction in your drain line, or make sure you have a lift in the middle of your drain hose. ... Frigidaire Dishwashers

The water doesn't stay at the bottom of Dishwasher & The detergent doesn'e get totaly emptied out from detergent Tray. It looks like the the residue remain in the Dishwasher & On Dishes too. Please, help us.


Hi there,\015\012 no indication that machine is not working,is there any power supply,check the power source,circuit breaker switch on.\015\012\015\012 Step 1: Check to make sure it's receiving ... GE 25 in. Profile PDW8200J Built-in Dishwasher

Dishwasher began smoking while cycling. Noticed some water in the bottom before starting the dishwasher. The little door for the soap pouch opened but the pouch stayed inside the door area. It smelled like burnt rubber.


Hi..the reason to this problem is probably due to the \015\012bad belt.you need to replace it with a new one.\015\012check this out..\015\012thank you..\015\012kindly rate my response.. ... GE Dishwashers

Water stays in bottom of dishwasher - Dishwashers


Float valve is jammed.Look inside the machine on the floor will\012be a small float valve. Looks like a small upside down cup. Lift it and\012clear anything from underneath. The valve is a safety feature\012to stop the machine ... Dishwashers

The top drawer of my fisher paykel dishwasher stops during the cycle and shows an icon of a tap with a line threw it (assume that means no or low water pressure). the bottom works fine so I assume water pressure is not the issue; is there a sensor that could be bad? Also, I did switch the controllers between drawers (good instructions on the fisherpaykelparts.net website) but the problem stayed with the drawer, ruling out the controller.


Did it fill with water? could be 1 of your water valves is faulty, or the little filter for the inlet water is blocked. please reply 4 more help. i"m sure i can fix this problem for you. good luck. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My Bosch Dishwasher das not drain water after washing is completed. The water level stays below door sealer. I did check it out filter on the bottom and everything simce ok but still dosn't work. Is there enything I can do before calling service??? Bogdan e-mail: [email protected]


Sorry to read about your problem, I hope this helps you out.you have done it allI tried to help you. Please help me and Rate/Vote on my response, thanks and good luck ... Bosch SHU9950 Dishwasher

My Kenmore Elite dishwasher (model 665.17462300) is not spraying the water from the basin in the bottom up through the rest of the dishwasher. The basin fills with water, then just makes a humming noise and appears to splash a little of the water around the very bottom of the dishwasher. When we cancel the cycle, it does drain out the water from the basin. I cleaned all the gunk and debris out of the basin in the bottom, but it didn't make any difference.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1393 seconds