Having problems with your KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher ?

Dishes are wet after wash. Appears drying cycle is not working.


Answers :


\012

Hi,
Check your heating element..

\012


A bad heating element causes many problems in dishwashers...

Dishwasher Problems The Heating Element not Working

\012


How to Replace the Dishwasher Heating Element

Dishwasher Maintenance

heatman101

Asker

\015
Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

MAytag dishwasher MDB7100AWW doesn't dry. AFter dry cycle dishes are wet but there is steam so heater element seems to work. COuld there be a vent for steam that is blocked? Is there a fan for drying that might not be working?


HiThanks for using FixYa. If the dishwasher is draining properly and is working perfectly fine then you'll need to open up the Dishwasher and check the heating element as that could have gone bad. You ... Maytag 24 in. MDB7600A Jetclean® II Built-in Dishwasher

Drying cycle Dishes are left wet. Every other cycle works except the drying stage. Lights are left flashing on this cycle.


To start ensure that heating element and fan are working. The element can be tested reading ohms with a multimeter.The fan can be tested evengizing it.If the fan and element are Ok, then test and eventually replace dryness sensor an ... Miele G848I Dishwasher

DISHES REMAIN WET AFTER DRY CYCLE. HEATER WORKS. IS THERE A VENT THAT COULD BE CLOGGED OR A PUMP FOR DRYING THAT DOESN'T WORK? THANKS


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the dishwasher is draining properly and is working\015\012perfectly fine then you'll need to op ... Maytag Dishwashers

F&P dishdrawer problem: I don't think the heater is working to heat water and dry, as dishes not very clean now and quite wet when cycle finished. The lights don't work anymore so have not had a fault code. How do you replace the heater element? Thank you.


First, open the door and look into \015\012 the tub and locate the heating element (if it is covered, remove \015\012 the lower dish rack and cover). The heating element has two terminals \015\012 which ex ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My Kenmore Elite dishwasher 665.16293401 is leaving my dishes much wetter these days on the heat dry cycle. Has something quit working? If I open the door it is hot and steaming at the end. It is a wet mess but the bottom is drained.


... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

Dishes are wet after wash. Appears drying cycle is not working.


\012Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers...Dishwasher Problems The ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Yes I have a whirlpool DU1345XTVB1 dishwasher. Just got in July. After each wash cycle the dishes are not dry. I have been using Finish gelpacs w/jetdry & also have a off brand drying agent in reservior to help dry dishes. The water temperature is set pretty hot & washer is draining good. I have tried checking wash cycle a few minutes into 1st cycle to see if water is in filling & heating. Didn't know if maybe heating element going out or thermostat not working? Thank you for your time.


<span style="FONT-FAMILY: 'Trebuchet MS'; FONT-SIZE: 10pt; mso-ansi-language: EN" lang="EN">Hi,<br />Check your heating element.. </span><br />\015\012<span style="FONT-FAMILY: 'Trebuchet MS'; FONT-SIZE: 10pt; mso-ansi-lang ... Whirlpool 24 in. DU1050SS Built-in Dishwasher

My dishwasher is leaving a film on all the dishes some of the times. Other times the appliance works fine but more and more often it is leaving a white film on all the dishes as though the rinse cycle is not working well. I have tried filling the jet dry compartment and have been using the same jet dry and detergent as always. The dishwasher is about ten years old and has been working well up to a few weeks ago. Ideas?


Check inlet water quality & whether softening salt is required. Check and fill rinse aid. refer user manual. ... Maytag 24 in. MDB3700 Built-in Dishwasher

Kenmore model 665.16509200 Does not clean very well and now dry cycle not working. Wash cycle takes almost 2 hours, and still dishes had gradoo and white detergent on them, even ones that were clean when they went in. The drying coil had plastic melted on it once before, so that could have caused that malfunction. I am not so concerned about that, it is the dirty dishes after 2 hours that is driving me nuts. The short wash cycle leaves EVERYTHING dirty, so I just quite even trying that.


... Kenmore 13599 / 13594 / 13592 Built-in Dishwasher

I bought a used GE Triton XL d/w with no manual. It worked great but now it is not cleaning anything, when the cycle is over the soap cup is open but half of the soap is still inside of the cup. I opened the d/w during a cycle and the dishes are wet top and bottom racks so I know it's getting water but the dishes are still filthy. Why is the soap not working? It's like water is spraying everywhere but the door where the cup is!


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... GE Tritonr XL GSD6260JCC Dishwasher

My Maytag Dishwasher mdbd880awq wont finish a wash cycle. It will wash and rise then when there is 32 minutes left it wont drain and wont dry the dishes, It just makes a clicking sound. I have to dry the dishes by hand and then use the rise only cycle to get the tub to drain. The drain only doesn't work either


... Dishwashers

The dishwasher (Dishlex DX302) is not drying the dishes any more. I thought I must have put it on the wrong cycle last time by accident, but have tried another cycle and it still won't dry and the dishes remain wet. Any clues?


Have you selected the eco wash cycle.it wont dry on an eco cycle. ... Electrolux Dishwashers

I have a GE Profile Dishwasher, Model# PDW7880J03SS that doesnt dry the dishes. I pulled out the dishwasher and checked the heating element for continuity with my ohm meter and got a closed circuit reading. I tested the voltage going to the heating element and got a 124V reading. However the dishes are still soaking wet after the drying cycle. What am i missing, what else could be wrong with the machine that the dishes won't dry at all?


Hi\015\012\015\012Check if the dishwasher is draining and filling properly is water temperature. Water temperature should be between 120 and 140 F. If water is not hot enough then heating element has gone bad, to check the element you'll ... Dishwashers

Wet dishes At the end of the cycle, the dishes are consistently wet. I am not using the energy saving dry.


If the dry cycle has a problem, check these:Heating element ... KitchenAid 24 in. KUDP01IL - Multiple Color Built-In Dishwasher

My kitchenaid dishwasher leaves a white residue on clean dishes. 4 year old appliance, worked great until 6 months ago. under warranty, service repairman said i was using too much soap( am not). he cleaned it with salt and vinegar stating i had lots of suds when he ran a rinse cycle. i always use jet dry and don't use the heat drying cycle. it didn't improve. i tried different soaps, more vinegar, and finally bought a special product to clean the dishwasher. the inside is stainless steel, very c


Hi,The scum, film and white residueproblems have started since the reductionof phosphates in dishwasher detergents.Here is a tip that will help you to solve the problem of films, residue, and scum in your dish ... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

I have a 2 year old Electrolux ESL 63010 dishwasher, and it worked perfect until a few days ago, when it did not wash cleanly and the dishes came out cold. I read a few forums and it seemed to indicate the heating element. So I ordered one a fitted it, but still the water is not getting hot, or drying the dishes after the complete cycle. I have done a visual check of the PCB board, which looks clean and good. No error sounds, and it completes all programs, but with cold water and no drying. W


... Electrolux Dishwashers

We have a FGHD2433KB1 model dishwasher. Among other problems that I have seen here (detergent door not opening, dishes not clean at the end) our biggest problem is that the dishes are never dry at the end. They are actually dripping wet. It doesn't seem like it is venting during the drying cycle. Any help would be welcome. thanks


Hi,\012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried in vainto clean the things... \012Bought new spray arms online and installed them inminutes...now the thing works ... Frigidaire FDB956RB Built-in Dishwasher

Wash cycle OK, but the drying cycle is faulty. The dishes are wet after 12 hours. Will not dry contents of washer! #SHU680SUC/U06


Make sure your water is hot enough. Water temp has to be at least 120 degrees even to activate the soap and also heats your dishes up enough to allow them to dry. Also, be sure you are using rinse agent such as Crystal Clear or Jet Dry. These brea ... Bosch Dishwashers

My Maytag dishwasher model #MDB4650AWW bought in 2005 has developed several ongoing problems. The first is that the dishes get clean but there is always sandy dirty dried bits left on the glasses. The utensils are clean and the dishes in the bottom rack are clean but the glasses also have this "residue" left on them. I have tried different detergents and rinse agents. I have also added a rinse cycle as well. Nothing works. Now, I am seeing this sandy dirty debris dried bits in the bottom o


... Maytag Dishwashers

Dishwasher is not drying. At end of cycle, dishes are still wet and damp, as well as the inside. Buttons are all pushed. Also, it seems to wash for more than one cycle. Did a light wash and after 1-1/2 hrs., it was still running. Purchased a couple of months ago. Dishes don't seem to be as clean as my old dishwasher.


Hi,Check your heating element.. A bad heating element causes many problems in dishwashers…Dishwasher Problems The ... Whirlpool MDBH969AWB Builtin Dishwasher

The dishes come out with white film on them. During the washing cycle water is not hot, it's only luke warm. I thought it was the heater but the drying cycle works well. Is it all connected to one heater? It is not because of hard water. It worked fine just last motnh. Please help! Thank you!!!


Are you having any issues with your water heater at all. Make sure to run the water at the kitchen sink on the hot side first ti ensure hot water is getting to your dishwasher. Also make sure that the jet dry dispenser has jet dry in it. Hope this h ... LG LDF8812 Stainless Steel Built-in Dishwasher

I have a Maytag MDB8951bws and I have noticed that the dishes at the end of the cycle do not feel hot but mildly warm and not completely dry. I also noticed that when I select the ''Sanitize'' option the light that tells you the dishes have completed being sanitized does not come on after the cycles are completely finished (the ''clean'' light does come on). One last note I will throw in is that the high temp wash seems to work quite well as a lot of steam is expelled when the door is opened dur


... Maytag MDB8951BW Dishwasher

Powder detergent does not dispense into the dishwasher during wash cycle. The powder gets wet and stay in the dispenser and then when the drying cycle comes on it dries the powder and it becomes hard in the dispenser. The dishes are not getting clean


Hi,\012There are three common problems that cause the Soap Dispenser or Cup not toopen. I have a tip that will explain these problems in detail....Dishwasher Repair Problem ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

Purchased 3 days ago. How do you know when cycle is complete? Lights never go out, doesn't say in owners manual? What dry setting should I use? Manual doesn't say, dishes are still wet when I let


... Electrolux EIDW6105GW 24 in. Built-in Dishwasher

Dishes stay wet after going thru dry cycle. Can


Check hot air. Refer service center ... LG LDF6810 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1561 seconds