Having problems with your KitchenAid 24 in. KUDI01ILBS Stainless Steel Built-in Dishwasher ?

KUDIO1ILBS2 KitchenAid Dishwasher, two years old, not heavy usage: control panel is dead, no other power problems in the apartment, the apartment's electical box shows all breakers ok.


Answers :

These dishwasher have a thermal fuse near the contol panel protecting the heat sensitive computer. Do you use the Sanitize or Anti-bacteria cycles?? If so then these cycles get very hot and could have made the fuse blow. Kitchenaid also had some loose connection problems at the fuse making the fuse heat up due to the electicity and not actual temperature. The new fuse comes as a kit with connectors already attached to the fuse (dont mess with them) and a junction block to splice the wires.
KUDS01IL KITCHENAID DISHWASHER ALL CIRCUTS ARE ON BUT DISHWASHER IS DEAD. NO
\015\012RESPONSE WHEN TOUCHING CONTROL PANEL BUTTONS.
Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDI01ILBS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

KUDIO1ILBS2 KitchenAid Dishwasher, two years old, not heavy usage: control panel is dead, no other power problems in the apartment, the apartment's electical box shows all breakers ok.


These dishwasher have a thermal fuse near the contol panel protecting the heat sensitive computer. Do you use the Sanitize or Anti-bacteria cycles?? If so then these cycles get very hot and could have made the fuse blow. Kitchenaid also had some loos ... KitchenAid 24 in. KUDI01ILBS Stainless Steel Built-in Dishwasher

Bosch APEXX model number SHY99A05UC/14 lost power. Power input line appears to have arced (white power line and wire nut show signs of stress). The power breaker did not throw at the junction box. Already cut back wire and re-attached new wire nut along with replacing the breaker at the junction box. Still no power. There are no other visible signs of power stress or water damage underneath the unit or inside the doo panel.


I do not have access to the user or service manual for this model.\015\012However, such symptoms could be result of heater element or thermal overload fuse blowing. Do you remember having a very hot dishwasher when the it lost power.\015 ... Bosch Dishwashers

When exterior breaker panel was replaced, my Frigidaire dishwasher (model FDB989GFC2) was accidently wired to 2 breakers and briefly took a 200v load. It started, then immediately showed a Power Failure code and shut off. The wiring has since been corrected but the dishwasher now shows no signs of life. Is it terminal or can replcement parts solve the problem?


Hi\015\012\015\012\015\012Thanks for using FixYa. You’ll need to check the following things--\015\012\015\0121. Fuse (blown or tripped).\015\0122. Check the wire fasteners at dishwasher junction box. ... Frigidaire Dishwashers

See below This is a post that I just copied to this space "I have a whirlpool Quiet Partner II, Model GU2400XTB1, that just suddenly will not start, as if the power was cut. Circuit breaker is fine. from the little Internet research I've done it looks as thou it could be a thermal fuse problem. How easy are these to replace, assuming that's what it is?" Mine is quiet partner III ... there is power to the connection box at the dishwasher it self (checked w/ light tester) ... but there is no power


Have you tryed leaving the power cord out of the socket for an hour or so sometimes they don't lose the memory until they have been left disconnected for a while ... Whirlpool GU2400XTP Built-in Dishwasher

The problem started with it not draining correctly and leaving water in the bottom - my husband took it apart and found a bolt in the drain. He removed it and now it won't start. It appears to not have power to the electrical panel- we have reset the breaker several times - left the breaker off for 10 minutes thinking it might erase the memory - I've asked for instructions to reset and I keep getting info that is very far removed from this model. I know it has a protocol because a repair


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012\015\012The reset on your dishwasher is as follows, ( I can't locate your particular model number...but its madw be whirlpool so there are only a couple of possible sequences ) however depending ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Hi - my Viking dishwasher has developed a problem where the pump runs continuously, whether the power switch is ON or OFF. After the power is turned ON, the troubleshooting guide indicates that there is too much water in the dishwasher. (One of the pot symbols on the display flashes continuously to show this indication.) I am unable to switch between programs, e.g., from quick rinse to pots & pans. I cleaned all the filters to no avail. I had to secure the circuit breaker in order to turn t


If you open the kick plate, you'll see the pan below the motor and check for leaks. The leaks will trigger the sensor to pump water out. Once you dry out the pan, the pump motor will stop and you should be able to reset the program. ... Viking DFUD042 Built-in Dishwasher

My dishwasher ran this morning with no problems. This evening it won't work at all. No lights come on at all, as if there is no power. I checked the circuit breaker box and all is well there. I flipped the breaker just to double check, but nothing. Sadly, I cannot find my instruction manual. Do you have any ideas?


The manual is no problem you can download it from this site.\015\012The problem you are experiencing will not be described in ... Samsung 24 in. DB5710DT Stainless Steel Built-in Dishwasher

Dishwasher does not seem to have power. I have a Kitchen Aid, under counter unit, 9 years old, model KUDS01I. I used it 2 nights ago with no problem. When I push a button, nothing happens, no lights show, etc. It is plugged into the lower half of a duplex socket with disposal plugged into the top. Disposal works, so the problem seems to be with the dishwasher. That also eliminates any issues related to breakers or ground fault indicators, etc. Is there a reset button on the dishwasher? Is there


... KitchenAid Dishwashers

Am15 dishwasher problem: The pad will only turn on and off. Can't get it to cycle. Was on cycle 4 needed cycle 1. Got it to cycle 1, but now on and cycle does not work and when I push the off button it reboots to on. I put new pad on thinking it was the pad but same problem. Question: Is there a way to reset the board? should I be looking some where else? I cut the power at the breaker box to see if that might reset with no luck.


... Hobart AM15-2 Dishwasher

Same problem! Stopped mid cycle, no power, no lights, nothing. Checked fuse box breakers fine. Bought it a year and a half ago! piece of SH#$! Its a Kenmore now its a $350 drying rack. please help!


Sounds like the main control board needs to e replaced this is the most likely problem ... Kenmore 15129 Built-in Dishwasher

An electrical panel breaker switch was replaced after the microwave and dishwasher both lost power. The microwave works after replacing the main panel breaker. However the dishwasher will not show any power. Checked the internal circuit board, no burned areas, cannot find an internal GFI reset, what can I do to get power restored to the main control panel or even the unit itself? Rick C


1)check any fuse in the circut board.(blown off)\015\0122)check any loose connection of neutral (or)phase wire to the machine(or)in the switch. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

The unit is a Maytag model MDB5601AWW which it has recently began to lose power at the touch pad. The electrical breaker has been checked to confirm normal voltage. Additional investigation suggests that the unit can be reset by (1) disconnecting the power at the breaker, (2) disconnecting and reconnecting the ribbon cable that interfaces the touchpad with the control board. However, the problem reoccurs after a few normal wash cycles.


It sounds to me then that the display board or touchpad needs replacing,you havn't said that it's not doing it's cycles.so it's not causing any washing or cycle problems.i would replace the display board. ... Dishwashers

Miele Diamante G 2150 SCU Dishwasher problem ----The program cycle indicators "Rinse", "Drying" and "End" flash at the same time. The drain pump is running when the door is open. I have reset the power and cleaned the drain pump and non return valve and Spun the propeller several times in both directions to check for obstructions. Still has the same problem. Water is being drained continuously even with power switch on dishwasher turned off.. Had to shut the breaker off to get it to stop. A


Hi\015\012\015\012Plugged system or a jammed drain pump can cause these issues, also make sure the drain hose is not blocked. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remo ... Dishwashers

Hotpoint Dishwasher BF1620 blew the main fuse circuit in fuse box during mid cycle wash? Re-set main power fuse circuit but now as soon as Dishwasher switched on immediately blows main kitchen power fuse in fuse box? What is problem?


This is happening because you have a very bad fault, a Phase to Earth short, problem. Leave machine UNPLUGGED, Breaker/Fuses OUT. do NOT use it, nor Touch it, It is possible to get severe electric shock. PLEASE get a registered serviceman to inspec ... Hotpoint 23 in. BFI62 Built-in Dishwasher

I have a model DU840SWLQ0 dishwasher,everytime we turn it on it trips the breaker in the breaker box,prior to thi problem the drain was stopped up,cleaned the drain now this problem


... Whirlpool Dishwashers

If I turn the power off via the breaker box, do I still need to unplug it? The breaker box off, did not help the situation. Thank you


Yes; that's right, if you disconnect \015\012from the board braker energy, there is no need to unplug power cord from\015\012 the Kenmore, either one or the other way, what is done here is to \015\012prevent the entry of energy. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Whirlpool gold quiet partner iii quit during a cycle. none of the lights on the control panel work. there is power going to the unit from the breaker box.


... Whirlpool Gold GU2275XTVy Dishwasher

My DD 603 has burnt out the power board marked 34740453-G. It tripped the circuit breaker at the power box. It is burnt out on the board where the loom connects for the upper washer. It is burnt vertually in the centre of where the loom joins to the power board and the centre of the loom. I am wondering if something else has gone wrong with the washer causing the power board to burn out, or can i just replace the power board?


... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

No power I have no power.  I checked the plug and it had no power, so I reset the breaker.  Power returned to the control panel.  I selected normal wash.  It started up and 2 seconds later no power again.  Breaker flipped again.  What is the problem?


... Jenn-Air JDB7910 Dishwasher

I have a Bosch SHU5315 dishwasher that doesn't turn on. I checked power getting to the machine, reset power at circuit breaker box and door lock appears to be working. Is this the power supply or computer brain motherboard?


Be sure lock at door is not loose switch at door if not closed wont come on ck door close switch ... Bosch 24 in. SHU5305UC Built-in Dishwasher

I have a couple of problems. Firstly, the auto programme now shows a cycle time of 199mins but actually takes much longer than that to complete - more like 4 hours. On the quick (!) wash cycle the time is 97 minutes, whereas it should be less than 30 mins. Second problem, the detergent box flap won't stay shut when loading, so I have to put the tablet in loose in the bottom. Could the 2 problems be related?


There is an issue with the machine not heating properly, it could be the control panel or the thermostat, The flap not staying shut is not connected to this. ... Dishwashers

My dishwasher won't turn on and makes a high-pichted ringing noise. The problem began when our power went out during a storm. The circuit breaker works as the disposal is connected to the same breaker and still works. The nosie stops when I trip the breaker. The unit is almost 6 years old and is a Profile.


... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

My du943 dishwasher will not power on....it looks like it lost power after the dishes were washed and before the water drained. The fuse is not blown, the power box underneath the unit appears ok, and I checked the thermal fuse after reading other posts with the same problem. What to do from here?


... Whirlpool 24 in. DU930PWP Built-in Dishwasher

FRIGIDAIRE DISHWASHER HI! MY NAME IS MARK AND I AM HAVING PROBLEMS WITH MY FRIGIDAIRE MODEL # FDB710LCB0/SERIAL # TH51153536 DISHWAHER. THE PROBLEM: IT DOES NOT COME ON AT ALL LIKE THERE IS NO POWER TO IT. I HAVE CHECKED THE BREAKER AND THE ELECTRICAL CONNECTION AND THERE ARE NO PROBLEMS AT THOSE POINTS. ALTHOUGH FOR A BRIEF MOMENT LAST NIGHT IT DID COME ON AND THERE WAS A "HUMMING NOISE AT THE DRAIN PUMP LOCATION (IT SOUNDED REALLY BAD) THEN IT SHUT DOWN AGAIN AND NOW IT WON,T COME ON AT ALL. A


Check your door switches behind console, next i would ck the circuit board for power in/out. there a tech sheet behind front panel for further diag test points ... Dishwashers

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1188 seconds