Having problems with your KitchenAid 24 in. KUDI02FR Built-in Dishwasher ?
Whirlpool / KitchenAid - KUDIO2FR - detergent dispenser won't open - dispenser, control board, or both faulty?
\015 The detergent dispenser no longer opens during the wash cycle. I know I can replace this part for about ($60), but I read a post by a technician elsewhere that the control board ($100) is probably defective, causing the solenoid to burn out and that both parts should be replaced. Before I buy/replace both, can anyone else substantiate this position?\015
Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDI02FR Built-in Dishwasher
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Whirlpool / KitchenAid - KUDIO2FR - detergent dispenser won't open - dispenser, control board, or both faulty?
... KitchenAid 24 in. KUDI02FR Built-in Dishwasher
My Kitchenaid dishwasher (model KUDS02SRSS0) keeps burning out my dispenser. First I replaced the dispenser, then I replaced the control board and dispenser, it worked for two weeks and now I have a melted solenoid again in my dispenser. I've measured voltage to the solenoid and it is getting 110V through the entire diagnostic cycle. This is wrong. It should only get power at some point during the cycle to open the dispenser. It appears the control board has failed again and in the same wa
HI. The relay that controls the voltage and timed release command, via logic chip, is indeed damaged(stuck on). This is a common theme with this particular design. The original control board was recently replaced with a substitution model ... KitchenAid 24 in. KUDP01DLBS Free-standing Dishwasher
Detergent dispenser wont open during cycle. Already replaced the dispenser unit. Not sure what to replace next or how to check if the proper signal is coming from the controls.
Replace the soap cup ... KitchenAid 24 in. KUDS01DLSS Built-in Dishwasher
Bosch dishwasher detergent dispenser will not open during cycle after I changed a burnt out control module. so changed the solenoid, still no joy so changed the dispenser? still will not open during cycle. Should the control module be programmed?
... Bosch 24 in. SHU43 Built-in Dishwasher
KitchenAid KUDC25CH Dishwasher Just installed a new control board, last week after some lengthy emails we decided it was probably the control board , control board in now in, as far as I know the dishwasher cycles thru all three of the small lite rinse buttons ad it may have finished completely, there wasno water in the bottom of the washer so all was pumped out and the dishs were dry......the large rinse button on the panel is blinking. I open and close the door but the light contiues to blink
The system does not allow me to view what other consultants have suggested to you about the problem with your dishwasher.\015\012\015\012Before you try anything else, get a Finish dishwasher cleaner kit from the supermarket and run the di ... Dishwashers
Working on a Whirlpool dishwasher DU915PWSS0 - The soap dispenser won't open automatically. We have replace the wax motor and have installed a new control board. When you pull up on the draw bar manually the dispenser door opens perfectly. I don't have a schematic and I don't have the test sequence so I can't run the diagnostic test. It's a blind assy process so you can't really tell if you have the draw bar over the wax motor and coupled. I need the schematic and or test sequence for the E
Please confirm if this is the model you have.\015\012\015\012I might have some access to th ... Dishwashers
Bosch Aquasensor Detergent Dispenser door wont open during cycle
Behind the dispensor door there is a small selanoid you will need to replace this, test to see if its open circuit, alternatively you can just place the detergent in side the machine before you put it on a wash cycle is this would have the same effec ... Bosch 24 in. SHU5305UC Built-in Dishwasher
Asea cylinda 1300 dishwasher detergent dispenser wont open when washing
Detergent dispenser wont open
There is a problem with the soap dispenser not getting signal to open 9 out of ten times it is the dispenser its self and needs to be replaced the other problem is the main control board ... Smeg 24 in. DWF614SS Stainless Steel Free-standing Dishwasher
Kitchenaid kudp02crbs3 detergent dooor wont open
... Maytag PDB3600A Built-in Dishwasher
Soap dispenser wont open to release detergent?
Hi\015\012Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doesn't allow the door to open. Th ... KitchenAid 24 in. KUDS02SRSS Stainless Steel Built-in Dishwasher
A Kenmore dishwasher, model#66513743K603 will wash okay until it drains after cycle that dispenses detergent. Then it takes in half amount of water, wash motor short cycles & then drains.Next cycle works okay. Main control board was replaced but problem wasn,t solved. Rene
... Kenmore Dishwashers
Soap dispenser will not open. I replaced the wax motor and still nothing. Is there a way to verify if the control board is bad?
Verify that the bottom tray is not in backwards. There is a space on one side only, usually, and this keeps the door forced shut. ... Whirlpool Dishwashers
Hi, I have a KitchenAid Model: KUDP02FRSS1. I push start/resume (it blinks) and am given the normal cycle with heated dry, or rinse only as my options. No other buttons work. Also, soap tray does not open during cycle. I replaced circuit board #8559825 to no avail. Is problem likely the control panel?
Control panel is the most likely the cause of your problem. A faulty door switch may also cause this. ... KitchenAid 24 in. KUDP02FRSS Stainless Steel Built-in Dishwasher
I have a Fisher and Paykel Nautilus DW920 dishwasher. However, the door to the detergent dispenser does not open reliably every load -- usually I have to open the dishwasher door about 20 minutes into the load and open the soap dispenser myself. The catch on the dispenser will have released, but the dispenser door will not have sprung open. I am not sure exactly what the problem is -- the soap dispenser door simply seems a bit stiff in its holster. Given a little nudge, it springs open fine. I h
When my dishwasher completes its cycle, there is powdered detergent left in the dispenser and the dishes aren't as clean as they use to be. This started happening after I ran a HI TEMP WASH with a SANI RINSE cycle. I'm thinking that either the detergent dispenser door is opening late or the water is not getting hot enough. To check the dispenser door, I left the door open and just poured powder into the dispenser compartment. This did not improve the cleaning.
Hi\015\012 \015\012Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doesn't allo ... Kenmore 16372 / 16374 / 16379 Built-in Dishwasher
Since purchasing my dishwasher last year I've constantly had intermittent problems regarding the detergent dispenser. It often does not open and therefore does not release the detergent into the wash...the detergent gets damp inside the dispenser and sticks....it often tumbles out when I open the dishwasher door at the end of the cycle.
I would replace the control board. Since the problem is intermittent this would indicate that the controller is not consistently sending voltage to the dispenser to open. ... Whirlpool GU2300XTSS Stainless Steel 24 in Builtin Dishwasher
I have a Whirlpool Gold (Quite Partner) Dishwasher that is about 9 years old. I was using a liquid gel Dishwasher liquid and it has been working fine. After I switched to a Cascade Action Pads (solid powder pallets), its detergent dispenser did not open during the wash cycle. I cleaned the dispenser and switched back to liquid gel. Now the detergent dispenser (that looks clean and fine otherwise) has stopped opening during the wash cycle. What's wrong and what can be done? I can be contacted
As well as controlling cycle times, the \015\012timer on many dishwashers also functions as an actuator for the \015\012spring-loaded dispenser door. At a certain specific time during the \015\012cycle, the timer will activate a lever that in turn op ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher
HI There, thanks for being willing to take my question. We have a 1 year-old White Avanti Dishwasher Model Model DW18/DW19PSS/DW181SS PROBLEM: detergent dispenser often does not fully open, leaving soap in the dispenser even thru the rinse cycle... it seems to get hung up on the upper rack. i can even hear the dispenser door pop open when i open the dishwasher after the cycle is complete, making me wonder if there is enough clearance for the dispenser door to flip completely open. THINGS I'V
... Avanti DW18 Built-in Dishwasher
I have a KitchenAid dishwasher model KUDC10IXWH1 that has no control power. I have already verified that there is 120V at the control board. The unit kept the lights on after the cleaning cycle was done and I couldn't shut them off. I reset the electrical breaker and now nothing works, but the board has power. Please give any advice you might have. I was thinking of replacing the board, but I'm not sure if it is the board or the front control panel. Any way to tell?
... KitchenAid 24-in Built-In Dishwasher White ENERGY STAR KUDC10IXWH
The machine works fine, but about one out of every 4 or 5 times it is run, the detergent remains in the dispenser. The dispenser door has opened and the detergent is hard packed from having gotten wet. It seems like whatever is supposed to cause the detergent to be flushed out of the dispenser is not happening. Am I loading the dishwaher is such a way that the detergent is not getting out?
Most likely the top wash arms are blocked and need cleaning. But could be something more like wash pump not working well, etc.\015\012\015\012Need the full model number of the dishwasher. ... KitchenAid Dishwashers
We have an older Kenmore Elite 665. Recently it the dispensing cup for liquid detergent is not opening at the correct time. At the end of the cycle the dispensing cup is open with remnants of detergent still in it and white soap stain down the door. John
It appears your timer/main controller/CCU or wax switch in the dispenser has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher
We have a Kenmore Smart Wash dishwasher. The detergent dispenser door will not open at the proper time, so the dishes are left dirty. At the end of the cycle, the dispenser door is open, but the detergent is still in it, goopy but unused.
... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher
The detergent dispenser does not seem to be opening properly. When the load is finished, the dispenser is in the open position but is full of hardened detergent, and the dishes, glasses and silverware are not adequately cleaned.
\012Hi,\012\012There\012are three common problems that cause the Soap Dispenser or Cup not to\012open. I have a tip that will explain these problems in\012detail....Dishwasher Repair Problem ... LG Dishwashers
Dishwasher (Whirlpool Model DU930PWQ0) won't pump out. Problem occurred after door was opened during a cycle. Then the pump-out function ceased to work. Washer fills and pumps correctly during the wash cycle. Any suggestions? My guess is that the electronic control may be faulty and it is not opening the solenoid valve for the drain cycle. The other option I have thought of is that the solenoid valve may be faulty and is not responding to the signal from the controller. The dishwasher is n
... Whirlpool DU930 Built-in Dishwasher