Having problems with your KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher ?

My Maytag Quietseries 300 has suddenly stopped draining H2O

\015 The dishwasher has been working fine (1-11/2 yrs) until a few days ago, now there is water that is remaining in the bottom of the unit and I guess isn't being pumped out. Any suggestions to how to figure out what the problem could be..like is it a fuse, a plugged hose, or what. Any help will be much appreciated.\015

Answers :

I had the exact same problem and did the exact same solution as tombax. It was working fine for 6 years until I came home tonight and my wife had a dish water lying in the bottom. I pulled the pump off (see tombax's post). If you then remove the white L pipe (3 torx screws), you will be able to see the impellar for the pump. There is a thin black plate directly under the impellar. Gently work it up and the impellar will come out of the housing (it's magnetic). Clean out around the magnet and inside the housing. I found build up there also. I put it back together and it works perfect.
My Maytag Quietseries has the same problem after less than 2 years. Mine is caused by using granular dishwasher detergent, which is the most common type of detergent. I took apart the entire pump inlet section (need a torx scew driver and a small socket for the impeller) and found the white abrasive material from the detergent (Cascade in my case) was packing in and pluging up all areas of the inlet. After I cleaned it all out & reassembled, dishwasher was back to 100%. Also noticed the normal cycle worked much better as well.
\015\012.
Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Maytag Quietseries 300 has suddenly stopped draining H2O


I had the exact same problem and did the exact same solution as tombax. It was working fine for 6 years until I came home tonight and my wife had a dish water lying in the bottom. I pulled the pump off (see tombax's post). If you then remove the ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

By jleejr on Jul 20, 2010" " I have a Maytag Quietseries 300 dishwasher that I bought new in 2004. The buttons on the control panel will not respond. That is, no lights will display when I push the buttons. It has behaved like this in the past and after several weeks of not using it suddenly it will begin working normally again. However, I think this time it has stopped working permanently. The model number is MDBTT79AWW. What do you think could be wrong? I have tried flipping the circuit breake


HI. The actual culprit in this situation will be your control panel(Defective Touch-pad circuit board). The panel and touch pad assembly are integrated. They share the same space. There is a small ribbon cable on the rear of the control panel that li ... Maytag Dishwashers

I have a Maytag Quietseries 300 dishwasher that I bought new in 2004. The buttons on the control panel will not respond. That is, no lights will display when I push the buttons. It has behaved like this in the past and after several weeks of not using it suddenly it will begin working normally again. However, I think this time it has stopped working permanently. The model number is MDBTT79AWW. What do you think could be wrong? I have tried flipping the circuit breaker to reset it but no c


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. It seems to be the ... Dishwashers

Dishwasher fills and drains but does not circulate during wash and rinse cycles. Stopped working suddenly (might be a clogged pump). How do I access the pump. The dishwasher is a Maytag MDBH970AWW


Clean the drain at the bottom middle. ... Dishwashers

I have a MDB4630AWS1 series dishwasher that is only a couple of weeks old. Suddenly, it now starts the wash cycle but then the Cancel/Drain light turns red, and it drains and stops the cycle. Check for items blocking the sprayers and looked for anything clogging the interior. It does this with all the settings. Seems to work for a few minutes, but then it just drains and stops. Any help would be greatly appreciated.


... Maytag MDB4630AWS Dishwasher

Maytag MDB7100AWS when drain button is pushed it tries to drain for 1 second and stops


... Dishwashers

Kenmore Elite Dishwasher (665.16053402). Suddenly stopped draining water from inside tub. Washed dishes were kinda funky leading up to the failure to drain. Have replaced air gap on sink top - still no drain. Send help...


Http://www.servicematters.com/maytag_library/docs/16021814.pdf\015\012\015\012\015\012\015\012 ... Dishwashers

Model 1895 drain cycle stopped suddenly.


... Asko 24 in. 1895 Built-in Dishwasher

Maytag mdb8600awq dishwasher drains good 20 seconds and stops


Dont know if you still have this problem, what I did was this - press the start button and keep going until you reach the number '2'. Leave it at '2' and in a couple of seconds it will start draining the rest of the water. Worked for me. ... Maytag 24 in. MDB8600AWS Jetclean II Built-in Dishwasher

My Maytag dishwasher MDB6759AWS3 just stopped working. I had to stop it mid cycle and then I pushed cancel drain and now some of the buttons light up but not the start button


... Maytag 24 in. MDBH950AWS Built-in Dishwasher

My 3 year old Maytag dishwasher (Model MDB8951AWB) suddenly will not drain. No blockage is obvious in any drain areas. What can I do?


... Maytag Dishwashers

My Maytag mdb 7 dishwasher stopped working on the same day that a Plumber came to our house to fix our toilet. He says he didn't turn off the water anywhere in the house, other than the valve beside the toilet. Yet our dishwasher all of a sudden stopped working. Can the 2 problems be connected? Or is it a coincidence or am i stuck replacing my dishwasher?


If he indeed only accessed the toiled shut off valve, then that would not affect the dishwasher.\015\012\015\012Even if dirt/sediment got into the line to the washer somehow, it should be able to be cleared at the inlet valve to the washe ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

My maytag dishwasher will run for about 5mins. then shut off. if you open it after it stops it has water in it. then you shut it back, it drains the water and stops. I have replaced the board in it and it still does it.


Hi\015\012\015\012The issue can be with the drain pump assembly not cleaned,\015\012you can clean the drain pump assembly by taking the bottom access panel out and\015\012then clean it completely. Check this video:\015\012\015\012 ... Maytag Dishwasher

Bosch D/W model # SHU9955UC. The drain motor will not stop running. Ran the reset sequence on the panel. Display reset to "0" minutes. Power cycled the D/W and when powered back on the drain motor started up again. What do I do ?


Hi ....This is a common problem. Remove the kick plate you will see the white base which also is a tray to collect leaks or backups. Reach your fingers over the top of tray and feel for water/wetness,if so safety switch has been activated and pump wi ... Bosch SHU9955UC Built-in Dishwasher

Bosch SHU43 My Bosch SHU43C dishwasher stopped washing, turns out the impella came free from the motor, I repairded impella and put it back together and now the dishwasher washes great however now it is stuck in a wash rinse drain cycle. Display counts down but the unit never stops running when it reaches 0. Also, the water level is higher than normal and I there is a kind of thumping sound repeatedly every 15 seconds " use to make that sound only once at the start of a cycle before the impella


Sounds like the control module is out -- cost about $100 (I am on my third). I got a "lifetime" warranty when buying my second one. If you are handy, you can replace it yourself. You can call Bosch to confirm this (I did). It mounts inside the door. ... Bosch 24 in. SHU53 Built-in Dishwasher

Maytag mdb9 will not drain. Put a new garbage disposal in and accidentally ran the washer (forgot to remove the plug from the disposal). Washer stopped working, will not drain. I turned off the circuit breaker and then repowered.


... Maytag 24 in. MDB9150A Built-in Dishwasher

My Kenmore Elite suddenly stopped filling with water. I pushed start but when I checked it hours later the soap dispenser door had opened, the soap is just lying in a puddle, and nothing is clean but the clean light on the front panel is blinking. I tried again to no avail. Any ideas? I've had the machine since it first came on the market and have had other issues with it--it never drains completely, it makes sounds like someone revving a sports car engine when the drain pump is engaged, my dish


Https://secured.whirlpool.com/Service/SrvTechAdm.nsf/2cd44500d572193285256a4 ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Dishwasher suddenly stopped working at start of cycle. opened door to see why water had stopped, there was small amount of water in bottom, it has now drained. turned it off and on again to restart cycle but now nothing is happening


... Bosch SHV4803 Dishwasher

Maytag Quietseries 200 not draining and shutting off before start


Check for a faulty microswitch in the door.. i have a kenmore that did the same thing.. it has two switches in the handle that operate the dishwasher.. if one or both are faulty you will have that problem.. hope this helps ... Dishwashers

Maytag MDB5100AWB, Dishwasher Drain pump runs dry/doesn't stop .


... Maytag Dishwasher

Dishwasher My dishwasher has suddenly stopped draining. I have removed the screen at the bottom and the majority of the water. What is the best way to check for a clog?


Has a disposer been installed recently? If so the drain plug may not have been removed...... Some DW have a check valve attached to the sump that may have a blockage..... Remove the drain hose from the disposer, if connected to one and inspect for bl ... Dishwashers

Is it possible to reset a Maytag QuietSeries 300 undercounter dishwasher? Suddenly, only a couple buttons and lights work. (none of which are the START button)


Hi,Have you tried to Disconnect the Power Supply for Few Minutes. This usually Soft Reset the Dishwasher.There is no Reset Button. If problem persists, you need to Replace Touch Pad which is a Common Issue on this Series. ... Dishwashers

WE HAVE A MAYTAG PLUS DISHWASHER ABOUT 3 YEARS OLD OR LESS. WE WERE GETTING READY TO WASH A LOAD OF DISHES AND THE LOCK BUTTON IS ON AND WILL NOT COME OFF, WE HAVE TRIED PUSHING THE DRAIN OFF BUTTON BUT IT WILL ONLY BLINK, WASHER WILL NOT RUN. LOCK BUTTON WILL BLINK 3 TIMES AND STOP WHAT DO WE DO?


Try holding down the drain button for about 5 seconds.If that still does not do it for you, try taking power from the machine to let it reset itself, easiest is to unplug the unit or flip the breaker switch for the section of the kitchen. ... Dishwashers

Our Maytag dishwasher has all of the sudden stopped rinsing the dishes. The machine sounds like it is running but no water is flowing. The wash cycle runs but not the rinse. Any clues as to why


Check inlet water supply for free flow. check strainer for blockage. Strainer is located at the machine body water inlet tube entry side. ... Dishwashers

My dishwasher will not drain. Have not installed a new garbage disposal or new dishwasher. Just all the sudden stopped working


Hi\015\012\015\012\015\012\015\012Thanks for using FixYa.\015\012Dishwasher not draining properly or not draining at all issues can arise due\015\012to different reasons. Usually, these issues are related to kinked hoses,\015\012knocked o ... GE Nautilus 24" Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1277 seconds