Having problems with your KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher ?

Kitchenaid custom 21 dishwasher will not turn on

\015 Our dishwasher will not turn on. Is there a reset or relay that needs to be reset?\015\012Thanks ben\015

Answers :

Hi, this is a control fault that is localized in the logic sector of the control board. the logic chip which holds all wash programing is damaged. you will need to replace the control asap if possible...

thank u
rate me!!
Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kitchenaid custom 21 dishwasher will not turn on


Hi, this is a control fault that is localized in the logic sector of the control board. the logic chip which holds all wash programing is damaged. you will need to replace the control asap if possible...thank urate me!! ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

The clean light on my Kitchenaid Dishwasher model KUD124SEBL4, stays on even after opening the door after w wash. Also 4 out of 5 time when you start the dishwasher no water turns on you have to cance


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Will a Bosch dishwasher custom panel fit a KitchenAid?


... Bosch 24 in. SHV57C03UC Built-in Dishwasher

I have a KitchenAid dishwasher, model KUDP02FR. The "normal" cycle light is flashing. When I push "cancel" or "resume/start", they start flashing as well, but the dishwasher won't start. I turned off the power and turned it back on. The "normal" light still flashes, but when I press "resume" it all starts over again. Any ideas? I can't find this in the troubleshooting guide I have. Thanks.


Hi\015\012\015\012Thanks for using FixYa. To\015\012resolve this you will have to reset the console. Do this by closing the door\015\012and press these buttons in sequence...\015\012\015\012 ... KitchenAid KUDI01TBK Dishwasher

Kitchenaid dishwasher....clean light will not turn off. Dishwasher will not turn on. Just had motor and pump replaced on Thursday 12-30.


Hi\015\012\015\012If clean light is blinking indicates an issue with heater circuit, door switch or wash pump. To resolve this please reset the power to the dishwasher. After, 5 minutes check if you are still getting the same error. If ye ... KitchenAid Dishwashers

My KitchenAid dishwasher model # kudp01ilbl2 won't start. It is the first time we're trying to start it since we had our water heater replaced (three, maybe four days ago). Not sure how much that may matter. I tried turning off electricity to the dishwasher at the fusebox (overnight), but that did nothing. Normally, you just need to hit the start button and the washing begins. Now, nothing happens. The dishwasher is about six years old.


... KitchenAid Dishwashers

Problem to turn on the KitchenAid dishwasher, model #: KUDP02FRSS1. I have this machine for over 2 years. After one year, sometimes, I cannot touch the touchpad to select some option of the cycles and options. Shutoff the power, and wait for few hours, it seems to work. Unfortunately, now the only cycles I can turn on is "Heavy Duty" and I can not hit Start to start the cycle. The other option on the touch pad I can select is the "Cancel". I turned off the power this time for 2 days and it seems


The electronic control board is most likely the issue. I would replace the pab that controls the dishwasher functions. The control board controls the cycles and the wash time selection as well as the on/off function of the dishwasher. ... Dishwashers

I just installed a new Kitchenaid dishwasher (Model KUDE60FVSS3). After filling with soap, closing the door and starting the machine, it fills with water, waits a couple of minutes and then I can hear low humming noices coming from down below. After opening the door it appears that neither spray arm has turned as if to wash. This dishwasher was purchased new a few years ago and kept in storage as our basement was being finished. This dishwasher has never completed one cycle. Any and all inf


If you have a garbage disposal, there is a plug in the dishwasher that has to be removed for the washer to drain. ... KitchenAid KUDE60FVSS 24 in Builtin Dishwasher

Problem to turn on the KitchenAid dishwasher, model #: KUDP02FRSS1. I have this machine for over 2 years. After one year, sometimes, I cannot touch the touchpad to select some option of the cycles and options. Shutoff the power, and wait for few hours, it seems to work. Unfortunately, now the only cycles I can turn on is "Heavy Duty" and I can not hit Start to start the cycle. The other option on the touch pad I can select is the "Cancel". I turned off the power this time for 2 days and it seems


Your touchpad is likely faulty. Sometimes called a control panel. You can get parts, manual, pictures, part numbers, and more at partselect.com or repairclinic.com ... Dishwashers

Brand new GE Monogram custom panel dishwasher was installed and plumber forgot to turn the water valve on . I ran the dishwasher a full antibacterial cycle w/ no water. Did this do damage to the dishwasher? Thanks for your help


There should be no damage. Most parts do not function when there is no water to circulate.It should be fine. ... Dishwashers

I have a newly installed Kitchenaide dishwasher. The copper pipe is secure under the sink and appears connected properly to the dishwasher. When I turn the shut off valve on, water begans to run from underneath the dishwasher. There is no water under the sink. The plastic hose does not seem to be the problem.


You should be able to remove the panel below the door and see where water inlet hose is connected to the solenoid valve. I'd bet that's where it's leaking since you say it's newly installed. ... Dishwashers

Kitchenaid dishwasher not turning on KUDC10XISS4


... KitchenAid KUDC10IXSS Builtin Dishwasher

Kitchenaid dishwasher sani rinse won't turn on


... KitchenAid Dishwashers

Ever since it was brand new, About once in every four or five times I try to turn on my KitchenAid dishwasher, it won't start. The start button blinks and beeps. I have to open the dishwasher an


... KitchenAid 24 in. KUDM25SH Built-in Dishwasher

Kitchenaid dishwasher model KUDG25SH turns on by itself. Also the various control lights are partially lit up.


... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

Our KitchenAid dishwasher (Model KUDP01ILBt6) doesn't run unless I turn off the breaker switch for 30 minutes, which is suppose to reset the washer. The next load will run, but then the same prob


... KitchenAid 24 in. KUDP01IL - Multiple Color Built-In Dishwasher

My Kitchenaid dishwasher model#KUDC10IXWH1 will not turn on. The breaker has not been tripped. How can I fix it?


... Dishwashers

Have a kitchenaid dishwasher KUDS25SHWH1 - the child-lock light came on and will not go off. It is a light and no button to push and hold except all of the select buttons for the type of wash you want, no air dry button. How do I get this light off?? The Child Lock light has come on by it's self and I cannot get it to turn off. I have never used this feature before. I have tried to hold the Energy Saver button for several seconds but the Child Lock light will not shut off. The dishwasher is loc


Unplug the unit for 15 minutes then plug it back in. This should reset all your computer system and make everything work again ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Kitchenaid KUDS25SH KitchenAid dishwasher Child Lock light flashing. Followed instructions for turning it off. Hold Energy Saver Dry button for 4 seconds. Light stays flashing. Dishwasher won't work. Cancel doesn't effect it.


Hold the button down until it beeps and the light goes off. Eric ... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

I have an old (not sure what year, 80s?) Kitchen Aid energy saver V Custom by Hobart dishwasher. We opened the dishwasher in the middle of a cycle and now cannot get it to re-start. When we lock it back up and push our normal buttons (Low Energy and Energy Saver/Dry Heat Off) or any other combination of buttons, the dial does not turn automatically and the cycle does not continue. I have also tried advancing the dial manually and still, nothing happens. I have even tried advancing it all the


... KitchenAid Dishwashers

My kitchenaid dishwasher is not working properly. The light above the button that says "Rinse Only" is flashing and there is no way to stop it or turn the dishwasher on. How can I fix it?


... KitchenAid KUDI01TBK Dishwasher

My Kitchenaid dishwasher kudr25shbt1 will turn on by itself. The child lock light stays lit along with the cancel light and can cannot be turned off by pushing the energy saver button. The machine will not operate in this condition.What part has failed .


No question about it, the electronic board needs to be replaced. Often the capacitors break down and create problems like you are experiencing. ... KitchenAid 24 in. KUDR25SH Built-in Dishwasher

Maytag dishwasher mde8600aww I just replaced dishwasher handle and switch assembly and turned power on at breaker and lights blink independantly like its in diagnostic mode. customer said it started doing this last night? I have no tech sheet or manual 4 this. Help


Hi\015\012\015\012\015\012Thanks for using FixYa. The model no# mde8600aww for your Maytag seems to be a model no# for a Dryer instead of a Dishwasher. However, from what you have described it seems it is the control pa ... Dishwashers

Is it common for Kitchenaid dishwashers to have water pooling inside them? It's almost like the valve for water coming in isn't shutting all the way...in the middle of the day, we'll find water inside the dishwasher...it drips out the front when you open the door...but when you turn it on, it doesn't have any problem draining the system...mysteriously, we find water in the bottom...what's up?


There is a rubber flapper valve that keeps water from running back into your dishwasher. It's a $5.00 part, but it's a bear to get to,\015\012\015\012You have to pull the drain pump to access this flapper.\015\012\015\012Also ... KitchenAid 24 in. KUDP02FRSS Stainless Steel Built-in Dishwasher

Start button flashes 2hr, but will not start the dishwasher, when touched. Also, lights on top of the door are not always functioning. I phoned Maytag and customer service had me turn off the circuit breaker for 5 minutes. This did not change the dishwasher. I think that the door latch is not snapping into position, when I open the door.


... Maytag 24 in. MDB7601A Free-Standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1784 seconds