Having problems with your KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher ?

Loud humming when the water enters the dishwasher. The copper pipe vibrates. The dishwasher is approximately 11 years old. Problem slowly getting worse over time. I tried to tie down the copper pipe in the basement to no avail. When I closed the right angle stop valve and reopened, the problem got much worse and won't go away even if I grab the pipe. Only happens when water enters the dishwasher.


Answers :

The fill valve solenoid has gone bad.u need to chg the fill valve assly.it is very easy to chge ad it is mounted on lhs bottom corner of the unit behind the toe panel.
Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loud humming when the water enters the dishwasher. The copper pipe vibrates. The dishwasher is approximately 11 years old. Problem slowly getting worse over time. I tried to tie down the copper pipe in the basement to no avail. When I closed the right angle stop valve and reopened, the problem got much worse and won't go away even if I grab the pipe. Only happens when water enters the dishwasher.


The fill valve solenoid has gone bad.u need to chg the fill valve assly.it is very easy to chge ad it is mounted on lhs bottom corner of the unit behind the toe panel. ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

I have a newly installed Kitchenaide dishwasher. The copper pipe is secure under the sink and appears connected properly to the dishwasher. When I turn the shut off valve on, water begans to run from underneath the dishwasher. There is no water under the sink. The plastic hose does not seem to be the problem.


You should be able to remove the panel below the door and see where water inlet hose is connected to the solenoid valve. I'd bet that's where it's leaking since you say it's newly installed. ... Dishwashers

Dishwasher will not fill with water. I've already checked the float assembly, that seems to be working fine. The water just doesn't seem to run into the machine. Little history on an unrelated problem: I want to mentioned that not to long ago my brother tried to put a bunch of celery through the garbage disposal. The sinks and pipes got all clogged up and we had to take them apart to clear up. Immediately afterwards the dishwasher stopped filling with water. I don't see how the two can be r


Hi,\012Here is a tip that will help you to find out why water will not come into the dishwasher... Dishwasher ... GE 24 in. GLD5500L Built-in Dishwasher

Got a Indesit Di620 Dishwasher that trips RCD after power up & immediateley as you shut door.Fault is definately related to pressure switch, disconnected pipe to switch and then able to start cycle, without tripping, small amount of water out of pipe,but cycle only lasts for a few minutes, then stops. ( blowing into pressure switch trips rcd )How can i test switch, or is it a water level problem ??Any help would be good, thanks S.C


... Dishwashers

BF41 Dishwasher with a leak stuck in mid cycle Hi, I have a 'general domestic Appliance Ltd' BF41 (95+G709394) dishwasher which recently started leaking at the door. After replacing the seal the problem seemed to ease, then recently the problem started all over again and the leaking got worse. A couple of day ago I couldn't stop it leaking and now it's stuck in mid cycle and even though the water is washing inside the machine it never gets hot inside or finishes the cycle. Ive tried stopping and


... Dishwashers

My dishwasher makes a banging noise whenever the water supply shuts off & it drains. It has been doing this for a long time. I finally bought a hammer arrester & soldered it on the line after the tee for tap & dishwasher & it sits about 1 foot up.this did not solve the problem. It still bangs loudly & I'm worried about damaging my pipes since they are old copper pipes. can you give me some advise it is a ge Potscrubber mod. #SSD539PS1181 Dave


... Dishwashers

My Bosch Classixx (about 10 years old) dishwasher won't fill The problem has only started since I pulled it out and cleaned! The programme sounds are as normal but no water enters the machine. I detected a small leak on the inlet pipe and tightened that. The machine drains when I add water manually though it has made a lot of gurgling noises for some time now when draining. When tipped on its side water comes out of the bottom of the machine (not entirely clear but not dirty either). When upri


... Bosch SHU9915UC Dishwasher

Smeg DWF612WH dishwasher has developed a leak. Water comes out of the rectangular hole on the side of the water softner used to mount what looks like a level or pressure switch. A few seconds after the fill valve opens water leaks out, not a lot just a small trickle. After the washer has filled and goes ito its cycle, it does not leak again. Over the past weeks the problem has got progressively worse.


... Smeg 24 in. DWF612WH Free-standing Dishwasher

Hi My dishwasher DS603 has a fault of F1 code beeping for the whole day. I have no clue that dont know how to do with it. It is not flooding however. I dont know if it has problem due to the water wasnt supplied this afternoon as the pipes are repairing outside. Now we got water supply back and it keeps beeping. i tried to dry it ALL UP but it still beeping. Please give me advice! cheers


... Fisher and Paykel 24 in. DS603H I Built-In Dishwasher

Hi My dishwasher DS603 has a fault of F1 code beeping for the whole day. I have no clue that dont know how to do with it. It is not flooding however. I dont know if it has problem due to the water wasnt supplied this afternoon as the pipes are repairing outside. Now we got water supply back and it keeps beeping. i tried to dry it ALL UP but it still beeping. Please give me advice! cheers


... Fisher and Paykel 24 in. DS603H I Built-In Dishwasher

I have a Bosch SHU9915UC/U11 dishwasher, installed in 2002. Recently, our hot water heater had to be replaced, and we were without hot water for five days. Air got into the hot water pipes, and dried out all the debri in the lines. When we got the new hot water heater going, all of the sediment in the pipes ended up in the in-line screen filters in various appliances (clothes washer, etc.). I have cleaned these out, and these appliances are fine. Since then, the dishwasher has been shutting


All inlet valves have a screen built into the valve itself,shut off the water remove the entire valve and you will be able to see built in screen,if you flush out the debris from it and re-install the valve it should work fine.  ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

No water will enter the dishwasher, There is no problem with the water supply or the supply line. The water flows from the supply line to the dishwasher connector but does not enter the dishwasher.


The water-inlet valve lets water enter the machine. Make sure it's not clogged. There is a screen on the inside of the valve, this sometimes gets clogged up with debris. Check to see if you get power to valve when unit is put into operation ... KitchenAid Dishwashers

Water seems to be leaking into the dishwasher at the end of the cycle the water appears to be clean, so I am wondering about a seal of some kind on the hot water line leaking or whatever. It is a Bosch Dishwasher SHU series 3200 My problem is the same. Water leaks in to bottom of dishwasher over about a 2-3 day period. The dishwasher runs fine. It does not ever run over. The water seems to stop entering the dishwasher after it reaches a certain level.


You have a bad water valve. When the unit is off, the valve should seal and the water should not flow. Something has gotten in the valve and is keeping the needle up or the diaphram in the valve has deteriorated. replace the water valve and you wil ... Dishwashers

Whirlpool Dishwasher ADG 450. Start as normal and it keeps intermittentlly stopping and starting. Washs / drains fine, but sometimes cycle seams to last for a couple of hours. I think it is four beeps when it is stopping and then immediately starts again. We had a problem months ago where as the sink was draining into the dishwasher out pipe, so dishwasher wasn't draining / filling up. Fixed the problem by turning the pipe the other way so water couldn't flow that way - but I don't know if that


... Dishwashers

Siemens dishwasher help i have a siemens dishwasher with no manuals and on my fresh water pipe there is a box which has a electric sign on it this also has another arrow on it is this a flow arrow? my copper pipe has my outlet on the top should my outlet be underneath to suit this arrow and the water is flowing down and not up the pipe thanks ****.


My siemense dishwasher (2 month old) stopped working\015\012No matter which program I choose, after 1 min the program stops and I get "tap" symbol on the led display. \015\012Instructions says it might be a problem with the water source b ... Siemens 24 in. SE25T250 Free-Standing Dishwasher

Zanussi DW908 dishwasher will not fill with water, when filled manually completes cycle untill fill time again. when filled continues on until water needed again. Only cold supply to machine. Water coming to valve, removed valve and freed it up as it was stuck, water flows through the valve when disconected from the dishwasher at filler pipe which leads up the side of washing chamber. When all connected up water will not enter the dishwasher. I,m beaten as I cannot access this area without maj


\012\012Hi,\012Here\012is a tip that will help you to find out why water will not come into\012the dishwasher... Dishwasher Trouble ... Zanussi Dishwashers

Dish-washer My dishwasher is not draining all of the water out of the dishwasher after it washes. I got someone to look at the drain pipes and he cleaned out the stuff and they still will not drain all of the water. I would like to know what I could do to get all of the water out of the dishwasher so that the water will come out of the bottom of the machine. Wanda


The problem is most likely that the pump empeller had been damage by pieces from a broken dish or a small piece of siverware. The only way to fix this is to take the dishwasher apart and replace the empeller. If you choose to do this yourself, you sh ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Hi I have a Meile G 685SC Dishwasher. It has a water inlet problem. It will not fill and just keeps cycling through the water filling process with the water inlet light flashing. I have taken off the inlet pipe and removed and cleaned the inlet filter and washer and put them back. The filter was blocked with a sand like substance. I have taken apart the antiflood valve also attached to the inlet pipe but it is gel sealed so unserviceable. The inlet pipe itself on removing from the vlave appears


Check that the stopcock is opened fully or whether the water inlet hose\015\012is kinked...Check that the water inlet filter is not clogged and clean\015\012it, if necessary, as described in the operating instructions....Check\015\012that the drain p ... Miele 24 in. Incognito G643SCVI Built-in Dishwasher

Dishwasher does not fill with water when started. Problem began slowly with dishes not rinsing completely. Overfill float appears to work properly. Water fills pipe leading to fill solenoid but does n


I am almost certain that your problem is the fill solenoid.If it does not work, there will be no water entering your machine.I would either remove it and test it or just replace it at this point.Tim ... Dishwashers

ASKO 1905 - Turn the dishwasher on and no water seems to be entering the d/washer. Water is turned on. Dishwasher gets very hot as no water is coming through the pipes.


... Asko Dishwashers

I've got a hotpoint bf168 dishwasher,been working fine until y'day when nothing washed, realised there was no water coming into it. Change water inlet pipe but still nothing, I can hear water going thru the pipe but then just seems to empty itself. Any ideas guys .


Hmmm.... could be the controler. or a stuck valve... have you tried to reset it? turn off power and turn it back on... ... Hotpoint 23 in. BFI68 Built-in Dishwasher

Whirlpool Dishwasher Model #GU940SCGQ2 waste water from sink drain entering the dishwasher. Drain hose drains into same pipe as sin drain. Drain hose is elevated and looped as high as the top of dishw


... Whirlpool Dishwashers

Viking dishwasher code says water line problem, but water enters the dishwasher 1st cycle then stops.


... Viking DFUD142 Built-in Dishwasher

I have two problems with my GUI1500 dishwasher. The 1st is that when water starts entering the dishwasher I hear a loud hammering/vibrating sound. It's strange, but the sound will stop if I turn on a faucet in the house. The other problem I have is that the soap dispensor will no longer stay closed. The Plastic tab that holds it shut has basically disintegrated. Will this cause the dishes to not come clean? Can this part be replaced? I don't see any visable screws holding it onto the door.


Hi - welcome to FixYa,\015\012\015\012The first problem isn't a fault with the washer, it's a plumbing problem called "water hammer", which is a resonating vibration through your pipes. It's usually caused by a toilet flush valve, but can ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

Water hi,i've got some problems with the dishwasher. It keeps telling me to check the water,but i've got no idea what to do. Any help guys?


... Siemens 18 in. SF24A262 ExtraKlasse Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2418 seconds