Having problems with your KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher ?

The water will not drain out of the bottom of the dishwasher...soap suds were everywhere spilling out on the floor After it was mopped up, I scooped out as much as I could. Appears the water has gone down...why would the suds spill out? Afraid to try again.


Answers :

Pull the dishwasher out and inspect the following:
Check the hose for kinks or food plugging the drain hose
check the drain valve solenoid
check the pump motor to make sure it's able to reverse
Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The water will not drain out of the bottom of the dishwasher...soap suds were everywhere spilling out on the floor After it was mopped up, I scooped out as much as I could. Appears the water has gone down...why would the suds spill out? Afraid to try again.


Pull the dishwasher out and inspect the following:Check the hose for kinks or food plugging the drain hosecheck the drain valve solenoidcheck the pump motor to make sure it's able to reverse ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Dishwasher does not drain completely. Overflowed into the kitchen. Unscrewed what appears to be drain and it was full of water. Indicator light read F 14 (or F16) and could not find either in the manual. Screen is clear. Tried rinse hold cycle and suds remained but no water. Help!


... Miele G 2432 SC Builtin Dishwasher

My LG dishwasher is making a strange noise and the water doesn't appear to be hot to wash the dishes. could it be the element that has gone


... LG 24 in. LD-12BW5 Free-standing Dishwasher

I have a Miele 590G dishwasher. Everything appears to work except for water supply. Any suggestions about what I could do or what could be broken? I opened the supply connection (the small gray box) and checked the filter - all seems good. But still - no water supply! Thanks in advance. Ross


You must to check also the tap of water which connect water to this small box may the water pressur out from tap is weak .\015\012you can use a small pan to help this test.\015\012 thanks ross ... Miele 24 in. G656SCi Plus SS Built-in Dishwasher

Dishwasher I have a whirlpool dishwasher that does not appear to be getting hot water. The washer water is cold initially and only seems to get warm once the heater in the base of the machine heats it. The hot water supply line does not get hot so I presume no water is being supplied. Is the water supposed to be hot at the start. If yes could this be caused be a faulty inlet valve and if so how can I check. The dishes are dirty especially on the top rack. Thanks for your help. David


Gendos is on track with his question. I have the same dishwasher and it doesn't get enough hot water to clean the dishes and runs for hours because the heating element wasn't designed to heat water, just maintain it. The only solution we have found ... Whirlpool GU2400XTP Built-in Dishwasher

Hi my L G dish washer is coming up with E1 . It comes on after about 2 min it takes water into the washer then it hummes for about 30 seconds then comes up with E1 and pumps water back out. I have checked the hoses which don't appear to be leaking -I read somewhere in your answers about this problem that it could be the Water Level in Drum lowering, this means there is a leak on one of the pipes. More likely it is the Circulation Pump, which is responsible for pushing the water to the Spray


Hello aderry -\015\012\015\012\015\012I'm a bit short of time as I'm on my way out to a service call, but I've uploaded the service manual to Rapidshare for you to download. \015\012\015\012\015\012Rapidshare download inst ... LG Dishwashers

No water delivered,or "spinning" of upper spray arm.Serviced @n year ago & worked very briefly. Spray arms & filter cleaned. Using a hose as water source to test.....spray arm isn't blocked. The problem appears to be water isn't being delivered to upper spray arms. What could cause this & how can I correct? Thanks for your time & response. Sincerely, Lee Ballard


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for\015\012using FixYa. If the dishwasher is not filling then it is w ... Avanti DW18 Built-in Dishwasher

My dishwasher is SHU 3000 series and over 10 years old. The problem is SUDS that will not go away. I have used on-line methods such as vinegar. I have gone through 6 bottles of "Dishwasher Magic" and have put it through cycles not using soap over 30 times and am still getting suds even at the end of the rinse cycle. I have called a local repairman and he says he cannot help me..that I should continue running the dishwasher time after time till the water is w/o suds. Any help for me?


... Bosch Dishwashers

I have a Neff built in dishwasher, model S44T09N3GB. When I set the program, it appears to be working on the screen but it does not take in any water. I have full water supply elsewhere in the house but it is below freezing outside - could it be a frozen pipe? Also, even before the water failed to enter the washer, it hasn't been cleaning dishes - they come out feeling chalky and aren't shiny.


... Dishwashers

Leaky Dishwasher I recently moved into a new house that has a brand new Magic Chef dishwasher. We haven't even had a chance to use it, but last night discovered water leaking from the bottom onto the floor. When I opened the door, there was about 3-4 inches of water inside. I baled as much of the (slimey) water out as I could, and that stopped the leak. Now afraid to run the dishwasher for fear that it might leak even worse. E71195 Type 777-0


... Magic Chef 24 in. DC4000 Free-standing Dishwasher

I have a Maytag dishwasher that is just over a year old. I still have suds in the bottom when it is finished. What could be wrong?? I have tried liquid vs powder detergent. The dishes are clean and there is no water standing -- just suds in the bottom.


You may want to cut back on the amount of detergent you are using. Your water may be softer than what the detergent manufacture has set there formula guide lines at. Scott ... GE Nautilus 24" Built-in Dishwasher

Water will not drain out of bottom of dishwasher.It will go through the whole cycle but will not drain. This is a Frigidaire model no.FDB510LCS3 Serial no.is:noth70219331.Pump hose was disconnected and drained completely,dishwasher was put through another cycle and still ended up with water puddled in the bottom!! Could this dishwasher be called a lemon??? Does the pump need replacing?? I have noticed on your website that many others are having the same problem.To me it appears that it may be sh


Check the input to the drain hose to make sure it is not blocked by something like a cherry pit.  That could cause the water to not drain fully. ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

Middle and top spinners do not spin The pump is pushing water up the back delivery tube. There are no dishes in the unit and I was able to trick the door into thinking it was closed so I could watch what was happening. Or Not Happening The spinners are completely free of calcium or soap build up and both top and middle are easily spun with a finger. While the pump and bottom spinner were working, I pulled the top drawer out partially and there appeared to be a good flow of water coming out of


Hi,\015\012 Remove each spray arm and check it is clear of food particlesat the jets. The next problem may occour at the rotating joint . If the seal is not good, you can loose a lot of water out of this point.. If both of these seem reasonable ... Dishwashers

After starting wash cycle the rotary dial advances to what appears to be the second phase and stops at about 1 oclock position. I replaced the timer/switch, same problem. Could I have a water temp sensing problem due to a poorly adhered sensor? I thought this may be the issue as the sensor at the water feed near the soap dispenser was loose on inspection. Model Bosch SHU4002UC/U06 Under counter Dishwasher


Check the thermostat sensor. If the sensor is faulty the amchine will not detect that the right temperature is reached and the cycle will not advance.The thermostat will read low ohms (about 1K) using a multimeter at Rx1 at ro ... Dishwashers

The dishes in my dishwasher are not getting clean, particularly on the upper rack. It seems to be because the upper water arms are not spinning during the wash cycle. The bottom spin arm is working fine. I have cleaned out both upper arms as best as I could without removing them (above and attached below to the upper rack), as it does not appear that these arms are easily detachable. I am thinking maybe water is not making it up the line to the upper arms? I also have a lot of dirt in the b


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. First of all please check the\015\012Water temperature by using a thermometer inside the dishwasher to measure ... GE Dishwashers

Have bosch SHE45 EVOLUTION PUSH BUTTON ON RIGHT FRONT PANEL. MY WASHER WILL NOT RINSE ALL THE SUDS OFF THE DISHES OR DOWN THE DRAIN AND HAD BAD SOAP RESIDUE BUILD UP. i HAVE USED LEMISHINE ONE TIME AND THE HARD WATER REDISUE IS GONE. BUT SUDS IS STILL IN BASE OF WASHER. HELP.


I started running the Hot water faucet till I got really Hot water then I started the dishwasher with No dishes in it and let it fill with hot water till it was almost full then I added a half a gallon of white vineagar to the water and let the dishw ... Dishwashers

Kenmore dishwasher Have a kenmore 655.15889020 dishwasher which does not appear to be pumping water fast enough. No apparent blockages. Arms circulate very slow. Enough water in sump. Could it be the motor for some reason is running slow? Or maybe some valve is not closing properly.


Fatubu, are you sure you have the correct model number, Im not finding anything on the posted model. They had an issue on models close to this that had an issue with a twisted or missing seal in the pump assy. causing water to fill the pressure swit ... Kenmore 24 in. 16032 Built-in Dishwasher

Model number 665.13763k600 Seems like dishes on the top rack do not get hit with a lot of water. Also, when soap packets are put into the soap compartment, the soap packets no longer dissolve. It appears that there may be a problem with water flow. Have had the unit for a few years. Wondering if it could be a filter or something?


... Kenmore 24 in. 16039 Built-in Dishwasher

Upper section (glasses, etc.) do not get clean. It appears that it could be a blockage of water to turn the upper water spray or...??? What should I do?


You need to locate the chopper. it's probably broken.Take all the racks outremove the lower wash arm twist off the long tube that goes to the upper wash armtake the 4 screws out torques t15take that plate off under ... Dishwashers

Hello, We have a combination oven and dishwasher. Last week I filled up the dishwasher and after about 5 minutes a blue spark came out at the bottom and it cut the electricity off. Once the electricity was restored we started it again and after a few minutes it just stopped after filling up with water. It blew a fuse again but only one fuse this time and now doesn't switch on anymore. We have emptied all the water from the dishwasher and checked the filter, etc and wonder what could have gone wr


Hi, I contacted the Rosieres web site in France and sent a message using the link Contact Us. Here is the reply;Dear xxxxx,we advice you to contact:TELE MENAGER VIDEO SERVICE21 rue georges Doublet0610 ... Dishwashers

Hi, I have a Miele G681 dish washer with an intake/drain light problem. I've read all posts about similar problems I could find both on this forum and others but I'm afraid I still can't figure my problem out. The intake/drain light starts blinking mid way into the dishwashing process. The dish washer fills up, rinses, drains, water is hot, everything seems to function just fine. Some time after the tablet drops from its door mounted container, and the time estimate reaches 46 minutes r


... Dishwashers

Proline Logic diswasher won't pump out water. Checked the following:- No blockage Pump works OK Pressure switch appears to work OK What other faults could cause this problem.


... Dishwashers

Hi, I have a Miele G638 Plus dishwasher and the Red Inlet/Drain light comes on shortly after the wash cycle starts. I have cleaned everything out and the impellor moves freely. I have also made sure the outlet is clear. I have tried resetting and repeating on different washing cycles but it always locks out after the washing cycle starts. Could this be a heater problem as the element looks quite corroded? I have had side panels off and the water appears to flow easily through the sid


Hi\015\012\015\012Thanks for using FixYa. The first\015\012thing that should be checked is if its draining properly as it could be that\015\012the drain hose is clogged an ... Miele 24 in. G638 Plus Free-standing Dishwasher

Dishwasher wont empty and does not appear to be blocked , i cleaned everything out of the bottom of the washer and still is not pumping out water. Could it be the pump? how would i test this? Tony


... Bosch 24 in. SGV53E03 Built-In Dishwasher

I have a Frigidaire dishwasher (FDB2810LDC1) and a Er code appears in the display with the sensing, rinsing agent low, sanitized, and clean lights all flashing as is the child lock light. After seeing the Er code, I opened the dishwasher and thought I heard the detergent tray open but most of the detergent was gone with a little remaining. This has happened before and we have had the electronic panel replaced twice. Could it be something else like something blocking the detergent tray from op


... Frigidaire Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1494 seconds