Having problems with your KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher ?

STOPS BEFORE DRAIN CYCLE

\015 CLEANS WELL, BUT I HAVE TO PRESS THE DRAIN CYCLE BEFORE IT WILL DRAIN. ALSO NO HEAT SANITIZING?\015

Answers :

Sounds like your heating element and/or temperature sensor. Most machines will stop at a point in the cycle to heat the water and will only move on when a certain temp is reached. These parts are fairly cheap.
Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Bosch Dishwasher does not drain all the water out of the dish washer after the finishing cycle...I usually start the washer and then push the drain cycle and it starts to pump for about 10 seconds and stops and starts and pumps again for 10 seconds and stops and then pumps for about 25 seconds and stops....doing this manual drain twice empties the dishwasher of the excess water....what may the problem be?


... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher

Drain pump runs non-stop. Continues when dial is in Stop position. When disconnected for hours, drain pump starts immediately when power restored. In any wash cycle position, drain pump runs and cycle never commences. Small amount of residual water in drain line when impeller cover removed. Board? Switch?


Sounds like the flood switch has activated.\015\012\015\012You will have to drag the dishwasher out from under the counter after turning off the power to it. Tilt to one side so that any water collected under it is expelled. This will fre ... Miele 23 in. Novotronic G841 Built-In Dishwasher

My dishwasher skips the final drain cycle. The lines are all clean and there is no clog. It drains just fine in the beginning of the wash cycle. Every time I do a load of dishes I have to run the full cycle, then leave the machine open for 3-4 hours and start the cycle again and listen for the drain at the beginning of the wash to drain the machine from the initial wash and stop the machine after it is done draining so it won't fill up again. Sometimes we have to unplug it and wait about an hour


... GE Nautilus 24" Built-in Dishwasher

My Dishwasher starts, then stops after 30secs and won't continue draining. Everytime I turn it back on it comes up on the steam cycle and won't go to any other cycle, drains for 30secs and stops again. Power light is flashing. Have tried holding power button down for 10secs with no effect. Filter is clean, pipes are straight-no kinks. How do I get it to start working again? It is a whirlpool dishwasher, ADP5550.


... Dishwashers

I have a MDB4630AWS1 series dishwasher that is only a couple of weeks old. Suddenly, it now starts the wash cycle but then the Cancel/Drain light turns red, and it drains and stops the cycle. Check for items blocking the sprayers and looked for anything clogging the interior. It does this with all the settings. Seems to work for a few minutes, but then it just drains and stops. Any help would be greatly appreciated.


... Maytag MDB4630AWS Dishwasher

I have a zanussi ZSF2440 dishwasher, when it turned on by the power button on the front you can choose a cycle and start it, Once the cycle is started it fills up with water but doesn't stop until it over flows setting off the flood protection, which cuts the power, so all the lights on the display go off and stops the water flow and drains the dishwasher and keeps draining the dish washer while the flood protection is on. It seems as if the dishwasher doesn't know when its reached its correct


... Zanussi Dishwashers

First we had drain issue with Bosch Integra® 500 SHX55M05UC Built-in Dishwasher ECO cycle. It stopped after a while. I thought it may be because last cycle might not be finished well. When we ran again ECO cycle with no drain issues but cycle did not finished as it used to be. I am sure because cycle countdown were not zero and because infra red light was off which is sing of complete cycle.


... Bosch Integra® 500 SHX55M05UC Built-in Dishwasher

Not draining caloric dishwasher is not draining...was working fine before i stopped it mid cycle to take out a glass...then the next time i used it i put it on the pots and pan cycle and after it dialed to off i opened up and found a "block" of detergent and it hadnt drained... i just put it back on the normal cycle and am trying again... we'll see ?


Does the motor come on when it is supposed to drain? If it does then by stopping the unit mid cycle you could have had a freak instance of food particulate blocking the air gap located on the back of your kitchen sink (if you have one) It would loo ... Caloric 24 in. CDU210C Built-in Dishwasher

I have a Kenmore Elite Dishwasher Model 665.172824000. We think it stopped part way throught the dry cycle. The green "Clean" light has been flashing since in 7 flash cycles non stop. I tried pushing the Cancel button, it starts the drain pump then stops and we are back to where we started. I tried to start a new wash cycle but when I close the door and push the start button it just give 3 quick red flashes and then nothing but the green clean light flashing again. I shut the breaker off fo


So sorry but the partsdirect site for sears locked down my computer. Check where the drain hose connects to your pump and see if there is a small device the hose connects to that has 2 wires going to it. If it does unplug the wires, turn power off, w ... Dishwashers

FDW60 Error code 3&4 . After reset m/c drains on all cycles. Start new cycle, m/c fills but then cycle stops. Makes bubbling noise and appears to overheat. Fault is same on all cycles. M/C drains on all cycles following reset.


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

My dishwasher SL34A015UC / 29 does not complete it's cycle. The cycle will stop with 1 minute left in the rince cycle and continue to run for hours, showing just one minute left. The dishes are not geting clean and there is a unplesent odor inside. I can hear the water draining during the cycle. The drain line is clear and there is plenty of water in the dishwasher. Any thoughts?


... Siemens SL5A70UC 24 in. Built-in Dishwasher

Bosch she44c06uc. Like many here, changed out the garbage disposal and didn't drain. Have reset the system by holding the "Drain Cancel". No help. The cycle stops at draining. Investigated and found small piece of glass wedged in the impellor. While having the interior cover over the impellor off, the motor for the drain impellor is humming, but the impellor does not move while engaged. The impellor will rotate by hand and stops at a point at 3/4 turn. I am hoping it is not in need of a new moto


Check the center of the impeller, it should be flat on one side round on three, the impeller might be rounded out from the shaft it sits on. You might just need a new impeller. Good Luck, N let me know Thanks. jimmy ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

The cycle doesn't seem to stop correctly. I start a load. It doesn't seem to matter which mode that I start in, but it will count-down the time, but at the end it hasn't stopped running. I've cleaned out the filter and the trap below. I've ran vinegar through a cycle. I've cleaned all of the spray arms. It doesn't seem to advance out of the wash mode. There is still some suds at the end. I have to end the cycle by canceling and draining it manually, then run a couple of "rinse--9 minute" cycles


Hello,\015\012\015\012Based on your description I'd say the issue is with the control. That is what I'd be looking for if called out to service the unit with the symptoms you've described. \015\012\015\012The issue is within t ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a Kenmore dishwasher model # 66513449K900 that will not stop running. I think it is stuck on the drain cycle. I can start the dishwasher on a cycle and it appears to clean the dishes, but after the cycle is complete, it continues running and running (on the drain cycle) until you open the door. What could this be?


It is possible that the machine does not move off the cycle because there are errors or back feedback from the inputs. For the program to end the main program controller must receive the feedback so as to switch off the circuit at the end o ... Dishwashers

My dishwasher stopped at the drain cycle. I have to press cancel, and cancel(which is also the drain button) again. Then,it drains but will not complete the cycle for heated drying. Is there a easy way to fix this?


Have you checked there is nothing blocking the filter at the base of the dishwasher?\015\012\015\012Please provide the brand name and model no. of your dishwasher so that I can help you better. ... Dishwashers

The washer cycle stopped without warning, i thought the timer or the timer motor but it is not the timer works fine and so is the motor. but the timer motor runs til the washer motor starts than is the timer stops and the washer is working but not cycling so no rince or drain or soap etc... just pumping water. if you can tell me what might be the problem, thank you. like i said the timer stops when the washer motor start.


... Jackson JPX-300L Dishwasher

Smeg Dwi409c dishwasher is stopping 3 minutes into cycle with no fault lights or anything, I hear it fill with water but then stops, but I do notice the water is not draining which I assume is why it is stopping, correct me if I am wrong. Have removed the filter but still not draining. Any ideas?


... Smeg Repair Pcb / Module Dwi409c

I have a candy trio 501 dishwasher with intergrated oven. When I put a cycle on it starts its first rinse then after 5/10 mins stops and beeps constantly. It's still full of water too. When I put it on rinse cycle it compleates the cycle so inlet and drainage should be ok. Ive removed drain pipe and made sure its not kinked and also clear. I've removed and drained the compartments that had water in and also blew down the pips to see if clear all ok. I've checked the heater element with meter and


... Dishwashers

Currently the only setting that is working is Sani Wash. If I use any of the other settings the Intake Drain light comes on and everythig stops. How can the Sani Wash cycle work fine and no Intake Drain light when all other cycles trigger the Intake Drain light and won't continue to wash? Thanks,Karen


I decided I'd wait for the repairman; I don't want to have to pay additional money. ... Dishwashers

I own the Siemans SL34A006UC dishwasher which had the recall repair completed. Now it doesn't work right. The unit goes through any of the cleaning choices but when it comes time to drain, the unit stops for a few seconds, swishes water for a couple seconds, stops again, then swishes for a couple seconds, stops and then goes back in to regular cleaning mode until the timer reaches zero. At each drain cycle, it does the same thing earlier mentioned 3 times in a row, then back to washing. The unit


You say "dishwasher which had the recall repair completed." (sic) "Now it doesn't work right" (sic)\015\012\015\012Being a professional I must advise,and that, if this is the case, th ... Dishwashers

I have model 363.14779100 that has a problem. When a drain cycle is at the end and the fresh water starts coming in, the draining won't stop therefor all clean water goes right back out the drain. I can open the door latch and reshut it and the cycle will complete but the same thing happens on the next drainout. Is there a switch that needs replacing??


... Kenmore Dishwashers

Asko dw20 pump keeps running even with door open and turned off... The machine got to the final cycle then the pump just keeps running and the glass icon (L2) keeps flashing. All the water is not evacuated from the washer. When I power off from the front the drain pump still runs (and water is still not draining). When I power cycle from the mains (waiting 10 seconds) the pump engages again and the water level drops a bit and then stops draining. I have done this until all the water is empty an


... Asko Dishwashers

Whirlpool Dishwasher ADG 450. Start as normal and it keeps intermittentlly stopping and starting. Washs / drains fine, but sometimes cycle seams to last for a couple of hours. I think it is four beeps when it is stopping and then immediately starts again. We had a problem months ago where as the sink was draining into the dishwasher out pipe, so dishwasher wasn't draining / filling up. Fixed the problem by turning the pipe the other way so water couldn't flow that way - but I don't know if that


... Dishwashers

HI: I have a Viking DFB450 and it continuously tries to drain, even after the cycle is done. I cannot stop the washer from draining, so I put something in the dishwaher door to prevent it from closing (whenever the door is closed, it immediately tried to drain). How do I stop the machine from doing this? Thanks-


See this possible cause:\012 \012 \012 \012 \012 \012 \012 \012\011\012 ... Viking DFB450 Dishwasher

Hello , we have a blanco BFDWC65 dishwasher supplied to us by our builder , The dishwaser fills with water ok then once in cycle it starts (with all operating lights ) then stops , it continues to start then stop for the rest of the cycle , Quiet some time later it finished and then drained the water ok , now it struggles to get to the end of the cycle. have checked all filters , water pressure and for clogged hoses , everything is ok in that department. Any help would be apprieciated


I would suspect the control board in this type of behaviour. As the machine is new I advise no interference, but to open a claim under warranty. You would have all the warranty papers for this unit, or should have received them from your builder. The ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1294 seconds