Having problems with your KitchenAid 24 in. KUDP01DL Built-in Dishwasher ?

My dish washer takes three hours to run a load? How can I fix that problem?


Answers :

Hi.

Reason for long cycle depends on what point of the cycle the machine is hesitating. The long cycle means that there is a problem meeting or detecting a condition that must be met to allow the dishwasher to complete or continue the cycle.

If the cycle is slow at start and machine takes a long time at filling, check the inlet water hose. Ensure that is not kinked or blocked, check also for blockage on inlet valve side.

If the machine fills cold water regularly, and then takes a long time to complete filling with warm water, or hesitates after filling, then check the hot inlet (if valve is double). Check the heating element is machine is self heating (only cold inlet), and most important check and replace the thermostat. A faulty thermostat can slow down the cycle, preventing control board from detecting when the right temperature had been met.

If the machine spries regularly, and then stops and hang before last part of the cycle, then check the pressure switch that decides when drain is complete.

If the machine is completing wash and hangs on a lot in drying , check the dryness sensor.

If all the above is OK, then you may have a defective timer board.

All tests must be done with power off. If you do not know what I was talking about, then it may be time to call the service number listed on manual to contact a technician.

All the best.

Ginko.


Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDP01DL Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dish washer takes three hours to run a load? How can I fix that problem?


Hi.Reason for long cycle depends on what point of the cycle the machine is hesitating. The long cycle means that there is a problem meeting or detecting a condition that must be met to allow the dishwasher to complete or continue the cycl ... KitchenAid 24 in. KUDP01DL Built-in Dishwasher

Bosch built in dishwasher shu4302uc The dishwasher appears to run through the cycle but the cycle takes over three hours. When the cycle finally finishes the dishes are not completely dry. Is there a way to adjust the timing for the cycles? I have checked the screens and they were clear.


\015\012There are no adjustments for cycle timing. What does affect timing is temperature of the water coming into the DW. The hotter your supply water, the shorter the time to cycle, BUT if your water is too hot, the cycle time may become too ... Bosch 24 in. SHU43 Built-in Dishwasher

Quiet partner III model/serial #8534935 won't drain; I tried to run the dish washer, made loud noises and I had to stop at beginning of cycle I removed the three screws in bottom, but couldn't take it apart


... Whirlpool Dishwashers

Power washer loses pressure. Engine runs fine. Taking the nozzel off, squeezing the trigger, and then putting the nozzel back on sometimes remedies the problem. How do I fix it? Thank you.


Your bypass valve is jamming. All you do is take it out, put a smear of o ring grease around the o rings then put back in, make sure you push it all the way in and should fix the problem. ... Karcher 2500 PSI Pressure Washer

My bosch dishwasher takes 3 hours to run. It does not seem to get hot. The dishes are not dry when I open it the next morning. What might be wrong and how do I fix it?


... Bosch 23 in. SHU33A Built-In Dishwasher

I have kelvinator dish washer in Bahrain. The sale agent J.A Zayani suddenly stopped its sale and workshop. The dish washer produces a high blasting sound while running though perform its cycle correctly. We are scared to use it. No one in Bahrain accept its repair as the agent has abodoned its operation. Did you fix anothe ragebt in Bahrain. Please advise what is this bang sound appearing once or twice during operation. Is it safe to run it. How to reapir it. Thanks in advance for your assist


... Kelvinator Dishwashers

Soap I also have a problem with the soap not completely emptying out when I run the dishes. I don't have a problem with the cleanliness of the cycle but my dishes have presoaked in my sink which is a very bad habit. But I would like to have a timetable for the different cycles. I don't understand why the machine has to run an hour when the heat is turned off.


Your soap is old. Get some fresh stuff, or use a liquid dw soap ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Frigidaire FDB520RHB Dishwashers : We bought this dishwasher about 3 months ago. Today I ran the washer before I left to do errands and when I returned, I believe the washer had finished its cycle. But about an hour later, I noticed it had started up on its own? It then proceeded to run for almost 3 hours before my husband canceled the cycle. We were kind of waiting to see if it would stop on its own, which is why we let it go so long. I think it usually takes about 1 1/2-2 hours to wash. Could


Try to run the dishwasher on a short cycle like rinse and see if it finishes the cycle.It is likely the heater or hot water temperature is not reaching the desired level and this could cause the extended wash cycle. Feel water temperature ins ... Dishwashers

Dishes and the dishwasher look dirty after they run, like it redistributed dirty water. The door is very dirty/filmy except right under the soap dispenser, like someone squirted dirty water on it but wiped right under the soap dispenser. If I run it a second time with vinegar it gets clean, but that is crazy, esp since it takes 2 1/2 hours a load. I have 2 of them and both are doing it. I have changed soaps, added more soap, used less soap, pre-rinsed dishes, put them in filthy, used jet-dry, no


Hi Mike_wend604,\015\012\015\012I am looking for a used Asko #1504, if you would like to sell yours please e-mail me at [email protected] and put "Asko" in the ... Dishwashers

I have a kenmore dishwasher model number 665.17332400 the air dry button flashes on and off when u hit start button do run washer the quick rinse button flashes as well and washer will not run. What is the problem and how do I fix it?


... Dishwashers

I have a Bosch dishwasher Model number SHU4302UC. The dishwasher takes about four hours to wash dishes. During the rinse cyle it can be running for over an hour and I will open it to look in side and find that the bottom is full of soap sudds. I believe it is taking too long to wash even though it does a good job.


Possibilities are that of an inefficient heating element ie..scaled up if hard water area especially. whilst the cycle is being completed then the components are working... so other than the element check the drainage for blockages (slow draining add ... Bosch Dishwashers

Dishwasher I am getting a run around with getting my LG dishwasher fixed properly. We had a tech more than once come in and look at our dishwasher. It has not been fixed and never dried the dishes properly. It is now leaking and going to a "del" level when we attempt to wash the dishes. It is also leaking on our fairly new tiled floor and under our new kitchen cabinet. Your tech stated the dishwasher was not installed properly. The installation dept , Francine stated it is not their problem


Not sure what you mean by a "del" level, but as far a drying issues:\015\012\015\012LG chose to use a very energy efficient drying method which relies on the residual heat of the dishes to help dry them rather than many manufacturer ... LG LDF6810 Built-in Dishwasher

Dish washer does not drain after the cycle is complete. The last few months when the dishwasher is done their would be a small amount of water left in the bottom. It didnt create any problems but would smell after a few days. So we would just run the drain cycle and it would empty. Well i got home to and the wife said the it was really full. The water was dirty and when you run the drain cycle it didnt drain. She said the dishes were clean. So i cleaned the vent, and filled the sink with


Check drain hose and drain pump.End of drain hose must be in same level with machine.Try it. ... KitchenAid KUDR01TJ Dishwasher

Frigidaire dishwasher won't end cycle - will run on and on for hours. Sometimes it cycles through, usually it just endlessly washes and rinses. I have to CANCEL the cycle, which causes the dishwasher to empty and run a few RINSE ONLY cycles (which are consistent, cycle time wise) to rinse the soap off of the dishes. Also, the door for the soap seems to stick - how long into the cycle before the soap door should open? Also, does opening the washer during it's cycle (to add more dishes) change or


I would say the resettable thermostat has failed. There is a thermostat which senses the water temperature, and when it fails, it causes the dishwasher to run constant. Replace the thermostat underneath the dishwasher and that should cure problem. P ... Frigidaire 24 in. FDBB540 Built-in Dishwasher

I have a new Whirlpool dishwasher. It has been working fine until a couple of weeks ago when all of a sudden I've been having a problem with the soap dish not opening and dispensing the packet of detergent. What should I do to solve this problem? I have run the cycle through three times and it still won't disolve the packet. The dispenser opens, but the packet is only partially disolved, leaving the dishes not washed. eileen mueller, glendora, ca


I suggest using detergent and jet dry....w/p doesnt sugg packets due to this issue ... Dishwashers

Asko 1475 dishwasher. the machine is taking three hours to run the cycles.


... Asko 1375 Dishwasher

Takes two and a half hours to run a load of dishes


They probably aren't running the hot water at the sink before starting the dishwasher. You know how it takes time to get hot water at the tap when you turn it on? well the new dishwashers use such little water, that they will fill with cold/warm wat ... Dishwashers

New pressure washer runs starts and runs for 30-45 minutes with no problems then dies and will not restart. Once it cools for a few minutes it will restart but will die again quickly. If it is allowed to sit for 30+ minutes it will run for another half hour but then dies again. Changed oil, gas, checked all obvious areas. Any suggestions?


Try removing the carb bowl and check for dirt/water etc , also if the machine is over heating it may be getting vapour locked ... Honda Pressure Washer PSI 3000

I have a Bosch dishwasher, stainless steel front- with buttons on the inside top( same as display, and the washing cycle won't start. Water seems to be running into the washer, as I can hear it, but the cycle never starts. Recently, I had clogged garbage disposer issue that has been resolved. The dish washer drains into the disposer, and I had free standing water left behind in the washer for 2days during this time.. Could this be the issue? Can you help me figure out this problem? Thanks!!


... Bosch 23 in. SHU 8805 Built-in Dishwasher

Sometimes I can run the dishwasher with no problems. Sometimes i will run it and leave the house and come back 5/6 hours later and it is still running on the wash cycle but it is only putting out heat and no water. So its drying up the soap on the dishes and not really washing anything, and it get stuck on that cycle


... Magic Chef 24 in. DU4500 Built-in Dishwasher

Bosch dishwasher I am looking for a wire diagram for a Bosch dish washer mod # SMU2046UC SER# ? FD 7609 470358 my problem is the timer will run but there is no operation at any point on the timer dial, and I cant find a wireing diagram for this unit. so that I can try to trouble shoot this problem.


... Dishwashers

Our 3yr old Bosch dishwasher model SHX46A06UC/46 use to run +/- 105 minutes on the regular wash cycle. As of last week it runs 3-4 hours. What would your diagnosis be or what steps can I take to pinpoint the problem?


The control module has be changed. you can go to thermador .com you can order it from them ... Bosch 24 in. SHX46A05UC Built-In Dishwasher

My Kenmore 16533 dishwasher all of sudden started running really loud on the wash cycle. I stopped the cycle, drained the unit, and looked for something obstructing--found nothing. Started it up, and the problem persists. The dishes do come out clean, however. The dishwasher is 6 yrs old. Is this a problem I could fix, or do I need a repairman? Is it worth the expense of a repairman, or is it time for a new unit?


... Kenmore 24 in. 16533 Stainless Steel Built-in Dishwasher

There is so much debris left on the dishes after the dishwasher has run, it's almost not worth running it. The debris is mostly small hard bits on the inside of glasses from the top shelf. Is this a drainage problem, how can I fix it?


This is a maintenance problem.. if the bits look like grains of sand it is actually food particles that breaks down during the cycle spraying the cups and glasses (usually the top shelf that gets hit worst). solution is to run a dishwasher cleaner th ... GE Dishwashers

Intermitttent beeping on bottom drawer of dish washer no error code only cycle to work all the way through is rinse cycle. Have turned off power supply over night did not fix problem. When you press pause button restarts for about five minutes then beeps again. No problem with top drawer. All inside cleaned using correct powder and rinse aid.


Panel control board Call Encompass Parts 1-800-638-3328 ... Fisher Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1987 seconds