Having problems with your KitchenAid 24 in. KUDP01FL Built-in Dishwasher ?

I have a Kitchenaid dishwasher, KUDP01FLSS5. Just now I used the normal wash and sani rinse cycle. The tub did not fully drain, and the lights on the buttons are unresponsive. I have power at the outlet, but nothing is happening at the controls. What can I do? I am an electrician, so if anything needs to be replaced let me know.


Answers :

Hello. turn it off at the panel for two full minutes. that will reset it. Then push the drain button and hopesully it will respond.
\015\012
\015\012If not get back. Joe
Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDP01FL Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Kitchenaid dishwasher, KUDP01FLSS5. Just now I used the normal wash and sani rinse cycle. The tub did not fully drain, and the lights on the buttons are unresponsive. I have power at the outlet, but nothing is happening at the controls. What can I do? I am an electrician, so if anything needs to be replaced let me know.


Hello. turn it off at the panel for two full minutes. that will reset it. Then push the drain button and hopesully it will respond.\015\012\015\012If not get back. Joe ... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

I have a KitchenAid Dishwasher KUDIO1iLBS2 and none of the lights come on and if I press any of the buttons nothing happens. The unit is getting power to it as I shocked myself. I did ordered and replaced the control board and still nothing is happening. Any suggestions or ideas? Is there a reset button or is there a possible fuse that is out that would make the lights not come on? Please help.


... KitchenAid Dishwashers

I have a maytag jetstream dishwasher / quiet pack. model dwu7702aae. it won't turn on and makes absolutely no noise. it gets power because i've tried changing the outlet with the garbage disposal outlet and it still won't work. there is power. now what? is there a reset button? when I turn the cycle knob absolutely nothing happens. it's just a little too quiet.


... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

My Samsung DMR77LHS dishwasher has lost power completely near the end of a cycle. About an inch of water remains. I have power to the unit. I checked the 15 amp fuse in the unit - it had blown. I replaced it, but still no luck. The fuse is not blowing, but there is no power to panel. Nothing happens when you hit the power button - no lights or anything. Unit acts as if ther is no power at all. I have seen similar posts. Any thoughts?


Hi, whenever a fuse of that magnitude, or any fuse really, Blows, you should never just replace it, as to have any device, blow a fuse, trip a breaker, requires a major fault, they do NOT blow spontaneously ever. So you have had a major short circu ... Samsung DMR77LHS Tall Tub Dishwasher

I purchased a diswasher (Hotpoint)about 1-1.5 years ago. It's model # is HDA3400G02CC and its SS# is TH887451Y. I don't think I registered it. No Matter, Two days ago, my garbage disposal stopped working. I checked the outlet. It had power. The switch to the Disposal was next to the outlet. I assumed that the switch was wired from the outlet. It wasn't. Bottom line, the switch nut was loose. I tightened it and problem solved. When I turned on the dishwasher, nothing happened. It acts like


I purchased your service (telephone support) and the dishwasher expert contacted me. We discussed the issue, he made recommendations. I followed his advise and solved the problem. Before I could recontact him, he called to follow up on my progress. ... GE Dishwashers

Model PLD4555RFC2 dishwasher stopped running. Reset the breaker but nothing happens. No power on touchpad. Does the control board or the console panel need to be replaced?


To check this you would take off the lower kick panel and go down the bottom of the machine where the power wire plugs into your machine and first assure that power is going to the machine. if you do have power going to the machine yet the touchpad h ... Frigidaire PLD4555RFC Dishwasher

New World DW60 dishwasher not working originally had E4 fault Power comes into the PCB the switches and led's light up but nothing happens. After about 5 mins there is a short beep. Does not show any error codes, New World sent a replacement PCB which made no difference except now have no error code. Circ pump, inlet valve, heater, drain pump checked independantly all worked.


I f you have warranty on this please call them, you have a defective\015\012D/W.Unless there is no charge for repairs ,don't spend a dollar on what\015\012is going to be a on going problem ahead.To explain how to fix this is\015\012what the manufactu ... Dishwashers

DU1055XTPQ3 built in Dishwasher... panel has power "cancel" button when pushed you can hear the pump running but on wash the light blinks about 3 times and goes out, nothing happens. Is there a sensor or something in the panel that needs replaced? Jim


Hi\015\012\015\012First try resetting the dishwasher by pressing the AIR DRY button and hold it for 15 seconds. After this if it blinks again 3 times then the control needs replacement. Hope this helps...please post back for further assistance. ... Whirlpool Dishwashers

I have a dishwasher (whirlpool) no computer or digital but when we close latch nothing happens , no start of anything, we check power and it is good to outlet, any suggestions?


Hi\015\012\015\012\015\012\015\012Thanks\015\012for using FixYa. Following are the main reasons due to which this problem\015\012occurs---\015\012\015\012\015\012\015\0121. Door is not latching properly. ... Whirlpool 24 in. ADP5966 Free-standing Dishwasher

Good day after the power is turned on to my brand new kudc03fvss dishwasher, nothing happens. have made sure that the power supply is ok and that the door is properly closed. there is 115 volts at the circuit board inside but nothing happens. no lights, no response to switch etc. just dead. need some advice


You said your getting 115 volts and that is across the power wire and its neutral not a power and ground.. i had a case like this last week and when i got there the unit had power if tested from black to ground but not from black and the white neutra ... Dishwashers

The dishwasher won't start, its stuck, pots/pan button is blinking, & the timer has (2)_ _ bars blinking. I tried to reset/pushed the start/resume button nothing happened. I pushed the cancel/drain button still nothing happened. I close the door tight..nothing. I check the trays if there something stuck inside..nothing. I unplug/replug the power cord nothing? my wife was using it when this got stuck about 3 weeks ago.


Did you hold the start/resume button for at least 3 seconds if this works the dishwasher will start ok but if there is a fault it will fail again best you contact your nearest service agent good luck ... Whirlpool GU2400XTP Built-in Dishwasher

Stops part way through programme water still in machine. Now no power to machine. Problem happened yesterday - cleaned filter and pump - power came back. Programme started but then stopped. No power - nothing happens.


Either there is a bad capacitor in the control panel, or the power supply has a faulty capacitor. You will have to get a multi-tester and test each component for resistance and current ... Dishwashers

I got this dishwasher from a friend that had mice chew the hoses and i was told that it worked perfect before the mice chewed it. I replaced the drain and fill hoses plus the power cord. when i put everything back together and power on I get F1 on the top drawer and the rotor rotates and the heater plate turns on. The botton drawer does nothing with no display. I checked all the wires with a meter and found good continuity thru every pin. I replaced the main filter board. I even switched the


Did the F1 error in the top drawer disappear after you replaced the mains filter board? ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Brand new, never used dishwasher. When I touch/press on the circle to select a function nothing happens. The PF (power failure) light keeps flashing & when I press clear/drain nothing happens. Won't allow me to select any other function.


... Frigidaire FGBD2451KF 24 in Builtin Dishwasher

Bosch Dishwasher SHE66C06UC is DEAD. Push Power Button and nothing happens? We did have a power outage just before this happened. I cannot find a fuse. Any suggestions?


Hello, ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

The lights are on on the quiet power 3, but nothing happens. it is not attempting to come on. I times numbers count down, nothing happens.


Unfortunatley your main control board has failed & need's to be replaced. ... GE Dishwashers

Hi, our LG Dishwasher LD 14AW2 is not turning on. Worked fine yesterday. This morning when went to turn it on at power button, nothing happened. We tried turning off at the power point and on again, but still nothing. Please Help? Honor


Check to see if door is completely closed, check water supply lines for kinks or blockage. ... Dishwashers

I have a Maytag MDB5601AWB dishwasher. all the switches except the heated dry switch are not working. I did the unlock thing and still nothing . Do I need to replace the switch panel or is there something I should try? I tested for power and have 120 volts coming into the circut board and through the door switch Comments: Aug 22, 2009 - I tested the door swich and I have power on both poles when it is closed. there is 2 switches on the latch but the one with power to it powers up the circ


... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

The motor continues to run with the diswasher powered off. In addition it will no longer enter wash mode. It can be powered on and wash mode can be selected, but nothing happens except the motor continues to run. Cycling the power feed off and back on does not solve the problem.


Hello John,\015\012\015\012The simple answer (without looking at the wiring diagram) is the float switch. The simple answer (after looking at the wiring diagram) is the float switch. I've posted the wiring diagram for this washer to Flick ... LG 24 in. LDS 5811 Built-in Dishwasher

LDS5811WW - machine will not power on??? When we push the power button, the machine won't turn on - we get nothing. Almost like it's unplugged - it's not, AND Yes there is power to the outlet. Front door leaks occasionally too.


Some newer d/w have a lockout feature to prevent littles from turning it on, often the kiddos accidentally activate the lockout during their explorations. Any chance it's locked?\015\012\015\012Also, I believe this type of unit has an adj ... LG 24 in. LDS 5811 Built-in Dishwasher

I have a Frigidaire FDB956rbc0 model. When the start/cancel button is pushed nothing happens. There is power and other buttons cause lights above what is pressed come on. Delay wash works but when it starts the washing light flashes. I have run a test on the cycles by pushing start/cancel and power dry button during power failure mode. all cycle run properly. Any thoughts?


... Frigidaire Dishwashers

I have a candy futura cdf322-80 dishwasher,done a load as normal then i put it on the next day and there was nothing no lights came on nothing, i checked the fuses and the socket they were fine,so i had an engineer out who said there was power going to the machine so he said it was the contol panel which is situated behind the temperature and programme buttons so i bought this part and replaced it but still there is nothing.


I would check for myself if there was power going to the machine. If it acts the ways your does, then either the control panel or the power supply is at fault. Slight possibility a wire that runs between the two may be faulty, but not as common ... Dishwashers

Dishwasher model# FGHD2433KBI. washer was purchesed mid July, used 4 times. I just put in some dirty dish's and closed the door. A couple minutes later the washer turned on. No lights were on. After a few minutes I pushed the cancel button. Nothing happened. I opened the door and it sounded like a sucking sound and the pump stopped. No water in unit. I closed the door it started again. I cut the power at the circut box. Waited a few minutes and turned power back on. Power failure light came on.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Dont have any operating instructions-it powers on-nothing happens


Try http://www.blanco-australia.com/content.aspx?PageID=95&CategoryID=162\015\012\015\012hope this is what you are ... Dishwashers

When I hit the start button on my dishwasher nothing happens. It still "finishes" the cycle but nothing ever cuts on. It doesnt fill with water and the sump pump never engages to drain the water that's not there. Any ideas? I know the inlet water pump works, I've detached it and connected it with a pigtail to an outlet.


Replace the main control board ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1158 seconds