Having problems with your KitchenAid 24 in. KUDR25SH Built-in Dishwasher ?

Start switch does nothing, yet "cancel" and other selector swithes appear to operate. Door close swith appears to be working. open and shut of power breaker does not "reset" Any suggestions? Thanks.


Answers :

Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDR25SH Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Start switch does nothing, yet "cancel" and other selector swithes appear to operate. Door close swith appears to be working. open and shut of power breaker does not "reset" Any suggestions? Thanks.


... KitchenAid 24 in. KUDR25SH Built-in Dishwasher

I have frigidaire dishwasher model # FFBD2411NS. It stopped working as if it had no power. I switched the breaker swith to shut if of then tut on. After that the lights above the "high temp wash" and "heat dry" buttons started blinking. What is going on?


Hello Marcus, since you have already reset the dishwasher, confirm\012that the door is properly latched and try selecting a cycle. If resetting the power did not correct the issue, it\012could potentially mean a number of things: a potential wiring f ... Frigidaire FFBD2411NS

Bosch APEXX model number SHY99A05UC/14 lost power. Power input line appears to have arced (white power line and wire nut show signs of stress). The power breaker did not throw at the junction box. Already cut back wire and re-attached new wire nut along with replacing the breaker at the junction box. Still no power. There are no other visible signs of power stress or water damage underneath the unit or inside the doo panel.


I do not have access to the user or service manual for this model.\015\012However, such symptoms could be result of heater element or thermal overload fuse blowing. Do you remember having a very hot dishwasher when the it lost power.\015 ... Bosch Dishwashers

My kenmore dishwasher model 665.16364300 has no power. The breaker did not shut off. The water heater breaker did shut off. What should i look for.


... Kenmore 24 in. 16362 / 16364 / 16369 Built-in Dishwasher

I have a Bosch SHU5315 dishwasher that doesn't turn on. I checked power getting to the machine, reset power at circuit breaker box and door lock appears to be working. Is this the power supply or computer brain motherboard?


Be sure lock at door is not loose switch at door if not closed wont come on ck door close switch ... Bosch 24 in. SHU5305UC Built-in Dishwasher

I have a Beaumark Wisperwash IV Model #405010, it was running when we had a recent power outage, once the power came back on, it continued to run. Next time I went to turn it on, it appears that there is no power!!! Have checked the circuit breaker, it is on...any suggestions?


... Maytag Dishwasher

GE Triton XL control panel suddenly went dark. Would appear the power is off but breaker tested ok and power verfied. I unpluged the unit for about 5 minutes. When I reconnected to power, 2 short beeps were heard but no lights on the panel are on. Any other ideas?


Hi\015\012\015\012 \015\012\015\012Thanks for using FixYa. From what you have\015\012described it seems that the control board has gone bad and should be replaced\015\012however, before replacing y ... GE Tritonr XL GSD6260JCC Dishwasher

Whirlpool dishwasher model #DU1100XTPSB wont work and the clean button flashes 7 times and pauses, any idea? I shut the power off to it at the breaker to see if it would reset, didnt work


... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

I have a KitchenAid dishwasher model KUDC10IXWH1 that has no control power. I have already verified that there is 120V at the control board. The unit kept the lights on after the cleaning cycle was done and I couldn't shut them off. I reset the electrical breaker and now nothing works, but the board has power. Please give any advice you might have. I was thinking of replacing the board, but I'm not sure if it is the board or the front control panel. Any way to tell?


... KitchenAid 24-in Built-In Dishwasher White ENERGY STAR KUDC10IXWH

I'm getting a PF power interupt code. When I press the "Start/Cancel" button the code goes away. Unfortunatly the unit will not power up. It appears to be completely dead. If I cycle the breaker the PF code comes back and we start the process again. What's wrong, help!! Bob


Hi,If pressing the cancel button doesn't get rid of the power failure error\015\012 "PF" then you have a bad control board. So you will need to replace \015\012the control board itself.You could try to disconnect the power su ... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

The problem started with it not draining correctly and leaving water in the bottom - my husband took it apart and found a bolt in the drain. He removed it and now it won't start. It appears to not have power to the electrical panel- we have reset the breaker several times - left the breaker off for 10 minutes thinking it might erase the memory - I've asked for instructions to reset and I keep getting info that is very far removed from this model. I know it has a protocol because a repair


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012\015\012The reset on your dishwasher is as follows, ( I can't locate your particular model number...but its madw be whirlpool so there are only a couple of possible sequences ) however depending ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Miele Diamante G 2150 SCU Dishwasher problem ----The program cycle indicators "Rinse", "Drying" and "End" flash at the same time. The drain pump is running when the door is open. I have reset the power and cleaned the drain pump and non return valve and Spun the propeller several times in both directions to check for obstructions. Still has the same problem. Water is being drained continuously even with power switch on dishwasher turned off.. Had to shut the breaker off to get it to stop. A


Hi\015\012\015\012Plugged system or a jammed drain pump can cause these issues, also make sure the drain hose is not blocked. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remo ... Dishwashers

One day the diswasher was working fine...the next time it turned it on it ran for about 3 min. then shut off and seemed to have no power. I checked the breaker...it was fine. A few days went by and all of a sudden the lights were blinking on the panel. So I pushed the cancel drain button. The water drained out and I then proceeded to load the dishwasher and turn it on again thinking it was just a fluke when it shut off earlier in the week. It did the same thing...ran for about 3 min and then shu


... Whirlpool GU2200XTSS Built-in Dishwasher

No power unit went dead checked power to base of unit ok also shut off breaker for 10 minutes to see if it will reset, no luck. Also removed inner door panel to reveal circut board to look for a reset or small fuse, none evident.


... General Electric GLD5960NSS Stainless Steel Built-in Dishwasher

Kenmore dishwasher My dishwasher stopped in the rinse cycle and no longer appears to be getting power, although the breaker works and the plug it is connected to is still receiving power. Is there a reset button for the motor, or some other idea to try and fix this? Thank you for your assistance. Mark


Mark, you probabley blew the thermal fuse located on the main board. Easy fix. Part number 8269213. You can ohm it out to be sure. You have to remove the inner panel to get at the control board. The fuse sits on the top side and clips on. Two wires ... Kenmore 24 in. 16293 Built-in Dishwasher

Kitchen circut was accidently turned off. Now whirlpool gold disher will not work(unit was not running and the door was not closed all the way when circuit was turned off, All circuit breakers are on) There are no lights on display when door is closed completely, and it appears to have no power. Worked fine prior, what could it be? The unit has not been removed from under the counter yet. Is there a fuse or circuit breaker on the unit? If so where is it located? Other troubleshooting ideas


Hello- Turn power off. Remove kick panel and cover for power wires. Check connections. If these are ok, most likely suspect is a fuse at the control. This is a little harder to get to. Remove inside door panel screws. Unplug wires and remove panel. F ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

When exterior breaker panel was replaced, my Frigidaire dishwasher (model FDB989GFC2) was accidently wired to 2 breakers and briefly took a 200v load. It started, then immediately showed a Power Failure code and shut off. The wiring has since been corrected but the dishwasher now shows no signs of life. Is it terminal or can replcement parts solve the problem?


Hi\015\012\015\012\015\012Thanks for using FixYa. You’ll need to check the following things--\015\012\015\0121. Fuse (blown or tripped).\015\0122. Check the wire fasteners at dishwasher junction box. ... Frigidaire Dishwashers

Kenmore we have a kenmore 665.1376 that is just over a year old. last night after about 15-30 min it shut down. there is water standing in the bottom but i don't think the float shut it off. checked the power breaker and everything seems fine there.


... Kenmore 15073 Stainless Steel Built-in Dishwasher

Dishwasher has NO POWER! Circuit breaker ok. It worked the last time we used it. No other appliances or lights are out. It appears to be only the dishwasher that has no power. Weird!


Turn breaker off hard to reset it then on2-3 times ... Dishwashers

Maytag MDBH979AWS dishwasher - there appears to be no power coming in to it. The dishwasher will not turn on and there are no lights on the control panel. I checked the power in the breaker box and it works fine. Any suggestions what to do next?


Maytag MDBH979 power sensor will not turn on dishwasher. The other buttons and lights turn on when pressed but not the power button. Please help. ... Whirlpool MDBH979AWS Builtin Dishwasher

Kenmore elite mod 665/17059 diswasher. unit was runing last night sometime during this time unit shut off. now it has no power at all. checked breakers and unit has power to it. could this be control unit?


It appears your timer/main controller/CCU has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites bec ... Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher

My dishwasher shut off in the middle of a wash cycle and has no power and the breaker in the panel is on


... Maytag Dishwashers

It appears that there is no power to the unit all of a sudden. I checked the breaker. I ran the dishwasher the day before with no issues. Any ideas on what could have happened?


It sounds like you may have blown the thermal fuse. The fuse is located behind the operator console. The part number for the replacement kit is 8193762. You can view an illustration at appliancepartspros.com. It sells for about $13 and instuction ... KitchenAid 24 in. KUDS01DLSS Built-in Dishwasher

FRIGIDAIRE DISHWASHER HI! MY NAME IS MARK AND I AM HAVING PROBLEMS WITH MY FRIGIDAIRE MODEL # FDB710LCB0/SERIAL # TH51153536 DISHWAHER. THE PROBLEM: IT DOES NOT COME ON AT ALL LIKE THERE IS NO POWER TO IT. I HAVE CHECKED THE BREAKER AND THE ELECTRICAL CONNECTION AND THERE ARE NO PROBLEMS AT THOSE POINTS. ALTHOUGH FOR A BRIEF MOMENT LAST NIGHT IT DID COME ON AND THERE WAS A "HUMMING NOISE AT THE DRAIN PUMP LOCATION (IT SOUNDED REALLY BAD) THEN IT SHUT DOWN AGAIN AND NOW IT WON,T COME ON AT ALL. A


Check your door switches behind console, next i would ck the circuit board for power in/out. there a tech sheet behind front panel for further diag test points ... Dishwashers

It appears to finish it's cycle, as far as the dishes are clean - however there is clean water that has pooled on the bottom. you can hear the water fresh coming in - the pump comes on for a few minutes, drains some of the water and shuts off - the pump comes on again - drains some of the water and turns off. I turned the water going into the dishwater off - the pump ran for a few minutes - drained some of the water and then just sits there with the red power light on - there is still the same


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Bosch 23 in. SHU3302UC Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1059 seconds