Having problems with your KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher ?

Door drops to floor

\015 I have the same problem. A Kitchenaid KUDP01FLWH6 model. I think this is what they call "planned obsolescence"!\015

Answers :

Sounds like springs and cables on door hindge.
Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The door now drops hard when opening. In the past the door would drop slowly and was "not heavy" . I found a rubber piece on the floor just below the door. It looks like a rectangular washer . I am assuming the rubber piece helped slow down the drop of the door. Is this a correct assumption? Is this an easily repaired problem? Your help would be greatly appreciated


... Whirlpool GU2700XTSS / GU2700XTSY Built-in Dishwasher

My repairman replaced the soap dispenser and the next time I used the dishwasher I noticed a few drops of water on the floor under the dishwasher door. I felt under the door and the insulation was soaking wet. Did the repairman not reinstall the door correctly and what is possible causing the leak?


... Whirlpool GU1100XTLB / GU1100XTLQ / GU1100XTLT Built-in Dishwasher

KITCHENAIDE DISHWASHER KUDR25SH DOOR DROPS TO FLOOR


Go to the next web:www.repairclinic.com God bless you ... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

Door sprung? door drops to floor and rack rolls out of washer


Remove bottom cover. look for an arm at bottom corners. should be two springs attached to give tension. probably got a broken one. drawer rolls out\015\012because door opens farther than it should. ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

KitchenAid KUDI10FL dishwasher- The door spring system broke and I repaired it, but now all of the sudden the dishwasher will not start. The door may have been dropped a couple of time before the spring system was repaired, but it did not hit the floor, just a hard sudden stop. All of the cycle setting lights come on when they are pressed except for the start button. Just before the start button stopped working the dishwasher started by itself or started several hours after cycle selection had b


Hi- It is possible that the door latch is not completely engaging. If the door dropped the hinges may have bent a little thus preventing a good contact with door switch. Try pressing and holding the door shut, hard, and pressing start. If that wor ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Door drops to floor, model dwu9920aax


... Maytag Dishwashers

Soft drop door mechanism came undone The soft drop door tub wheel


It's held in place by a soft drop nut (99002192). If damaged, the tub wheel part number is (99002183), and the soft drop bolt is (99002189). ... Jenn-Air JDB6510 Built-in Dishwasher

My Jenn Air dishwasher model # JDB6510AWP FRONT DOOR DROPS DOWN. I CAN STILL HERE THE SPRING FLEXING. I ALSO FOUND A WIRE ON THE FLOOR UNDER THE UNIT


... Jenn-Air JDB6510 Built-in Dishwasher

Dishwasher tablet dispenser door opens mid cycle dropping the undissolved tablet on the floor of the machine. It remains undissolved at the end of the cycle.


... Dishwashers

Maytag dishwasher door drops to floor - Frigidaire PLD2855RFC Dishwasher


... Frigidaire PLD2855RFC Dishwasher

Door drops to floor


Sounds like springs and cables on door hindge. ... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

We have a built in diswasher MDBH969 AWQ which is less than 2 years old. Suddenly the Door to the washer drops down quickly rather than what appeard to be spring loaded and would drop slowly before.


... Whirlpool MDBH969AWS Builtin Dishwasher

Door opens beyond position parellel to floor


Hi dougisommer\015\012\015\012I'm Harvey the Master Plumber.\015\012\015\012Your question is: The door springs seem fine but when we open the door and wheel out the lower ... Maytag 24 in. MDB4100 Built-in Dishwasher

Dishwasher ''soft drop door'' mechanism came apart - door now drops


I had a similar issue as described by mc1bean. One day my Jenair dishwasher door just fell down. The right side spring was fine. The left side spring was still hooked into the door hinge but the cable was laying on the floor in 2 pieces. Over tim ... Dishwashers

Door dropped Opened door on my FDB421RFR and a loud cracking noise occurred - now the door drops quickly. I guess the spring(s) have broken - does anyone know if the spring is on the rhs looking at the front? I sure hope so, I can probably access that side without pulling the unit out! Is it good to spray these with WD-40 or do they just age anyway?


... Frigidaire 24 in. FDB421RF Built-in Dishwasher

Maytag Dishwasher Quiet Series 300 Door Leak: Model No. MDB8600AWG: The door leaks both from just beneath the touch pad at the top of the door, leaving a streak down the center face of the door (minor annoyance) as well as from the bottom left and right corners, more of a concern. I have cleaned both door gaskets and tried to reseat the inside door panel, to no avail. There appears to be a way to adjust the door travel (the door sags almost completely to the floor when opened), but I have yet to


... Dishwashers

Door leak The dishwasher is 2 and half year old and is randomly leaking for at least one year or even more. The leak originally occurred at both lower ends of the door, close to the hinges. The leak was about one liter and the door panel sound insulation soaked with water. After door panel was removed, the leak location was identified at both ends of the lower door gasket. The outside part of the U-shaped gasket was filled with water, and eventually water was spilled on the floor. The leak can g


I had the same problem. On the right side of the tank in Bosch dishwashers there is a steam port. If you place a large object in the right hand edge of the tray, a pressure build up causes the leak. Put large stuff on the left and you should be good ... Bosch 24 in. SHU5305UC Built-in Dishwasher

I have a Kenmore Model 665.15955792 dishwasher. Water is leaking out the bottom of the door. I changed the door seal and the defusers but it continued. I took off the front of the door and I see the water filling into the base of the machine. When the dishwasher starts the cleam cycle, water is pushed up into the small square holes in the bottom of the door and then splashes up over the lip of the door and out onto the floor. It has never done this before, just started recently. I have had the d


... Kenmore Dishwashers

Door mechanism door has 2 springs on each side, on the right the spring works on its own. But come to the left side and it has a long belt type piece of metal,the spring and a hook type piece that makes up how the door opens and closes.this left side has come apart and dont know how it goes together,therefore the door just drops very sharply to the dismay of my partner.plz reply to [email protected]


Wind metal strap around plastic bush and hook above hinge ... Candy 24 in. CD622 Free-standing Dishwasher

The door release bar on our KitchenAid KUDV24SE is hanging loose and so the door won't open. According to the installation booklet, the dishwasher should be attached to the floor or countertop to prevent it falling over when the door is opened, so I can't pull it away from the counter for better access. How do I open the door from the front? Thanks.


Looks like a very tight spot to be in. Your best bet is to get the toe panel off (item 8) in ... KitchenAid 34 in. KUDV24SE Built-in Dishwasher

Jdb2100aws dishwasher - door handle fasteners loose, handle ready to drop off. This is a dissambly question: The middle section of the door has an upper one-third (which contains the input switch strip) and a lower two-thirds; the upper section must be removed to tighten the door handle fasteners. After wiring is disconnected (yes, power is OFF), the upper section appears to be held to the shell by some kind of barbed fastened from the inside, run through a tab on the door shell and into a fema


After removing the stainless cover l tried to disassemble the door further but found it difficult, there is a hard thick plastic cover, i took my dremel and cut a small hole large enough for a wrench to fit and tighten the thin nut on the handle, lin ... Jenn-Air 24 in. JDB2100AWS Built-in Dishwasher

I need the diagram for the door pulley system so I can make sure I am hooking it up right. The original door chord/pulley assembly broke. I ordered new parts, Now I want to make sure I am putting it back together the right way. The edge of the screw- on floor panel is pushing the plastic hook off of the door hook when you shut the dishwasher door.


... KitchenAid Dishwashers

Our KitchenAid KUDS011JBS1 dishwasher sometimes leaks water on our kitchen floor. It seems to drip from the bottom edge of the door onto the floor. It's not a huge amount of water, but is enough to be a concern... it leaves a small puddle on the floor. What should I check and how do I fix this? I'm hoping it's an inexpensive and easy fix. Note that we've had this dishwasher for 8 years and have only noticed leaking during the past 6 months.


... Dishwashers

Kitchenaid model kudso3ctblo, Type 577-0 Ser. FU3202943 When the dishwasher is finished, the soap tablet is still inside the dispenser & the door is still closed. We can open the door by hand & see that the soap has not dissolved. We found a tiny spring on the floor last week. Is there a metal spring in the dispenser? Could this have broken off & now keeps the door from opening?


... Dishwashers

Whirlpool ADG993 Hi -Had several issues with the door similar to those posted, coming away at the hinge, not sitting flush so wont close. New issue - the latch has given way, it sounds like it works but the catch is not holding, the door then falls to the floor. Any suggestions for making the latch hold the door closed? - thanks..


Dear friend,\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012ngfam at you service!\015\012\015\012If its new your warranty is for 12 months!If the dishwasher is 10 years or older its not worth inve ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0778 seconds