Having problems with your KitchenAid 24 in. KUDS02SRSS Stainless Steel Built-in Dishwasher ?

Time takes longer than it shows - 90 minutes takes 3 hours!

\015 Time remaining seems not to decrement properly. For example, display stays at 82 minutes for over 30 minutes. Does not seem to count time properly. I don't remember it doing this when first using it.\015

Answers :

It is possibly the fault with the element not working and therefore awaiting the stats to cut in does the water heat up? if not its either a faulty element or the heater relay on the control board.
Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDS02SRSS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Time takes longer than it shows - 90 minutes takes 3 hours!


It is possibly the fault with the element not working and therefore awaiting the stats to cut in does the water heat up? if not its either a faulty element or the heater relay on the control board. ... KitchenAid 24 in. KUDS02SRSS Stainless Steel Built-in Dishwasher

I have a couple of problems. Firstly, the auto programme now shows a cycle time of 199mins but actually takes much longer than that to complete - more like 4 hours. On the quick (!) wash cycle the time is 97 minutes, whereas it should be less than 30 mins. Second problem, the detergent box flap won't stay shut when loading, so I have to put the tablet in loose in the bottom. Could the 2 problems be related?


There is an issue with the machine not heating properly, it could be the control panel or the thermostat, The flap not staying shut is not connected to this. ... Dishwashers

When dishwasher is set to begin, sensor takes very long period of time. Cycles are longer than minutes indicated. Dishwasher fills with water but does not wash. Water then drains as though cycle is complete and moves to next cycle. Then the process continues. When cycle for drying is reached, much heat is given and occasionally it smells as though there is burning. A 82 minute procedure turns into hours.


... Kenmore 24 in. 16532 - Multiple Color Built-in Dishwasher

Washer went dead. replaced thermal fuse and it worked for about a week and went dead again. Before going dead it seemed to take it a long time to do a load of dishes. The last load ran 1 1/2 hours and still showed 45 minutes to go on the timer before it quit completely. Any ideas?


Sounds like you have a bad control board on unit.and the reason the thermal fuse went out is one of the relays are getting stuck on unit. before long the fuse will go bad again when the resistance level gets to high again. i would replace the control ... KitchenAid 24 in. KUDP01DL Built-in Dishwasher

Bosch dishwasher Dishwasher runs much longer than timer, stays at 88 minutes for an hour! When I open it and then close again, timer will say 90 minutes! It will run for hours till cycle is completed! Most of the time dishes are still wet.


Hello guest. seems you have a leak in the base. Looks as though motor is washing dishes but actually its the drain pump thats been activated which doesnt allow the timer to proceed forward. ... Bosch 24 in. SHU53 Built-in Dishwasher

Model IGV 659.1 Dishwasher When switched on the 'time display' takes longer than 2 minutes to display the planned wash duration. The display works fine to set a delayed start. After cycling the start delay round to 0, or after RESET (buttons A and C pressed) the unit is then 'nudged' into displaying a time. After, at last, a time is displayed the unit works fine.


... Kuppersbusch Dishwashers

Hi - I have a Neff S5456X2GB/13 and it has decided to wash cold and doesn't dry. When washing in auto mode it seems to take forever but does eventually stop, and I've noticed that when opened the time to go indicator can vary quite a lot (sometime goes backwards in that if you wait ten minutes and look again, it's saying it's going to take longer than it did before) I have replaced the pump in the past so I know how to dismantle the machine. What are the possible causes of this problem and ho


Ok, really you have maybe three problems, that to me seem interconnected.\015\012\015\012First, IF connected up to the Hot water source, then either that has failed or the Inlet Solenoid has.\015\012\015\012Second, the heating element has ... Neff Dishwashers

Is it possible that when I set the dishwasher to normal or automatic, the cycle takes over two hours!! I think it was 136 minutes. MUCH longer than any other dishwasher I've ever had


Hi,\012Yes, many dishwashers now will take at least two hours and some more depending on various things that ti checks as it is washing...\012With the newer detergents and cooler water temps. the cycles are getting longer...to do the same ... Thermador 24 in. DWHD94BP Built-in Dishwasher

My dishwasher BOSCH SGS4802EU/12 dont stop after 92 minutes, wich is the time of one cycle. it take more than 3 hours to finish. I think that can be resolved if y make a reset on the dishwashwer, but y dont how to make the reset. Can you help me please? Best regards. Pedro Antunes


... Bosch Dishwashers

Bosch SHE44C02UC digital display shows longer time for regular wash than power wash


Sadly enough, same problem. looks as though micro processor is defective. ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

My Bosch SHE45M built-in dishwasher is suddenly taking an extra-long time to go through its cycles. On Regular wash it will countdown from 117 minutes to 31 minutes. When it hits that time it resets to 87 minutes, then counts down to 1 minute and will not stop. I have to hit the cancel-reset buttons for it to drain. I have tried to do a hard reset by cutting the power at the breaker for 20 minutes or more. I'm interested in potential parts and a description of how to fit it! Thanks in advance.


... Bosch SHE45M06UC Built-in Dishwasher

Electronic control pad is pushed for quick wash and the LED display would show 52 minutes. Now when it pushed the display shows 17 minutes and performs all the functions that would occur at the end of a normal cycle. Can set for the longer wash cycle 94 minutes and performs all functions start to finish. Think the control board is bad any advise.


... Maytag 24 in. DWU9902 Built-in Dishwasher

Have a 665-16293201 dishwasher with electronic controls and smart sensor. Approx 10 years old in great shape. it just started having a problem - it takes a long time for the sensing to be completed at the start of a wash and then the washer will start and display a time - like 92 minutes - turn the sensing light off, then start to wash and count down. when it gets to 86 minutes, it starts to sense again and will continue washing while displaying 86 and with the sensing light on. It will keep


... Kenmore 24 in. 16293 Built-in Dishwasher

I have the dishwasher model number FGHD2433KF, I have noticed in the last few that I have used my dishwasher no matter what setting I push after a few minutes it jumps to 99+.... Example a push quickwash and start it, the time that shows on the screen is 50, it counts down to 49 then it jumps to 99+. Every setting I originally set starts out at the right time that is listed in my book but then after a few minutes it jumps to 99+. Do I need to call service. I purchased the dishwasher in May of


... Frigidaire FGHD2433K 24 in Builtin Dishwasher

Cycle time Our dishwasher used to take 73 minutes from start to finish but now it takes 111 minutes, any clues to why?


... GE 24 in. Profile PDW7300G Built-in Dishwasher

During power scrub cycle which is the one we use most of the time the dishwasher stays at one minute fot a long time. the dishes come out clean and it finally does finish cycle just dont know why it takes so long on last minute of cycle for so long


It's just heating the water more ... Bosch 24 in. SHU43 Built-in Dishwasher

It takes some time for the pressure to build up in the discharge gun and seems to take longer each time after I release the trigger and then start to spray again


... Pressure Washers

Takes more than 2 hours to complete a one hour cycle. Will sit on "1" minute left for the last 45-60 mins. If the door is opened during this long one minute the washer still has water in it and will reset to 13 mins remaining.


Hello,\015\012\015\012Welcome to fixya.\015\012 \015\012**What I`m about to share applies to Almost all Electronic control B/S/H/ dishwashers. That includes Bosch, Thermador ... Bosch SHU5315UC Dishwasher

We have a Kenmore 665,16532 ultra wash dishwasher. When it goes through a wash cycle, it takes a total of 3 hours. It sits at 62 minutes for about 30 minutes, and then at 42 minutes for about 20 minutes. What does that mean?


... Kenmore Dishwashers

I have a Bosch model SHU43C02UC/47 dishwasher that will count down the time until it reaches one minute and then goes back up to 25 minutes. Sometimes a 125 minute cycle can take 180 minutes.


... Bosch Dishwashers

Kenmore elite model 16583200 Cycle has always taken too long. LED will display time remaining. A typical cycle will display for 73 minutes and then take 3 times the amount of time to run through.


... Kenmore Dishwashers

KitchenAid KUDP01DLBS2 dishwasher. Runs for a very long time on any cycle; time does not seem to advance. (takes 2.5 hours or more for normal cycle. "sensing soak", "water heating" lights on for a long time, even though it appears that water is not being heated. Checked incoming water temp, is hot. Did not do this when new, something has changed. Typical cycle was 1 hr 10 min. before.


Sounds like the heater inside the dishwasher is not working. The machine is trying to get the water up to a preset temperature, probably in the neighborhood of 140 degrees. That is one of the things that it is sensing.After the machine fi ... Dishwashers

My dishwasher is brand new Model FDB1502RGS0. I used it for the first time today. It seemed to be cleaning for a very long time. It was up to 2 hours and I had to leave so I turned it off. How long should it take. That seems like an awfully long time. I kept waiting for the drying mode to start and it sounded like it kept filling up and emptying. Does this sound right? Please advise asap.


Most DW today take a minimum of 90 minutes. Run the hot water from the\015\012sink until it gets hot, then start the DW, this will shorted the first\015\012wash cycle. It is not uncommon for the DW to run 2hrs or more based\015\012upon the water temp ... Dishwashers

I have a Bosch 5306 from about 2001. It seems my problem is not unheard of, but the description of the diagnostic routine I've seen is lacking. My problem is this: Poor Cleaning / EXTREMELY Prolonged Cylce Time (i.e., Timer starts off at some time... then jumps UP to longer time... counts down through the cycle... stays on "1" for hours). I'm okay enough with tools and manuals to consider fixing it myself and am looking for: a) reasonable diagnosis; b) source for repair (not owner) manual; c


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012Based on your description I'd say the issue is most likely with the control...unfortunately. If you want to post back with your email address I can send you a service manual ( not owners manual ) ... Bosch Dishwashers

Bosch she44c wash cycle time keeps extending. Once averaged about 130 minutes, now starts at about 150 minutes indicated. Seems to hang up at 1 or 2 minutes before cycle end, then keep running for as much as 4 hours. Water is hot, filters are clean.


We have had the same problem, except the water was not getting hot either. After a ton of research there was an issue that kept popping up. There was a massive recall on many of the model and serial #s. According to the recall there was a fire risk f ... Bosch Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0976 seconds