Having problems with your KitchenAid 24 in. KUDS25SH Built-in Dishwasher ?

The 4-way hydro sweep spray arm is quite loose and hits the bottom and side of the dishwasher and makes a lot of noise


Answers :

Repair Help & Product Troubleshooting for KitchenAid 24 in. KUDS25SH Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The 4-way hydro sweep spray arm is quite loose and hits the bottom and side of the dishwasher and makes a lot of noise


... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

KitchenAid KUDPO1IL dishwasher has a buzzing noise during wash (and rinse?) cycles. Recently had to replace the top spinner (and connecting screw), as it had fallen off, but I think the noise was happpening before that. Today I re-clipped the flat pipe at middle back; one side had come loose. That might have helped a bit. Previously, I took out the bottom spinner and found a 1-2" string-like strip of gray nylon under that. I wanted to check a grinder, to see if something was trapped in that, but


... KitchenAid 24 in. KUDP01IL - Multiple Color Built-In Dishwasher

Our dishwasher started making a noise, when we checked we found the spinner on the bottom of the washer was very loose. Is there a bushing on the shaft that could have worn out? This dishwasher is 10 years old


... Kenmore 24 in. 16532 - Multiple Color Built-in Dishwasher

My brandt super silent dishwasher has been making a rattling noise when operating. Noticed the bottom rotating arm is loose. Is there a fitting to hold this arm firm.


... Dishwashers

I have a Whirlpool Dishwasher model number DU8400XB-1 it has leaked at the bottom left side for a while and now all the way across. I removed the inside of the door and saw that the splatter shield had come loose. I put it make in place but still have leaking. any advice


Drum maybe the problem ... Dishwashers

Kenmore 17362 dishwasher was making a bad noise and now the motor seems to be locked up. I might have already un-jammed the motor by removing the cover on the bottom (inside), and turning the knife impeller on the outside of the screen, but I can see lint type material in the hole on the other side of the impeller. Hard to explain, but it is in the hole in the center of the unit and there is a screen like the knife impeller has behind it. I could clean this lint if I could get the door off. How


... Kenmore 24 in. 17362 / 17364 / 17369 Built-in Dishwasher

My Bosch Classixx (about 10 years old) dishwasher won't fill The problem has only started since I pulled it out and cleaned! The programme sounds are as normal but no water enters the machine. I detected a small leak on the inlet pipe and tightened that. The machine drains when I add water manually though it has made a lot of gurgling noises for some time now when draining. When tipped on its side water comes out of the bottom of the machine (not entirely clear but not dirty either). When upri


... Bosch SHU9915UC Dishwasher

My Kenmore Elite dishwasher (model 665.17462300) is not spraying the water from the basin in the bottom up through the rest of the dishwasher. The basin fills with water, then just makes a humming noise and appears to splash a little of the water around the very bottom of the dishwasher. When we cancel the cycle, it does drain out the water from the basin. I cleaned all the gunk and debris out of the basin in the bottom, but it didn't make any difference.


... Dishwashers

The dishwasher is not cleanining properly. Cannot lift off the 4-way hydro sweep (with jet spray) (it seems stuck) to clean the removable filter. Kitchenaid Model KUDB220T. I have done this before - but this time cannot remove the 4 - way hydro sweep. found a half ring of metal in bottom of dishwasher - please help


I would suggest you look at diagrams 4 and 5 in the attached assembly drawings. You will have to remove bolt ... KitchenAid Dishwashers

Dishwasher is making a loud grinding noise when it's started. Doesn't matter the cycle choice; the cycle starts as normal then once started up starts making a sort of grinding noise as the water is pulsing, like something is stuck or blocking the "push" of water. I couldn't see anything stuck in the bottom - any thoughts before I call a repair person? I've never owned a dishwasher before - maybe there's a basic drain/blockage thing I should check out first? And, any recommendations for repair


... Maytag 24 in. MDBH970AW Built-in Dishwasher

I have a Maytag MDB7100AWW dishwasher that makes a lot of noise from the motor at the end of the drain cycle. When there is water in the dishwasher it doesn't make any noise and washes well. This url (http://www.applianceaid.com/maytag-dish-noise.html) describes my problem exactly but I can't remove this part. I have unscrewed the 3 screws keeping it in place but it seems to be still attached to the motor. How can I remove it?


... Maytag MDB7100AWB Dishwasher

My dishwasher is leaking on the sides of the door and then runs to the bottom, but I think it is leaking down from sides to the bottom, I can see water splashing out from the side, my gasket is not loose or hard, my Maytag is 13 years old


Try cleaning the gasket. Around the bottom they will have a lot of food and soap build. It worked for me .Good luck ... Dishwashers

Made funny noise; stopped to investigate; then wouldn't restart; followed directions below from FixYa and restarted. It finished the cycle, apparently correctly, except it left a little water in the tub. Also, continued to make a lot of noise--a loud motor hum/buzz or similar. Did not make this noise during dry cycle. Dishwasher is Kenmore Model 665; stock number 16839. Can you give continued diagnostic instructions? Appears there is a cracked washer under the lower wand assembly; th


The solution was nearly correct. The person who answered only forgot to mention that water level and pressure switch must be tested. This can cause drain pump working longer than necessary and humming, and machine underfilling, which can cause noise ... Dishwashers

Dishwasher My Maytag dishwasher makes a noise during the wash cycle. the noise stops during the drain cycle and continues again in the rinse cycle. We've checked the outlets/inlets on the bottom of the machine for blockage and there are none. The washer arms are free of any debris. The noise began about 3 days ago. Thanks for any help


I had this same problem. I think its the upper spray arm vibrating during wash cycle. To verify; prevent the upper arm from rotating by putting a long spatula through the top rack or zip tie the arm so it don't rotate. If th ... Maytag 24 in. MDBH940AWS Built-in Dishwasher

The dishwasher started making horrendous noises. I removed the bottom panel and narrowed the noise down to the motor (the noise starts and stops when the motor kicks on and off). How do I remove the motor to visually check it out? I thought I had all of the screws removed, but it feels like something is still holding it in place. thanks My model number is GSD4060N10SS (GE Dishwasher)


... General Electric GSD4060NSS Built-in Dishwasher

LG dishwasher making squealing noise. Motor was replaced under warranty but still making noise. Also soap not being rinsed out of dispenser and not drying dishes properly. Lot's of rinse agent in holder.


... LG LDS4821WW 24 in. Built-in Dishwasher

Model No: SE6 TIE 1 GB/17 Tecnik integrated dishwasher The dishwasher started to make a strange noise. I scooped the excess water out of the bottom and reset the machine but when switched on again it just pumps water into the bottom of the macine. I have removed and cleaned filters as per the manual troubleshooting section! Thanks for any assistance


... Tecnik Dishwashers

HDA3400G020WW noise I have a Hotpoint dishwasher model HDA3400G02WW it makes a lot of noise, it makes loud click/bang at every cycle change, and loud humming


Dear sir the problem you have sounds like the solenoid that opens the drain actuater can be worn out open the bottom panel run tru a cycle observe when the solenoid open it may be that there is something causing the solenoid to buzz either worn out o ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

We discovered broken glass dish in bottom of dishwasher with some pieces below the bottom pump area. Shortly after the washer is making a louder noise during operation time. The water pump is quite when filling but after fill the noise comes during the wash time. The heat element works fine. What can be done to quite the wash cycle????


Sounds like you have broken glass in the wash pump you will have to remove pump from sump and clear also check the drain pump.good luck let me know how it goes ... KitchenAid KUDK03ITBK Built-in Dishwasher

Excessive motor noise all parts in place correctly DD603 bottom dishwasher won't turn on top dishwasher just makes noise


Disassemble the pump and check the impeller. I would bet it's broken and the noise is caused by pieces rattling around. (I'm inferring that the part on top that isn't turning is the spray arm; that won't turn if there isn't any water spraying out of ... Fisher and Paykel Dishwashers

I have a kenmore quiet guard standard dishwasher. About 2 weeks ago it started leaking. today I pulled it out and found that looking straight ahead at the door on the lefthand side under the bottom is 2 small wire metal fittings that screw up into the bottom of the dishwasher. one was loose and dripping water. when i screwed it back in i noticed that it was stripped out. can it be replaced or should I scilicone around it to stop it?


... Dishwashers

If i switch on my dishwasher, all lights flash on and off red,and it's makes the beeping noise when it does when the wash is finished... no water is coming in either... please help... it does nothing and you cannot press any of the buttons to use a cycle. it is making a humming noise. i have checked the filter in the bottom of it, and have switched it off at the wall and back on again. cheers,


Un plug it remove bottom drawer. look in back left corner of cabnet on bottom, is it wet dry it out and try again ... Fisher and Paykel Dishwashers

Hydro arm hits bottom rack


Your best bet would be to get a wash arm rebuild kit from an appliance parts dealer ... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

Frigidaire PLD4375RFC Dishwasher makes a lot of noise when washig


... Frigidaire PLD4375RFC Dishwasher

My Bosch dishwasher SGS46E26GB/90 makes a knocking noise when started. the timer does not advance and the check water light comes on.There is water in the bottom (up to the bottom of the door) . If I reset the DW the water drains ok. If I mess with the buttons E3 shows on the display the 'quick' light stays on and the eco light flashes. I've checked the filter where the water hose is fastens to the rear. I've cleaned the filters at the bottom of the DW and cleaned out the pump area under them.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2714 seconds