Having problems with your KitchenAid 34 in. KUDP01FLSS Stainless Steel Built-in Dishwasher ?

MY DISHWASHER DEVELOPED NOISE

\015 THE NOISE HAS DEVELOPED AND SOUNDS LIKE IT IS COMING FROM THE LOWER END. I TOOK OFF THE LOWER 4-WAY HYDRO SWEEP AND THE NOISE WENT AWAY. IS THERE A GEARING BELOW THAT HYDROSWEEP THAT IS REPLACABLE? THE HYDROSWEEP SEEMS PREETY SLOPPY (LOOSE).\015

Answers :

Norrmally you could see if the wash arm as wear on it look around the wash arm interior if its worn out you will see if its oversized but most likly not it could be that something whent tru your pump i am a service teck that has worked for kitchenaid for years its could be something in yours pump or also your dreain impeller seal is wearing out i still have this problem today on some of are machine its a small winding noise that comes and goes it wont arm the machine you could change the drain impeller with the seal included in the kit this shoul go away my kitchenaid is 28 years old and have been doing this noises for quite sometimes its sounds like when you turn your fingers on a glass its a winding noise thanks from gilles
Hi friend/////\015\012
\015\012It could be the impeller on the motor. The impeller fits over the shaft of the motor and might have split/broken up. That funny noise is probably the shaft spinning inside the damage impeller. Fortunately the impeler is fairly inexpensive and easy to replace. I believe there are one or two parts/covers to remove that are held in by a roughly half dozen torx screws.
\015\012
\015\012it could be Motor bearing failed.  The whining/grinding noise is likely the motor bearing. When pulle dth emotor off  the bearing will completely destroyed.\015\012
\015\012thank iu...........
Repair Help & Product Troubleshooting for KitchenAid 34 in. KUDP01FLSS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

We have a GE GLD-4400N10BB dishwasher, purchased in 2008. Several months ago the dishwasher developed an intermittent growling noise during the wash and rinse cycles. And now the noise lasts during


... Dishwashers

Noisy dishwasher my Kenmore quietguard 4 has developed an exceptionally loud hum/buzzing noise seemingly coming from the door of the dishwasher, when closed, locked and put on either drain or wash cycle.If the unit is allowed to sit for 1-2 days, the drain cycle will empty the tub without the buzzing noise starting. If anything else is attempted afterwards, like a wash cycle, the noise immediatley starts at a low level, then becomes steadily louder, until the full volume is reached, and does not


I have aloud buzzing nose and humming what is the problem ... Dishwashers

DISHWASHER NOISE I HAVE A HOTPOINT DISHWASHER MODEL HDA3420Z02BB SERIAL # TT813162Y. IT IS ABOUT 10 YEARS OLD AND JUST TONIGHT DEVELOPED A CLICKING/ GRINDING NOISE AT THE BOTTOM OF THE DISHWASHER. I REMOVED THE LOWER COVERS AND IT APPEARS TO BE COMONG FROM THE MOTOR AREA OR I GUESS THAT IS THE PUMP ATTACHED TO IT. JUST WONDERED IF THERE IS A PATTERN FAILURE WITH THIS MODEL AND IF SO IS IT FAIRLY EASY REPAIRED?


A noise could be created by something getting down into the motor-pump assembly piece of glass, piece of bone, wire tie anything really. If this is the case and you can remove it before it causes further damage problem solved. At ten years old the ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

My CDA CW497 has developed problem. When i select a program say 70 degrees and press the start button and close the door the dishwasher starts in the the normal way bit after about 15 seconds the dishwasher stops making any noise and beeps once. When I open the door the green on/off light intermittently flashes. Any thoughts what the problem is please?


... Dishwashers

MY DISHWASHER DEVELOPED NOISE


Norrmally you could see if the wash arm as wear on it look around the wash arm interior if its worn out you will see if its oversized but most likly not it could be that something whent tru your pump i am a service teck that has worked for kitchenai ... KitchenAid 34 in. KUDP01FLSS Stainless Steel Built-in Dishwasher

My 1yo slimline hotpoint dishwasher LST216 has developed a fault when trying to run the 'normal wash': washing stops after a couple of mins, the lights start flashing and the alarm comes on as soon as the water is being drawn into the machine. When I open the door I can hear a whirling/grating motor noise coming from the bottom of the machine. I have cleaned all filters and have run other programmes to check overall functionality and they all work as expected most of the time. I cannot unders


... Hotpoint Dishwashers

I have a new Ariston LKF720 dishwasher. In part of its wash cycle it is very noisy - not water noise, but a grating motor-like noise. Is there anything I can do? Is there anywhere I can watch a dishwasher do a run and listen to its noise, Ariston or other brand? We bought the present one off the floor and did not expect any problem, having had other dishwashers for years, they being quiet. The poor technician already changed the motor, but it is still just as noisy. I am even considering sellin


... Ariston Technologies L63 Free-Standing Dishwasher

When I start the dishwasher, it sounds normal. A few minutes after it starts, it makes a loud, thumping noise that lasts for several minutes. After a while, it stops making noise, but about half way through the cycle, it starts making the loud, thumping noise again. It's loud, annoying, and does not get our dishes clean. We have to wash several dishes by hand AFTER we have run the dishwasher.


I have made the assumption that your d/w is a siemens machine, however if not pls repost with the make and model.\015\012There are a few possibities...check the spray arms are clear by removing any blockages in the holes, check that there ... Dishwashers

Noisy dishwasher My dishwasher is about 2 years old and about 98% of the time it makes a very loud growl/rumbling noise in the wash and rinse cycles. I have checked to make sure that it is not clogged and open the door during the cycle but can't pinpoint where the noise is coming from. Sometimes it runs with no noise but that is not usually the case. Any thoughts?


This is a known issue for GE dishwashers and may be similar for other\015\012models too.  The fix is simple.  The noise is due to\015\012vibration of the arm for the middle sprayer.  Just secure it with\015\012a tie wrap or wire and th ... Dishwashers

The dishwasher started making horrendous noises. I removed the bottom panel and narrowed the noise down to the motor (the noise starts and stops when the motor kicks on and off). How do I remove the motor to visually check it out? I thought I had all of the screws removed, but it feels like something is still holding it in place. thanks My model number is GSD4060N10SS (GE Dishwasher)


... General Electric GSD4060NSS Built-in Dishwasher

Dishwasher My Maytag dishwasher makes a noise during the wash cycle. the noise stops during the drain cycle and continues again in the rinse cycle. We've checked the outlets/inlets on the bottom of the machine for blockage and there are none. The washer arms are free of any debris. The noise began about 3 days ago. Thanks for any help


I had this same problem. I think its the upper spray arm vibrating during wash cycle. To verify; prevent the upper arm from rotating by putting a long spatula through the top rack or zip tie the arm so it don't rotate. If th ... Maytag 24 in. MDBH940AWS Built-in Dishwasher

We recently purchased a new pump for our frigidaire gld4355rf dishwasher. The old one started making grinding noises. When we moved the dishwasher it had leaked due to a failure of an interior seal. Our new pump is now making the same grinding noise but it is not constant. When my husband adjusted the pump by using his hand when he got into a certain position the noise stops. We keep the screens clean. Is there an issue with the pump in this model?


... Frigidaire GLD4355RF Dishwasher

A GE triton dishwasher causes hammer noise when stops filling. The sink faucet works fine as do all the other faucets in the house. I cleaned all of the traps in the dishwasher. Because the sink works, I don't think it is a sink valve problem. I turned off the water to the house and drained the system, the air chambers should be good. Is there some component of the dishwasher that could be causing the noise? Would cleaning the pump help? If so, how would I do that?


The cause of the hammering noise, (slamming) is due to the water inlet valve on the Dishwasher (DW) shutting off abrutly once the DW reaches the proper amount of water.\015\012\015\012If this is an older DW, you might want to replace the ... GE Dishwashers

Dishwasher makes grinding noise during wash cycle (after pre-wash). noise persists for 15-20 minutes. It seems as though the inlet valve doesn't open during this phase of the cycle. adding water to the dishwasher manually eliminates the noise and water circulates through the wash arms. I'm trying to determine if this is a controller issue or a valve/pump issue.


Water-inlet valve\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012\015\012\011\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\01 ... KitchenAid Dishwashers

Frigidaire dishwasher has buzzing noise


... Frigidaire Dishwashers

Strange noise when using the dishwasher


The sound may generate form inlet Solenoid. It may come from water pump also. Check inlet water flow also for proper pressure. ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

Loud noise coming from under year old kenmore dishwasher


The impeller get new and change it\015\012Vitally ... Kenmore 13789 / 13782 Dishwasher

I have a portable Sears dishwasher model # 66517769k600. It makes grinding noises when empying out the water, then stops. Sounds like maybe something is jaming the inpeller blades on the pump that removes the water as Water is left in dishwasher. It will restart in about 15 mins , run for 15 to 20 sec and stop again with same noises. What needs to be done to fix this issue? Approximate cost of part? Thanks in Advance, Chris


Hello &\015\012Welcome to FixYa\015\012\015\012It's a simple\015\012fix as the ... Dishwashers

My dishwasher is making a noise and will not drain. when I looked underneath, the thing that connects to the hoses was what was making the noise. It looks like some sort of motor and has copper coils in it. the water from the dishwasher flows to it and I guess it pushs the water on threw.


Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... Frigidaire 24 in. FDB1250REC Stainless Steel Built-in Dishwasher

I have a Fagor LFU-451T and is regularly seems to 'stick'. it emits a low rumbling noise but nothing seems to happen for hours. If i open the dishwasher and pour water into it, the water fills up but when i close the dishwasher the rumblind noise continues and the water drains away without problem. Are you able to le me know what is wrong? regards Barry


I have had a look at the user manual for your dishwasher.\015\012\015\012I am surprised you have not observed any of the error codes flashing. (se ... Fagor Dishwashers

I have a Maytag MDB7100AWW dishwasher that makes a lot of noise from the motor at the end of the drain cycle. When there is water in the dishwasher it doesn't make any noise and washes well. This url (http://www.applianceaid.com/maytag-dish-noise.html) describes my problem exactly but I can't remove this part. I have unscrewed the 3 screws keeping it in place but it seems to be still attached to the motor. How can I remove it?


... Maytag MDB7100AWB Dishwasher

Excessive motor noise all parts in place correctly DD603 bottom dishwasher won't turn on top dishwasher just makes noise


Disassemble the pump and check the impeller. I would bet it's broken and the noise is caused by pieces rattling around. (I'm inferring that the part on top that isn't turning is the spray arm; that won't turn if there isn't any water spraying out of ... Fisher and Paykel Dishwashers

Dishwasher is making a loud grinding noise when it's started. Doesn't matter the cycle choice; the cycle starts as normal then once started up starts making a sort of grinding noise as the water is pulsing, like something is stuck or blocking the "push" of water. I couldn't see anything stuck in the bottom - any thoughts before I call a repair person? I've never owned a dishwasher before - maybe there's a basic drain/blockage thing I should check out first? And, any recommendations for repair


... Maytag 24 in. MDBH970AW Built-in Dishwasher

I have a KitchenAid Dishwasher Model #KUDS03FTSS0 for about 1 1/2 years. Within the past week I have noticed it being noisier then before. I pulled off the bottom panel and the noise appears to becoming from the middle of the machine, an area that is covered by a semiclear plastic case. It has this noise when it is turning the spray wheel inside. Can this be the motor going bad? I installed the dishwasher and marveled at how Quiet it was. Now it's not that quiet machine in the kitchen.


The motor is going out. this is a warranted part, so call for service and just pay the labor ... KitchenAid Architect? II S SERIES KUDS03FT Stainless Steel Built-in Dishwasher

Dishwasher noise Our Ge Profile smart dispense built-in dishwasher makes loud noise twice or thrice as if a motor is running.


See the fix at the following link:http://www.fixya.com/support/t204050-ge_adorda_dishwasher Simply zip tie the water tube for the middle spray to the upper basket.......it works! ... GE Profile PDW8400J Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1693 seconds