Having problems with your KitchenAid Dishwashers ?

Roach invasion left detritus on A&E conotrol panel

\015 Called repairman, who said Part #8531234 on ribbon cable to PC board (bar code R3M309ZA on board) needed to be replaced. Dishwasher still under warranty when situation occurred in 2006 but condition not covered. Repairman said replacement would cost $500 (original cost of entire machine). I could not and still cannot afford that so have been using DW as dish drainer. Now, with old age and arthritis I need the dishwasher but don't know where to turn. I certainly cannot afford a new one!\015

Answers :

Place an add on craigslist the part takes all of 30 minutes to change. it shouldn't cost 50 dollars to have it installed
You can get the parts at \015\012www.repairclinic.com\015\012if you want.
Repair Help & Product Troubleshooting for KitchenAid Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Roach invasion left detritus on A&E conotrol panel


Place an add on craigslist the part takes all of 30 minutes to change. it shouldn't cost 50 dollars to have it installed ... KitchenAid Dishwashers

Our Amana ADB1500AWW dishwasher leaks at far left and far right edges ( at bottom points) of the inside door panel due to a design flaw. ie - In the fully open position ( door in horizontal position) the far left and far right edges (at bottom) of inside plastic door panel are stressed beyond what the plastic can withstand consequently the edges of the panel crack as far as 3 inches from edge to inside. This crack is very small and cannot be seen until the panel is removed and then full insp


... Amana 24 in. ADB1500AW Built-in Dishwasher

The Start button does not light up, yet the left side did light up for wash cycles. I'm guessing the PC Control board has some issue with touch button panel, as a faint high pitched shrill can be heard from the board after I took the door off and put my ear to the board. Also, over time the left side of the panel stopped lighting up too, so I through the circuit breaker. Can you advise which component it is. I'm guessing the faint high pitched shrill is the PC COntrol board attempting to communi


You have a faulty touch pad that will need to be replaced. Below is a \015\012link to a video you will want to download so you can see how to replace \015\012the touch pad.\015\012\015\012\015\012\015\012 ... Haier ESD400 Stainless Steel 24 in. Built-in Dishwasher

Leak from a De Dietrich Integrated Dishwasher has caused 3 red lights on the left of the Control Panel to flash and also a Blue Light on the right hand side of the Control Panel to flash. On resetting the Appliance Controls, the machine starts pumping out and then closes down, with the Control Panel lights flashing again. Help


Pull the built in unit out and tilt towards the rear right leg and the water will drain on to the floor. The Dishwasher then restarts but the anti flood sensor will reactivate after 2-3 more washes. Do not know final fix yet. ... De Dietrich Dishwashers

Pld2560lcc1 Dishwasher...Control Panel shows 65 minutes left on lower rack, works for about 1 minute, shuts down. None of the buttons work. I changed the control (major circuit) board, same problem. I wonder if it's the control "panel"? I took that off and looked at it. Seems okay, but could the problem. I've heard this model has control problems, but I'm not sure if they mean the major control board or the control panel that has the buttons.


Pulled the touch pad, go after the middle third with a very small screw driver, cleaned the flex circut with contact cleaner\015\012\015\012powered up fine seems to be working again ... Frigidaire 24 in. PLD2560LCC Energy Star® Built-in Dishwasher

Dishwasher leaking Our dishwasher all of a sudden started leaking. I've taken the front panel off the door and can see exactly where. It's not a hole or anything...it's at the front, left edge of the basin, the bottom left corner at the front. It seems that right after it fills with water, it starts to leak once water is moving around inside and washing cycle starts. It is as if big waves are being pushed to the front left corner and over the lip of the basin. I don't think the water level is to


Just an idea...if i'm understanding you correctly,could the door seal be creased there or folded over by use and age to permit this to happen? cause you said nothing is missing ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

PLD2560LCC1 Frigidaire Dishwasher...Control Panel shows 65 minutes left on lower rack, works for about 1 minute, shuts down. None of the buttons work. I changed the control (major circuit) board, same problem. I wonder if it's the control "panel"? I took that off and looked at it. Seems okay, but could the problem. I've heard this model has control problems, but I'm not sure if they mean the major control board or the control panel that has the buttons.


... Frigidaire 24 in. PLD2560LCC Energy Star® Built-in Dishwasher

Smeg e2 error (water level tripped). Filter is clean and no rubbish below filter on inside of dishwasher. I have taken the front panel off but am not sure where the float device is located - I am wondering if it is just to the left of what looks like a solenoid. There is no water in the base of the unit in the front panel so would rule out any leaks. Reset program and turned off power at socket but still not using hot water. Possible PCB issue ? Any advice appreciated. Smeg DI612C Dishwasher.


... Dishwashers

No kinks in the line. Vent at sink is clear. Will pump some water just not all of it. Pulled left side panel off and removed hoses-no blockage. Pulled drain hose off and turned plump on, seemed to have good pressure/volume. Is this a timer issue? or control panel? Model SHU4022UC/U06


Alright, so you have a Slow Filling Dishwasher. In order to keep small particles of dirt and minerals out of the pumps and nozzles of dishwashers, manufacturers install a small screen in the primary inlet water line to trap any contaminants. Over ti ... Dishwashers

Quit working during wash cycle, about 6 liters of water left in bottom, looks like it quit during rinse cycle. There is power to the door switch and door switch works shutting off power when door is opened. However the control panel does not respond to any push button. I have had a problem in the past with moisture from the door vent getting into the control panel area causing the push buttons to become eratic.


The capacitors in the control panel could be bad or have burnt out. Do check all connnections and if necessary, check the continuity of the power to and from the control panel with an ohm/voltmeter. ... Dishwashers

During the cleaning of our dishwasher (ADG7952 model), it started beeping and there was a F8 message reading on the panel. The water has not drained away. We have tried to clean the filter and remove excess water left. Unfortunately, we cannot find the user manual-not sure that it was left when we moved into the house. Not sure what the problem may be?


... Whirlpool 24 in. ADG7952 Built-in Dishwasher

Maytag MDB5601AWS Dishwasher worked fine when I moved into my new home less than 2 weeks ago. It just stopped working a few nights ago and the sellers did not leave info on the dishwasher. The only buttons that light up are the buttons on the right side of the START/CANCEL button (which does not light up at all) and the LIGHT WASH button on the left side of the panel. The DELAY WASH button blinks for a while, and then all lights on the panel go off completely. No noise at all comes from the


CLICK HERE for your owners manual.\015\012\015\012If, after reading through it, You feel you h ... Dishwashers

I have a GE Quiet Power 3 built in dishwasher. With 1 min. left in a cycle, I opened the door, removed an item, then closed the door again, but it didn't finish the cycle. The machine continued its single beeps to indicate the door was open. Reopened and closed the door. None of the buttons on the control panel respond. Have unplugged and left overnight, plugged back in, beeping continues.


... GE 24 in. GLD6500L Built-in Dishwasher

Dishwasher/diplomat-adp8342 not draining,left standing for a few months and now programe panel wan't work,if i turn it off then press the panel a few lights will go on but nothing semms to work,


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Kenmore model 665, cleaned around control panel with a brush and now only left side will flash now showing quick rinse flashing only and is locked can't change and seems as if right side of panel will not do anything


... Dishwashers

I have a Maytag MDB4800AWB and it leaks at bottom left side between the two panels, is there a seal I can replace,and if so, how do I do it? Also according to the warranty Maytag covers leaks of door


... Maytag Dishwashers

Non-starting unit The dishwasher will not start, reacting as if the door is not closed. The right side of the control panel (air dry, sani rinse, hi-temp scrub) allow selection i.e. the indicator light comes on. However, none of the cycle selection buttons on the left will engage.


... Kenmore 24 in. 16934 Built-in Dishwasher

I have a Bosch dishwasher model no. SHU66C05UC that does not drain properly. After checking for a clear drain tube and finding no problem. I removed the left side panel and found that the red float was not rising in the tube. If I pull up the trigger device to engage the pump switch the machine drains. What causes the float to stay down and what is required to free it? Thanks for any help.


Water in the base. ... Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher

Fisher Paykel control panel to far left side has a film on it that chipped off - showing a shinner stainless steal under it. I guess this is a coating of some sort. Dish draws are 4 1/2 yrs old. Mild det on them only. Only bottom draw has the cracking on it. -- can that be fixed or just has to stay ugly.


You can buys the parts that look chipped/ broken and replace them. Panel parts are very easy to replace.\015\012\015\012Check out which parts you need from the parts manual and order from the local fisher and paykel distributor.\015 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Can I purchase a left side panel for the LG LDS4821st dishwasher? If so what is the cost, how soon could it be shipped and what is the shipping cost? Thank you, Gail


I'm not sure what you mean by ";eft side. I know applianceart.com has custom cut stainless steel pieces and if they can't do it, they have a matching faux stainless that was on HGTV a while ago. You should call them, they can probably get you what ... LG LDS4821ST Stainless Steel 24 in. Built-in Dishwasher

Maytag Dishwasher Quiet Series 300 Door Leak: Model No. MDB8600AWG: The door leaks both from just beneath the touch pad at the top of the door, leaving a streak down the center face of the door (minor annoyance) as well as from the bottom left and right corners, more of a concern. I have cleaned both door gaskets and tried to reseat the inside door panel, to no avail. There appears to be a way to adjust the door travel (the door sags almost completely to the floor when opened), but I have yet to


... Dishwashers

Hello My Haier DWI 5212P (also known as Proline DWI 5212P) dishwasher is not working. The indicator panel has 3 nights flashing so I realise these are warnings, but do not know what they are telling me. In order from left to right the 1st, 2nd and 4th LED's are flashing. Those are the ones that I would normally press for Heavy Duty, Normal Wash and Glassware. Any advice you can offer? Thanks in advance. Cheers Davie


... Dishwashers

There is all water still left in the bottom and there are no lights on the front panel. have pushed the button but nothing happens


Open the the door look at bottom where the water is accumulating you may need to remove the dishes and the bottom trey, In the very most lower corner of the inside of the dishwasher you will find a drain it will not look lik ... Bosch Dishwashers

I have a GE monogram zbd5900 that continues to drain, won't shut off. The drain pump just runs. None of the lights on the control panel will come on, tried pressing and holding buttons to clear, nothing. Turned off and on circuit breaker (even left it off overnight) and did not change. Drain is not blocked, pulled the unit out and put water in the bottom and it pumped the water out just fine. any thoughts?


See if you can access the tech sheet, should be on the right side of the underside of the unit after you remove the toe panel, or perhaps in the console. Almost sounds like a stuck key pad but the tech sheet might shed more information on this malf ... Dishwashers

Smeg DF612S All starts well but after 40 minutes stops with a beep and will not progress to the main wash cycle. Instead all programme lights come on (located on the left), along with the first 2 phase lights (the first two of the lights on the right hand panel). This indicates error code 3 (cannot pump out water), but water is entering and draining perfectly. Please advise.


Check to make sure there r no kinks’ in the drain line or\015\012that it is not clogged it sounds like the sensor is tripping because there is\015\012too much strain on the pump just like a breaker. ... Smeg 24 in. DWI612 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0745 seconds