Having problems with your KitchenAid Dishwashers ?

Door drops hard and i have an error code 7 -

\015 Kithchen Aid Dishwasher -door drops hard and i have an error code 7 - sounded like the spring in the door snapped the other day -\015

Answers :

The door slamming open is a broken spring/springs. They are very easy to replace - remove the screws holding the dishwasher in... pull out slightly and replace with good ones on the sides.
\015\012
\015\012Can you clear the error code by shutting off power to it?
\015\012
\015\012(Mdl # helps)
Repair Help & Product Troubleshooting for KitchenAid Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Door drops hard and i have an error code 7 -


The door slamming open is a broken spring/springs. They are very easy to replace - remove the screws holding the dishwasher in... pull out slightly and replace with good ones on the sides. \015\012\015\012Can you clear the error code by s ... KitchenAid Dishwashers

The door now drops hard when opening. In the past the door would drop slowly and was "not heavy" . I found a rubber piece on the floor just below the door. It looks like a rectangular washer . I am assuming the rubber piece helped slow down the drop of the door. Is this a correct assumption? Is this an easily repaired problem? Your help would be greatly appreciated


... Whirlpool GU2700XTSS / GU2700XTSY Built-in Dishwasher

On my bosch shu66 diswasher the error code indicates a number 1, aqua sensor I think. There is a screw missing in the soap dispensor and it's been letting water into the door interior. could this be repaired by replacement of the screw and drying out the interior insulation and wiring The solution I tried didn't clear the error code on the panel. Is there a reset or do I need to replace the aqua sensor or ? The machine still won't start and displays a #1 on display. There is no water in the whi


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Error Code dishwasher is 14 years old, model number 47918 - error code has appeared in the LED panel inside the door but only shows the letter F, any ideas what the problem may be?


... Creda Dishwashers

Caple DI604 dishwasher stops almost immediately after starting. Error code is that the 3 left lights are on when I open the door. Does anyone know what the error code means?


... Dishwashers

Code F2 I just replaced the door switch on an inoperable DD-602. My top drawer was working fine, but my bottom one has been offline for a while (door switch failed and I never got around to fixing it since I had the top). Well, my top finally failed too so I replaced both switches. Looks like everything is good on the top, but my bottom is erroring with an F2 code now. Kindof makes a thumping noise as it starts the cycle -- maybe 3-5 short thumps and then a 10 second delay, repeats. Any ideas? C


F2= \015\012The motor has not\015\012been sensed rotating\015\012\003 Foreign object has jammed the rotor\015\012\003 The rotor has failed\015\012\003 The hall sensor has failed\015\012\003 The electronic controller has ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher Paykel Dishwasher Door Open error code


If it is a dish drawer type there is a clip at the rear of the drawer that holds the drawer closed. you will need to withdraw the drawer partially to look in. with the drawer open the fingers should be facing towards you. If not you will need to reac ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Leaks water from bottom of door. Error code E7 ?


I found this and it also may have to do with the door seals...how old is the unit...if door seals get old and stiff..(not soft and pliable) they sometimes leak...after usage the heat and moisture may cause them to swell and or become soft thereby sea ... Hobart 24 in. LXIH-3 Built-in Dishwasher

Cl error code (door)


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. You are right Error CL means door is open or door switch\015\012is open. However, replacing a door latch ... Frigidaire PLD4375RFC Dishwasher

I have a Fisher and Paykel DW60CDX1 dishwasher, the display originally came up eith an error code for the door, which seemed to be the problem as it restarted with some pressure on the door, then it stopped again and now there is no LCD display and no action, cycle butten lights are on but will not make a noise when pressed. We live in the bush and cannot get a easy service option. Is there a diagnostics mode I can try, although the LCD may not work?


Old question, but for anyone else, hears the answer - http://www.recalls.gov.au/content/index.phtml/itemId/1015047This model has a product recall, minehas done the same as described above, recall issued Aug 2012. ... Fisher and Paykel 23 in. DS603H W Built-in Dishwasher

I have a Hoover dishwasher model D7610 and the springs in the door seem to be broken. The door drops down hard instead of easy. Can I replace the springs myself or do I have to get a repair guy to do it?


... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

SIEMENS DISHWASHER ERROR CODE E15 WITH FLASHING TAP SYMBOL. WILL NOT SWITCH OFF WITH ON/OFF SWITCH OR BY OPENING DOOR ,FULL OF WATER. LEAKING FROM LOWER FRONT CORNERS BELOW THE DOOR.


... Siemens 24 in. SE25A266 ExtraKlasse Free-standing Dishwasher

KitchenAid KUDI10FL dishwasher- The door spring system broke and I repaired it, but now all of the sudden the dishwasher will not start. The door may have been dropped a couple of time before the spring system was repaired, but it did not hit the floor, just a hard sudden stop. All of the cycle setting lights come on when they are pressed except for the start button. Just before the start button stopped working the dishwasher started by itself or started several hours after cycle selection had b


Hi- It is possible that the door latch is not completely engaging. If the door dropped the hinges may have bent a little thus preventing a good contact with door switch. Try pressing and holding the door shut, hard, and pressing start. If that wor ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

SIEMENS DISHWASHER ERROR CODE E15 WITH FLASHING TAP SYMBOL. WILL NOT SWITCH OFF WITH ON/OFF SWITCH OR BY OPENING DOOR ,FULL OF WATER. LEAKING FROM LOWER FRONT CORNERS BELOW THE DOOR.


Order Management System \012\012You will find a manual on this link that may help you ... Siemens 24 in. SE25A266 ExtraKlasse Free-standing Dishwasher

LG 5811 Error Code


The most likely cause of this is the control panel circuit board has failed, to replace it remove all the screws that hold the door halves together take them apart and the panel is sandwiched between them, the p ... LG 24 in. LDS 5811 Built-in Dishwasher

I have a belling IDW604 it starts to fill and the program light flashes but it stops within 15 seconds or so. When I open the door it has just filled the bottom filter with water. I have no error code. Any advise please?


I have the same problem .i searched the net and cant find a solution .any help would be great ... Belling 24 in. IDW603 Built-in Dishwasher

I have an LG Dishwasher model LDF9810ST. Error code E1 keeps showing (Water Leakage Problem) NO water problems anywhere to be found. I have a hard time shutting down the machine. It has had a new MAIN BOARD, and a NEW MOTOR. This unit is not 1 year old yet. Any suggestions?


Are you draining the unit in the basement or under the kitchen sink?\015\012\015\012If you are draining the unit to the floor you will need a new drain hose with a syphon breaker. This drain hose is factory installed on all new LG dishwas ... LG LDF9810ST Built-in Dishwasher

For the Kitchenaid model#kudso1flbl2 type 5770, the door will drop like a rock, if not supported. Does this sound like it requires a spring? Is there a way to fish out or reattach the old opring? How hard is it to install a new spring? Thanks Jeremy.


Very easy, take out the two screws from the counter that hold the unit inplace and only pull it out a few inches, then you can angle it a little and get to the spring. They are on the sides at the bottom (you can miss em) if its broke go to marcone.c ... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

Dishwasher door drops hard when opened. - GE Dishwashers


Sounds like one of the doors springs is broken or has come detached from the dishwasher housing frame. If you have a plain dishwasher door, ie one that does not have a wood panel matching your cabinets, and the spring(s) are broken, new springs cost ... GE Dishwashers

Leaking dishwasher leaks intermittently. I removed the side panels and there is no sign of water in the base of machine. Door seal seams to be intact. What else can I check. Seal that needs replacing? Machine is 18 months old. seams to leak on the right side of the machine. Please advise. many thanks. My dishwasher showed the error code either OE or E1, I think it was more OE. I stuck my hand in the filter in the bottom of the machine and then it was okay but the next time it was used it leake


What sort of soap powder do you use\015\012some soap powders foam a lot in machine causing dishwasher to leak through seals\015\012also check that the machine is square that is the door is closing parallel with cabinet\015\012do no ... Dishwashers

Our Ariston LD87 dishwasher is displaying the error code AL04,also the clip on the door is broken and no longer shuts properly. what can we do to solve these two issues? Thanks


... Dishwashers

Kenmore elite dishwasher runs until it is manually shut off by opening the door? My Kenmore Elite runs continuously until I manually drain (cancel) the cycle. Then I have to rewash with no soap to simulate the rinse and again manually drain (cancel) the cycle. This was a $650 dishwasher. I am not sure how to reset the controller or even trouble shoot for an error code. Any suggestions?


It appears your timer/main controller/CCU has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites bec ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Hi, I have an aeg 60870 dishwasher showing error code 30 and the pump is going all the time, even when you open the door, any suggestions of things i could try please?


Sounds like the Anti-Flood system activated (polystireen float at base of machiene coupled to a micro switch) the purpose of this system is to put the drain pump on and stops any other function on the machiene. The anti lood system activates when any ... AEG 24 in. Favorit 60870M Free-standing Dishwasher

Heller HDW12ISS Error code E4 on time display panel...and making pumping noises whilst door open


... Dishwashers

Frigidaire PLD4375RFC Dishwasher Dishwasher. Error code PF keeps flashing. I can open and close the door, it goes off. A litle later it starts flashing again. PF, means power failure


... Frigidaire PLD4375RFC Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0654 seconds