Having problems with your KitchenAid Dishwashers ?

I have a kitchen aid dishwasher model # KUDM01TJWHO The clean light has a 7 code. Your link to diagnostic mode/reset didn't work for this model. The tech sheet isn't behind the kick plate nor door panel. Need more suggestions do you have a tech sheet for this model?


Answers :

You need to see if your getting power from the control all the way to the heating element something in the heating system is not working. some times the element burnes out and takes out the other stuff with it, so check for continuity at the element and thermostats befor replacing the control if all are bad it cost as mutch as a new washer or allmost
Repair Help & Product Troubleshooting for KitchenAid Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a kitchen aid dishwasher model # KUDM01TJWHO The clean light has a 7 code. Your link to diagnostic mode/reset didn't work for this model. The tech sheet isn't behind the kick plate nor door panel. Need more suggestions do you have a tech sheet for this model?


You need to see if your getting power from the control all the way to the heating element something in the heating system is not working. some times the element burnes out and takes out the other stuff with it, so check for continuity at the element ... KitchenAid Dishwashers

Miele G892 dishwasher stopped working. No lights at all. There is power from the outlet to the block behind the kick plate. According to manufacturer, there should be lights even with the door open so this likely isn't a door interlock problem. Any suggestions?


This seems to be a failure of the main program controller unit.It needs to be confirmed that the unit received power, if so the controller is faulty.\012Check if there is any fuse , check if there is line break to the unit. ... Miele Touchtronic G892 Built-in Dishwasher

Kitchenaid model KUDIO1ILBL6 The lights for Heavy Cycle ,Normal Cycle and Cancel blinking at the sametime constantly. The tech sheet is missing and the unit is appox. 5years old.have shut power down for 5 minutes .When power turn back on only the Heavy Cycle light blinks costantly. Have Ohmed out the door switches and check adjustment OK. Checked board strips and plugs for good clean and tight connections OK. Thanks


Hi, You need to reset the unit by pushing the buttons. Push the heated wash/heated dry a few times. All the lights will light up and the dishwasher will continue its . Let ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

DISHWASHER QUIT WORKING IN ALL WASH CYCLES EXCEPT SHORT WASH CYCLE. YES I HAVE TRIED TO FIX IT. I HAVE REPLACED THE CONTROL MODULE WITH A NEW ONE. ALL WIRING LOOKS CLEAN AND IN GOOD ORDER. NO EVIDENCE OF CORROSION. NOW UNIT WILL NOT WORK AT ALL, BUT "CLEAN LITE INDICATOR' IS FLASHING IN SEQUENCES OF 7. I HAVE FOUND THE SCHEMATIC SHEET BEHIND THE KICK PLATE. AND USING IT I HAVE TRYED TO USE THE DIAGNOSTIC PROGRAM BUT CANNOT FIND ANY PROBLEMS. AFTER DIAGNOSTIC PROGRAM IS COMPLETE THE DI


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012With the symptom you`ve described ( specifically the clean lite ) this is an error of poor water circulation or a heating fault...many times manifesting in th ... Whirlpool Dishwashers

Normal wash light blinks, machine will not run. No reset key code exists on the kick plate or inside the washer door panel. I have cleaned to drain hose and hot water supply is ample. Thanks Model 16029


... Kenmore 24 in. 16029 Built-in Dishwasher

I have a custom asko dishwasher model 1585. Kick plate is broken and cannot be repaired. Where can I find kick plate kit for this model?


... Asko 24 in. 1585 Built-in Dishwasher

I have a whirlpool A class ADP 4305 electronic control dishwasher that has a blinking light(seven times) at a time. There is no tech sheet in the door. i have opened the front pannel.But no tech sheet?


... Whirlpool Dishwashers

How do the back and side panels come off? I have removed the screws from along the front around the door seal and from under the kick plate, but the top panel is somehow just clicked on keeping everyt


... Bosch 24 in. SGS56E02 Exxcel Built-in Dishwasher

I have a frigidaire dishwasher model # fdb1050 which is leaking a small amount of water from the right hand corner of the door. I assume it is caused by the door seal but I cannot tell. Do you have any suggestions


Hi,\012Yup.. it's the door seal...\012\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101 ... Frigidaire 24 in. FDB126RB Built-in Dishwasher

Hello: Our Whirlpool dishwasher (model # DU943DWKQO) door will not close all the way and the door handle appears to be jammed. Any suggestions? :>)


The door not closing is possibly linked to 2 reasons. One is the springs at the base are having too much tension possibly due to dishwasher not being level at base and leaning forward. The other possiblity is simply a fault in the door latch. ... Whirlpool Dishwasher Door Hinge Bearing Sleeve 4160355

Door cable the door cable hook and eyelet broke. how do i remove the kick plate and re-attach it.


... GE 24 in. GSD3400G Built-in Dishwasher

CMA diswasher model L-1X16 sprays water out of the bottom of the door during use. Spec sheet calls for one gasket at the top of the door which is intact and in good shape.


... Cma Dishmachines Dishwashers

After cycle completed, opened door and found water did not drain. i removed the screen at the bottom and used wetvac to **** all the water out. i was also able to hear suction from hose to sink P trap. i'm confident there is no blockage. i attempted to run again only to find out the pump was running but, no water was filling the machine. Yes! the valves are open! two different issues? one other thing; due to the no thought behind this, the name plate was stuck to the inner part of the door whi


Possible that the drain pump needs a closer look , clean and check if the pump is working. If there is voltage to the pump during the drian then the pump is faulty.\012The second issue if the inlet chocking , check the inlet filter , check the ... Bosch SHU9915UC Dishwasher

Dishwasher leak I have a General Electric Potscrubber Mobile Maid dishwasher (model GSC720?) that hasn't been used in some time, but appears to still work OK. It has a leak from the left hand vent opening in the bottom of the door when operating. The seal around the door appears intact and doesn't leak. Can you suggest a probable cause, and remedy? Thanks, Bob.


With dishwasher empty and disconnected, find the screws around the area of the "vent",you may need to open it from the bottom. There will be a hose that has either ruptured or just needs the clamp tightened with a screw driver. I think that the hose ... Dishwashers

Main wash door won't open on whirlpool model du810swkqo recently bought new home with new (?) dishwasher but it looks like the main wash door (where the soap goes) doesn't have room to open. any suggestions?


The cover is spring loaded. manually open the cover and pour some really hot water by the hinge, manually open and close few time, onec it is loose, put few drop of machine oil and work it again. ... Dishwashers

Dishwasher will not start cycle it is locked and will not unlock. door panel suggestion says press and hold energy saver dry pad x3 seconds that is not an option on this model. what can we do.... the numbers 8573025 and the other is 8573030 the numbers on the door we also have additional numbers from our user manual that is part no 8269551


... KitchenAid Dishwashers

As noted on this webpage, we, too, have an intermittent leak out of the left side of our dishwasher door. We had a repair person look at it who suggested we might had inadvertently not rinsed regular dish soap off the dishes, but this is not the case today. Any suggestions? It's kitchenaid dishwasher model KUDS10IV, purchased 1/25/10.


... KitchenAid KUDS30IV Builtin Dishwasher

The cycle does not complete - it seems to end when the detergent doors should open - but this doesn't happen. Water is running in and out ok - spotless machine - detergent door easily opens manually. Any suggestions any one? Running out of plates!!


That is about the time it should start to heat the water.if its not heating at all then this could be the problem.when you say it ends i'm wondering if it has pump out the water or stopped with water in it.If they don't heat then they generally don't ... Whirlpool GU2400XTP Built-in Dishwasher

This is a past problem posted that I am now experiencing with my Kenmore Elite Model 655.17489300 dishwasher. Looking for any suggested solutions, Rick Past Problem: I have the same problem with my 2004 Ultra Wash Model 665...fills with water, sensing light comes, then stops for a second. Then you can hear another pump kick in (it hums) and just runs continuously but no water is spraying through the arms. When you cancel the wash, it drains perfectly. I've checked the filters, all is c


The symptoms you have mentioned could be linked to the soil sensor which some models come with. The purpose is to run the drain pump and let more water flow through inlet valve if during wash cycle the dishwasher detects soil collection in the accumu ... Kenmore 24 in. 16539 Built-in Dishwasher

I have a GE dishwasher model number GLD55OOLOOWW. It was starting a start cycle and i opened the door to put more dishes in and my finger must have hit a button on the door and now two lights flash off and on and it wont reset itself. It has been on for several hours and still blinking and beeping every so often and unplugging it does not help. Any suggestions how to solve this problem. Thank you.


Try pressing the cancel button ... Dishwashers

Kenmore Ultra wash model 665 17779990 normal wash comes on after door closed and about a minuet starts flashing,any suggestions??


... Kenmore Dishwashers

Maytag dishwasher model #mdbh979aww3 no lights except when you push options found tech sheet put in test mode and all lights worked. removed touch strip from board and drain motor came on after 5 se


... Maytag Dishwashers

I have a Bosch Ascenta model dishwasher. The detergent door isn't opening during the wash cycle. Any suggestions?


... Bosch Dishwashers

I have a Bosch Ascenta model dishwasher. The detergent door isn't opening during the wash cycle. Any suggestions?


... Bosch Dishwashers

Dishwasher is leaking in front on the floor during the final rinse cycle. we opened the kick plate but did not find any water farther back. We also checked around the seal of the door . did not find any leakage.


Try a different detergent like cascade.. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1449 seconds