Having problems with your KitchenAid Dishwashers ?

Dishwasher Type 577-0, model KUDK03ITWHO doesn't clean

\015 Dishwasher Type 577-0, model KUDK03ITWHO Serial # FU3113825 fails to clean dishes although seemingly going through a full cycle; the upper rack looks to be untouched after the cycle; could something be clogged? Also, the detergent dispenser isn't dispensing the powder, but leaving a clump of detergent in the dispenser.\015

Answers :

Repair Help & Product Troubleshooting for KitchenAid Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher Type 577-0, model KUDK03ITWHO doesn't clean


... KitchenAid Dishwashers

For Miele Dishwasher G2470SCVI Need help with remaining water in the bottom. Model# G2470 SCV1 SF Type-HG03. Runs through the entire cycle,long,short ect..everything is clean and dishes look great but


See this causes and fix it. God bless you\012 \012 \012 \012 \012 Belt, Water Pump\012 \012 \012 \012 \012 \012 \012 \012 \012 ... Dishwashers

Our LG 6810 dishwasher has stopped cleaning. After the cycle the dishes are wet and covered in greasy clumps. We ran the test cycle and got the following: 3H/U3 11 22 33 44 55 66 04-2 32 33 0 (inlet valve) 35 36 37 38 23 (Thermistor) 3A 3A (beeped twice and showed 3A) 3A (beeped twice and showed 3A) Any advice you could give me would be appreciated. I have the service manual but have never done any type of dishwasher repair. I'd like to not have to replace this dis


1.) Take racks out of unit.2.) put both of the spray arms in the 12 o'clock position3.) Run the washer,once the washer has started wash cycle,open the door and ensure the spray arms have moved off of the 12 o'clock position. Write down re ... LG LDF6810 Built-in Dishwasher

LG model LDS5811WW/02 has never cleaned the dishes since first installation. Put clean dishes in and they will come out dirty too! Have tried all dishwasher soap types and brands and drying agents. Always scrape and rinse dishes prior to loading. Dishes loaded various ways but problem remains. Repairman says unit is working fine. Also never dries dishes completely. Often leaves soap dispenser completely or partially filled. We are on a farm and have hard water but we have a softener/iron remover


If the soap/detergent isn't completely rinsing out of dispenser, it sounds like water isn't directed the top spray-arm. possible a defective vario motor; as it directs water to the water channel that supplies water to the middle and upper spray arms. ... LG LDF8812 Stainless Steel Built-in Dishwasher

How to clean black residue out of the filter, dishes and drain hose in my Whirlpool dishwasher. Model No. DU810SWLUO, Type No. 280-0. How to prevent black residue from building up in the dishwasher.


There are could be several reasons for the black residue you mention.\015\012\015\012Not sure of the age of the dishwasher, but most common could be the quality of water used or if aluminium dishes are washed. \015\012\015\012 ... Dishwashers

We have Bosch model SHE44C02Uc. The motor seems to run for more than 10 hours, even though the indicator is on "0" minutes. Our dishes are cloudy, there is food always on the bottom, the filters have been cleaned -as much as we can get them clean of calcified dishwashing detergent.


Can you tell me how you can allow this to run for 10 hours ????? Are your sure you mean ten (10) hours?\015\012What in the world are you thinking while this is going almost half the day ? And then you say everything is still dirty.... somethi ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

I have a kenmore dishwasher model 58715199400. the clean light keeps blinking. ive seen posts that say to press heated dry, normal wash buttons repeatedly until all lights flash. my model doesnt have a normal wash button, it has a rotating knob instead. any tips?


... Kenmore 24 in. 15199 / 15194 / 15192 Built-in Dishwasher

My kleenmaid dishwasher super silent model system DW5 doesnt appear to be heating the water on any cycle so it is not washing properly and leaving the powder etc on the glasses up the top particularly and also it does not go completely to the end of the cycle by itself(any cycle).Or completing the drying cycle. I have to switch to 0 cycle to make it complete the clicking to start again. What is the gauge on the inside of the dishwasher on the left that can be adjusted from 1-5 is this a heat


Http://frigidaireservicetips.com/pdfs/486_5.pdf\015\012\015\012\015\012\015\012Service manual, generic, use this to troubleshoot and repair.\015\012\015\012 ... Dishwashers

I have a dishwasher and the lid to the soap won't release and my dishes aren't getting clean if I just pour the soap in. It's a whirpool Model #DU810SWPQ0 Type 280-0. Can I just buy a replacement part or do I need a whole new dishwasher?


Hi,\015\012\015\012Yes you should be able to purchase a new combi dispenser and not a new dishwasher. you should be able to find a local whirlpool supplier through the internet. This is provided the unit is not too old for spare parts. ... Dishwashers

Hi I have a LG LD-2052 dishwasher. It gives me an E 0 error - the water does not pump out when I open the machine after a few minutes when started to wash and message of E 0 appears? Have cleaned an


... LG Dishwashers

I have a MODEL 577-0 kudk01ILb55 KITCHENAIDE dishwasher. I am trying to remove the inner pplastic bar that goes vertically through the system from top top bottomj so that I can clean out the filter. But I do not see how to remove that bar. I have looked online for a repair manual of some type but have been unsuccessful. Can someone tell me how to remkove the bar so I can get to the filter on the bottom? I have already removed the star shaped rinse sprayer.


... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

Model 66516039402 Type 575-0 Green light flashes intermittanly on Clean Problem is I cannot get the dishwasher to start. When pressing Start it flashes red a few times and then stops


... Kenmore Dishwashers

My dishlex dishwasher is a model 560 silent range with eco save and has a printed circuit type switch arrangement it has man code of b8833ww or 88833ww the problem is that the pause start button activates but dose not latch in I suspect that the problem is with a latching relay behind the switch panel as i have had the front off and cleaned the contcts with contact cleaner! all of the buttons work including pause ! any advise would help as would a wiring diagram and or a operation or wor


Latching relay or door lock assembly need for you to check on that model number 560 silent range wont come out on dishlex's site should be a dx followed by some numbers try also to shut off the main power for 7 minutes to the unit to reset the contro ... Dishwashers

Bosch (not sure of the model but it is at least 6 or 7 years old). It is a built-in with a dial (cycle) and buttons (on/off and type of wash/rinse). The dishwasher accumulates mildew and frequently needs to be taken apart and cleaned.


Your condenser dryer has ceased functioning. try opening the machine for an hour or so after the wash cycle has fininshed ... Bosch 24 in. SHU53 Built-in Dishwasher

I have an E3 error message on m SMEG STX1 dishwasher. I've cleaned all pipes so am fairly sure that the heating element needs to be replaced. How do I access the heating element to test it? If there is a procedure for taking apart I would be very grateful indeed. Type 10031 model no 1471588673


Hi.E3 means that there is a problem with the heating system. The problem is either heating element or thermostat. The heating element in SMEG dishwashers is usually located underneath the appliance (in some model is at one side or at the ... Smeg 24 in. STX1-1 Free-standing Dishwasher

I have a Kenmore Type 575-0 Dishwasher, model number 665.16033401, Style 16033. It runs trough the cycle, once the cycle is complete the clean mode light is on but most dishes are still dirty. I had someone here to repair this about a year ago. All he did was press alternating two buttons, which I have tried, it resets and lets you start a new cycle. However, the problem remains. Last time there was only button pressing involved, no need to replace anything. So, I would hate to have to pay ag


You need an electronic control and heating element ... Dishwashers

Stupid dishwasher! have a maytag model MDB5100MWQ and it was working fine then poooof it the lights go on and it sprays water and thats it, the soap door doesnt open, the indicator lights turn on but nothing happens, then about 20 min later the rinse only light and clean light start blinking what the heck is going on with this damn theig thanks :) brittany


Can you tell me if it drains at all? it sounds to me with the model that it may be the drain pump indicating its clogged. When you open it up is it filled with water? sitting in there idle as in its not draining or siphoning out.let me kn ... Dishwashers

I have a kitchen aid dishwasher model# kudp021rbs and its about 3 years old and it doesnt seem to be cleaning the dishes very well. it also leaves a heavy white film on alot of the dishes. what can i do to fix this


Hello Kevin. Empty the dishwasher then pour in two cups of white vinegar. Run your longest and hottest cycle, pot scrubber if that is a choice. This will thoroughly clean the interior of your machine and solve your problem. J. ... KitchenAid 24 in. KUDP02IRBS Stainless Steel Built-in Dishwasher

When I try to start the dishwasher, I can get the light to show I want it do do a normal load. Then when I hit the start button, it lights up but the machine will not sstart. Then in a few minutes the lights on the control panel at the top of the door go out. What can I do to fix this? The model # is KUDS011JBS0 tHE 0'S HAVE A SLASH ACROSS THEM THE TYPE IS 577-0 SUPERBA


Hi,\015\012\015\012Your control board has gone bad... you will need to replace it.\015\012The replacement is not very hard, just make sure that you mark where all of the wires go before removing them.\015\012\015\012Here ... KitchenAid Dishwashers

Our dishwasher is type no:575-0, model:665.17369301.dishes r not getting clean properly.


This may help you.I had the same problem and fixed it by disassembling the lower spray arm and return filter, and cleaning all the junk out.\015\012Most dishwashers have 'risers' that bring the water up to the top\015\012sprayer or arm lo ... Dishwashers

I have a diplomat dishwasher (model AP8322) the water doesnt seem to be heating up, as a result the dishes are not being cleaned.... Any ideas?


Hi. i would test the element first. this will be the likely issue.First, open the door and look into the tub and locate the heating element (if it is covered, remove the lower dish rack and cover). The heating element has two terminals wh ... Dishwashers

I have a Sears Kenmore Elite Ultra dishwasher 665.1315 model. For the last 3 weeks, it keeps having the clean light blinking 6 times pause then 1 blink and pause and repeats cycle again. I have turned off the breaker...I have reset by pressing the heated dry and normal wash until all lights are flashing. It then completes some type of cycle and looks ok. When I opened the door, steam came out and all was hot inside. However, once I try any new wash cycle, it seems to wash but after 1-2 hours and


Call sears service and tell them you need service there is a service flash and will be no charge ... Kenmore 24 in. 15932 Built-in Dishwasher

Kenmore BuiltIn Dishwasher Stock 17512 Model 17512200 Type 575-0 Serail FM3309375 Probelm: Water sprays out of lower arm weakly, and not out of upper arm at all. Action taken: Unscrewed the 4 screws holding down the item underneath the lower spray arm, and then the small item under that. Found major refuse from years gone by, removed, cleaned. Reassembled, same issue. I suspect I have to get 1 more level down, to the intake for the pump? found 2 screws to remove, but was not suc


... Dishwashers

My dishlex dishwasher is a model 560 silent range with eco save and has a printed circuit type switch arrangement it has man code of b8833ww or 88833ww the problem is that the pause start button activates but dose not latch in I suspect that the problem is with a latching relay behind the switch panel as i have had the front off and cleaned the contcts with contact cleaner! all of the buttons work including pause ! any advise would help as would a wiring diagram and or a operation or workshop ma


Hi.The switch on this machine's control module is electronic. I do not think you will find a relay. In normal conditions the button is not supposed to stay latched If the button is defective you may get the same problem when ... Dishwashers

I own 2 model KUDS01FLSS1 KitchenAid Superba Dishwashers. The first unit had the clean light blinking so I read the post below and reset it. I thought everything was fine but half way during the cyc


... KitchenAid 24 in. KUDS01FLSS Built-In Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2276 seconds