Having problems with your KitchenAid Dishwashers ?

Have a hotpoint dishwasher full of little black

\015 Have a Kitchen Aide dishwasher full of little black pepper sized particles that won't wash away\015

Answers :

I have a Bosch SMS 4012 works fine till cycle finished. when I turn it off it trips the power safety switch at the switch board. To prevent trips happening I have to switch off at the power point and unplug .The washer is 20 years old and the problem started around 3 months ago.Is it a major problem.
\015\012
\015\012
\015\012Frank. C
Repair Help & Product Troubleshooting for KitchenAid Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Have a hotpoint dishwasher full of little black


I have a Bosch SMS 4012 works fine till cycle finished. when I turn it off it trips the power safety switch at the switch board. To prevent trips happening I have to switch off at the power point and unplug .The washer is 20 years old and the problem ... KitchenAid Dishwashers

Our Hotpoint Dishwasher Model HDA200X-73BA has two little white plastic pipe stubs poking out of the bottom of the dishwasher. During one of the cycles--(I don't think it is the drain cycle)-- some water is being released from one of these pipe stubs and then it stops and the other one runs some water. They each only run for a few seconds, but the water is just running on the floor. These little pipe stubs are about one half inch in diameter and project out of the bottom of the dishwasher about


Hello. go to the sears direct website, click on the blue link below, and enter your model number. ou can then access an excellent parts diagram which will show these stubs and what may be missing from them. Joe\015\012\015\012 ... Hotpoint Dishwashers

Hotpoint hda3440g02sa leaves a little water at the bottom of the dishwasher I have checked the check valve have even replaced I have put a high loop in the drain hose and still no help it leaves just a little water I hate to put a new pump because I have on this type of dishwasher before and still no help


Hi\015\012\015\012 \015\012\015\012When the dishwasher leaves just a little water and drains\015\012maximum then I would say that it is fine & the drain pump is also working\015\012fine. These units are designed in such a way tha ... Dishwashers

I had a black out and the dishwasher was running at the time. The dishwasher emptied out all over the floor. when the power came back on the dishwasher was flashing an error code 4. I rang Whirlpool for assistance and they said it was over full but it was totally empty. We turned the dishwasher off at the wall hoping it would reset but it is still saying error code 4. Can you suggest something else we can do?


The trouble looks to be little confusing. Whenever the power failsduring mid cycle this happens. Try running the balance cycle. Since you say the water is fully drained, try adding water manually tothe wash chamber to certain ... Whirlpool Dishwashers

Hotpoint dishwasher full of water after cycle complete


If the motor is running, the diverter solenoid valve is probably not functioning. It is attached to the pump. With the power off, take the solenoid apart and remove whatever is jamming it. Toothpicks are a favorite as are any large food particle. ... Neff 24 in. S5443X2 Built-in Dishwasher

I just purchased a G.E. dishwasher with a black front panel that is glossy. My daughter used a mister clean sponge to clean it and is now full of scratches, is there anything I can use on it to get them out without having to replace the panel. I also have a G.E. frig with a different finish on it, it has a rough texture it never marks or shows finger prints best refrigerate I have ever owned, and was wondering if I could get that finish on the dishwasher door panel.


Once paint is scratched it is scratched. There are cheap and inexpensive ways to cover that panel with a glossy black, or even stainless or white, or whatever. Go to www.applianceart.com, they have a ton of options to help your dishwasher getting b ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

My dishwasher is blowing little gummy black spots on dishes and inside dishwasher during a washing cycle and i would like to know how to fix it.


... Kenmore 24 in. 16039 Built-in Dishwasher

I have two rubber pieces that fell off dishwasher door. is from door hinge and what might they be. pieces are black oval and about 1 inch long. the disherwasher door has little resistance when opening and closeing with out these rubber pieces.both black rubber pieces have split.


... Kenmore 24 in. 16039 Built-in Dishwasher

My LG Dishwasher LDF7932ST has White, Black and Green wires coming out of the unit, no problem there, however the ALL Grey Cord that was in a separate bag does not help me identify which wire is white and which wire is the black, I can only see that the green wire is in the middle of the three attached to the grey cord as I can just see a little bit of green, how am I suppose to know which ones are the other two? I tried pullilng back the grey rubberized cord to see if it was show me ... but no


Hi,\015\012\015\012There is a simple way to tell is to look at the plug end of the cord...\015\012The blades on the plug will be two different sizes...\015\012The blade that is the larger of the two will be the white wire... ... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

Samsung dishwasher not getting water hot - Samsung DMR57LFB Full Console Dishwasher - Black


... Samsung DMR57LFB Full Console Dishwasher - Black

My dishwasher is leaving little gummy black spots on dishes and on the inside of dishwasher


... Kenmore Dishwashers

My Hotpoint BC1450 slimline dishwasher stays constantly on the 'Drain' cycle. Doesn't matter if I turn it off on the unit or at the socket. It has full salt and full rinse aid. Any suggestions antone? Thanks, James


... Hotpoint 18 in. BCI45 Slim-Line Built-in Dishwasher

WHY ARE THE LIGHTS BLINKING ON MY DISHWASHER - Maytag Jetclean Plus MDB4630AWB Full Console Dishwasher with 5 Wash Cycles, 12 Place Settings, Heated Dry Option, JetClean Plus Wash System, Control Lockout and Energy Star Qualified: Black


... Maytag Jetclean Plus MDB4630AWB Full Console Dishwasher with 5 Wash Cycles, 12 Place Settings, Heated Dry Option, JetClean Plus Wash System, Control Lockout and Energy Star Qualified: Black

My dishwasher is putting little black spots on my clean dishes, hard to get off


Aluminum untensils have rubbed against the dishes,use a mild abbrassive cleaner to eliminate marks....... how do i let inlet water out of my candy dishwasher ... GE Dishwashers

I have a hotpoint vision one dishwasher and aftrete initial start it bleeps loudly and flashes the 65 number. It appears there is little water entering the machine


... Hoover 24 in. HD98E Built-in Dishwasher

Little black and brownish tar like spots on dishes and inside dishwasher.


... GE 24 in. GSD2000Z Built-in Dishwasher

Hotpoint dishwasher uses excessive salt. Full resevoir disappears used after a few washes. User guide says it should last about a month.


... Dishwashers

My dishwasher hotpoint fdl570 is full of water when i press the start button after about 10 mins all the lights on the display start flashing can you help


1)check the blockage in drain.(any block in drain hose)\015\0122)check the drain motor working.\015\0123)remove the water manually and start up.(if it works may be on the drain pump problem) ... Dishwashers

We just purchased a whirlpool dishwasher & while taking it out of the box I noticed a gray piece in the lower back with a red electrical part in the middle with a wire connected hanging down. I looked up the part number to find out it was an actuator. The little black plunger was broke. What does this actuator do & what should I do about it?


You just got it. call for service or take it back for a replacement. If that piece was damaged, what else was jarred and soon to fail. I would return it for a replacement.Eric ... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

There is black stuff appears to be mold around the bottom circle in a 14 year old maytag dishwasher. I tried to wipe of very little comes off. I was thinking of trying a bathroom mold cleaner. but figured I'll try the internet first.


Use some bleach. Will kill the old ... Dishwashers

My Bosch dishwasher is great! However, recently the interior has been covered in black grease after a full cycle. What do you think the problem is?


Increase water heater temp to 130 degrees if no children in home 125 degrees if children in home use cascade complete detergent jell ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a frigidaire dishwasher model FDBC45BAB0. It has a black door (full door, not panel). I would like to either replace entire door panel w/stainless. Or get a stainless panel just for the front. Any ideas? Thanx


Hello! Here is a website that offers a selection of stainless door covers........www.kitchensource.com/kau/frigodw.htmGuru...................saailer ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

The water that is left in the bottom of the dishwasher is dirty and leaves little black specks on the top of the dishes. What needs to be done?


Hi,Here is a tip that I wrote that will help you with your problem...Dishwasher ... GE Nautilus 24" Built-in Dishwasher

We have an Hotpoint FDW70 Dishwasher that for some time has had an A10 fault which although stops the machine some times 70% of the time it does a full cycle. However it is now tripping out the electric at the mains. It is not RCD protected, but does not blow it's own 13amp fuse or that of the fused extention lead it is pluged in to. Tends to blow after about 5 minutes. I know about the fault code A10 being 'Fill Valve Triac' but as not an engineer what is that? and what parts are needed and or


Hi the fill valve triac is the plastic vlave that the inlet hose connects to you can get them for about £10 you reset the machine after replacing it by switching it on, pressing the power button leaving it off for about a minute then switching ... Dishwashers

I bought a used kitchen aid dishwasher, installed it and it ran one full cycle. Now it will not do anything. there is a little green light that flashes on the cancel button. It is a stainless steel KUDW02FRSS1 Thank You


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2000 seconds