Having problems with your KitchenAid Dishwashers ?

I have a Kitchen aid dishwasher model # kudpo1ilbs6 the clean light is blinking 7 times then stops for a sec and does it again


Answers :

I am assuming the problem does not go away when you turn the mains power off and on.
\015\012
\015\012The problem is linked to the temperature variation in the incoming water.
\015\012
\015\012This confuses the diswasher. You have to reset it now. Try this sequence..
\015\012
\015\012Press heated dry, normal heated dry, normal quickly within 5 sec. All lights should light up.

Advance through the cycles by using the start button
\015\012
\015\012Please post a comment to confirm if this helps.
Repair Help & Product Troubleshooting for KitchenAid Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Kitchen aid dishwasher model # kudpo1ilbs6 the clean light is blinking 7 times then stops for a sec and does it again


I am assuming the problem does not go away when you turn the mains power off and on.\015\012\015\012The problem is linked to the temperature variation in the incoming water.\015\012\015\012This confuses the diswasher. You have ... KitchenAid Dishwashers

The clean light on my kitchen aid dish washer kept blinking and would not stop. after reseting it by pushing the buttons 2-3 times it cycles though and stops. then nothing works when i push the buttons. model : kudpo2crbl4


The electronic control looks for a temp. rise of 2-4 degrees. If no temp.rise control assumes a heater fault and blinks clean light 7 times. Bad heater. Water fill when completed can be no less than 1/2 inch below heater. If so, water valve probably. ... Dishwashers

The clean light blinks 4 times in a row then stops then starts on my Kitchen aid Dishwasher.


... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

I have a Kitchen Aid Dishwasher KUDROITJBLO that has the "clean" light blinking 7 times. I have cleaned the filter but that did not help. I have shut the power off but when I turned the power back on the clean light start blinking 7 times. Any suggestions?


... KitchenAid Dishwashers

Dishwasher stops at mid cycle. Starts blinking for 7 consecutive times stops and starts blinking again. A technician came and showed me how to reset by pushing different buttons and it will start again but only to stop once again. Please help. Email me at [email protected] Thank you Kitchen Aid KUDSO1FLSS6


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

My Miele G892SC has been disconnected during remodeling of our kitchen. Now our plumber has re-installed it. Yesterday, after pushing "ON" the washer ran for a minute of so, then stopped. Today, after closing the door, I can not set anything. red light "Intake/drain" is blinking, red lights Rinse aid and Salt are steady red


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. You’ll need to first reset the unit by holding the start\015\012button down for more than five sec ... Miele G892SC SS Dishwasher

Whirlpool gold, quiet partner III, My dishwasher is not cleaning very well and when it is done it flashes clean. The clean flashing light wont stop. It flashes 7 times and stops for 3 sec then starts again. I know how to reset washer using heated dry and normal buttons but when i run it again when it is finished it goes back to the clean button flashing


... Whirlpool Dishwashers

I have a Kitchen aide dishwasher Model KUDI01ILWH6 that will not turn on..there is a control lock light on and I have tried pushing the cancel button but all that happens is the control lock light flashes 3 times and the dishwasher still wont turn on....Please , how to I disengage the control lock


... KitchenAid Dishwashers

New dishwasher (Beko 2542F slimline model). Put it on for 1st time last night -when I got up this morning, the cycle which should have taken just over 2 hours hadn't finished. There's soapy water in the bottom of the machine which hasn't drained and the "wash" light is still on. Looks like the dishes are clean but hasn't moved onto the rinse/dry part. Followed instruction in manual to drain it (hold start stop button till lights flash and should drain in 45 sec) but nothing happened.


... Beko Dishwashers

My kitchen aid dish washer model KUDI01ILWH6 stopped working . the only light that comes on is the light for hi temp dcrub.please advise


... Hotpoint 24 in. DWF32P Free-standing Dishwasher

Kitchen aid dishwashers model kudi1o1ilbl6 won't function. Cancel light flashes 7 times pauses and flashes 7 times repeat for ever. killing the power did not reset. Advice?


Open door, press in rapid sequence the following keys: hi temp scrub, energy saver dry, hi temp scrub, energy saver dry. Close the door until it latches, then open it and depress the cancel key. The lght should clear. It's a beautiful thing. ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

I have a DU1100XTP83 dishwasher and does not run. The clean light flashes 7 times, stops for about a second and then blinks 7 times, etc... Before all this started to happen, and I don't know if it was related, there was an odd odor I couldn't identify in the kitchen.


... Whirlpool Dishwashers

My kitchen aid dishwasher will not start I replaced the interface control board thinking that was the obvious problem. When you go to set the dishwasher to start some of the settings don't always light up then when you push the start button the lights will flash then start but it's not flashing and won't start. I get lucky once in a while and get it to flash then start. I don't know where else to look. I don't want to start replacing parts one at a time till I get lucky. My model # is KUDIO1F


Check all cables especially the ribbon cables from the user interface to the electronic control assembly as steam from dishwashings will create small amounts of corrosion and inhibit signals to and from these 2 components,unplug each,inspect,and reco ... KitchenAid Dishwashers

Kitchen aid dishwasher stopped working -- lights blinking - no operation KitchenAid KUDIO1ILBL6


... KitchenAid Dishwashers

Kitchen Aide dishwasher clean light blinks 4 times and controls are locked


... KitchenAid Dishwashers

Kitchen aid Model#KUDSO1DLWH3, stopped working. No lights, No function. Circuit breaker ok. water in bottom of tub


CHECK FOR VOLTAGE TO UNIT, CHECK THE WALL SWITCHES, CHECK THE GFI OUTLETS FOR TRIPPED. ... Dishwashers

I have a Kitchen Aid dishwasher Model KUD1021RWH1 that is malfunctioning. The display has the Heavy Duty, Normal and Cancel lights all flashing on and off at the same time. This problem has been intermitent. The happens after we fill the washer and want it to start. I push the Normal button and the heavy duty button flashes with the normal button and the dishwasher wont start. So, I push the cancel button and it flashes also.The washer has been cycling fine since we bought it a few years ago unt


... KitchenAid 24 in. KUDI02IR Built-in Dishwasher

I HAVE A KITCHEN AID DISHWASHER MODEL KUDP02FRSS THAT THE CLEAN LIGHT IS FLASHING 7 TIMES AND IT WILL NOT RUN. HOW CAN I FIX THIS PROBLEM?


... Dishwashers

I have 2 identical Kitchen-aid dishwashers model KUDC25ss1. They both stop early in the wash cycle, with lights flashing on control panel. I shut them off, and after a while they will go through cycle completley


Maybe a power surge. have it be the power coming into machines. let me know if this helps ... KitchenAid 24 in. KUDC25 Built-in Dishwasher

My kitchen aid dishwasher was running on the normal clcle then all of a sudden it stopped. No lights operate on the touch panel.


Most likely cause, is a blown fuse on the control panle, with a torx 15 screwwdriver you can remove the control lpanel accessing hte control board, on it youll find a small white rectangular fuse with 2 wires attached to it, it more than likely has b ... Dishwashers

Kitchen aid dishwasher model#KUDSO1FLSSO CLEAN LIGHT BLINKS7 TIMES- I DID THE RESET SANIRINSE-ENERGY SAVER-DRY ETC... CLOSED DOOR NOTHING. WE DID HAVE TO REPLACE THE ELECTRONIC CONTROL ASSEMBLY (PART# 8564542 ) BY THE " CONZ"AREA IT WAS BURNED AT THE TOP BY THE "T" AREA. NOT SURE IF THAT HELPS MY HUSBAND IS OUT WITH FRIENDS TONIGHT HE GAVE UP WE HAVE UNPLUNGED THE UNIT AND MY HUSBAND SAID HE EVEN DID OUR BREAKER- HE CAN FIX ANYTHING BUT THIS IS REALLY STARTING TO p... HIM OFF AND WANTS


... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

My kitchen aid dishwasher (8573025) "normal", "light china", "and "cancel" buttons are blinking. I can't get them to stop blinking and cannot get the dishwasher to start .


... KitchenAid Dishwashers

On KUDS01IL Kitchen-aid dishwasher, 'Normal' and'Rinse only' lights flashing, and 2 horizontal bars on time display, won't reset and won't run. Please help.


... KitchenAid 24 in. KUDS01ILWH Built-in Dishwasher

I Have a Kitchen Aid DW Model KUDS02FRSS2 and it stop during a cycle, Now nothing works, No lights, no water, completely dead. I'm pretty sure it's the Thermal Fuse but what would cause that t


... Dishwashers

Kitchen Aid KUDS01 FL changed out main board, now only will drain water out then green light flashes 7 times


... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1349 seconds