Having problems with your KitchenAid Dishwashers ?

KUDS01IJBL0 Water leaking from "latch" area,


Answers :

Repair Help & Product Troubleshooting for KitchenAid Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

KUDS01IJBL0 Water leaking from "latch" area,


... KitchenAid Dishwashers

Leaks My dishwasher is only about 14 months old. Suddenly it has developed a severe leak. This leak appears to be coming from the area of the front left leg, and from the hinged area of the closed door. It has gotten alot worse now.


Duct tape...mine did the same thing, i tried hot glue, then daul compound high heat epoxy....finally i ripped the inside window off, covered it w/ tape, making sure i put the tape layered starting at the bottom so the water falls over (like roof shin ... Danby 22 in. DDW396 Free-standing Dishwasher

Removed rear toe-plate to detect leak. Leak caused by broken drain hose. Hose replaced. To do this the unit was tipped forward onto its front door to allow access to the base area. Water allowed to drain out the front base area. Unit re-assembled but now does not switch on. Water connected. Base-plate dry. No water was detected at upper-front control panel. Power is connected and reaching unit ( multi-meter test ). Tipping the unit forward seems to be the cause. Is there any fuse,


The micro switches are frequently replaced on the door handle and they don't need to ever get wet. A lot of amp draw burns those switches up while they are dry. If they were wet and power was applied then they got fried my friend. The good news is th ... Dishwashers

Karcher k3.68m leaks from the pump area. If I turn it on without holding the trigger down on the wand it will not blow pressurized water. If the motor is idle and the water is turned on then it leaks a lot from the pump area. What part should I replace?


... Karcher PSI Electric Pressure Washer

I have a hotpoint HDA2000G00WW built in dishwasher. The dishwasher does not run unless you press the plastic door under the latch area. I have adjusted the latch and that does not resolve the problem. I notice that the top three screws that hold the plastic eschucion are no longer holding as the plastic screw areas have broken on the eschucion. Do I need to replace the eschucion or can it be tightened some other way?


... Hotpoint 24 in. HDA2000Z Built-in Dishwasher

I HAVE A MIELE G646 SC DISH WASHER AND IT KEEPS LEAKING WATER INTO THE LOWER TRAY AND CUTTING OUT BECAUSE THE FLOOD SYSTEM KICKS IN.I HAVE THE MACHINE IN THE GARAGE WORKING UP ON TWO WORK MATE WITH THE UNDER TRAY OFF FOR THE FIRST FEW CYCLES THERE WAS NO LEAKING THEN WE FOUND IT LEAKING DOWN THE FILL PIPE.THE WATER IS LEAKING FROM AROUND THE AREA THE FILL PIPE FITS TO THE WATER SOFTNER BUT NOT ALL THE TIME.AN ENGINEER FROM MIELE SUGESTED IT COULD BE THE VENT INSIDE THE SIDE OF THE MACHINE BUT EV


Have you made sure the water sofener filler neck locknut is tight to the bottom of the dishwasher?i have had experience with one machine where spilled salt was not rinsed away after the softener was filled and this corroded a very small pin *** ... Miele 24 in. G646SC Plus Free-Standing Dishwasher

Hey Everyone! Ok try this one! I have been working on a KUDS25 Kitchenaid Dishwasher. It was leaking like a siv from the bottom. I replaced both top and bottom plastic bearings and also tightend all the screws at the bottom. Leak Gone, I thought. It now has small leaks down both sides. I have since been told by the owner that he took the door apart himself. I pulled out the dishwasher from the cabinet and ran it. I could see the leaks at the top on both sides of the door latch. I cou


Hello davidgalb. You can install a new gasket to seal the door again. That old seal is not flexible any more. That said, for my time and money I recommend a replacement dishwasher, this one has definitely seen better days. Joe ... Dishwashers

I have an Excell Pressure Washer Model VR 2522, it is leaking from the botttom but can find its exact location of the leak, have all the part but can't find the leak and don't know what area it's leaking from


Hi and welcome to Fixya. Your model has the A14527 Pump assy on it and they are notorious for the pistons leaking due to blow by and the 16 MM seal on the piston starts to leak near the drive shaft. \015\012In addition the O-rings #2950 that m ... Pressure Washers

I have a Bosch SMU2042UC/14 dishwasher. The door will not latch. I have replaced the door latch and handle and still have the same problem. The dishwasher still works, will a little leaking, even though the door does not latch.


Is the latch adjustable? Have you checked your seals and your hinges? One of these has to be the cause. If you do not have the expertise to troubleshoot this problem yourself I would recommend a professional servicing the machine. If you need any oth ... Bosch Dishwashers

Leaking Dishwasher seems to be leaking. Otherwise it's performing fine. I have laminate floors, and there are water seeping out along the seams of the flooring area near the dishwasher. The dishwasher is captured by the floor (dishwasher was installed first then floor was put in at 1/2" higher level), so we can't pull it out to check where the leak is coming from. Can dishwasher be repaired from the inside w/out removing it from where it is? Only way to pull it out seem to be cutting a part of


This is a huge problem for you. when you have a leak coming from the bottom of the dishwasher the machine will have to come out. but first check the door gasket to make sure the leak is not coming from there. ... Jenn-Air 24 in. JDB4950 Built-in Dishwasher

Leaking? My dishwasher is leaking from around the area of the overfill protection float.is it possible if the float is bad will it leak under the unit?


I had this problem, our kenmore dw would leak maybe 1 out of 5 runs. found that the overfill float was so full of crud and calcium that it was weighing it down, and alowing too much water in - thus leaking out the top of the shaft of the float.\0 ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

My Bosch dishwasher shx46a05uc/23 won't latch and the lights won't come on. It will go through a cycle but that is independent of the door being closed. It's also leaking, I'm assuming because it's not latching. Any ideas? Many thanks...


... Bosch 24 in. SHX46A05UC Built-In Dishwasher

I have kenmore dishwasher model no. 665.1371 I'm getting a leak just under the door area the connects to dish washer are good, there is white plastic unit the water line is hook to is dripping from that area but I can't see were it is coming from sometimes it stop on it's own for a couple of weeks and starts up again. Thank you your time


... Kenmore Dishwashers

We have a bosch dishwasher model shx43c and water is dripping on the floor from the area of the supply line, taking the supply line fitting out and re taping it and re tightening it has not helped, could the valve be leaking back this way, instead of the more common leaking into the dishwasher itself?


If the supply line is leaking it could be a 3/8 supply line maybe the rubber washer built in the line is shot try replacing the supply line.they are about 15.00 at home depot.do not over tighten the new line you could damage it.some times people cros ... Bosch SHU9925UC Built-in Dishwasher

Have a 1700 psi washer and it leaks out the bottom of washer when hose is turned on. Seems to be leaking out of pump area.


... Karcher Pressure Washers

Leaking dishwasher I have replaced the rubber grommet around the soap dispenser latch and have double checked it for leaks.It is not leaking and I suspect that was never my problem.The water is coming from the lower right hinge area.I do not qualify for the maytag recall.I have never used the rinse aid dispenser but find it peculiar that there is no rubber washer in sight.Could I have a bad door seal? Maytag Model #DWU7402AAB


Hi there, dishwasher leaking might be due to either of these causes, check these:Main tub sealNote… If the main motor of your dishwasher is mounted vertically, beneath the center bottom of the dishwasher, the foll ... Maytag 24 in. DWU7402 Built-in Dishwasher

My Kenmore under counter ultra wash dishwasher model 665.15825691 has started leaking at the lower corners of the door. The leaks seem to occur during the final rinse while the water is being heated. I have tried cleaning out the door bottom and the tub edge where the door and tub interlock. There is no gasket in this area.


Happened on my dish washer too. Remove lower rack, remove lower spray arm by removing the center plastic nut, check screws (torx) on outside edge of pump. Tighten these as necessary, mine were loose causing water to spray forward against the tub c ... Kenmore Dishwashers

My maytag DW has developed a leak that comes at the end of the cycle. not leaking from any hose or line but perhaps above the motor area. any suggestions?


... Maytag 24 in. MDB8951AWS Stainless Steel Built-in Dishwasher

Laking below sprayer large rubber piece covers area that is leaking


Sounds like your thermal relief has popped and is not reseting. These are an easy replacement. Usually availble as a "thermal relief valve" in sizes 3/8npt or 1/4"npt ..national pipe thread. Might also mean that your pump is overheating. Check and r ... Pressure Washers

Water Leak at vent area in door...


On this model the vent is open and shut by a wax motor. The vent should be closed tight during the entire wash cycle and the first 6 minutes of the drying cycle. Check the operation, make sure there is not a bunch of gunk restricting it. If you are ... Maytag 24 in. MDB4000 Built-in Dishwasher

Miele dishwasher leaking around door area


... Dishwashers

Electrical Burning smell from latch area of door


... GE 24 in. Profile PDW9280JSS Built-in Dishwasher

GE 24in GSD980X Dishwasher water leak in pump &motor area


I had the same problem. There is no way of replacing seal/joint between pump and motor. It can't be taken apart w/o destroying parts, it only comes as an assembly. Costs around 130$ for pump/motor assy, so it might not be worth it. ... GE 24 in. GSD980X Built-in Dishwasher

How do I stop my Danby counter top dishwasher from leaking when it sits with water under the filter area?


... Danby DDW497W Counter Top Dishwasher for 4 Place Setting

Troy Bult 01902 Leaking gas from air filter area


... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0483 seconds