Having problems with your KitchenAid Dishwashers ?

KUD102CRWH1 The dishwasher does not start after a cycle. I have to reset the breaker in order to get it to run. The green led light flashes twice when I press start and I also replace the thermal fuse. Any assistance would be greatly appreciated. Unit is approximately 4 years old and not sure if there are any recalls on this. Thanks


Answers :

Repair Help & Product Troubleshooting for KitchenAid Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

KUD102CRWH1 The dishwasher does not start after a cycle. I have to reset the breaker in order to get it to run. The green led light flashes twice when I press start and I also replace the thermal fuse. Any assistance would be greatly appreciated. Unit is approximately 4 years old and not sure if there are any recalls on this. Thanks


... KitchenAid Dishwashers

My GU2500XTPSO would not start. The panel wouldn't light up. My husband ordered and replaced the thermal fuse but the new fuse burned out immediately. Can you help? It will not start or light up. Should I look at another problem causing the thermal fuse to burn out?


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

I have whirlpool Dish washer model GU 120 ES (bought in 2001). When we start the dish washer cycle the unit starts for a minute, then the "start indicator" light flashes. As indicated in the instructions, we press the "start button" for five (5) seconds, at this time the washer clears the water out and stops. If you can assist this would be greatly appreciated. Thanks Jeff


I called the service tech.... ... Whirlpool Dishwashers

Unable to start dishwasher, only functioning light on the panel is the cancel/drain light. push that button the machine funtions for a minute or two and shuts off,also the light above normal wash is blinking. When the machine last functioned it would start with a very high decibel level.If its the circuit board I need an approximate replacement cost. Bob


If you go to searspartsdirect.com you can get the exact cost of the module. ... Dishwashers

Whirlpool - Quit Partner I - DU1048XTP: Start at the beginning - Dishwasher would go through most of it's wash cycle and stop and the 'Start/Resume' LED would start flashing. Would press 'Start/Resume' and wash cycle would start again and run non-stop. Would have to hit 'Cancel/Drain' to stop. Called local service tech and he said board would need to be replaced. First board he brought failed right away, second board was installed. Tech also replaced latch handle assembly because it was missing


Have you asked the technician if the water temperature is OK.\015\012\015\012Run it again and after 30 minutes cancel and see if water temperature is warm or not. If not warm enough, then likely causes are heater is faulty or if you are u ... Whirlpool Dishwashers

I'm Just Not Getting Any Pressure, There Is A Plastic Type Valve That Needs To Be Replaced And I Need The Correct Name Of The Part, Any Assistance In This Regard Would Be Greatly Appreciated.


... Kms Factory Reconditioned Power Boss 20344R 2500 PSI 23 GPM 160cc Honda GCV Gas Powered Pressure Washer With 25Foot Hose

I have an Indesit IDL500 dishwasher. It had stopped heating the water up, it looked as if it had short circuited and so i replaced it, i have power going to the element. A couple of forums state that it may be the pcb behind the timer/selector switch. Does this pcb control the program selection and heating of the element? or is there a thermostat that controls the stop and start of the heating element? Any help would be greatly appreciated


Hi\015\012\015\012The unit\015\012has two thermostats and you can test both of them for continuity before\015\012replacing, no continuity replace the thermostat. Hope\015\012this helps...please post back fo ... Indesit 24 in. IDL500 Built-In Dishwasher

Diswasher A couple of days ago my dishwasher would not start, there are lights on the front panel and it starts a washing programme but doesn't actually wash anything. I removed the filter from inside the dishwasher and it is full with water, it seems like there is a blokage somewhere. Would a blockage cause the diswasher not to start. Any help on this problem would be greatly appreciated.


Jhgf ... Whirlpool 24 in. ADP6940 Dishwasher

Dishwasher 66513752K601 keeps blowing the thermal fuse. (Bi-Metal W10258275). I have replace the Thermal fuse several times. After i replace the fuse for some reason after a few months or less it will blow it out again. I have also replace the front panel assembly after it stopped working correctly. I would like to know how to test the dishwasher to find out the root cause of the fuse issue. I don't want to be replacing the fuse every time and don't have the $$ to buy a new dishwasher. Everythin


... Dishwashers

I have model number KUD 101TJBL0. I have spent about 300.00 on repairs. It keeps blowing the thermal fuse. I have had it replaced sev. times. My repair man has given up on solving the problem. I did read on another website that you need to replace the wiring kit that comes with the fuse. Me service man never did that and when I asked him about it he said that is not the problem and would not replace it. So, before I just scrap my diswasher and but a new one I thought i would order another fuse k


Hi,This applies mainly to Kenmore Dishwashers with the model number\015\012665.15835791 but also to any Whirlpool or Kenmore dishwasher with an\015\012electronic display. There are several possible trouble makers on this\015\012dishwasher ... Dishwashers

Cloudy Dishes My dishes have just recently started turning cloudy with white fllm. This has never happened before and the dishwasher is approximately two years old. There is no issues with hard water, and have used Jet Dry, have tried cleaning it with bleach and vinegar, and have used soap and no soap. Please give me suggestions as to why this would start occurring now. I took off the inside panel and it was full of all kinds of gunk which I since cleaned out. I would like to know how to avoid t


There is a new product out that filters the water going into your dishwasher. the film or cloudy white look is caused by hard water. this filter eliminates the problem and is very affordable. you can get it at dishwasherfilter.com. i was amazed how c ... Dishwashers

Diagnostic dishwasher stops shortly after starting a cycle. I start a cycle, it runs water into unit, starts to wash. After 5 seconds it stops, 10 seconds later it starts again, repeats 2 more times, then all lights on panel go out. any help would be greatly appreciated.


... Samsung 24 in. DB5710DT Stainless Steel Built-in Dishwasher

Fdw60 dishwasher yet again my dishwasher has broken again, now it is trippin my electric in the house, the problem that was starting up was a eco light flashing i read on here what to do and that seemed to of fixed it, but since i did that it starts up and as soon as water starts to enter it trips my electric and advice would be great


Hold the start key down and it should re-set . Please Rate This ! Thanx!! ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a Maytag QuietSeries 300 dishwasher. My original problem was with the control panel lights not coming on. Another repair website recommended replacing the circuit board. We replaced the board, but it did not solve the problem & the dishwasher would not work. Replaced the control panel. Lights come on, but when the start button is pushed "21" flashes on the time display. What do I do?


HI,Just visit this link HERE and your problem will be solved.Goodluck,Please don't forget to rate the solution. ... Dishwashers

My lawn mower with a Briggs motor Wont start, has spark fuel is good , the unit is approx 5 years old, but seldom used, worked great last year, drained the fuel, and stored it for the winter.Refueled it and wont start. I can getting started if I pour a little gas down the carb, but naturally it wont run long. I'm thinking needle and seat, any help would be appreciated. Thanks


... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

Honda GC 160 Engine, I had the carb replaced about 1 year ago, now its doing the same thing. At first it wouldnt start at all, I cleaned the carb, then it started would speed up and die. I then took the carb off and cleaned the jets, now it starts with the choke in the closed position only, at high speed it sputters and dies, but will I run it at med speed it runs but will die with tiller has a load, also when you put the choke to open it always dies. I dumped all the gas, and checked the fuel


This really sounds like a carb problem, good to hear that you are taking the carb all the way off and soaking it, this is the best way to clean a carb. I don't think it would be the fuel pump, they either work or they don't. I would check the governe ... Karcher 2500 PSI Pressure Washer

I have a Bosch dishwasher, model SHU9915UC/U11. The spring mechanism on the detergent door cracked, and I bought the part to replace it. I took the front cover off of the dishwasher to determine how to replace it. Two white plastic "things", maybe spacers, fell out. I need 2 things: a) how to gain access to the spring on the detergent door so that I can replace it, and b) how to put the door spacers back on. An exploded parts view would probably help a great deal. Michael J. Orr


Hello! This is Guru...Saailer...I have your information...Due to size limitations I'll need your e-mail address in order to send it to you...Send an e-mail to me and I'll send an exploded view diagram and parts list...Guru...saailer... ... Bosch SHU9915UC Dishwasher

My Kenmore elite dishwasher 665-1646 wont start when i push the cycle buton it lights up but when i push the start it shut's down any help would be great thanks.


... Dishwashers

I have the two drawer model dish-drawer system. In the past the top seal leaked and since has been replaced with a new seal. Worked well for several years after but then the top drawer quit running. So we started to use the bottom drawer. That was fine for awhile althought it would pump waste water into the top drawer. Now neither drawer will work. The bottom drawer starts up and shuts down. I pulled the lower drawer and it is dry.


If your model has got an LCD display are you able to record what shows up on the display when the bottom drawer shuts down. If no display then are you able to note down the LEDs which are on inside the top of the drawer lid. It is likely there is no ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My Frigidaire fghd2433kf1 starting flashing PF occasionally. I would open and close the door and it would go away. It became more frequent until two days ago when the dishwasher stopped mid cycle and flashed PF. When I opened and closed the door, everything went dead and the dishwasher no longer works. It acts like it has no power coming into it. I checked the breakers and the wires connecting the power into the dishwasher. No luck. I replaced the control panel, but not the control board. It did


... Frigidaire FGHD2433KF Builtin Dishwasher

Hello, We need some assistance with our Kenmore dishwasher. Last night after I started a load, the dishwasher just stopped and then the washing and drying lights started flashing red, sanitized and green are flashing green and the 6 hour delay button is flashing red. I have pushed the start/cancel button but to no avail. My husband shut the power from it to see if it would reboot, it does not help either. It runs a little bit then quits and does not clean the dishes. Could you give us sugg


Hold the start button for 3-4 seconds and see what that does ... Dishwashers

I have a Kenmore Ultra Wash 665.17772990 and bought it second hand washed a load maybe two but worked great and now it wont start is there a sequence code I can put into it I have seen some suggestions of one but I lost power and lost it. If you have any advice it would be great. Thanks for your time. Paul


Either the door lock is not making contact or the thermofuse on the control board is bad. ... Dishwashers

The touch pad for favorite setting and start don't work. The only way we can make it run is by using delay start. Would like to fix it ourselves if someone can tell us what needs to be replaced. Thanks Sue Andrews [email protected]


Your looking at either the main control board or touchpad. I would say 80% controlboard 20% touchpad. Does the bottom light up when you touch the start button or delay button?James Memije\012Head Technician\012Accufix Applianc ... Frigidaire 24 in. GLD3450RD Built-in Dishwasher

I have a hobart lx-g model which i purchased used a month ago. At the start everything worked great...then when ever i would push the "off" button it would shut down and restart by iteself... lately i've been getting lots of error msg's (one was E4...) and now it overflows all the time, its as if it's gone banana's... what do I need to do to fix my problems (chane the cpu???)


Hi,Initially would suggest to check that the power supply requirements are satisfied. You might also need to check the breakers. Depending on the exact model number, the AC supply can be as shown below: ... Hobart Dishwashers

F&P DD603i Greetings! My mother-in-law went to use her 18-month old Fisher&Paykel DD603 bottom drawer today (Thanksgiving) but it started beeping and showed an error with the motor. From the messages here, it looks like you may have a service manual for this unit? If you do, would you be kind enough to forward it to me also? My mom-in-law would greatly appreciate it, and I could probably get an extra slice of pumpkin pie!! Thanks, Craig [email protected]


Service manuals can be found at http://www.fisherpaykelparts.net ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1291 seconds