Having problems with your KitchenAid KUDE60FXSS Builtin Dishwasher ?

Why does clean light flash 4 times - KitchenAid KUDE60FXSS Builtin Dishwasher


Answers :

Repair Help & Product Troubleshooting for KitchenAid KUDE60FXSS Builtin Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Why does clean light flash 4 times - KitchenAid KUDE60FXSS Builtin Dishwasher


... KitchenAid KUDE60FXSS Builtin Dishwasher

Clean light blinking 6 times - KitchenAid KUDE60FXSS Builtin Dishwasher


... KitchenAid KUDE60FXSS Builtin Dishwasher

We have a kitchenaid dishwasher model#kud102irbl serial#FU1705420 Clean light keeps flashing on 7 times, waits a few seconds and flashes 7 times again. How can we repair this?? Dishwasher will not leave this mode. WE can not use it at this time.


If the clean light flashes 7 times, pauses, then repeats...When\015\012the dishwasher doesn't sense a water temperature increase, it will\015\012stop working and lock the functions (clean light flashes 7 times, all\015\012buttons are non ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

I have a kitchenaid KUDP01FL dishwasher. The clean light is flashing 7 times. I am not able to reset it and the dishwasher will not run. I would like to know the proper reset sequence and if that does not fix it what to try next.


... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

My kudpo1ilbt6 kitchenaid dishwasher clean light flashes 7 times, then pauses, then repeats. Cannot break out of this mode and get dishwasher to start. Reset circuit breaker also. Is this a diagnostic code? How to put controller into diagnotic mode?


... KitchenAid Dishwashers

Clean light flashes 7 times on dishwasher Kitchenaid dishwasher


... KitchenAid KUDS50FVSS Builtin Dishwasher

Kenmore 665 17033400 Elite dishwasher clean light flashes 7 times and it wont run. i used the reset combination, all lights lit and stayed lit until i pressed reset. Then it started a wash. now the wash seems to be finished, though i am not sure and the clean light is flashing 7 times, pause, 7 times, etc.


That signals an issue with a faulty heater &/or heater drive circuit.(that info comes from their troubleshooting guide)I ran into it this weekend and discovered that the heater coil in the bottom of the washer was broken. ... Kenmore 24 in. 17032 Built-in Dishwasher

Dishwasher Fault Hi, My dishwasher is a Diplomat ADP8322 (which i think is a rebadged whirlpool unit) & has been playing up recently. When you start a cycle it is fine for a minute or so then it starts beeping, the rinse light comes on & the light next to the start button flashes 11 times, pauses then repeats. I have read online that this flashing relates to what the fault is, but i cannot find out what fault the 11 flashes relate to. The first time this happened i cleaned out all of the filters


... Dishwashers

I HAVE A WHIRLPOOL DISHWASHER AND THE LED LIGHT FOR CLEAN KEEPS FLASHING AND IF I PUSH THE CANCEL BUTTON IT PUTS IT IN TO A DRAIN CYCLE THEN THE LIGHT KEEPS FLASHING I CAN SELECT ANY CYLCE I WANT BUT WHEN I PUSH THE START BUTTON ITS LED FLASHES SEVERAL TIMES AND THEN STOPS AND THE CLEAN LED LIGHT STARTS FLASHING AGAIN


Check out it there is a water leak to the bottom housing. Usually this happens when there is a leak activated the flood sensor causing LED light turned on. Dry out the leak then leave it unplug for 24 hours so the sensor dry out by itself. Make sure ... Whirlpool Dishwashers

I have a kenmore dishwasher mo. no.665.17039401 the clean green light flashes 7 times and it keeps doing that if i try to start the dishwasher on the start button a red light flashs three times what do how do i fix it .i made shure the door was locked


... Dishwashers

Kitchenaid dishwasher The clean light was flashing 7 times, so I did read and try the solution SaniRinse-EnergySaverDry-SaniRinse-EnergySaverDry and this did get the machine to unlock and start up. Thank you! But I'm noticing that no watre is going into the machine. I can hear it drain some water. It is very hot and steamy in the machine so no heater problem, but I don;t see any of the soap on the bottom of the machine rinsing away. I'm afraid its stopping because the motor is overh


... KitchenAid 24 in. KUDP01IL Stainless Steel Free-standing Dishwasher

Clean light flashing seven times - Maytag MDB4630AWB Builtin Dishwasher


... Maytag MDB4630AWB Builtin Dishwasher

Does not start and clean light is flashing - KitchenAid KUDE60FXWH Builtin Dishwasher


... KitchenAid KUDE60FXWH Builtin Dishwasher

KUDI01ILBL6 CLEAN LIGHT IS 7 TIMES FLASHING - KitchenAid 24 in. KUDS01FLSS Built-In Dishwasher


... KitchenAid 24 in. KUDS01FLSS Built-In Dishwasher

Clean light flashes 6 times kitchenaid dishwasher


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Clean light is flashing - KitchenAid KUDS30IVBL Builtin Dishwasher


Please read your instruction manual and go the section troubleshootingpress down the overfill protection float on the floor of the dishwasher's\012 tub in the right, front corner near the door. If it cannot move up and \012down freely, the "clean ... KitchenAid KUDS30IVBL Builtin Dishwasher

Clean light flashes 7 times - KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher


\015\012\015\012Crack open door \015\012\015\012Within 3 seconds push Hi-Temp Scrub, Heat Dry, Hi-Temp Scrub, Heat Dry\015\012\015\012Close and latch door\015\012 ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Cleaning light flashing 7 times - KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher


\015\012Crack open door \015\012\015\012Within 3 seconds push Hi-Temp Scrub, Heat Dry, Hi-Temp Scrub, Heat Dry\015\012\015\012Close and latch door\015\012\015\012P ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

I have a Whirlpool dishwasher mod. number GU2400XTP6 the clean light flashes then stoppes when the start button is pushed. the light on the start button flashes three times and stoppes then the clean light starts flashing again the machine dosen't start. I've checked the micro switches in the handle release and they are working fine. will I have to replace the main computer module? If so were do I get it and how much dose it cost?Thanks


... Whirlpool Dishwashers

Hi, I have a KitchenAid Superba diswasher model #KUDSO1FLSS2 that has quit working. All the buttons seem to work and the lights light up as they should but when you hit the 'start' button the light that you selected for whichever cycle would flash once, then close the front door and dishwasher would start. The 'start' button was acting up and would have to press a few times before light would flash and then the dishwasher would work. Now everything lights up but start button does not work. Opene


Hi.Test the start button switch.The switch is tested by disconnecting power and reading Ohms, this will tell you if it does open and close the circuit.If the start button is part of the control assembly, then this kind o ... Dishwashers

Kitchenaid dishwasher beepand and clean light flashing


... Dishwashers

Hotpoint BC145 Dishwasher not cleaning starts to kick in but then just sticks on the "R" light flashing and cannot reset even after turning off. Itbeeps when pressing the select button sound weaker and shorter than they used to and the light does not move from the "R". On a couple of times I have tried it has reset and then the dishwasher starts but after about 3 minutes there is a low beep(not the usual beep when a programme finishes) and the washer stops and the light is flashing on the "R" ag


... Hotpoint 18 in. BCI45 Slim-Line Built-in Dishwasher

Hello my Kenmore built-in dishwasher (model: 17352) has a flashing light as of yesterday. The "clean" light flashes 7 times then pauses then flashes 7 times continuously. I don't have the troubleshooting manual. What does this indicate?john Racette


... Kenmore 24 in. 17352 / 17354 / 17359 Built-in Dishwasher

Whirlpool gold, quiet partner III, My dishwasher is not cleaning very well and when it is done it flashes clean. The clean flashing light wont stop. It flashes 7 times and stops for 3 sec then starts again. I know how to reset washer using heated dry and normal buttons but when i run it again when it is finished it goes back to the clean button flashing


... Whirlpool Dishwashers

Dishwasher won't start. Clean light keeps flashing. I have tried cancelling a couple of times, and it goes through a 2 minute process and goes right back to the flashing clean light and not allowing it to start. I have already tried shutting off the breaker as suggested by someone but it did not solve the problem. Any other ideas?


Hi\015\012 \015\012Thanks for using FixYa. If the clean light flashes 7 times, pauses, then repeats...When the dishwasher doesn't sense a water temperature increase, it stops working and locks t ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1917 seconds