Having problems with your KitchenAid KUDR01TJ Dishwasher ?

KitchenAid Dishwasher (KUDP01FL) - electrical problem

\015 The diswasher mentioned above has worked for several years. Yesterday, none of the lights on the selection buttons were working and it doesn't work at all. Please help!\015

Answers :

Kill the power to the unit. Pull the control panel down to access the control board located on the right hand side of the panel. There will be 2 wires coming in to a white plastic clip on fuse located on the side of the control board. It will have a plastic pliable shield over it. Pull the 2 wires and check for continuity across this fuse. If no continuity then go to parts house with model number of unit and ask for thermal fuse for your unit. Replace this fuse following the instructions included in the kit and use all the parts included in the kit.
Repair Help & Product Troubleshooting for KitchenAid KUDR01TJ Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

KitchenAid Dishwasher (KUDP01FL) - electrical problem


Kill the power to the unit. Pull the control panel down to access the control board located on the right hand side of the panel. There will be 2 wires coming in to a white plastic clip on fuse located on the side of the control board. It will have ... KitchenAid KUDR01TJ Dishwasher

My Kitchenaid dishwasher Model KUDPO1FLSS3 stopped working. The electrical works, as we checked the breaker and the little lights on the panel turn on, but the machine will not start. We're thinking there might be a problem with the connection where the door closes. We've checked out everything we can think of, but no luck. The plastic panel is worn away in places, so some of the buttons are exposed-can't imagine that matters, though. Help!


... KitchenAid Dishwashers

KitchenAid Dishwasher KUDP01FL: Called repairman to replace balance link kit. Then door extremely stiff to open & heard loud pop when one of the ropes came off the roller. Repairman came back & put rope back on & replaced door seal, then the door won't close & he claims need a new door latch. When he left, door again extremely stiff to open & heard same loud pop when one of the ropes came off the roller. Now he says he can't fix it and to call someone else. I now have three problems: (1) The doo


May have bent door hinges,, need to check all alignment of door, hinges and latches... ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

KitchenAid Dishwasher (KUDP01FL) - unable to remove two wires from thermal fuse box. Help


... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

We have an ariston LS 620A dishwasher. For the last year every few months the dishwasher seems to cause a short in our electrical box causing all the power to go out in our house. It is only when the dishwasher is on that this occurs. We turn the power back on and everything, tv computer etc starts then turn the dishwasher on and everything shorts out again. We have had an electrician in who said that there was no electrical problem and that it was the dishwasher. After 2 months or so the dishw


The problem seems to be water seepage into the electrical contact.If the heater has lost its insulation this problem could accur( element to body )Disconnect the heater and give a try without any load and soap. If itperf ... Ariston Technologies Dishwashers

I have a kitchenaid model KUDS01JBT dishwasher. The Chopper Assembly keeps pluging up causing the dishwasher not to wash properly. Can I remove the chopper Assembly and run the dishwasher without causing any further problems to the dishwasher or will it cause other problems with the pump etcetera? Thank you for your assistance. Sincerely, Pat


\015\012\015\012Check the water temperature. Should be 125 to 140 F. \015\012\015\012Check pump re-circulation., Listen, see if it sounds like it is spraying the water around with enough pressure. ... Dishwashers

Fdw60 dishwasher yet again my dishwasher has broken again, now it is trippin my electric in the house, the problem that was starting up was a eco light flashing i read on here what to do and that seemed to of fixed it, but since i did that it starts up and as soon as water starts to enter it trips my electric and advice would be great


Hold the start key down and it should re-set . Please Rate This ! Thanx!! ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Dear Sir. I own a Zanussi dishwasher ZDIS 102. i have been using it for more than 2 weeks and i see a phenomenon which i didn't find the Answer in the manual and even in the place where i bought it. i place the dishes in the dishwasher and after 5 minutes the lights on the control panel began pulsing. it does not exist any of the problems said in the manual. firstly i thought it was an electrical problem (in case the voltage is low). please can anyone tell the reason of the pulsing and what it


... Zanussi Dishwashers

Dishwasher I read your site and I bought a Kitchenaid Dishwasher two weeks ago, my 6 year old Jennair died. I paid 800.00 dollars and the Model is KUDK03FTBLO ser FU2602019. I have this same problem posted by kayzy on Feb 05,2007 We are having to hand-dry our dishes. The tops of the drinking items on the top shelf contain more water than usual, and the items on the bottom shelf are needing hand-dried as well. I have called kitchenaid and service no one will help me they keep telling me t


Get valves on both cold and hot water coming into the dishwasher, I would first turn the cold all the off and the hot midway ....now try it.\015\012ps: it might only have a hot coming in.\015\012if still problems keep turning that hot down perhaps to ... Kenmore 18 in. 14432 / 14439 Built-in Dishwasher

Bosch dishwasher SHE44CO2UC/22 no power or light, no response to the power on. We have checked fuse box and electrical supply. Is this an electrical panel problem? Is there a "fuse" to the dishwasher?


Hi sir,first thing to say is that whether it may be an short circuit between circuits,,or due to an over voltage the fuse may be burnt,,please check the control panel..back of dishwasher,,,if u checked fuse and circuit,,and think no probl ... Bosch SHU5315UC Dishwasher

Kitchenaid dishwasher model# KUDK031TWHO seems to allow water into bottom of dishwasher but will not shoot the water over the dishes in order to clean them. Not sure if there is a simple solution to this problem or is this problem only solved with the replacement of the pump/motor


You put the bottom basket in reverse. Turn it arround, and align the centre pipe to the pressure nozzel.\015\012Vitally ... Dishwashers

We have a KitchenAid dishwasher (KUDI01FLSS6) which has not been working properly for a long time. We have the dreaded green blinking light mystery. We understand that this could indicate several different problems. We have found that if we run the sink water until it is hot, then start the dishwasher, and then after ten minutes we open then shut the door, it will consistently run the full cycle perfectly. Does this give you any hint of what might be the problem component -sensor, element, the


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Kudi25ch I have an older kitchenaid dishwasher. The problem started when the dishwasher was leaving a lot of soap on the dishes. I put in a liquid rinse. Now it won't start on my chosen cycle which is "normal and enegery saver. It will start if I put it on soak and scrub. When I press the chosen cycle the rinse light blinks 3 times. I have had this problem before and had a tech tell how to reprogram it. I took off the spray arm and checked the drain screen there was nothing there


... Dishwashers

I have a Kitchenaid dishwasher. Mod # KUD102CRBS1 which is hardly 2 years old. The door keeps separating from the trim and water seeps out, I fastened the trim, this took care of the problem for ca 6 month, now it is leaking again from the door, has anyone the same problem? I am steaming mad, this was an expensive appliance, which could only clean dishes somewhat with one brand of detergent, all other brands leave a gray film, and now this! MY previous dishwasher was a rel. basic GE but it got t


This is a fairly common one... I always use a silicone sealant/adhesive to make sure it stays put. A thin film does wonders. ... Dishwashers

Blanco BFDW6 dishwasher drains and sounds like it is going to start but stops after 2-3 seconds. Yesterday it was playing up and made a fairly small puddle on the floor. Electrics seem to have been a problem from early on as after a few months it would let me open it during the beginning of the cycle to add items without needing to restart program. I am not sure if problem is electric (may need a reset?) or due to anti-flood feature.


... Frigidaire 24 in. FDB126RB Built-in Dishwasher

Kitchenaid Dishwasher-Water Problem


Check that water entrance valve works (it is an electromagnet valve,loocated at the pipe's enterance to the machine).\015\012If it doesn't work, test that it get power. In case it get power and dosen't work - You can easyly open the valve and clean i ... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

Problems with my 2 KUDS01FLSS1 KitchenAid Superba Dishwashers. Yes I own two of these dishwashers and both are not working...Please help me!


... KitchenAid 24 in. KUDS01FLSS Built-In Dishwasher

My KitchenAid dishwasher model # kudp01ilbl2 won't start. It is the first time we're trying to start it since we had our water heater replaced (three, maybe four days ago). Not sure how much that may matter. I tried turning off electricity to the dishwasher at the fusebox (overnight), but that did nothing. Normally, you just need to hit the start button and the washing begins. Now, nothing happens. The dishwasher is about six years old.


... KitchenAid Dishwashers

KUDS30 leaking my kitchenaid dishwasher (about 1 1/2 years old) had a leak bottom left side and had gasket replaced. It worked well for approx another 6-9 months without any leaks and now the same problem is back. The dishwasher isn't overloaded. A repair person came last week and ran the dishwasher empty and it didn't leak when she was here. The 2 loads after continue to leak approx 2 cups of water each cycle.


... KitchenAid 24 in. KUDS25 Built-in Dishwasher

We have a 2003 KitchenAid KUDI01IL Dishwasher that will not start . We had problems with the top rack dishes getting clean and we replaced the chopper. The dishwasher worked fine for one cycle, but now will not start. The buttons have lights except for the high temp scrub light. The dishwasher will drain when cancel is hit but that is it.


... KitchenAid 24 in. KUDI01IL - Multiple Color Free-Standing Dishwasher

KitchenAid dishwasher, Model # KUDP021RBS1 - "Normal and cancel lights blink constantly". I had this same problem about two weeks ago so I googled your site and though the solution I found was not exactly applicable to my problem but I tried and that is - Press high Temp, heated dry, high temp and then heated dry and then cancel button and then close the door. Would you believe it worked like a magic wand. But this same problem resurfaced and I am trying all those old tricks but nothing is worki


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have a newly installed Kitchenaide dishwasher. The copper pipe is secure under the sink and appears connected properly to the dishwasher. When I turn the shut off valve on, water begans to run from underneath the dishwasher. There is no water under the sink. The plastic hose does not seem to be the problem.


You should be able to remove the panel below the door and see where water inlet hose is connected to the solenoid valve. I'd bet that's where it's leaking since you say it's newly installed. ... Dishwashers

FRIGIDAIRE DISHWASHER HI! MY NAME IS MARK AND I AM HAVING PROBLEMS WITH MY FRIGIDAIRE MODEL # FDB710LCB0/SERIAL # TH51153536 DISHWAHER. THE PROBLEM: IT DOES NOT COME ON AT ALL LIKE THERE IS NO POWER TO IT. I HAVE CHECKED THE BREAKER AND THE ELECTRICAL CONNECTION AND THERE ARE NO PROBLEMS AT THOSE POINTS. ALTHOUGH FOR A BRIEF MOMENT LAST NIGHT IT DID COME ON AND THERE WAS A "HUMMING NOISE AT THE DRAIN PUMP LOCATION (IT SOUNDED REALLY BAD) THEN IT SHUT DOWN AGAIN AND NOW IT WON,T COME ON AT ALL. A


Check your door switches behind console, next i would ck the circuit board for power in/out. there a tech sheet behind front panel for further diag test points ... Dishwashers

KitchenAid KUDR01TJ Dishwasher Cleaning Problem


Sinder...this sounds more like a water temperature issue than anything else. First, turn on your hot tap. If you can't hold your hand under it after it fully heats (over 125)...you should be okay. If not, raise your water temp or use the sani cycl ... KitchenAid KUDR01TJ Dishwasher

Kitchenaid KUDP23OB/KUDP23HB Dishwasher Stinks. Tried vinegar and baking soda and it still smells like something died. How do we rid ourselves of this problem? Clean the drains in the sind and used ic


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1917 seconds