Having problems with your KitchenAid KUDR01TJ Dishwasher ?

Blinking "rinse only" & "cancel drain" indicator lights

\015 Is there a reset or other solution for blinking "rinse only" & "cancel drain" indicator lights. If not, how do I repair?\015

Answers :

My kitchen aid manual states that a stuck key will cause that key light to blink. If yours is like mine, the buttons are not mechanical, but rather a membrane switch. (Flat sticker like) This statement takes up less than 2% of the technicians troubleshooting guide. Mine is on the back, bottom right hand side. good luck.
Have you unpluged for 5-10mins? check manual for fault codes..genrally in rear. Sorta sounds like a drain problem...maybe...very common.
Repair Help & Product Troubleshooting for KitchenAid KUDR01TJ Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Blinking "rinse only" & "cancel drain" indicator lights


My kitchen aid manual states that a stuck key will cause that key light to blink. If yours is like mine, the buttons are not mechanical, but rather a membrane switch. (Flat sticker like) This statement takes up less than 2% of the technicians troub ... KitchenAid KUDR01TJ Dishwasher

I have a Whirlpool Gold Quit Partner III, model GU1100XTLB1. When I run the normal cycle it functions well until near the end. At that time the unit stops and the pots&pans indicator light blinks. If I hold the cancel button in the unit drains then refills and the light starts to link again. I don't know how to reset this unit because I only have air dry. If I leave the power off for a day I can get the unit to reset. If not, it just fills back up with water and the pots&pans starts blinking aga


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a blinking cancel light on model GU1200xtlt1 and will not start in any cycle. Also if I push another button it flashes rinse button and cancel button. Before this it ran in Sani Clean over and over again and I could not change the cycle. I emptied out a bit of water from the bottom because it did not drain also and the water was not smelling too good.


... Whirlpool Dishwashers

My Kenmore 15652 dishwasher has the Pots/Pans light blinking. When I try to press cancel the quick rinse light also blinks, as well as the cancel light and the pots/pans light. When I release cancel the pots/pans light still blinks and the other two turn off. How do I reset dishwasher so it works normal?


... Kenmore 24 in. 15652 Built-in Dishwasher

Kenwood Elite Dishwasher Mod#665.13779 K600 "Normal Wash " light blinks continuously with NO washer action. No other wash modes light up when pressed. Washer does not do anything. However, a couple of times I got it to make a noise as if it was draining, but then nothing happens. Push "Cancel" and it blinks in unison with Normal Wash light. Open door and close it, "Cancel" light goes out and Normal Wash light continues to blink. Have tried various combination of buttons to try to "Reset"


... Kenmore Dishwashers

Whirlpool GU2300 built in Dishwasher. It rather suddenly began shutting off in mid-cycle. If I cancel or open it, getting it to finish the cycle or even drain takes many tries.Once started, the cycle might take several hours with long pauses during the cycle. When it puases, none of the lights are on at all. If the cycle is disturbed, the normal wash light blinks, and if I hit cancel, the cancel light and the normal wash light blink.


... Whirlpool Dishwashers

I HAVE A DISHWASHER, KITCHENAID SUPERBA, I DON'T HAVE THE MODEL OR SERIAL NO#. THE ONLY NO#. I CAN FIND IS 8270140, THE DISHWASHER IS NOT RESPONDING TO ANY COMMANDS, THE RINSE LIGHT IS BLINKING AND THAT IT!!! I TRIED TO CANCEL BUT THE LIGHT COMES ON LIKE DASHES ON THE SGREEN THEN WHEN I HIT CANEL AGAIN IT GOES OUT, AND THE RINSE LIGHT JUST KEEPS BLINKING. HELP ME I THINK IT JUST NEEDS REST BUT I DONT KNOW HOW ? I CAN WITH THE HOUSE WHEN WE BOUGHT IT, HELP!!!! THANKS MARLA


I HAVE A DISHWASHER, KITCHENAID SUPERBA, I DON'T HAVE THE MODEL OR SERIAL NO#. THE ONLY NO#. I CAN FIND IS 8270140. The unit is not drying the dishes?\015\012 ... KitchenAid Dishwashers

Maytag dishwasher MDB8959SAS0 cancel drain light is flashingThe cancel drain light flashes, when you open and shut door thislight flashes 3 times rapidily the just blinks constantly, what is happening?


... Dishwashers

KUDI01ILBL6 Kitchenaid dishwasher is blinking the Rinse light. Upon pressing any button, the Cancel, Normal and Rinse Only lights are blinking. Does this "code" mean something specific? How can I reset the board?


... KitchenAid Dishwashers

Kenmore Dishwasher Model 665.11643300 Cycle will not run. Normal Wash light blinking Cancel light will also blink (but can be cancelled by holding button down) I tried shutting down the power and resetting at the breaker. I tried other buttons like Air Dry, etc to see if there was some sort of sequence Note* last cycle ran was rinse cycle many months ago - house has been vacant and dishwasher has not been in use.


I will look a bit further in detail about your dishwasher problem. I am assuming you have checked the inlet water tap to the dishwasher is turned on. ... Dishwashers

My kenmore dishwasher, model 15822, just stopped working. The quick rinse light is blinking. The only other buttons that work are the pots & pans light which blinks when pushed, and the cancel button which will run through the 2 minute cancel cycle.


These are known to develop sticky switch contact pads. They stick in the contacted position and stifle the panel. Sometimes heat can be applied with a hair dryer to release them and make the unit function again. This is more than likely a temporary f ... Kenmore Dishwashers

Electrolux Dishwasher Model EIDW6105GB1... no error codes...I select the cycle, everthing appears normal...start to hear water fill, but doesn't progress to point of opening soap container. When I open the door all lights are blinking. I've canceled and tried various cycles, but with same result... all lights are blinking. Even tried just a rinse only. all lights still blinking.... This unit is only 4 years old!


... Electrolux Dishwashers

My Kenmore Dishwasher 665.16359301 quit working. I flipped off the breaker then back on again. The cancel light comes on and it sounds like its going to drain but theres no water in it. After about 20 seconds it stops and the normal wash cycle light starts blinking. Thats it. I did the reset procedure and it started to work then went back to the normal wash light blinking.


... Kenmore Dishwashers

Clean light comes on my Kenmore Elite Dishwasher Model # 665.17263. This happened once before and has to do with the heating element. The service guy showed me how to press the buttons in a certain sequence to "unstick" the unit and it worked fine. The Quick Rinse light keeps flashing. When I push a previous sequence recommendation it switched to pots n pans and Quick Rinse and Cancel all started blinking. Then in about 2 minutes went back to Quick rinse. I did one sequence and it started to d


It seems that there is something stucks in your dishwasher...is there any error code? ... Kenmore 24 in. 15079 Built-in Dishwasher

Whirlpool Gold Quiet Partner IV Dishwasher, Model GU1500XTKT0, Serial number FL4104935, Type 575-0, during a Rinse Only cycle suddenly the cycle light began constantly blinking, which could not canceled or stopped nor placed into diagnostic cycle or other wash cycle. The repairman checked everything and decided problem was Electronic Control Module, which he replaced; blinking Rinse Only went off, but Normal Wash is now constantly blinking and repairman seemed confused and is wanting to repla


... Whirlpool Dishwashers

Hello - On my KitchenAide model nbr: kuds01flss0 Dishwasher the the cancel light blinks constantly and only the rinse light will come on. Also it won't start even when the rinse light comes on.


... KitchenAid 24 in. KUDS01FLSS Built-In Dishwasher

Miele g892 scu plus, about 5 years old. when on, all it does is run some motor (humming sound) and flash salt or intake/drain. No program lights on. Sometimes can be reset so rinse light comes on and nothing blinks, but humming motor still runs and salt eventually blinks. I removed toekick panel; there is water in pan. I disconnect drain hose, only a little water came out. Any ideas?


... Miele G892SC SS Dishwasher

Blinking cancel light and blinking quick rinse light -won't run


It would be helpful if you provide the full model number of the Kenmore dishwasher.\015\012\015\012generally the problem you are having could be tested by first resetting the dishwasher. I think someone has already given you this suggesti ... Kenmore Dishwashers

I have a kenmore dishwasher model #655.1374 or 655.1384 which is only about a year old. I am having a problem with the controls. It will not allow me to use smartwash. The only control that can be used is quick rinse. I reset it by pushing Sani rinse and heated dry. All the lights come on and it seems to do a test. But after that still the same thing except if I push start resume it goes to normal wash which stays on a long time and periodically the cancel drain light comes on as well as the 4


... Dishwashers

Problem with my Kitchenaid KUDP02FR dishwasher. Working fine until yesterday, now the Cancel, Normal and Light/China indicator lights are all blinking at the same time. Cannot cancel out or restart the dishwasher. Tried unplugging to reset, but it just goes back to the lights flashing. Thanks!


... KitchenAid 24 in. KUDP02FR Built-in Dishwasher

I have a whirlpool dishwasher thats a quiet partner 2. the cancel drain light keeps blinking and nothing else is happening. i try to unlock it and then the normal light starts blinking also and still nothing happens. i called a local repair shop and they said i need to change the control board so i did and its still does the same thing. can you give me an idea of where i need to start to fix my problem?


Can you here the pump running or check to make sure there is no water in the base... ... Dishwashers

665.15789300 I have the same problem,pots anp pan light was flahing, i pused cancel and it drained. then i restarted cycle then the pots and pan started flachig again. i canceled again but it didn't drain so I opened and closed the door & now the quick rinse flashes and it will not do anything else.Please help....Allyn


... Kenmore 16872 Built-in Dishwasher

Light keeps blinking on quick rinse, and will not cancel when cancel button is pushed.it just keeps blinking no matter what pad button i push.machine will not work at all. kenmore dishwasher model 665 15717000


... Kenmore Dishwashers

KitchenAid KUDM01TJBS0 blinking Rinse and Cancel Lights


... KitchenAid 24 in. KUDM01TJ - Multiple Color Built-in Dishwasher

Stupid dishwasher! have a maytag model MDB5100MWQ and it was working fine then poooof it the lights go on and it sprays water and thats it, the soap door doesnt open, the indicator lights turn on but nothing happens, then about 20 min later the rinse only light and clean light start blinking what the heck is going on with this damn theig thanks :) brittany


Can you tell me if it drains at all? it sounds to me with the model that it may be the drain pump indicating its clogged. When you open it up is it filled with water? sitting in there idle as in its not draining or siphoning out.let me kn ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1406 seconds