Having problems with your KitchenAid KUDS01DJ - Multiple Color Dishwasher ?

Kitchenaid kuds01dj model. washer fills with water then stops and then the motor hums and does not seem to engage. after a couple of minutes water drains out and the fill process starts again. as before motor hums gets really hot but doesnot engage. does this mean i need a new motor, capacitor? please help


Answers :

Repair Help & Product Troubleshooting for KitchenAid KUDS01DJ - Multiple Color Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kitchenaid kuds01dj model. washer fills with water then stops and then the motor hums and does not seem to engage. after a couple of minutes water drains out and the fill process starts again. as before motor hums gets really hot but doesnot engage. does this mean i need a new motor, capacitor? please help


... KitchenAid KUDS01DJ - Multiple Color Dishwasher

When i turn my Viking dishwasher on the motor starts to run but no water comes out. It was humming along for several hours before i realized that nothing was really happening. I turned it of and then tried again but the same thing happened. It sound like a motor and/or pump working but no water enters the chamber. Thanks, Jonathan


It sounds like the Water Supply Solenoid is bad. I would change that and let all of us know what happens. ... Dishwashers

I have an avanti dw 18 dishwasher . the problem i am having is the when i turn the on button on the motor goes on however no water fills up. The motor is only humming. But; when i press down the float from inside the machine the water fills up and the machine starts to work. after the water drains again the motor continues to run and hum and the dial does not move. when i manually move the dial nothing seems to change . the motor continues to only hum. Even when the dial is in the stop position


... Avanti Dishwashers

Kenmore dishwasher fills with hot water but will not wash, just a faint hum. goes through cycle, drains fine, like motor doesn't turn on.


The faint "hum" sound is your wash motor trying to turn on. You either have a piece of glass/tooth pick/ ect.. or a worn out bearing. Its time to change your wash motor. If you do a DIY you can save money over having a service man come out and charg ... Kenmore Dishwashers

Dishwasher fills with hot water. Float OK - water feed stops when full. Motor humms but no water spray (in all opperating modes). Cancel selection (with cancel button) and close the door. The water drains then the unit shuts off. Water feed OK. Drain Cycle OK. Looks like spray pump hung but do not know. Cannot find a reset button (as with disposal) or way to free hung pump motor. I did see glass pieces in the drain. Possibly a small piece hanging the motor.


If you found broken glass inside the machine some has likely migrated to the pump. about the only way to fix that issue is to remove the pump and either replace it or disassemble it and clean it out. ... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

Miele g892 scu plus, about 5 years old. when on, all it does is run some motor (humming sound) and flash salt or intake/drain. No program lights on. Sometimes can be reset so rinse light comes on and nothing blinks, but humming motor still runs and salt eventually blinks. I removed toekick panel; there is water in pan. I disconnect drain hose, only a little water came out. Any ideas?


... Miele G892SC SS Dishwasher

Maytag DWU6402AAB dishwasher hums but motor does not run. I've taken the inside apart down to the disk-shaped impeller. It turns freely so the pump and motor are not stuck. When control knob is turned motor hums at the places where it normally should run. The water valve & heating coil seem to be operationg normally. i assume the next step is to test the motor &/or motor relay. Is this correct and how do I do that?


... Dishwashers

I have a fridgidaire Gallery dishwasher model # FDB949GFS2. It was not spraying water while running, so I checked for clogged wash arms and hoses etc. So I replaced the motor assembly and now I hear the motor running, it fills with hot water but it is still not circulating water. Is there something else I need to check. Thanks Tom


Most likely the wash sump is blocked. Refer this diagram. You will have to open the sump (item 14) and loo ... Frigidaire FDB949GF Dishwasher

The motor is making a loud humming noise when turning on, water comes out, then stops, and the fan shuts off, then motor keeps making the humming souond? Does the motor need to be replaced?


... GE Dishwasher Mechanism Assembly - WD26X10045

FDB750RCC1 When I start the DW, the motor hums loud then soft then loud then soft...if I advance the dial some sections of the cycle nothing will be running and others the motor is on, but no water is getting into the unit. I just replaced the inlet valve and solenoid and that didn't change anything. I can see water in the recirculating pipe running up the unit, but it will just try to make it up and fall back down. Not sure how to proceed...my thoughts would lead me to the main motor, but


Can you hear the water solenoid click when it calls for water? If so, check that the water source valve is on and water comes out of the valve. Check the entry hose for kinks. Remove everything under the lower arm down to the deck keeping track ... Frigidaire 24 in. FDB750RCC Stainless Steel Built-in Dishwasher

GE Triton XL Dishwasher won't start, Runs but won't allow the hot water to enter the dishwasher at the beginning of the wash cycle. Just hums with no hot water.


Check the float switch make sure it not stuck or may be full valve gone bad ... GE Dishwashers

My tappan dishwasher is only 1 1/2 yr old and its not getting at least 1/2 of dishes clean. We have tried everything from changing to liquid soap, increasing water pressure at meter, not using while washing clothes. We used a dishwasher cleaner to remove calcium, and run hot water in sink before using. We know the wand, pump and drain are working. It is model TDB210RFB5 with 1.1A motor. Is the motor too small to clean dishes? I wish I could get my money back or exchange for an upgrade. Thanks!


... Electrolux Dishwashers

My whirlpool quiet partner II is not quiet at all. When I start the cycle it starts humming and a little vibrating and I open it up and no water. I close it and wait it out every 10 minutes I open it back up and no water. The heating element is hot and stinky since there's no water. But once the wash cycle is over the rinse cycle works and theres water. What's the issue?


... Whirlpool GU2400XTP Built-in Dishwasher

I was trying to wash dishes and i noticed that the motor wasn't running but water was filling up the unit. I smelled something burning, and i shut it off and took off the cover and i felt the motor and it was very hot to touch. I assume the motor is frozen. How do I change the motor? Is my diagnostic accurate?


Hi.From your description it sounds like the pump motor has blown and must be replaced.Before replacement the motor can be tested by jumping eac of its wires to energize it directly, for safety reasons the operation must be done by a ... Dishwashers

Kenmore (Whirlpool) 655 1589910 Dishwasher. Fills with water, motor makes horrible noise (buzzing / loud hum). Dishes do not wash and there is no evidence that any water pumped up to the spray arms. Spray arms are not clogged. We have a fully functioning water softener so it is not a hard water issue. Unit does drain normally. Either filter is badly clogged or pump is bad. How do I get to these parts to check them out?


You need to clean/ check the chopper. sounds like you have a bad motor. about 2-300 dollars for the part ... Kenmore 15899 Built-in Dishwasher

My Frididaire Dishwasher Model FDB1250REC1 is discolored inside. Its a browninsh color and it has gotten on my Corningware dishes and stained some of them. I can get most of the color off the dishes if I scrub hard. I have run cleaners for the dishwasher thru and cleaned it temporarly. Do you think this is the soap I use, amount of soap or maybe the water. Not sure its the water cause there is another one on my water line that is not really having this problem. I always run hot water just before


So you need to install a water filter, before you connect water supplie, then you need a special soap to clean wachine (Calgonit diswasher cleaner powder ) use-it without dishes. then use a dishwasher salt (to disolve all water dirt and colour) and r ... Dishwashers

Kenmore Dishwasher #14451-Motor Hums-Water won't drain...


... Kenmore Dishwashers

Follow-up I've removed the lower arm, I'll spend some time and see whether I can get the pobem sorted out. My wife noticed the the detergent was smeared all over the door and repeated tries didn't get it out. Therefore, the water is not spraying. I can confirm the water is filling on the bottom and draining. The heater is working well. I am thinking there is no pressure to send the water through the tubing to the upper and lower arms. The motor is hot to touch (118 degrees with my temp probe). I


... Kenmore 24 in. 15199 / 15194 / 15192 Built-in Dishwasher

I have the Kitchen aid KUDS01DL dishwasher. It was working fine until last week. When starting a cycle, the washer fills with water. Once filled, the motor makes a humming noise and does not circulate the water. I end up stopping the cycle and the discharge pump empties the water. I took apart and cleaned the basin this morning. I did find some random garbage but it did not seem blocked. Do you have any ideas?


... KitchenAid 24 in. KUDS01DLSS Built-in Dishwasher

I have a Kenmore Dishwasher Model #665.168790000 and the water fills just fine and empties fine when cancelling cycle but when pressing any wash cycle the pump/motor just makes a loud humming noise and does nothing. I took apoart the lower assemblies to clean everything out but the problem hasn't gone away. Do I need to replace the motor or the whole motor assembly (also contains impeller kit)??? Also, I don't think I need to replace the whole sump & motor assembly do I???


... Kenmore Dishwashers

GE TRITON dish washer. Utensils are stained after wash. I tried all that suggested solutions like cleaning with white vinegar, make sure hot water flows before it starts. I donot think we have hard water problem and also tried Jet dry rinsing. Nothing is working still i see utensils soap stains and not completely rinsed. I am desperately looking for an answer. I am thinking of is there a way i can test whether the middle tower is really opening up to spray water or not. It might be something els


Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... Maytag Dishwasher

I have water left over after each wash and it is really cloudy? I use the right amount of dishwasher liquid, etc. It has hot water. When I first got it about 2 years ago, it did not have this issue. I assume a little water left after the wash is okay? But, it is milky cloudy for the past 3/4 months now. I have a Maytag Legacy Series Quiet Series 300 machine...


Try running your disposal for a few minutes and then run through the rinse cycle. mine does this too sometimes and i just need to clean my disposal in my sink as some stuff gets caught up in it. ... Maytag 24 in. MDB9750AW Dishwasher

I have a GE GSD3200 dishwasher about 6 years old, which had been working well until this past week. When turned to 'start' the motor runs but no water fills the tub. I then poured 4-5 pots of hot water into the tub and tried to re-start. As soon as it was turned to 'start', I could hear all of the water draining out. How bad does this sound :) ?


Look inside the dishwasher and there is a little round cup shaped thing in the bottom of the washer. It shuts the unit off if the water gets to high. Lightly push down on it to reset. It should fill with water now. You should look into why it was tri ... Dishwashers

FDB105OREC4 My dishwasher is not cleaning my dishes. I push the start button and water seems to be trickling in then it stops and no sounds protrude from the machine for several minutes. Eventually another loud motor seems to turn on and drain the water out of the machine. The soap dispenser usually opens and the soap block that usually dissolves is setting on the bottom of the machine. It seems the water is plenty hot but the rotating washer arms might not be moving. Please help me find the par


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

I have a Kenmore Elite dishwasher (model 630.17303406) and it just stopped working. Doesn't drain what's left in the bottom and just makes a humming sound when turned on. Power is good, sounds like the motor is working. Doesn't seem like it is drawing water in. I want to check the pump and motor, anybody have any advice?


If nothing obvious like blocked / obstructed outlet pipe\015\012You need to check if the outlet pump motor in line with the outlet hose is spinning when in the outlet mode. First check if it is spinning by looking at it and see if the small fan ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0986 seconds