Having problems with your KitchenAid KUDS50FVSS Builtin Dishwasher ?

This is not clearning properly and leaves a white dirty film on everything. I've disassembled and checked the little black drainage flap and it doesn't seem to be blocked. my wife claims that she heard several large thumps when we turned it on yesterday. it's less than a year old. any advice?


Answers :

Repair Help & Product Troubleshooting for KitchenAid KUDS50FVSS Builtin Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

This is not clearning properly and leaves a white dirty film on everything. I've disassembled and checked the little black drainage flap and it doesn't seem to be blocked. my wife claims that she heard several large thumps when we turned it on yesterday. it's less than a year old. any advice?


... KitchenAid KUDS50FVSS Builtin Dishwasher

Hi . I have a Zanussi DE6965 which has started displaying the error message AL6 every now and then. When it stops and shows this the water has not pumped out. If you turn it off, leave for half an hour or so and turn back on it sometimes works fine to the end. Sometimes it stops again. Eventually after several stop starts it works through. Any advice what could be causing this? Thanks.


... Zanussi 24 in. DE6965 Built-in Dishwasher

When I press the start/resume control, the dish washer start/resume light blinks 2 to 3 times, then turns-off. then the dish washer beeps several times; however, the dish washer does not start. when turned the breaker switch off and on, and then I press the start/resume control, the dish washer go through a normal wash cycle. The next day when I press the start/resume control, the same thing happens. 2 to 3 blinking lights followed by beeping for several seconds. Dish washer does not start


... KitchenAid KUDC10IXSS Builtin Dishwasher

When I start the dishwasher, it sounds normal. A few minutes after it starts, it makes a loud, thumping noise that lasts for several minutes. After a while, it stops making noise, but about half way through the cycle, it starts making the loud, thumping noise again. It's loud, annoying, and does not get our dishes clean. We have to wash several dishes by hand AFTER we have run the dishwasher.


I have made the assumption that your d/w is a siemens machine, however if not pls repost with the make and model.\015\012There are a few possibities...check the spray arms are clear by removing any blockages in the holes, check that there ... Dishwashers

My LG 24 in LDS 5811 ww quite working in the middle of a cycle. I have power to the machine, but no lights come on, nothing works. I turned off the power and removed the front pannel. The large brown wire and large orange wire that are plugged into the back of the control panel start to smoke. So does the large black wire and the large white wire. Any ideas, is this the heater or is the panel bad?


The unit will need a new Wire harness, Pump/motor assy, Main Pcb and inner door liner.\015\012Contact LG @ 1800 243-0000 they may help you out. ... LG 24 in. LDS 5811 Built-in Dishwasher

Hi threr I have the following problem with my Haier DW12-EFM dishwasher: The dishwasher seems to operate properly for the first several minutes untill program selector knob stops betwin position 2 and 3. After I turn it manually it keeps on turning and than it stops again after I turn it again it operates till the end of the program but the dishes are not clean enough to be used. I also noticed that the heater does not operate (water is cold). Do you know wht the problem might be. Reg


... Haier 24 in. ESD100 Built-in Dishwasher

Water was turned off while we were on vacation. Wife ran dishwasher without turning on the water. Turned on the water this morning, however unit won't pump water into the washer .


\012Hi,\012Here is a tip that will help you to find out why water will not come into the dishwasher... ... Maytag Dishwasher

Thumping noises and a belch when turned on. Will not start.


... Bosch SHE4AM02UC 24 in. Built-in Dishwasher

SHE4AM15UC/05 dishwasher will not start When I turn on light for regular wash lights up but will not start after I push start button. When I turned it on the rinse agent light was on, I added some and that light is no longer on but after several tries it will no start. Electricity went out yesterday but dishwasher was no on when it went out..


... Bosch SHE4AM15SS Stainless Steel 24 in. Dishwasher

When the dishwasher is turned on a sound is heard but no water is heard splashing what is the problem ?


Hi,Here is a tip the will elaborate on your problem more, but the bottom line is that you need to replace that fill valve...Dishwasher ... Hotpoint Dishwashers

My wife opened the Dishwasher in the middle of a cycle and turned the cycle to off. Dishwasher will not turn on. Power is ok. Bottom of Dishwasher is full of water. How can we get the dishwasher to restart?


... General Electric Spacemaker® GSM1800N Built-in Dishwasher

The lock on light wont go off. We can not start the dishwasher. We have tried holding the noheat option for several seconds and have turned off the circuit box for several minutes and neither one made the lock on light stay off.


That is the correct button to push to turn the control lock off. You can try to reset the control by removing power for two minutes. If the dishwasher is doing the same thing, most likely the touch pad has a shorted button or a bad connection on the ... Kenmore Dishwashers

Will not turn on. turned dial several times to different setting, will not start. checked electric switch, its on; checked circuit breaker, on.


... Hotpoint HDA2000G Built-in Dishwasher

Our dishwasher lets the water in but does not spray the water on the dishes to clean them. It makes a thump type sound when we hand turn it to the washing cycle and does not pump any water out when we turn it to that cycle as well! Please advise! thks Bob Rupnow


SOUNDS LIKE THERE IS AN OBSTACLE IN THE PUMP IMPELLER OR THE MOTOR HAS A PROBLEM. THIS IS FROM THE THUMP DESCRIPTION. THERE ARE OTHER POSSIBILITIES WITH THE RELAY THAT CHANGES FROM WASH TO DRAIN, BUT USUALLY HAS A DIFFERENT MALFUNCTION. ... Dishwashers

Smelly Dishwasher Hi I have a Baumatic bad6002 dishwasher. The smell that comes out of it is putrid and has been from day one. We rinse everything before it goes in, I have used dishwasher cleaners and hung smelly things in there to prevent the smell but it still stinks. I do not use cheap cleaners only finish or morning fresh. It gets turned on approx every 2-3 days and the dishes actually go mouldy before it gets turned on. I have had several dishwashers and this is by far the the most disgust


... Baumatic Dishwashers

KitchenAid Dishwasher KUDP01FL: Called repairman to replace balance link kit. Then door extremely stiff to open & heard loud pop when one of the ropes came off the roller. Repairman came back & put rope back on & replaced door seal, then the door won't close & he claims need a new door latch. When he left, door again extremely stiff to open & heard same loud pop when one of the ropes came off the roller. Now he says he can't fix it and to call someone else. I now have three problems: (1) The doo


May have bent door hinges,, need to check all alignment of door, hinges and latches... ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have a Miele Dishwasher 2430 Sci. It's been not used for 5 months and when I returned it worked fine for several times (at least 6). NOW the intake/drain light keeps blinking. I have already cleaned out the drain and replaced it properly (there was nothing in there and it was clean). No water is coming into the dishwasher?however I know that the water hook-up is on (the first thing I checked). I turned the water on and off several times and AM SURE it's on now. What else could be


The usual course of events is to check and clean the filter, check and clean the water pump and well, check and clean the waste pipe and any connection to a sink or waste disposal system, then check the inlet warer pressure, then the machine level / ... Miele G2430SCi Dishwasher

My Bosch dishwasher keeps on filling with water. It won't turn off. I had to turn off the water source to it for the night. Please help. I have a large family and rely on this appliance every day. Thanks!


The problem that you described should be the float switch. It could also be a defective fill valve (stuck open) ... Bosch 24 in. SHU43 Built-in Dishwasher

When i turn my Viking dishwasher on the motor starts to run but no water comes out. It was humming along for several hours before i realized that nothing was really happening. I turned it of and then tried again but the same thing happened. It sound like a motor and/or pump working but no water enters the chamber. Thanks, Jonathan


It sounds like the Water Supply Solenoid is bad. I would change that and let all of us know what happens. ... Dishwashers

I have a whirlpool quiet partner 3 24" ss. After a severe storm came through and knocked the power out the glass express light will not stop blinking which in turn makes the dishwasher unable to turn on. Please tell me the code if there is one to press or what the problem may be.


I had to call in an expert ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

AFTER A BRIEF POWER OUTAGE DUE TO ELECTRICAL STORM THE F1 CODE FLASHES AND PUMP RUNS CONTINUOUSLY. TURNING POWER OFF ONLY STOPS IT FOR SEVERAL SECONDS. TURNING OFF POWER TO DW AND BACK ON DOES NOT RESET. I HAVE REMOVED THE BOTTOM DRAWER AND CHECKED FOR WATER, BUT UNIT IS DRY. IS THERE ANOTHER WAY TO RESET THE SWITCH?


Hi there,The f1 fault is cased by a leak on the dishwasher.It is activated when water gets to a dangerous level in the base of the appliance near to the PCB.The main reason this happens is putting cups on the drop down s ... Dishwashers

Whirlpool GU2400XTPT Dishwasher is on island of Utila, Honduras. Upon return after several months absence, light was flashing but dishwasher would not turn on, light would not turn off, no other buttons would light up. I am thinking a power surge might have hit it and maybe knocked something out. Problem is, I need a part from here to take down there and hope someone there can install it. Help! Thanks! Barbara Chaney


I had a svc. tech come and he said I need a new "panel". Darn.It's $133 plus labor. He said the "normal" button had shorted out,especially since that's the wash I use all the time. It's only two years old, and I didn't buy an extended w ... Whirlpool GU2400XTP Built-in Dishwasher

XL30 Hi temp. Two problems: 1) Hi temp booster not working...worked on and off for awhile, now won't get up to 180. 2) Turned on today and water flooded out. Water overfilled machine, turned off and heard pump drain unit.


To attempt to solve the over filling, clean the probes in the back right corner. Use a green scrubby pad.\015\012\015\012There is also two probes under the front screen. Clean them too.\015\012\015\012As far as the booster not ... Dishwashers

Suddenly, an error message appeared on the display of my Frigidaire gallery series dishwasher, model number GLD3450RDS0. On advice from Electrolux customer service, we cut off the power supply for one minute. When we turned the power back on, the display read PF (for power failure), but then it went completely black. Any advice?


... Frigidaire Dishwashers

The contol lock LED is illuminated on the front panel of my Maytag dishwasher. (Neither my wife nor I pressed the control lock for 3 seconds!) We've tried to extinguish it by pressing it for 3 to 5 seconds, but it remains ON. We've turned off the breaker to the dishwasher overnight, but when we turn the breaker back On, the contol lock LED comes on. We simply can't unlock the control panel. We can tell that all of the other buttons work just fine because pressing any of them causes the 3 Sec LED


If by pressing the control lock button for 3 seconds does not solves the problem.then there are 3 possibilities due to which this problem may occur\015\0121)the door is not closing properly. the dishwasher door latch is either cracked internally or t ... Maytag Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1015 seconds