Having problems with your KitchenAid Stove / Oven / Range Infinite Switch 8203536 ?

CANNOT REGULATE EATING ELEMENT - KitchenAid Stove / Oven / Range Infinite Switch 8203536


Answers :

Repair Help & Product Troubleshooting for KitchenAid Stove / Oven / Range Infinite Switch 8203536

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

CANNOT REGULATE EATING ELEMENT - KitchenAid Stove / Oven / Range Infinite Switch 8203536


... KitchenAid Stove / Oven / Range Infinite Switch 8203536

F2e0 light on my oven - KitchenAid Stove / Oven / Range Infinite Switch 8203536


... KitchenAid Stove / Oven / Range Infinite Switch 8203536

GE Adora electric range-The top element in the oven works the bottom element in the oven got burn out because of a grease fire. The oven has a new bottom elenment, however the bottom oven element doesn't come on after programming.


... General Electric Adora GHDA676NSS Stainless Steel Built-in Dishwasher

Need help my oven is not working, the self cleaning works fine, the broiler also works, but the oven will not heat. what can i do? Our Kenmore gas range will not heat to the proper temp. The oven ready beeper goes off in about 3 minutes and displays 350 which the internal temperature is not. There also seems to be excess heat coming from the vents under the top of the stove, (under the timer, clock etc.). This could be something I just never noticed.


Hi, The ignitor is not working right and is going bad....have the repair man replace the ignitor, or DIY....Check out this tip about your problem...Oven not Working or ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

GE Adora Electric Range elements or oven not working


... General Electric Adora GHDA676NSS Stainless Steel Built-in Dishwasher

We have a KitchenAid KEBC147KSDS06 24" conv. oven. After putting it through a clean cycle, I tried to preheat it to conv, bake @ 350 deg. The display comes up normally and the fan runs, but after 5 sec. the temp disappears from the display and 'Lo' appears in its place. The conv. fan continues to run but neither upper nor lower element heats. Following a suggestion, I tried to reset the oven by turning off its circuit breaker and powering back up, but it did not correct the problem.


It depends how long you had the self-clean function running. The oven is known to overheat and damage the thermostat during self-clean.\015\012\015\012See postings on some user forums.\015\012\015\012 ... KitchenAid 24 in. KUDS02SRSS Stainless Steel Built-in Dishwasher

Nothing comes on on my kitchenIaid KUDI24SEBL4.checked door switch(2poles,com and NO3)res was infinite across com and NO3 and 0 when the actuator was depessed.the actuator has to be held down after it clicks to get a 0 resistance otherwise it goes to infinite.is this correct.if so I guess I need to check the timer?


... KitchenAid Dishwashers

Stove wobbles when closing oven door - Viking VGCC5304BTP 30" Pro-Style Gas Range with 4 VSH Pro Sealed Burners w/ VariSimmer, 4.0 cu


... Viking VGCC5304BTP 30" Pro-Style Gas Range with 4 VSH Pro Sealed Burners w/ VariSimmer, 4.0 cu

Ge kenmore XL44 oven will not heat - GE Kenmore Whirlpool Stove Bake Element


... GE Kenmore Whirlpool Stove Bake Element

I'm having trouble with the oven. It burns if I use the temperature setting called out in recipes. I've lowered the temperature by 10 degrees but I still need to closely watch it. It cooks very unevenly. My cakes and cookies are always more brown on one side than the other. Many times the bottoms of my breads are burnt. I have only had the stove about 5 months. It's a gas range.


If brown on top & bottom or left & right side / if one side is darker the look at door aliment . if top and bottom may be the top element of no pre heat ./ alway's preheat oven / cookies in the center . load the oven ev ... Dishwashers

I'm getting error code AM71 UI75 EEKGO-097 on my kitchenaid stove. The oven is not turning off unless I unplug. Please help.


I'm not sure exactly what that error code means, but being a technician I can tell you the control board and the oven sensor need to be replaced. The control board simply because it tells the oven what to do and when to do it, the sensor because its ... KitchenAid Stove / Oven / Range Infinite Switch 8203536

REPLACE GE OVEN DOOR HINGE REPLACEMENT JSP40 - GE Kenmore Whirlpool Stove Bake Element


... GE Kenmore Whirlpool Stove Bake Element

Dead spot? We just moved into a house and the built-in frigidaire oven, model no: CFEB27S2AS1 bakes on only the low heats, 0 - 250 and high heats, 450 - max but does not heat (red indicater light not come on nor any heat) at mid-range. Is there something I am not doing, or does it need to be "rebooted", and if so how do I get to the power plug/switch as it is embedded in the wall?


Hello\015\012\015\012You said, We just moved into a house and the built-in frigidaire oven, model no:\015\012CFEB27S2AS1 bakes on only the low heats, 0 - 250 and high heats, 450 -\015\012max but does not heat (red indicator light not come ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Oven donot come on - GE Kenmore Whirlpool Stove Bake Element


... GE Kenmore Whirlpool Stove Bake Element

My kenmore xl44 oven will not heat - GE Kenmore Whirlpool Stove Bake Element


... GE Kenmore Whirlpool Stove Bake Element

We have about 5 bauknecht oven and we have a problem with the heater element adn selector switch,where we can buy the spare parts in singapore


... Bauknecht 24 in. GSF8971 Built-in Dishwasher

HOD6615 Vision one dishwasher - water is not heated, errors after 15-20 mins. Element seems to meter out ok, is this more likely to be the safety switch or control panel, any tests to prove. Could anyone tell me what part the safety switch plays in element connection.


... Hoover Dishwashers

When the oven is switched off after cooking the cooling fan runs to cool the oven down,it now keeps running all the time when the oven is off,the only way to stop it is to turn off at the ciruit breaker,what is the possible cause for this?????????? no.FFB1601CWW WALL OVEN


Sounds like the thermostat which allows the cooling fan to keep running after oven switched of is faulty may be stuck on or shorted will need to be replaced.let me know how you went. ... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher

Smooth top range oven message KAL


... Whirlpool Kenmore 8523692 Smooth Top Surface Element

I have a frigidaire oven model fef352fwa and the broil/bake elements will not work. The top elements will work. The control board parts #is sf5312. Can this board be repaired, or is there else that


... Kenmore 24 in. 17462 / 17464 / 17469 Built-in Dishwasher

Bosch she4am Unit starts briefly, then stops about a minute into the operation and lights the CLEAN led. I located the diagnostics code paper, ran the test a few times, and come up with the same code...the CLEAN led lit indicates a door switch problem. I removed the door switch, it's a magnetic hall effect transistor..seems to work but not sure it's showing proper voltages. It reads 8vdc or so across the switch with door open, and about 11.7vdc with door closed. Seems too narrow a range to me


... Dishwashers

The oven will not turn on, it has not worked since a power outage. it is a gas oven the burners on the stove top work, but the oven will not.


Its either the eoc ( clock ) of the ignitor . see if ignitor is glowing and how bright / if orange replace . if its not going it may be clock . mm ... Dishwashers

My PLEB30m9ec microwave has burned out two door safety interlock switches in 4 months. It works well otherwise. The second switch appears melted. switch or oven?


... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

I have an Indesit IDL500 dishwasher. It had stopped heating the water up, it looked as if it had short circuited and so i replaced it, i have power going to the element. A couple of forums state that it may be the pcb behind the timer/selector switch. Does this pcb control the program selection and heating of the element? or is there a thermostat that controls the stop and start of the heating element? Any help would be greatly appreciated


Hi\015\012\015\012The unit\015\012has two thermostats and you can test both of them for continuity before\015\012replacing, no continuity replace the thermostat. Hope\015\012this helps...please post back fo ... Indesit 24 in. IDL500 Built-In Dishwasher

Replacing heating element in Kitchenaid dishwasher KUDI01TJBL0


... KitchenAid KUDI01TBK Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0863 seconds