Having problems with your KitchenAid Superba Architect Series II KUDS30FX Fully Integrated Dishwasher with 4 Cycles, Nylon Racks, ProScrub Option, NSF Certified Sani-Rinse, 49 dBA Whisper Quiet Sound Insulation and CEE Tier II Energy Star Qualified ?

Kitchenaid kuds30fx DISHWASHER washes then quits without drying

\015 The two wash stages appear to be completed, but the drying step does not occur and all indictor lights turn off. When the dishwasher was new, wash and dry completed with the light on the front of the door on.\015

Answers :

Repair Help & Product Troubleshooting for KitchenAid Superba Architect Series II KUDS30FX Fully Integrated Dishwasher with 4 Cycles, Nylon Racks, ProScrub Option, NSF Certified Sani-Rinse, 49 dBA Whisper Quiet Sound Insulation and CEE Tier II Energy Star Qualified

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Whirlpool Gold Quite Partner III dishwasher. Can I just choose the drying cycle without washing and rinsing?


No I am sorry that is not an available cycle. ... Whirlpool GU2400XTP Built-in Dishwasher

The GE Profile Dishwasher will not allow me to start without the heated drying light coming on. I want to wash without this headed drying at the end of the wash. When I try to turn it off it turns the start cycle off. This happend over and over again when I want to turn on the machine, It finally lets me get an unheated dry wash started to complete. A problem every night. PDW7800N15CC. Serial MM8243388


... GE 24 in. Profile PDW9800J Built-in Dishwasher

My Kenmore dishwasher model #66515639000 quit working. It was washing dishes just fine one day and then the next the buttons weren't working properly. The pots & pans button was flashing with the cancel button. After searching on your site, I tried to resent the control panel by pressing the normal wash button and the air dry button 3 times then opening and closing the dishwasher. Now the quick rinse button is flashing. Any ideas of what to do now?


... Dishwashers

Dub750x leaks My Whirlpool Quiet Wash Plus Series Model DUB750XB-0 dishwasher produces a small puddle of water on tile floor in front of unit, but it doesn't seem to be coming from underneath it as tile/grout right in front of it aren't wet. This happens hours after the dishwasher has been run, usually at night, whether on Air Dry or Heat Dry setting. This began occurring recently after years of use without the problem. Sometimes it occurs more than once after washing/unloading. Coul


... Whirlpool Dishwashers

I have a kitchenaid model KUDS01JBT dishwasher. The Chopper Assembly keeps pluging up causing the dishwasher not to wash properly. Can I remove the chopper Assembly and run the dishwasher without causing any further problems to the dishwasher or will it cause other problems with the pump etcetera? Thank you for your assistance. Sincerely, Pat


\015\012\015\012Check the water temperature. Should be 125 to 140 F. \015\012\015\012Check pump re-circulation., Listen, see if it sounds like it is spraying the water around with enough pressure. ... Dishwashers

Hi, I have a Siemens SE24A230GB/17 dishwasher and it is not completing the wash cycle (any selected). It appears to be stuck on the 'wash' part of the program. I have done the reset actions as advised in the User Manual and tried another program, without success. I have found that the possible causes could be the timer or thermostat. The estimated time remaining display counts down, but the program does not complete the wash and move onto rinse and dry. Any help or advice you can provide would


... Siemens Dishwashers

My kitchenaid dishwasher won't wash. The clean light blinks and if I can get it to cycle, it turns on to ''2 minutes'', during which 2 minutes it makes some washer-like sounds but doesn't clean, dry or spit out any water. Before this, I wash having trouble getting my dishes clean. I wash able to get the bottom rack clean using the heavy duty cycle, but the top rack still didn't clean


... KitchenAid Dishwashers

Kitchenaid kudp02cr Dishwasher has a blinking drying light during wash cycle, when we cancel it shows the washing light on soild. We have tried resetting the panal, but it isn't stopping. WHat do we need to do and is something wrong with the system.


... KitchenAid 24 in. KUDP02CR Built-in Dishwasher

Have a kitchenaid dishwasher KUDS25SHWH1 - the child-lock light came on and will not go off. It is a light and no button to push and hold except all of the select buttons for the type of wash you want, no air dry button. How do I get this light off?? The Child Lock light has come on by it's self and I cannot get it to turn off. I have never used this feature before. I have tried to hold the Energy Saver button for several seconds but the Child Lock light will not shut off. The dishwasher is loc


Unplug the unit for 15 minutes then plug it back in. This should reset all your computer system and make everything work again ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Our Kitchenaid dishwasher model # KUDP021R will not start. We close door, select wash and press start. The control lock light at the top which is lit flashes a few times and then stays lit. Dishwasher remains silent. An aside which may be helpful is that the door has always seemed to be not quite straight...as though it had to warp a tiny bit to close and lock.


The problem you have already identified could be the door switch is not closing when you shut the door. Please confirm your dishwasher is KUDP02I (i and not 1).\015\012\015\012One way to check is find out the door switch on the door panel ... KitchenAid Dishwashers

Hello, We need some assistance with our Kenmore dishwasher. Last night after I started a load, the dishwasher just stopped and then the washing and drying lights started flashing red, sanitized and green are flashing green and the 6 hour delay button is flashing red. I have pushed the start/cancel button but to no avail. My husband shut the power from it to see if it would reboot, it does not help either. It runs a little bit then quits and does not clean the dishes. Could you give us sugg


Hold the start button for 3-4 seconds and see what that does ... Dishwashers

My kitchenaid dishwasher quit working, the hi temp scrub and heat dry buttons light up but nothing else does. The dishwasher makes no sounds and doesn't even try to turn on so I tried bypassing the thermal fuse, safety latch, and replaced the motherboard so to speak and still nothing so PLEASE HELP!?!


... Dishwashers

Frigidaire FDB1502RGC0 dishwasher set for normal wash and heat dry option, both leds are on. dishwasher cycles through wash, but never makes it to dry cycle. After wash, the leds for OPTIONS high temp wash and dry cycle start blinking and do not stop blinking until I hit cancel - which cancels everything. Open unit and water sitting in bottom. Is it a bad operator panel? Water pump did seem to be working during wash cycle. NEED HELP.


... Frigidaire 24 in. FDBB540 Built-in Dishwasher

I have a MOdel KUDS30IX kitchenaid dishwasher It woks under wash but then drains water and shuts down. all lights go out. dishes only air dry. any suggestions?


... Dishwashers

Zanussi dishwasher washer will go through the wash without heating water ,hence no drying of dishes. not sure of model


Zanussi dishwasher may have a faulty heating element (wire in bottom of wash tub) check for videos to test. ... Zanussi ZT485 Built-in Dishwasher

I have a KitchenAid KUDS30IXBL Dishwasher and the ProScrub and Heat Dry lights do not shut off after a wash. Is there a way to clear this or is it a bigger problem requiring a service call? Thanks


... KitchenAid KUDS30IXBL Builtin Dishwasher

Kitchenaid kudc03fvss0 dishwasher stopped mid cycle without drying dishes last week and then stopped altogether with lights flashing and full basin. I disassembled filter/pump cover in bottom and cleared several plastic pieces and cleaned chopping blade and screen. After unplugging/plugging and pressing cancel button the pump runs for about 10 seconds and stops with normal and heavy duty lights flashing. What should I check next?


... Dishwashers

Kitchenaid kudp01ilbs6 dishwasher only the wash cycle lights up not the dry cycle


... KitchenAid 24 in. KUDP01IL - Multiple Color Built-In Dishwasher

No water in kitchenaid dishwasher -- everything dirty and dry after wash cycle. rinse cycle the same. any ideas what might be wrong?


Simplist reason for no water in a machine that has been working well, is to check to see if the float, that is telling the machine to add water or stop because it is full, is stuck. I have had a measuring spoon fall out of its tray and fall under th ... KitchenAid Dishwashers

The kitchenaid dishwasher (model KUDC25CHSS1) appears to have the 'child lock' engaged on the led display panel. The 'energy saver dry' light is flashing red and when I attempt to push 'cancel' it only flashes and never goes away. When I attempt to press a 'wash selection' the 'child lock' then flashes. Please help.


On my unit, I had the same problem (child lock LED on, or flashing.The cancel process of pushing anything was not possible, as a bad/stuck switch prevented any input from the control panel buttons.The underlying cause of the problem turne ... KitchenAid Dishwashers

Cycles from wash to clean without drying. - Bosch SHU9952 Built-in Dishwasher


Could be a bad timer ... Bosch SHU9952 Built-in Dishwasher

I have a General Electric pdw7880J03ss dishwasher. Tonight, I went to start a load of dishes and the Heated Dry option wouldn't turn off without the lights going to RINSE ONLY. Then the 1hr setting started coming on. Then was able to get the load to start but then it stopped somewhere in the cycle. Now, no lights will come on the panel though I can hear the beeping. Dishes appear to have washed...


Hi\015\012\015\012Press and hold the heated dry button for 15 seconds to reset\015\012the control, if this wont work then it means that the control board is bad and\015\012should be replaced. Hope this helps...please post back for further ... Dishwashers

I have a Triton dishwasher. Last cycle, it completed washing then started drying and started beeping and the drying light is flashing. When I finally opened the latch, the beeping stopped, but the drying light is still flashing. The dishes were clean and warm - they air dried the rest of the way. I have not been able to get the drying light to go off. I have turned the breaker off over night, and flipped back on. The dishwasher goes back to flashing washing, and then clicks to drying and th


Hi,\015\012Make sure the salt level is ok - add 1Kg of salt if you have not done it in a while, and check rinse-aid level if apliccable.\015\012\015\012If this does nothing, then remove the lower kick panel for access to a data shee ... GE Dishwashers

KUDU03STSS2 The dishwasher won't start and you cannot select a cycle. Hiting cancel twice will turn a small steady light on in the time window were the spining light normally is before a cycle starts, at which time closing the door will drain the dishwasher. Tried using the reset combos: hot wash, heat dry, hot wash, heat dry - all lights came on but nothing reset. Also tried same sequence doubling the heat dry. Unpluged for ten minutes, still nothing. Can select rinse, but unit does not start,


... KitchenAid Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1699 seconds