Having problems with your LG 24 in. LD-12BW5 Free-standing Dishwasher ?

My LG dishwasher is stopping after a few minutes into the wash cycle with an error message OE and making a sound. The dishwasher tablet is still inside the dispenser and while there is water in the unit it isn't hot. Any ideas what is wrong, I don't have a manual


Answers :

Hi rebeccasolom,

OE means "Outlet Error"

The drain pump is either clogged or the outlet hose is kinked.
- Inspect the Drainage hose at the back for kinks.
- Open the unit, and at the bottom sump check the small drain pump area for any foreign object that may be obstructing it.

Kind Regards :-)

If you found this solution helpful, please rate it.
Repair Help & Product Troubleshooting for LG 24 in. LD-12BW5 Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My LG dishwasher is stopping after a few minutes into the wash cycle with an error message OE and making a sound. The dishwasher tablet is still inside the dispenser and while there is water in the unit it isn't hot. Any ideas what is wrong, I don't have a manual


Hi rebeccasolom,OE means "Outlet Error"The drain pump is either clogged or the outlet hose is kinked.- Inspect the Drainage hose at the back for kinks.- Open the unit, and at the bottom sump check the small drain p ... LG 24 in. LD-12BW5 Free-standing Dishwasher

I have a Bosch SHU53513UC/U12 dishwasher. My initial problem is that the washer smells bad after a cycle and I've noticed some water sitting in the bottom of the unit. After running a diagnostic test, it results in a "2" heating fault. I followed your advice and used a current coil to and attached it to the GYBK-a1-3 hot wire on the control board. After running the test again, it only gets as high as 1.15A and manual says it should reach 11A. What should I do next?


Hello,Welcome to FixYa. ... Dishwashers

I have purchased a Bosch dishwasher SMS50E22au. The manual instructions say cold water connection only yet there is also instructions for a hot water connection . We have solar hot water, and we are unclear as to whether we can connect to solar hot water.


... Bosch SMS69L 24 in. Built-in Dishwasher

I have an Asko DW1875 dishwasher (10yrs old) which has just recently started having problems. The initial symptom was that during a washing cycle, unit showed '1' and inside became very hot (melting some plastic cups/plates in unit). On further investigation (with diagnostic mode), the dishwasher is filling and draining with no problem. When circulation pump runs there is barely any water pressure in blades (just dribbles out) and water leaks into undertray via a plastic white tab near front (v


... Asko D1876 Dishwasher

Smeg e2 error (water level tripped). Filter is clean and no rubbish below filter on inside of dishwasher. I have taken the front panel off but am not sure where the float device is located - I am wondering if it is just to the left of what looks like a solenoid. There is no water in the base of the unit in the front panel so would rule out any leaks. Reset program and turned off power at socket but still not using hot water. Possible PCB issue ? Any advice appreciated. Smeg DI612C Dishwasher.


... Dishwashers

I have a Blanco Dishwasher Model BFDWC65X. It appears that the thermostat may be faulty as the water gets extremely hot on cycle 3 which is supposed to operate at 45 degrees centigrade. When I open the door mid-cycle, clouds of steam emerge and the whole dishwasher smells hot - almost a burning smell. I have found an online source for a replacement thermostat, but would like to know how difficult a job it will be to replace the thermostat. Also where can I find a manual that details where the th


... Dishwashers

Our Lamber GS900 underbench dishwasher machine did not fill the hot water anymore so we have to pour hot water manually until it reached the required level. It drains perfectly and work as it should be.


Check the float switch. If the float is stuck or the switch is jammed or broken, the d/w will not fill. ... Dishwashers

Dishwasher water isnt getting hot, Hot water heater in house is working fine.


Change the hot water elemeny\015\012Vitally ... GE Profile PDW8600J Built-in Dishwasher

I have a fridigaire dishwasher PLD4555RFC0. The dishwasher now only cleans poorly if at all. The detergant used is powder and the detergant has been the same since purchasing the unit 3 years ago. The detergant does not completely dissolve on some dishes and is now staining/etching the dishes. I do not have a water softener, however, have tried the flushing with vinegar multiple times with no improvemnt. The water appears to be very hot as steam emerges when opening the door during the cycl


Sounds like your water is too hot(etching) and maybe not enough water should be about level with heater . ... Frigidaire PLD4555RFC Dishwasher

Installed an older model dishwasher for a friend power works oes throuth the cycles but its not pumping water into the uniT there is no clogs and i hear the pump turn on. unsure why its not getting water into the unit another friend thinks its cause the air tube isnt hooked up but i think it may be something more then that any ideas


You will need to disassemble the bottom part where the bottom rotary spray nozzle is(the part that shoots water upwards). The impeller might have come loose or it is clogged in that area. ... Hotpoint Dishwashers

I have a bosch SPS5462GB/19 dishwasher but no manual. does it run off the cold water or hot water? where can i download a manual from?


... Dishwashers

Dishwasher fills with hot water. Float OK - water feed stops when full. Motor humms but no water spray (in all opperating modes). Cancel selection (with cancel button) and close the door. The water drains then the unit shuts off. Water feed OK. Drain Cycle OK. Looks like spray pump hung but do not know. Cannot find a reset button (as with disposal) or way to free hung pump motor. I did see glass pieces in the drain. Possibly a small piece hanging the motor.


If you found broken glass inside the machine some has likely migrated to the pump. about the only way to fix that issue is to remove the pump and either replace it or disassemble it and clean it out. ... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

Dishwasher does not start it seems there's no water coming in the tub. I got a trouble shooting manual from ejunkie.com and tested the coil of the water valve which read 1000 Ohms, which means it's OK. Then I hot wired the coil while connected to the water line and the valve opened and I had water flowing [ in a bucket] I have tried to start the test program [hold power scrub plus and regular switch at same time then start button] and lights start flashing you hear drain pump come in then the un


... Bosch SHV4803 Dishwasher

My Bosch SHY56A02 dishwasher won't fill....When cycle is started, it seems to pump water out but none in. Water feed is good....Added water manually and it pumps out immediately. Also, unit continues to run with door open...door switch is not jumpered. Could it be the fill valve? More likely the control module? Thanks for your help!


Hi,\015\012\015\012As water is filling in your dishwasher a float rises along with it. When the float reaches a predetermined level it shuts off the flow of water by activating a switch thereby preventing a leak. Sometimes the float can g ... Bosch Dishwashers

Kitchenaid dishwasher - small pieces of food are left on otherwise clean dishes. Water level comes to about 1 inch below heater coil. I ran it without dishes (or soap) and added about a quart of water so that level came to about 1/4 inch below heater and that's when I noticed food pieces on drain surfaces (nylon filter under bottom spray arm unit and circular plastic "trap" surrounding it). Spray arms holes are clear and water is hot.


It sounds as if you figured the solution out. The holes in the spray arm(s) get plugged by small debris, (tooth picks, seeds, bits of plastic like candy wrappers, etc) and the water does not reach the dishes to wash and rinse effective ... Dishwashers

I have an ADP6000IX Whirlpool dishwasher which is comming up with a Fault code Err4. The manual indicates overfilled and possible cause "too much inlet water", however there is no water sitting in base of machine, and have unloaded all dishes and Err4 still comes up. I have switched unit on and off at wall but has not re-set. I have disconnected water pipe from tap and reconnected.Is there anything further I can do?


Hi, \015\012\015\012You can solve this by cleaning and de-greasing the filter frame, basket and sensor Also there might be a low threshold for oils/greases/debris of any kind, so you have to rinse and load. By removing outflow tube ... Whirlpool Dishwashers

Water keeps coming into the dishwasher. Had to shut the hot water shut-off to stop the water from continuously filling the unit. How can I make repair myself.


Hello,Welcome to FixYa. ... Bosch 24 in. SHU53 Built-in Dishwasher

D1876 Asko dishwasher doesn't fill. It runs fine if I manually fill the unit with a couple of pitchers of water. Likely culprits seem to be a faulty water level sensor or water fill valve. Any suggestions on how to proceed with troubleshooting/repair?


Hello, Welcome to FixYa. Based on your description and provided the dishwasher is indeed 1) an Asko ... Asko D1876 Dishwasher

There are two hoses coming from my Bosch SHE45M06UC dishwasher. One is obviously the drain coming from the back of the unit, and the other is attached to the side looped and not connected to anything. I went online to the Bosch website for a installation manual and it describes this hose as a air venting hose. Does the end attach anywhere or does it just hang loose on the unit. My husband detached it from its original position and thought it was part of the water line. HELP!


Many people realize the dishwasher connects to a little hose on the sink, it is called an air gap. However, many people wonder " The air gap is there to prevent the water from being siphoned out of the dishwasher. When water flows through the drain ... Bosch Dishwashers

I have a kenmore ultra wash quietguard deluxe & notice it has been connected to the hot water supply. As I am making some changes I would prefer to connect the cold water supply will this make any difference to the operation of the dishwasher. The unit is less than 2 years old. Thank you


Depends... some units heat the water for you in which case it would not matter and would infact save you money over time. If your unit does not heat the water your going to want to leave it alone for better cleaning performance. Check your owners man ... Kenmore Dishwashers

Hello. I was given a dishwasher, whirlpool ADP 755. I've had it about a year and finally got it plumbed in yesterday, so excited! Not having ever had a dishwasher before, i'm uncertain what to do and i cant find a manual online. I tried putting some cups in it and running it on all the different settings on the dial but each time the cups are still dirty. The machine is steamy so looks like hot water is passing through, but its clicking through all the programs very quickly and leaving stuff dir


... Dishwashers

I have a Sears Kenmore Elite dishwasher Mod. # 665 - Ser.# FJ4805735 that intermittantly skips the wash cycle and pumps the hot water out just after filling. This unit was built in 2000 but the entire drive unit was replaced about 6 yrs. ago. If the problem lies in the electronics is it worth a do it yourself repair. I have an antique (1970'S) appliance repair background and electronics is not my forte. Money is tight and I would like to squeeeeeeeze another couple of years out of this appli


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012Would you be able to supply the complete model number. The Kenmore elite dishwashers where made by many different manufacturer's over the years, even within t ... Dishwashers

I removed an old dishwasher and replaced it with this GE 24" Profile GSD533ODO1WW unit. It seems to run through the cycles like it should but it doesn't seem to run any water for some reason. I hooked up a new water line to it and turned it on. There where no leaks that I could see. Is there any installation manual that you could send me to make sure that I didn't miss anything or is there anything that you can tell me that I should look for? Thanks, Jesse


... Dishwashers

Bosch dishwasher, Model SMU 7056, UC 09, FD 7309. My older unit has operated flawlessly for years. Two days ago it started to "stall" in one cycle and not progress to the next, e.g., stayed in the wash cycle and would not move on to rinse. In addition the heat generated in the machine was way below normal. A repairman told me that if the water doesn't get hot enough, the unit will not move on to the next cycle. I always use the "Regular Wash" option, but tried other options such as 'Economy


... Bosch Dishwashers

Dishwasher was cutting out intermittently,totally dead no power then after 15mins or so,finally went bang this am,smoke etc,took insection cover off at bottom swit6ched on again to see spark dead short on unknown unit with four wire block connector attatched,two white to same connector and two purple,left disconnected and workin fine,hot water,inlet and outlet both working fine so what does that unit do?


... Bosch 18 in. SRS43E02 Slim-Line Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2171 seconds