Having problems with your LG 24 in. LDS 5811 Built-in Dishwasher ?

Not cleaning on top rack. Pump, fill tube asm. & spray clean. Has any seen if this issue could be the deverter motor in the pump or the control board?

\015 LG DISHWASHER M#LDS5811WW, S#704KWNMOO431, NOT CLEANING GOOD ON TOP RACK. WASH PUMP ASM. WAS DISMANTLED FROM SPRAY ARM DOWN AND FOUND VERY LITTLE IN PUMP.CLEANED OUT. SPRAY ARM AND FILL TUNNEL ASM. GOING TO THE FILL ARM WAS ALSO CLEAR. STILL NOT CLEANING GOOD. NOT SURE IF PROBLEM IS POSSIBLY WITH THE DIVERTER MOTOR THAT SUPPLIES SPRAY ARM WITH WATER OR THE CONTROL NOT TELLING THE DIVERTER TO TURN AND ALLOW THE WATER TO GO INTO THE UPPER SPRAY ARM. DO YOU KNOW IF THESE UNITS HAVE THIS ISSUE SO THAT I DON'T HAVE TO UNINSTALL THE UNIT TO CHECK THE DIVERTER VALVE IN THE BOTTOM SIDE OF PUMP ASM.?\015

Answers :

Just to review, the LG dishwasher family, including the LDS5811 has the Verio motor and the check valve that diverts water from the bottom rack to the top rack.

If the valve is blocked/jammed, this would cause the symptom you describe. The valve is visible from inside the DW after you open it up.

It is also possible that this motor has failed.


Repair Help & Product Troubleshooting for LG 24 in. LDS 5811 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Not cleaning on top rack. Pump, fill tube asm. & spray clean. Has any seen if this issue could be the deverter motor in the pump or the control board?


Just to review, the LG dishwasher family, including the LDS5811 has the Verio motor and the check valve that diverts water from the bottom rack to the top rack. If the valve is blocked/jammed, this would cause the symptom you describe. T ... LG 24 in. LDS 5811 Built-in Dishwasher

Dishwasher will drain but not wash, is this a motor issue or control board. I guess my real question is does the pump motor, wash and drain as well???


Your dishwasher s probably clogged take apart an clean this happens to me all the time my wife thinks its a garbage diposal its not ... Whirlpool Dishwashers

Dishwasher won't drain; no problems with drain line. Could it be the control board, a relay or the the pump motor?


... Bosch SHX55M02UC Built-in Dishwasher

I have a Bosch SHE44C02UC/46 that will finish all of the cycle but leaves a couple inches of water in the bottom. If I pull out the dishwasher and manually active the drain pump float it will drain the remaining water out of the dishwasher. I heard about a cold solder joint on the main controller board but I am not sure if this could be the issue. Please advise wat advise you can. Thanks.


... Dishwashers

SMU50e32SK dishwasher showing E06 in display after a few seconds. Dishwasher has one Main Power PCB and one control unit PCB in the front. Info: Main PSU PCB has been shifted due to overvoltage. All sensor checked, seems to be ok after this has been shifted. I don't think the induction motor(big pump) has been affected due to the relays in front. Could it be the Control PCB in the front or maybe the small drain PUMP. Well some of you properly now what E06 is referring to on this model.


... Bosch Dishwashers

Continuous running I have taken on board solutions already published on the site re possible controll panel damage etc. But I would like to check that the waste water pump isn't blocked before dismantling the controll panel. Could you describe how to access the pump to check it out. Thanks Rogspeed


... Bosch 22 in. SKT5108 Free-standing Dishwasher

SMU50e32SK dishwasher showing E06 in display after a few seconds. Dishwasher has one Main Power PCB and one control unit PCB in the front. Info: Main PSU PCB has been shifted due to overvoltage. All sensor checked, seems to be ok after this has been shifted. I don't think the induction motor(big pump) has been affected due to the relays in front. Could it be the Control PCB in the front or maybe the small drain PUMP. Well some of you properly now what E06 is referring to on this model.


... Bosch 24 in. SMU40 Built-in Dishwasher

I have an older Maytag model #WU482. For some reason it will not drain and will only run using the economy mode. I can hear the timer ticking at all other cycles and it does click between cycles. I recently replaced the drain float and the machine had been working fine after. The motor is working and the belt is good. I think the kids were playing with the timer knob. Could this cause a problem with the timer motor? Or does this sound more like a pump out issue, impeller? I'm thinking its


First,inspect the drain float. Make sure it rides on the micro switch correctly or it will not take on water.Check the float micro switch for continuity. Check for power at the water valve when it calls for water. Remove the wire harness from the tim ... Maytag 24 in. PDB1420 Built-in Dishwasher

The start timer control cycles but nothing happens. The motor seems to gurgle while attempting to fill with water - but no water comes through. We have had this problem before and the repair person replaced the timer control board. Could this be the same problem reoccuring? I have also tapped and cleaned the water float as described by GE website.


I bought a new one and installed it myself. hardest part of installing was taking the old unit out. I compared the cost of a second repair of a 10 year old dishwasher vs. purchasing a new one. We also checked the pump and solenoid to find problems th ... GE Nautilus 24" Built-in Dishwasher

Kitchenaid dishwasher model KUDM01TJB0 Fills with water, heats water but pump dosent run in wash (dosent spray water) Drains water. Every thin appears to work but the pump in the wash mode. I checked the control board and it has no visable issue.


... KitchenAid 24 in. KUDM01TJ - Multiple Color Built-in Dishwasher

Asko 1875 had a new main board, wax motor and temp thermistor fitted 6 months ago. now thw machine pumps in the water but does not wash what could be the problem


Hello, welcome to FixYa. Based on your description and provided the dishwasher is indeed 1) an Asko 1875 and 2) filling with water, draining, heat ... Asko D1876 Dishwasher

I have a Neff dishwasher S6409N1GB/09 and for the last 3 months engineers have been out to fix it but it still does not work. They have fitted a new motor, new pump, new circuit board, new fill tube, new breather, can you advise what the problem could be, because the engineers have given up on it, help. Mr Dave Gallagher


... Neff Dishwashers

I have a Thermador dishwasher # dwhd650gfp with displayed error code 2, I verified oily residue on dishes and caked up grease on sump trap filter. This unit is 14 months old. I first reckognized that the dishes were not drying completely after cycle, then noticed the cold grease accumulation in drain area, then saw "E02" displayed on message board. I have read through some blogs that this issue could be a defective heater assembly, shorted or open circuit at the connection at the control pan


Hello,Welcome to FixYa. \015\012\015\012You would've been correct in your suspicion , of Bosch built dishwashers prior to this more recent revisions ... Dishwashers

Asko 1805 DW Circulation pump NF. What is the most common cause / fix. Is it the motor, impeller, capassitor or control board?


The pump motor can easly be tested by 1) Physically looking at the pump motor in the pump out mode. The motor must spin freely. The motor has 2 push on electrical connections that must have AC voltage across them in pump out mode. If voltage is prese ... Asko 24 in. 1805 Built-in Dishwasher

Hello, My Bosch she44c dishwasher is not evacuating the water from the machine. I checked the line and i can hear the motor trying to pump. I've tried to make sure the impeller was clean, so at this point i don't know what it could be. It has had the circuit board replaced due to recall.


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

WP DW Mod # GU1200XTLS0: this unit filled with water and just stopped running. I have power to the unit. The control panel does not light up at all. Its wierd that I have power to the board and all the wires seem to have power! No burnt spots and no burnt smell on the board.Hmmm! Door latch and switches all check ok. Oddly it seems like the line power to DW goes all the way thru the unit and back through the nutural wire. Could the motor windings be burnt out?


Hello , there should be a fuse located by or on the side of the board with 2 wires going to it , one from the latch and one from the board ,it does come off , use an ohm meter to check it , it should ohm out or have low resistance make sure to take t ... Whirlpool GU1200XTLS Stainless Steel Dishwasher

I have a Bosch SHU9925UC/14 and will not power on. Breaker is on and power to the unit. Could this be a control board gone bad or motor?


... Bosch SHU9925UC Built-in Dishwasher

PLD2560LCC1 Frigidaire Dishwasher...Control Panel shows 65 minutes left on lower rack, works for about 1 minute, shuts down. None of the buttons work. I changed the control (major circuit) board, same problem. I wonder if it's the control "panel"? I took that off and looked at it. Seems okay, but could the problem. I've heard this model has control problems, but I'm not sure if they mean the major control board or the control panel that has the buttons.


... Frigidaire 24 in. PLD2560LCC Energy Star® Built-in Dishwasher

Pld2560lcc1 Dishwasher...Control Panel shows 65 minutes left on lower rack, works for about 1 minute, shuts down. None of the buttons work. I changed the control (major circuit) board, same problem. I wonder if it's the control "panel"? I took that off and looked at it. Seems okay, but could the problem. I've heard this model has control problems, but I'm not sure if they mean the major control board or the control panel that has the buttons.


Pulled the touch pad, go after the middle third with a very small screw driver, cleaned the flex circut with contact cleaner\015\012\015\012powered up fine seems to be working again ... Frigidaire 24 in. PLD2560LCC Energy Star® Built-in Dishwasher

KitchenAid KUDC25CH Dishwasher Just installed a new control board, last week after some lengthy emails we decided it was probably the control board , control board in now in, as far as I know the dishwasher cycles thru all three of the small lite rinse buttons ad it may have finished completely, there wasno water in the bottom of the washer so all was pumped out and the dishs were dry......the large rinse button on the panel is blinking. I open and close the door but the light contiues to blink


The system does not allow me to view what other consultants have suggested to you about the problem with your dishwasher.\015\012\015\012Before you try anything else, get a Finish dishwasher cleaner kit from the supermarket and run the di ... Dishwashers

The Start button does not light up, yet the left side did light up for wash cycles. I'm guessing the PC Control board has some issue with touch button panel, as a faint high pitched shrill can be heard from the board after I took the door off and put my ear to the board. Also, over time the left side of the panel stopped lighting up too, so I through the circuit breaker. Can you advise which component it is. I'm guessing the faint high pitched shrill is the PC COntrol board attempting to communi


You have a faulty touch pad that will need to be replaced. Below is a \015\012link to a video you will want to download so you can see how to replace \015\012the touch pad.\015\012\015\012\015\012\015\012 ... Haier ESD400 Stainless Steel 24 in. Built-in Dishwasher

GE Mod # GSD22360Z04WW will not drain water. I manually pushed the solenoid down and the pump and motor seemed to run. No water pumped out of the hose that was disconnected from the garbage disposer. I have discovered that the plug for the disposer was not taken out where the dishwasher hose attached. The dish washer stopped working after a new disposer was installed. I rotated the control knob and at no time did the solenoid for the pump operate. It went back to normal position after control kn


... Dishwashers

Hello, I've been working on a Bosch Dishwasher. It has no display of any kind, and there's a strange grunting sound coming from the wash motor when power is applied (like if you had just plugged it in), as if it's trying to start. The junction box is getting 120V, all connections to the junction box are fine, and the display board and the main control board are all getting the proper voltage. Now, we've already replaced the main control board and the problem persists. The tech line suggested


... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher

My husky gcv 160 with a honda motor, has stopped pumping water. My brother said he went to use it and the motor wouldn't pull so he left it alone, i tried it and it pulled and started fine but the pumps not pumping and the relief valve( guess that's what it is) is spraying intermitingly, Could you please help, Thanks


... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

Kenmore 665.13823 dishwasher couldn't stop a washing cycle. It was identified as "control board" issue. Is it possible to fix the circuit board/timer insted of replacing the board? Also, where are the mayjor screws located to open the housing for the control board? Thanks


Hi,Unfortunately there is no way to repair circuit board or timer. The procedure to replace control panel is :-Step 1 Disconnect the power supply to the dishwasher by turning off the circuit breaker. The circuit br ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1169 seconds