Having problems with your LG 24 in. LDS 5811ST Stainless Steel Built-in Dishwasher ?

Unit does not power on...

\015 Had obtained used dishwasher a month ago. Now does not power on.. \015\012\015\012Starting to trouble shoot... basic ideas / list? \015\012\015

Answers :

Repair Help & Product Troubleshooting for LG 24 in. LDS 5811ST Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Samsung DMR77LHS dishwasher has lost power completely near the end of a cycle. About an inch of water remains. I have power to the unit. I checked the 15 amp fuse in the unit - it had blown. I replaced it, but still no luck. The fuse is not blowing, but there is no power to panel. Nothing happens when you hit the power button - no lights or anything. Unit acts as if ther is no power at all. I have seen similar posts. Any thoughts?


Hi, whenever a fuse of that magnitude, or any fuse really, Blows, you should never just replace it, as to have any device, blow a fuse, trip a breaker, requires a major fault, they do NOT blow spontaneously ever. So you have had a major short circu ... Samsung DMR77LHS Tall Tub Dishwasher

Opened door and unit did not have electrical power (lights did not come on either unit). Called serviceman. He stated there was no electricity to unit(s). Called electrican. He stated wiring to the dishwasher had power. Called serviceman again. He came out and dishwasher worked. He did nothing to it. I opened the door and the lights(buttons) came on. Unit worked for a few days and this morning, there was again, no power to the unit. What is likely wrong with this dishwasher?


... Fisher DD603B / DD603W / DD603H Dishwasher

WP DW Mod # GU1200XTLS0: this unit filled with water and just stopped running. I have power to the unit. The control panel does not light up at all. Its wierd that I have power to the board and all the wires seem to have power! No burnt spots and no burnt smell on the board.Hmmm! Door latch and switches all check ok. Oddly it seems like the line power to DW goes all the way thru the unit and back through the nutural wire. Could the motor windings be burnt out?


Hello , there should be a fuse located by or on the side of the board with 2 wires going to it , one from the latch and one from the board ,it does come off , use an ohm meter to check it , it should ohm out or have low resistance make sure to take t ... Whirlpool GU1200XTLS Stainless Steel Dishwasher

I have a Baumatic BDW 45.1 slimline dishwasher, the unit will power on but I cannot select a program. I was able to place the unit in to reset mode once by holding down 'P' and power cycling the unit. This then allowed me to choose a program and complete a full wash cycle. Now I cannot repeat this steps and the unit remains with just power light on. There are no Error codes displayed at all. Could this be a problem with the front panel?


... Baumatic 18 in. BDW45.1 Built-in Dishwasher

No power My dishwasher Model DMR77 quit working yesterday during a wash cycle. No power ie, no display light or tones. I am getting power to the unit, checked with a volt meter. I am thinking Power supply, or is there a reset on the unit.


Hi,\015\012 The main PSU is part of the control board. You may be lucky to find an aged fuse to replace, but it's more likely a power transistor that's fried.\015\012\015\012Unplug and remove the control board to see which bit's toa ... Samsung DMR77LHS Tall Tub Dishwasher

Kenmore elite mod 665/17059 diswasher. unit was runing last night sometime during this time unit shut off. now it has no power at all. checked breakers and unit has power to it. could this be control unit?


It appears your timer/main controller/CCU has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites bec ... Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher

Unit does not power up. checked power to unit ok checked power to latch switch - ok appears circuit board is bad. Traced 120v to board. Any other checks before getting new dishwasher?


Hi mgray770,\015\012It sound like you have done a good job already, but just a couple thoughts before you go buy a new one. If the board does nothing then it could be locked, check your owners manual or whirlpool.com for the exact unlock inst ... Whirlpool Dishwashers

I have a maytag dishwasher model MDB8600AWQ that suddenly stoped working, no power lights on panel. I have had multiple problems with this unit with a complete service approxinamtely 1 year ago and had no problems until there just seems like there is no power to the unit. It is used infrequently and has been wwll maintained. Is there an easy solution or should I just give up on this unit.


Please refer to the diagrams on this site. \015\012\015\012If the ... Maytag Dishwashers

Brand new haier hdc1804tw wont start. i press the power button unit beeps once and power light comes on but i cannot select cycles. unit will then beep every five minutes. i have made sure there's water and unit is level. i have left it unplugged for over five minutes with same resulting issue.


... Haier HDC1804TW Dishwasher

Have GE Monogram ZBD6880 dishwasher. Ran unit and unloaded. Went to use the next day, and none of the buttons to select and start will work- it is as if the unit has no power. I confirmed that there is power to the unit. Is there a way to reset, seems like it might be something simple.


... GE Monogram® ZBD6880NSS Stainless Steel Dishwasher

I have a Kenmore dishwasher Mod. 66513743 there is power to the unit - but the unit does not work (no lights, etc...) I have pressed the reset button, turned power off and back on to unit - but still nothing --- any ideas?


... Kenmore 13742 / 13744 / 13749 Built-in Dishwasher

Siemens SE25M851 randomly looses power. power to the unit is fine ie fuses ok and constant power. if i give the unit a bit of a jiggle it some times comes back to life. any suggestions?


It could be the lid switch. See if "jiggling" the door handle pin points the problem. The door switch normally sits behind the door handle.\015\012\015\012If so, it is either a faulty door switch, or more likely a brocken piece of plastic ... Siemens Dishwashers

AEG Favorit 45250Vi dishwasher. Following a power failure, the unit won't restart, although power is at the unit. No lights sgow. Is there a fuse or resettable trip in the unit? If so, there is it. (If not, why not!)


... AEG 21 in. Favorit 45250Vi Built-In Dishwasher

No power to unit, dishwasher model DU960PWKB1. Unit was running, then abrubtly stopped, leaving water in the tub, and no power to drain or run unit. All breakers good, no other signs of problem. Help!


HI, there are four problem spots that i recommend checking. these are the most common hot spots for a non responsive dishwasher. Check each area thoroughly to address this issue.1. No power to the dishwasherMake sure there's p ... Dishwashers

I have a kitchen aid dishwasher model kuds01dlsp3. The unit has no power. A repairman found that the power to the unit was fine and then said we needed a new circuit board. The charge would be approx 270. When I look at prices the whole assembly unit cost 179. wouldn't replacing the electronic component be much cheaper?


Hi\015\012\015\012\015\012\015\012\015\012\015\012Thanks for using FixYa. First\015\012thing is to verify that power is available at the power board of the\015\012dishwasher. Open the power board cover and check if the breaker is tr ... Whirlpool Dishwashers

There is power to the main circuit control board, but no power exiting. unit will not run. no power to display.


There is a possibility that it could be a thermal fuse located in series with the hot side wire. If you are able to find it, and own an ohm meter, find out if it is open. ... Dishwashers

The unit is a Maytag model MDB5601AWW which it has recently began to lose power at the touch pad. The electrical breaker has been checked to confirm normal voltage. Additional investigation suggests that the unit can be reset by (1) disconnecting the power at the breaker, (2) disconnecting and reconnecting the ribbon cable that interfaces the touchpad with the control board. However, the problem reoccurs after a few normal wash cycles.


It sounds to me then that the display board or touchpad needs replacing,you havn't said that it's not doing it's cycles.so it's not causing any washing or cycle problems.i would replace the display board. ... Dishwashers

I have a McCulloch FHH18A power washer. When plug it in without the water turned on, the pump will start. As soon as I turn the water on to the unit, the GFCI power cord trips. Water does flow through the unit as I have water at the wand nozzle when not plugged in. Any suggestions?


I would guess there is a leak somewhere inside the unit that is spraying water on some electrical component and causing a ground fault. ... McCulloch FHH18A Electric Pressure Washer

I have power to the unit but there are no lights on door when closed. Unit will not respond to any buttons and lock not on.I have opened up the door panel and have power to the door switch and then to the board.What is my next thing to check?


Ok so you have power going to the unit at the bottom if the unit is not under warranty? first are any LEDs operating at all when door is opened? if not you most likely have a control issue to test this you would remove the screws along both sides of ... KitchenAid 24 in. KUDI02IR Built-in Dishwasher

Kenmore Ultra Wash Model 665.15801891 (Serial FJ3403697). This is in the USA. Unit will not run. Two lights are lit on the display panel and do not go off - 'Drying' and the #2 on 'Delay Hours'.rn I have turned off the power at the breaker box hoping it would reset. Once power is turned back on the Lock light comes on. I can clear that by pressing 'No Heat Dry' for 4 seconds but then the 2 lights mentioned above come on and do not go off. Any suggestions? Can you tell how old the unit is by t


Plase confirm if your model has the same front panel as the one shown in this manual.\015\012In that case try this sequence to reset the dis ... Kenmore 15899 Built-in Dishwasher

Came home and dishwasher was stil running from the morning. Opened the door and all the lights on the control panel were lit up and unresponsive. cut power to unit for 1 min and now the controls don;t light or respond to anything . They are not locked and there is power to the unit any ideas ?


Hi\015\012\015\012\015\012Thanks for using FixYa. From what you have described it seems that the control panel has gone bad and needs to be replaced however, if you want more information then please do revert with the manufac ... Dishwashers

My Asko D3232 will not turn on. No power light will work and I've checked breaker and outlet for power (which are okay). Any ideas. Unit is 3 years and 2 months old. Is there any reset switch on the unit?


... Asko 24 in. D3250 Built-in Dishwasher

Kenmore 13599K600 stopped working. Panel board doesn't respond - no lights, no response. Power getting to unit... checked at hard wire ends behind kick plate panel and power is reaching the unit.


Had the same issue and had to replace both the board and the fuse. Six months later, same issue again. It might be when the "Sani Rinse" is used as it dies at the end with some water left but the water is very clean. Possible defect? ... Kenmore 13599 / 13594 / 13592 Built-in Dishwasher

Maytag MDBtt60awb will not start. Power definitely at dishwasher as panel lights are on, however "start" button does nothing. Dishwasher is less than 2 years old. The panel buttons eventually turn off. I've cycled the power to the unit with no response. The door is definitely latched. Unit ran fine a few days ago.


Most likely you have a bad motor when replacing the motor ihave found it is cheaper to get the pump with the motor attached where as they charge you more money for just the motor or the pump seprately try allbrands appliance parts they seem to be che ... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

No power unit went dead checked power to base of unit ok also shut off breaker for 10 minutes to see if it will reset, no luck. Also removed inner door panel to reveal circut board to look for a reset or small fuse, none evident.


... General Electric GLD5960NSS Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0727 seconds