Having problems with your LG Dishwashers ?

I believe there are counter weights on the main door that allow you to open the door a few inches. Mine will only open the the full [down] open position. What typically goes wrong and how do I fix it? Also there is a streak of sopa leading from the rinse aid fill location. Where do I look to find parts. One of the plastic spacers on the handle broke.


Answers :

Most of my exprience has been that there is a pully/spring arrangement for the door tension. You'll have to pull your D/W out far enough to see and adjust.
\015\012Regards, --W/D--
Repair Help & Product Troubleshooting for LG Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I believe there are counter weights on the main door that allow you to open the door a few inches. Mine will only open the the full [down] open position. What typically goes wrong and how do I fix it? Also there is a streak of sopa leading from the rinse aid fill location. Where do I look to find parts. One of the plastic spacers on the handle broke.


Most of my exprience has been that there is a pully/spring arrangement for the door tension. You'll have to pull your D/W out far enough to see and adjust.\015\012Regards, --W/D-- ... LG Dishwashers

Rinse Aid was filled with detergent one day. Now it's not working properly - we tried to rinse it out with water and it's now filled with "jet dry" but the door fails to open during the cycle.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Please follow the step-by-step procedure to resolve the\015\012is ... Miele Dishwashers

Hi, My dishwasher keeps stopping mid cycle and the door pops open. The soapy water is always gathered in the bottom and there's no way for me to get rid of the water, unless i restart the full cycle. The dishes are all getting stained with white marks, even though the salt and rinse aid is filled. Please help!


Sounds like the latch is worn out you mabe able to get a new one at appliancezone.com.... also check the drain for debris ... Baumatic 23 in. BDW9 Built-in Dishwasher

Strange behaviour! Hi. Our machine has been unused and plumbed in since we moved into the property (18mths ago) and not required its services until recently. After filling with appropriate rinse aid, salt etc.. We choose the appropriate cycle [1. Intensive or 2. Normal], turn on and after approx. 10 seconds the cycle stalls and we hear a continuous ticking sound..!?  We open the door and everything is bone dry! Has any body experienced the same problem? Many thanks


I think it has to do with a faulty program disc. it can't switch to the next program phase. try turning it a bit. ... Indesit 24 in. D61 Free-standing Dishwasher

I have a Kenmore Ultra Wash built-in Diswasher. The flap on the detergent door does not open as it should during wash cycle. Also, I thought the rinse aid was empty so I went to fill it and its obvious that it has not been dispensing either. Otherwise the dishwaser seems to work ok, but we have hard water & I've tried everything and still have residue on dishes.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. First of all please check the\015\012Water temperature by using a thermometer inside the dishwasher to measure ... Kenmore PRO 24 in BuiltIn Dishwasher with Ultra Wash HE Filtration 13173

Hello, I have a Kitchen Aid (model # KUDMO1T JWHO) dishwasher that runs the motor in all cycles, with water fill & drain working fine, but the pump is not pumping water during any cycle, as the spinners and the inside of the washer are dry when I open the door, except for the water sitting in the bottom. Also, no normal swishing sound of water when the motor runs in any cycle. Looks to me like a mechanical break in the pump drive. How do I check the pump drive on this model? Do you have any


... KitchenAid Dishwashers

Bosch Shu43C02UC dishwasher fills with water but the washing won't start. As the filling nears complete, a double clicking noise occurs to start the washing motor but nothing happens. The time continues to countdown but the machine is silent. When I open and close the door, the click click noise is heard but the machine is silent. I can cancel the cycle and drain the water but none of the washing or rinse cycles will activate but the timer works. The soap door even opens if the timer is left to


Have you checked the inlet water temperature is at the correct level for the dishwasher.\015\012\015\012Please provide the full model no. of your dishwasher -- Shu43C02UC /??\015\012\015\012I think the problem is linked to th ... Bosch 24 in. SHU43 Built-in Dishwasher

Bosch SHY66C05: interlock broken, dishwasher rinse-aid leaks, and soap does not open (sometimes)


Don't know what you did with the spring but it only needs replacing if it is broken ... Dishwashers

The dishwasher detergent is not dissolving. There is rinse aid in the dispenser - sometimes the door opens and the detergent comes out and sometimes it doesn't. If the detergent does come out then it is just sitting in the rack - should it drop to the bottom of the dishwasher? I have checked the door cleaned out around it to make sure the hook and release are working. I opened the door and the water is hot.


... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

The Rinsing aid door keeps opening in my Bosch dishwaser


I believe paddy55 is correct about the rack position affecting the rinse agent door. When the top rack is moved to the higher position, the rack hits the latch on the rinse agent door, causing it to pop open.Move the rack back to the low ... Dishwashers

My Kenwood dishwasher KDW24FI/B has worked fine for approx 2 years. But now when I put my dishwasher on, the cycle never seems to end. After a few hours of running I opened the door to find the tablet hadn't dissolved but lots of steam coming out. I tried 2 more times and the same thing happened. The pump is working and everything seems ok. After reading the manual I have noticed the salt and rinse aid lights are iluminated. I have never put salt or rinse aid in since I had the dishwasher so thi


Lol is it a stereo or a kenmore, dishwashers dont use salt, but water softeners do ... Dishwashers

The some dispenser and the rinse aid dispenser seem to be "stuck", soap door doesnt open and dishes appear streaky from no rinse aid. this happened after I cleaned the deposits from under the screen in the bottom of the dishwasher. how do I clean the dispensers?


There is a solenoid which pops open the soap lid after the initial rinse.\015\012\015\012If the solenoid or soap lid latch is faulty, you will need to replace it. In the interim just poar your soap in the bottom of the dishwasher tray bef ... Bosch Dishwashers

Drying problem Hi Our 3-day old LG dishwasher is not able to dry our dishes. After the cycle is finished 2 hours later, I open the door to find that water is everywhere. As if the washer is skipping the dry sequence completely. The "vent" on the inside of the door doesn't seem to have an outlet--why is this a vent if nothing can escape? The owner's manual says to use a rinse aid to help drying. I don't believe in using band-aid's; something else is wrong. Any help/advice is appreciated. Thanks,


Hi,\015\012\015\012As I had the same problem, I worked on my machine and found out the heater unit was not working (it is a brand new machine ! - remark : as I moved overseas, LG did not cover it with their warranty).\015\012\015\012But b ... LG LDF6810ST Stainless Steel Built-in Dishwasher

I have a GE dishwasher (purchased in1992) the door falls open I suspect a broken spring. I looked all over the door hinge and cannot locate a spring(s). Where are they located. Also because of the age would I be better off to just replace the washer?


... Maytag Dishwasher

Quit working during wash cycle, about 6 liters of water left in bottom, looks like it quit during rinse cycle. There is power to the door switch and door switch works shutting off power when door is opened. However the control panel does not respond to any push button. I have had a problem in the past with moisture from the door vent getting into the control panel area causing the push buttons to become eratic.


The capacitors in the control panel could be bad or have burnt out. Do check all connnections and if necessary, check the continuity of the power to and from the control panel with an ohm/voltmeter. ... Dishwashers

Cloudy dishes dishes and glasses come out with white cloudy film like they are not rinsing........jet dry compartment won;t fill up with the liquid ....... soap door is broken. can still use it we just start the washer with the door mostly open.


New product designed for this problem. Free samples available!CloudyDishes.com ... Bosch Dishwashers

I have a 1999 bosch SHU 4300 dishwasher given to me. It worked great for about two weeks. Now it takes for ever *3-4 hours* to complete a cycle (if it does). I have opened the door to see it filled with sudsy soap after this long. I have checked the hoses and they are not kinked. Once the cycle of cleaning is over, If I reset it manually, it will rinse the dishes and empty just fine. But I have to manually get the dishwasher to advance to the rinse and dry cycle every time now.


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a GE Triton XL dishwasher and the rinse aid dispenser in the door won't allow rinse agent to go in and fill it. It is 4 years old. Thanks!


... Dishwashers

I have white crusties with black spots in all along the seal on inside of door, and along filter on top left side of door (inside). and also i use jet dry and my glasses and dishes are coming out cloudy looking. also i have to fill the rinse agent every wash instead of monthly. Is there any special cleaning that needs to be done to this?


Problem is your water. that is from the calcium in the water. go to www.dishwasherfilter.com and get the filter system . it will make your dishes sparkle and help clean out ... Whirlpool GU2400XTP Built-in Dishwasher

Do4esnt clean My Bosch SHX33a05 dishwasher has a problem. It fills and drains well but nothing gets clean. It appears as if the arms are not rotating but the inside is wet when I look inside. I have put a bit on catsup on the inside door and even that is on at the end of the cycle. I have opend and clodes the door multiple times during the cycle and bot arms appear to not be rotating. Nothing is blocking them. I have clean the microfilter, the drain screen and open up the impeller to make sure t


... Integra SHX33 Dishwasher

Hi I have a problem with my Bosch SHU43CO6UC/22 dishwasher. using "power scrub plus" and "regular" cycles it will continue to fill and overflow the door, after the cycle has run even when the power button is off. I am using the quick wash cycle at the moment .After the cycle has run i open and check if the water has drained or not,If it has it does not continue to fill and flood.If there is water in the bottom after the cycle has finished it will keep rising untill I push the rinse hold button


The bosch dishwashers use a fill valve that is attatched to the inlet hose. yours is stuck in the open position. this usually happens when you have hard water, as the minerals build up on the sealing surface of the water valve. there is no easy ... Dishwashers

AEG Diswasher Model / Favorit 44080IM PNC 911925601/01 (located in UK) Wash cycle finish light flashes 5 times in sequence then starts again - please advise the meaning of this error signal ? History Machine started running immediately door was closed before any programme selected filled with water and main was motor runs and circulates water Water is not heated and detergent door has not opened Machine will continue to circuluate water until turned off If reset used then


1 blink is machine is having major power supply problem.the power supply board needs replacement.\015\012-----------\015\0122 blink is CCU error.that control board problem.\015\012-----------------\015\0123 blink is the CT error.that is ... Dishwashers

My dishwasher, a Whirlpool DWF B10, is not cleaning properly. When the cycle has finished, there is always a block of undissolved dishwasher tablet/powder left behind. My guess is that the seal to the powder door has gone and allowing the tablet to get wet too early and part dissolve before the door opens - is this likely to be right? If so, can I get a replacement seal or do I have to replace the whole powder & rinse aid containers ??


... Whirlpool Dishwashers

The tablet is still still in the door when the cycle has finished. It is wet and part disolved and the litle door has opened. I have checked the rinse aid and salt and cleaned the spray arms but they were clear. I always check nothing is in the way of the arms spinning. Any suggestons?


It actually sounds like maybe the packet is getting partially melted to the inside. Have you tried washing with no heat at all? Or maybe change brands on detergent packets. The main thing is your door is actually opening all the way, if so, then the ... Bosch Dishwashers

Model KUDI24SEWH2 - the dishwasher was operating, I opened the door to add another dish. When I closed the door, there was a small click and nothing happened. The lights indicated to me there was rinsing and drying going on, but in reality, nothing happened.rn We were told it might be the thermal fuse, but have just check that and it is fine. It will fill, just not pump or drain. Any help?


... KitchenAid Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1550 seconds