Having problems with your LG Dishwashers ?

"LE" flashes after about 2 minutes

\015 It only runs for about 2 minutes then does the chime and blinks "LE". I turn it on and then press "normal". It starts (I think) but then after 1-2 minutes chimes a few times and blinks "LE" and stops working. I don't think the soap dispenser even opened but it was already starting to get a little steamy. I THINK the problem started yesterday when I THINK I opened it to unload it but the lights were still on as if it hadn't totally finished drying.....? I'm not sure though.\015

Answers :

Le means locked motor disassemble the filter and work your way down to the macerator(steel chopper blade) remove it and see if the side labeled "this side up" is really up, its in english... dont think the chinese labourers paid attention to the warning cause i have seen alot that were wrong way

if it was installed correctly order the complete motor/sump assembly btw you do know LG d/w came with a 2 year warranty right? and some of the water distribution system had a longer limited warranty
read your manual, it states warranty, then price the part, then call warranty depot to ask them their service call and labour to install motor/sump
\015\012
\015\012If you dont feel comfortable doing this call a techinician out ASAP,
Repair Help & Product Troubleshooting for LG Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dishwasher is flashing the clean green light, however it shows it has 2 minutes remaining from previous cycle, i have let that 2 minutes run throught, but it then show up again as 2 minutes left, but still flashing clean, and i can not cancel to staret new wash cycle


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the clean light flashes 7 times, pauses, and then repeats. When\015\012the dishwasher doesn't sense a ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Miele Optima G 2430 - The dishwasher will pump water in for 5 seconds with the Intake/Drain light flashing 5 times. Then the light stays on for 5 seconds and it does nothing. This process is repeated for about 10 minutes untill the washer is filled to the just below the door with water. Then the washer starts running for about 1 1/2 minutes and drains the water. Then it all starts over. If I let it do this for a hour - The display reads F12 with the Intake/Drain light flashing.


Hi\015\012\015\012The first thing that should be checked is if its draining\015\012properly as it could be that the drain hose is clogged and needs to be cleaned.\015\012The drain pump also should not be clogged. ... Miele 23 in. Novotronic G841 Built-In Dishwasher

Dishwasher cycle starts briefly for a couple of minutes and then stops again and the standard wash and eco wash programme lights are then flashing together? It appears that water is drawn into the appliance for a short time and it then seems to start and empty itself before the above lights start to flash, all within 3-4 minutes?


... Hotpoint 23 in. BFV62 Built-in Dishwasher

My Whirlpool dishwasher ADP 5340 stops after 5-10 minutes, Start button flashes 8 times. After I press it works for about a minute and starts flashing again


... Whirlpool 24 in. ADP5966 Free-standing Dishwasher

I have a KUDS25 dishwasher and the child lock is flashing. I have held down the "Energy Saver" button for the 4+ seconds and it still flashes. I have tripped the breaker for minutes, only to have it restart flashing. It ran perfectly until this issue yesterday. HELP!! It will not operate with this light flashing.


... KitchenAid 24 in. KUDS25 Built-in Dishwasher

My dishwasher AEG Electrolux Favorit 40660 stops after a few minutes, the program led is flashing and the end of cycle led is flashing about every 4 seconds.


... Dishwashers

Dishwasher Fault Hi, My dishwasher is a Diplomat ADP8322 (which i think is a rebadged whirlpool unit) & has been playing up recently. When you start a cycle it is fine for a minute or so then it starts beeping, the rinse light comes on & the light next to the start button flashes 11 times, pauses then repeats. I have read online that this flashing relates to what the fault is, but i cannot find out what fault the 11 flashes relate to. The first time this happened i cleaned out all of the filters


... Dishwashers

Our dishwasher starts at 96 minutes, counts down to 91 minutes, and then keeps clicking and flashing, and won't run.


Hello there:\015\012\015\012 \015\012 The cycle doesn't complete\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012\015\012\011\015\012 \015\012 \01 ... Maytag Dishwashers

The dishwasher is flashing error 20. The wash cycle begins to work but after a few minutes the wash cycle will stop and the light flashes on the program selected. We have tried turning the dishwasher off from the switch to no avail. Please advise us on what we can do to fix this.


... AEG 24 in. Favorit 3A Free-standing Dishwasher

I HAVE A BAUMATIC D/WASHER BHD5 TYPE DW-24E1,(ABOUT 8 YEARS OLD) IT IS A WHILE SINCE LAST USED THEN 1 NIGHT AS IF IT HAD STARTED BY IT'SELF IT STARTED MAKING A BEEPING NOISE ALL 4 INDICATING LIGHTS AS WELL AS SALT AND RINSE AID WERE FLASHING HAVE SINCE TOPPED UP SALT AND RINSE AID BUT ROUGHLY 1 MINUTE AFTER STARTING IT BEGINS TO BEEP AND ALL LIGHTS FLASH. COULD YOU TELL ME THE PROBLEM. MANY THANKS


... Baumatic Dishwashers

DISHWASHER STOPPING I HAVE A WHIRLPOOL ADG 7560/01 DISHWASHER. AFTER 4-5 MINUTES IT STOPS AND HAS A CONTINUOUS BEEPING AND THE START LIGHT FLASHES 4 TIMES THEN A PAUSE etc. I HAVE CLEANED THE FILTER LIFTED THE MESH AND CLEANED THE BOWL OF ANY DEBRIS AND WATER. I HAVE ISOLATED IT FROM THE ELECTRIC SOURCE LEFT IT FOR 10 MINUTES AND STARTED IT AGAIN TO FIND IT DOES THE SAME . LOST IS THE WORD THAT SPRING TO MIND. HELP!! MARTIN


... Dishwashers

The machine carries out the wash cyle (eco setting)Machine then stops with lights 2 and 4 flashing. Contents very hot with steam. Cycle not finished. Can stop flashing by switching off for a minute.


Sorry to hear that you are having problems with your Indesit Dishwasher.This is a "common" issue that is easily fixed. The lights 2 & 4 flashing means "Unable to reach temperature to dry". So, what happen here is your DW is trying t ... Dishwashers

Dishwasher won't start. Clean light keeps flashing. I have tried cancelling a couple of times, and it goes through a 2 minute process and goes right back to the flashing clean light and not allowing it to start. I have already tried shutting off the breaker as suggested by someone but it did not solve the problem. Any other ideas?


Hi\015\012 \015\012Thanks for using FixYa. If the clean light flashes 7 times, pauses, then repeats...When the dishwasher doesn't sense a water temperature increase, it stops working and locks t ... Dishwashers

Fast flashing dishwasher starts ok, then stops after a few minutes with the ''fast'' light flashing. It does not matter what cycle its on, the same result occurs.


The outlet pump could be triggered because the "anti flood device" polystireen float and micro switch at the base of the washer has detected a water leak from a leaky hose or water spil) This device automatically puts the pump out motor on and stops ... Dishwashers

My Dishlex global 300's rinse light is flashing after 5 mins use. About 2 inches of water stays at the bottom of the washer. Bought this second hand and it has not been used for a few months. Do I need to fill the reservoir under the washer or lean it at 45 degrees to dislodge anything in the sump. If you have had the problem of the washer starting its program and then stopping after 5 minutes and the rinse light flashing I would appreciate your advice. Cheers Hyph


The flashing rinse light is an error code. I am assuming that your control board is good because the lights are working. I'm also assuming that this model has two pumps. One for filling and one for draining. The rinse light flashing is probably i ... Dishwashers

Normal Wash, Heated Dry, Hot Wash, and Hot Start lights all flash. Dishwasher will not do anything except beep every couple of minutes with these lights flashing.


... GE Dishwashers

I have the double drawer dishwasher. It is 3 years old. For about 1 year now one of the programmes - the second one along which is for quite dirty crockery and cutlery (programme is about 99 minutes) - STOPS after about 60 minutes. It bleeps and flashes and the pot wash programme and eco button are on when I open the drawer. Sometimes the programme works right through. No pattern or consistency. Also the dishwasher isn't cleaning terribly well. I've checked the filters as much as I can an


A few things you could do.\015\012\015\012Is this happening with both drawers.\015\012\015\012Take a clean damp cloth and wipe the switches and the inside panel.\015\012\015\012Get a couple of Finish dishwasher cle ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

WHIRLPOOL DWF A10 LIGHT FLASHING WHEN START BUTTON PRESSED MAKES NOISE FOR A COUPLE OF MINUTES THEN STOPS LIGHT FLASHES 4 TIMES


... Whirlpool Dishwashers

My kitchenaid dishwasher model kudpo2frsso built in lights are flashing normal and cancel I shut off the breaker for 20 minutes pressed Normal heat dry X2 Then cancel x2 but to no avail. Any suggestions its the day before Thanksgiving HelpI T The Normal and Cancel lights are flashing simutanuously and the dishwasher is not working at all


... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

Have a frigidaire dishwasher (model- PLD4375RFC0)about 2 years old. Set to run as we left to go out of town- when we came back all lights flashing including error- found a child's plastic bowl that had fallen to the bottom and had a melted spot as it was next to the heating element. Called support and were told to master restart- shut the power off for 15 minutes. Did and now flashing "27". Cannot find a code for that and neither could support without sending out a repairman. Any advice before


... Frigidaire Dishwashers

My whirlpool ADP 4601 works for 10 minutes then stops and flashes aseries of 4 flashes repetedly


... Whirlpool Dishwashers

Allan Dishwasher won't start. Clean light keeps flashing. I have tried cancelling a couple of times, and it goes through a 2 minute process and goes right back to the flashing clean light and not allowing it to start.


Turn off the power at the breaker to the DW and wait 15 seconds and then turn it back on and see if problem is fixed. Reboots the controller. ... Dishwashers

I have a Kenmore Elite Ultra Dishwasher and the cleaning light is flashing. I have tried pressing the start/resume button and closing the door within 3 seconds. I am not able to turn on my dishwasher. I have tried turning off the power for 20 minutes but when power was restored the green light continues to flash and the dishwasher will not work. This machine was installed in May 2008. Help!


If the clean light flashes 7 times, pauses, then repeats...When\015\012the dishwasher doesn't sense a water temperature increase, it will\015\012stop working and lock the functions (clean light flashes 7 times, all\015\012buttons are non ... Dishwashers

My bosch dishwasher, one month old, has the active light flashing and the reset button won't reset it when I push it. A friend that was over opened the door when it was running because she can with hers, but ever since then, I had to take the water out and the active light is flashing and the wash light is lite. I hold the reset button for 5 seconds and then I shut it off for about 5 minutes, but when I turn it back on, the same things are happening


It sounds like the float is stuck. There is a float that stops the water from coming out when you open the door. It sounds like your friend stoped it in mid cycle and it jammed in the open position. Look on the inside of the machine for a plastic pie ... Bosch Dishwashers

Hotpoint BC145 Dishwasher not cleaning starts to kick in but then just sticks on the "R" light flashing and cannot reset even after turning off. Itbeeps when pressing the select button sound weaker and shorter than they used to and the light does not move from the "R". On a couple of times I have tried it has reset and then the dishwasher starts but after about 3 minutes there is a low beep(not the usual beep when a programme finishes) and the washer stops and the light is flashing on the "R" ag


... Hotpoint 18 in. BCI45 Slim-Line Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0701 seconds