Having problems with your LG Dishwashers ?

What is the rating on a LG 6920 2009 dishwasher?


Answers :

Hi,\015\012
\015\012As per LG it is marked as 5 star. But as per User , it is not as good as other dishwashers. It has been given a low rating of 2.5. ( Overall ).\015\012
\015\012Reasons \015\012
\015\0121. Normal cycle lasts 2 hours & power scrub adds more time w/o much more power.\015\0122. Sets too low\015\0123. Flatware trays are a horrible design\015\0124. S spray jets are too close.\015\012
\015\012Overall an average dishwasher at an overpriced rate.\015\012
\015\012Hope i helped you.\015\012
\015\012Thanks for using ' Fixya ' and have a nice day!!
Repair Help & Product Troubleshooting for LG Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

Miele dishwasher optima G 2420. during instalation and test for water hardness display shows 'P' then '1' then '0'. is this a water hardness of '1' or of '10'


... Miele Optima G2470SCSF Dishwasher

My kleenmaid dishwasher super silent model system DW5 doesnt appear to be heating the water on any cycle so it is not washing properly and leaving the powder etc on the glasses up the top particularly and also it does not go completely to the end of the cycle by itself(any cycle).Or completing the drying cycle. I have to switch to 0 cycle to make it complete the clicking to start again. What is the gauge on the inside of the dishwasher on the left that can be adjusted from 1-5 is this a heat


Http://frigidaireservicetips.com/pdfs/486_5.pdf\015\012\015\012\015\012\015\012Service manual, generic, use this to troubleshoot and repair.\015\012\015\012 ... Dishwashers

I am looking at buying two different ( I think) GE Dishwashers. 1 The "GDWT260R10SS" which in the Sears site says its Energy Guide rating is 280 or the GDWT260RSS which the GE site says 384 kWh. ARe these the same units and if so why the different model numbers and energy ratings?


... Dishwashers

Bosch dishwasher SGS45EO2GB/45 does not complete washing cycle. It stays at 1 min left with pump running. I have reset the machine twice at which stage the pump empties the machine and the display shows 0 mins. However, have tried it agin and same problem. Any ideas, please?


... Dishwashers

Poor cleaning Hi, This dishwasher is 1 year old and, until recently, has been cleaning well. Now, the dishes come out spotted and bits of food remain. Wash arms rotate freely. I have tried both liquid and powdered soap. Unit sounds like it is running normally. Water is hot and of normal flow rate. Are there any strainers to clean? Any other suggestions.


The problem is hard water. www.dishwasherfilter.com has a\012product to solve this problem once and for all. It filters the water going into\012your dishwasher and remov ... Whirlpool 24 in. GU3200XTP Built-in Dishwasher

I have a Bosh Logic dishwasher SGS65L12GB/04 The other day it got to 1 min left and would not stop pumping out water and continued even with the door open. After 5 mins playing around it started working again for a further 2 washes. Now when switched on the pump for pumping out the water works continuously. Reset it time seem to count down but does not do anything reset time goes to 0 and beeps but still the pump runs even with the door open. all buttons seem to work fine but no washing and pu


Hi Jonathan,\015\012\015\012Welcome to FixYa.\015\012\015\012Your float may have got stuck or it's possible that you have water leaking into the bottom of the washer. In the bottom of the wash compartment, next to the drain yo ... Bosch Dishwashers

Bosch auto 3 in 1 dishwasher not running full cycle. When the programme starts, water starts to fill then stops and water drains as the timer goes back to 0.


... Bosch Dishwashers

My garbage disposal badger 1 was just replaced with the same badger 1 disposal. my dishwasher will not drain water anymore. the old one had a hole where the attachment to the dishwasher hose goes but ther isnt one for the new 1 but the hook up is there. Do i have to drill a hole in the new 1 for the water to drain out


I THINK NO :\015\012 THE DRAN PATH MAYBE BLOCKED\015\012 ALL YOU DO 1ST TO SURE THE PLUMPING IS OK OUT SIDE THE M/C\015\012 THEN IF IS OK BE SURE FILTERS INSIDE M/C AFTER YOU OPEN THE DOOR OF M/C PERIODICLY CLEAN AFTER E ... Dishwashers

Replaced control board 447325 in bosch SHU66C05UC/23; FD860300407. What code to select 0,1,2,3,4?


... Dishwashers

Bosch Dishwasher My 8 year old Bosch is not draining. It will not go past 1 minute on the rinse cycle, and 13 minutes on the regular cycle. For the past few weeks I have noticed a lot of bubbles in the bottom of the dishwasher after it is done, but it was draining. Now it's full of water and will not go past the 1 minute mark. I need to fix this, I can fix this, I just need some expert advise on how to do this myself. Thanks!


What is the model #?... there are 2 buttons when pushed together it will drain the water out..try the button to the left next to power scrub... and economy...hold the 2 buttons for 3 sec. you will hear you drain pump running.. if you don't hear any ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a Kenmore Elite Dishwasher Model 665.13773K600. It seems to have no power to the touch pad (top) control panel. I have already checked the circuit breaker and the power to the dishwasher. A friend said that it may perhaps be the thermo fuse cut out that needs to be replaced. 1) Is this true? 2) How can I remove the 1" thick control panel touch pad after removing the six screws- it seems to be stuck, and I don't want to break the plastic touchpad.


... Kenmore Dishwashers

Bosch dishwasher shu4322 has code 1 aqua sensor what is the sensor do and where is it located


Most of the dishwasher has a Thermal hold period in which the machine will not advance to the next cycle until the water temperature reaches a specific degree. it is possible that your aqwa sensor/or heater is bad OR as in most of the cases, the Time ... Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher

Hi! My Bosch dishwasher (SHE46C02UC/22) will not shut off. The display says "1" - like there is 1 minute left, but it will not stop. Yesterday morning I started the dishwasher at 7:30am and at 11:30am I realized that it was still running. I opened it and it still had soapy water on the dishes and had not cleaned the dishes well. Any ideas?


... Dishwashers

Dishwasher runs the wash cycle from 84 min to 1 minute. Then continues to run at 1 minute and does not finish the cycle. When reset is performed, the dishwasher empties.


Hi\015\012\015\012\015\012\015\012\015\012The main reason for the cycle not to go through properly or rather taking a longer time is due to the temperature of the water. Make sure that the water level should not cover the ele ... Bosch SHU5315UC Dishwasher

I have F&P DD603 with problem with bottom draw. Once a programme is selected and door is closed, the dishwasher beeps three times then tries to start itys cycle. It then starts but stops every 1-2 minutes (like pause botton has been pressed). If you press start again it starts for 1-2 mins then stops again. I have tried turning off the power and totally cleaned out the dishwasher but no change? Any suggestions?


Hi \015\012When you pull out the drawer, pay attention to the bottom near the bottom front panel, you will see a little tab. this tab is at both sides of the drawer, press these tabs in and pull the drawer fur ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Hi I have a LG LD-2052 dishwasher. It gives me an E 0 error - the water does not pump out when I open the machine after a few minutes when started to wash and message of E 0 appears? Have cleaned an


... LG Dishwashers

I have a 7 yr old GE Tritron XL dishwasher that I rarely use. Last time I used it was almost 2 months ago. A week ago I noticed a horrible rotting stench coming from the inside. I poured 1 cup of vinegar in the base and let it sit overnight. Next morning I ran the dishwasher with detergent but no dishes. Odor still there. Checked bottom of dishwasher for food - nothing there (I prewash dishes before putting them into dishwasher). Added 2 cups of vinegar, ran dishwasher on hottest setting. Sti


... Tappan MDB531RF Dishwasher

My 1 yr old GE dishwasher model # GLD4900P00WW lost power during the drying cycle & blew the rest of the circuit. An electrician has fixed the rest of the circuit & rewired the dishwasher to it's own switch in the breaker box. The dishwasher still has no power. Is there a fuse somewhere in the dishwasher that could've blown? If so, how do I locate it?


... GE Dishwashers

I have a SHU3032UC BOSH Dishwasher for a couple of years now. Always worked as expected. Latetly, the dishwasher never stops. It looks stuck on an "unknown cycle"... The cycle dial stays at the "bottom" cycle (there's nothing written). If I turn it 1-2 "clicks", the dishwasher continues its work and ultimatly finishes with very good cleaning results. Once, I open the dishwasher when it was stuck in the "bottom" position, and there was hot watter at the bottom. Here's what I've tried so


Hello, welcome to FixYa.\015\012\015\012Based on you description of the timer not advancing I suspect the thermostat isn't satisfied when heating the water.\015\012\015\012The SHU 30** unit`s with a mechanical timer have very few if any, issues with ... Dishwashers

I have an Inglis dishwasher.Serial number-FC3312512,Model number-IBU37002 or it could be IBU37062.I do not know how old the dishwasher is, as I justed moved in to my house this October,and the dishwasher came with the house.Last night I reset the options on the dishwasher,and had the cycle running on heavy duty.About 1 hour after the dishwasher was running this very bad smelling--like smoke- steaming odour was coming out of the door vent of the dishwasher.The smoke alarm went off in my house,and


... Dishwashers

Bent leg We had tile installed and so we have to be able to adjust the legs by approx 1/2 in. to pull the dishwasher out. The timer went out and so we were going to replace the dishwasher, but the new one won't fit in our cabinet. So, while trying to put the Bosch back in, I guess the back leg hung up on something and bent ... can't screw it in, can't screw it out, dishwasher is out of level as it is. Questions as follows: 1) how important is it to have it level? 2) any suggestions on wh


It's hard to say what to do about the leg without seeing it. You should at least try to get something under it to get it level as possible. If not perfect, it is better to have it tilted slightly back than foreward. ... Bosch 24 in. SMU40 Built-in Dishwasher

1. changing dishwasher settings from the various dishwashing selections (i.e., auto, auto plus, regular, delicate, etc.). I cannot change the settings from one to another. 2. getting film free cleaning results. Honestly this dishwasher has never provided crystal clean (filmless glasses) or completely dries the full load.


... Bosch SHX68M06UC 24 in. Built-in Dishwasher

I have a Whirpool DU1145XTPQA dishwasher... It has started "Not Draining the water" at the end of the cycle. Dishwasher is only 2-3 years old. I have completly disconnected it and have taken it to my garage so It could be tested in a more userfriendly envoronment... I have found no blockage of any line..... The screen in the dishwasher is completely cleen...yet , when you press drain, It drains at a very very slow rate. I have noticed a small 40 Watt pump (drain pump) that attaches to the mai


There is only one motor that drains the unit.it seems to me that the impellar wheel is not turning fast enough to do the job,you have eliminated all other possible cause with the exception of the main board.\015\012\015\012replace the dra ... Dishwashers

My built in dishwasher ser no sm843049B-Model number GSD696ON1OSS will not reset. I mistakenly used the delay wash setting. It is set at 1 hr. I have used the start/reset button several times and the delay continues to show 1 hr. I don't see that the timer is moving in any way. It seems to be "stuck" at 1 hr . Is there a way of "erasing" the previous input? D Bafkas


Hi,\015\012\015\012Try to do a hard reset by unpluging all the cords for 1hour and then plug it back.\015\012\015\012Goodluck,\015\012Please don't forget to rate the solution ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1848 seconds