Having problems with your LG Dishwashers ?

LG Model LD-14AW2 - loud bang and door dropped open as if a door hinge or spring snapped. Are both sides of door normally supported. Are parts available to repair. Where do I get a manual. Colin


Answers :

Hello- Parts are available locally at app. parts store. Need complete model #. Usually have to pull out unit to install. Replace both sides. There will be a spring, sometimes with a cord to pull door up. Either part can break, so get both. Not easy, but you can save a bit by doin it yourself. Hope this helps. -Thanks- ED
Repair Help & Product Troubleshooting for LG Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

LG Model LD-14AW2 - loud bang and door dropped open as if a door hinge or spring snapped. Are both sides of door normally supported. Are parts available to repair. Where do I get a manual. Colin


Hello- Parts are available locally at app. parts store. Need complete model #. Usually have to pull out unit to install. Replace both sides. There will be a spring, sometimes with a cord to pull door up. Either part can break, so get both. Not easy, ... LG Dishwashers

Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!


... Whirlpool GU2400XTP Built-in Dishwasher

Need the wiring diagram for the front panel/door of the dishwasher. The wiring diagram in the owners manual does not provide adequate description of which wires connect where. My problem is that, in taking off the door, two wires became disconnected and I cannot tell where they should be reconnected. I called Viking and they are unwilling to provide this (they prefer I call an authorized repair person). Does anyone know whether a repair manual exists for this and where I might get ahold of one.


This is all I could find go to this address www.specsserver.com/CACHE/FILE5412.PDF at the very end is wiring diagram but its not in detail ... Viking DFUD042 Built-in Dishwasher

Gaggenau GM 915-710 UC6 dishwasher will not fill and wash. Close the door, turn lever. Empties water from sump. (drain hose was not clamped above disposal outlet nipple, fixed that) Machine empties sump, but will not stop after sump is dry. Will not initiate fill and wash. Manually stop machine. Can't get control board to do the diagnostic to get an F #. Pressing button 1 and 3 at the same time. A couple of the plastic tabs on the circuit boards plastic support housing that link the


... Gaggenau GI936-760 Dishwasher

We have a Maytag "Dependably Quiet" Dishwasher approx. 17 years old. The door doesn't close properly (after I mistakenly lifted and pulled on it at the same time to pull the machine out slightly further). It seems to have dislodged at the bottom somewhat and I don't have any repair manuals that show how it is secured. Both of the springs and plastic hook mechanisms are in place for either side, however, it has dropped slightly down on the left side and binds on the bottom access panel. Any h


It would be helpful if you provided the model number of your dishwasher.\015\012\015\012See below links to service manuals for a few models of Maytag dishwasher, not sure if any of these is yours. I believe the last one might be the Quiet ... Dishwashers

Dishwasher will not run when door is closed, jiggling the door sometimes will allow the dishwasher to run. My guess is there is a contact problem by the latch but I can not find any parts or repair manuals for this Asko 1585. Any insight?


You need an interlock you just take the top panel of and its screwed on underneath handy enoungh to do just make sure you unplug it first :) ... Asko 1385 Dishwasher

The door of our Eurotech Dishwasher EDW 254 E when opened and released just suddenly "drops" down uncontrolled. Apparently the "spring" the right lower corner broke. Also, it does only poor, unacceptably thorough cleaning job now. Will you please dispatch a repair person or suggest names and addresses / tel. nos. / e-mail addresses of repair persons / shops that can fix it. If spare parts are needed please indicate the source(s) for them. Possibly send us via e-mail a copy of the manual for t


Hi.Problem is likely the door hinge springs, hinges, stoppers or other part comprised in the door hinge assembly.See parts B ... EuroTech 23 in. EDW254E Built-in Dishwasher

I have a KitchenAid m/n KUDIO1FLBL6. What is the part number I need to order to get the spring / pulley assembly to repair the door (door drops down with no resistance).


... Dishwashers

DOOR TENSION The door is too "savage" the tension need adjusting but how there are no obvious screw's available or do we have to remove the dishwasher from its fixed position to get at screws on the side that is if they are there?


Open the dishwasher and look at the top of the chassis, where the door catch is. You'll see 2 screws with hexagonal heads, one on either side of the catch. Turning these screws will apply or reduce tension on a wire liked to a spring on ... Indesit 23 in. DV62 IX Built-in Dishwasher

Have a leaky gate valve shaft seal that I want to replace myself (part # WD8X181). It only leaks when in the drain cycle. Repair manuals are not available for this model. How much disassembly is involved to replace this seal? Do I need to gain access to the shaft from inside the housing pump assembly (drain sump)?


... GE Dishwashers

Hobart lx30H Fuse f1 3.2amp 250vac blown, f1 feeds relay board. No booster temp, pump and sump heater active (OK). Can problem be from other devices that are driven from the low power relays on this board or are we looking at a board failure as the only answer. No skinny on door panel, Can't get access to OEM repair manuals anywhere on line Thanks


Possible bad relay coil ... Hobart 24 in. LXIH-3 Built-in Dishwasher

Customer bought house with a Viking Dishwasher already there. He has no user manuals or documentation with the model number listed. None of the stickers on the side of the door have a Viking model number. This unit is a Quiet Clean System with Auto Water Heating and is (he thinks) about two years old. How can I find out what the model # might be or better yet how do I find out the part # to fix the main control board / interface. It just keeps blinking.


Check the back of the unit for a tag.... otherwise - removing the clock... it should have a part number on it.\015\012\015\012Thanks! ... Dishwashers

I have a whirlpool for Ikea dishwasher that is built in and I put it on the normal 30 minute cycle before I went to bed and 8 hours later it was still going. I opened the door and machine was full of suds. It is like it gets stuck and can't move on to the next part of the cycle. I have checked the filter in the bottom of the machine and checked the salt and rinse aid levels.


It could be waiting for the temperature to reach the required level.\012\012Sounds like the heater element has died. ... Whirlpool Dishwashers

The door support on our machine seems to have failed and it has to be manually lowered otherwise it crashes down - can this be repaired?


There is a spring at the bottom of each door connected to the door and the frame of the dishwasher.Slide the dishwasher out to access the side where the spring is. One or both are probably broken. ... Fisher and Paykel Dishwashers

I have an zanussi LS6 and in the display it on and off shows the A1 and B2 and spills water. The problem though is not what normally comes with A1 and B2. Somehow the water gets to electrical parts and all power is out in the café. Several experts that has been to see the machine clame it has something to do with the electrical system - that measueres when there is enough water. They say it has something to do with machine having the salt container and they have all given up repairing it. I boug


... Zanussi 24 in. LS6E Free-standing Dishwasher

I have a dd24dctb6 Fisher Paykel dishwasher and the handle on the top drawer came off on one side. I can get a handle kit but don't know how to disassemble the existing handle. Is there a repair manual somewhere? thanks


... Fisher and Paykel DD24DCTB6 Builtin Dishwasher

I need a repair manual or advice on an AEG favorit 675.Starts normally,after the rinse--opens the soap tray---does not wash the soap out of the tray then gets "stuck" in the cycle


... AEG Dishwashers

Where can I get the instruction manual for a Bosch Classixx Dishwasher SGS53C12UK? I have bought a second hand dishwasher that has only been used for 6 months. The programme works fine but when I go to use it again - check water shows on the display. I have to tilt the machine back as water is stored at the base of the machine, surely this is not normal? It there a simple solution to this or alot of cost involved with a new part? Any help would be much appreciated. Thank you.


... Bosch Dishwashers

I have a leaky gate valve shaft seal that I want to replace myself (part # WD8X181). It only leaks when in the drain cycle. Repair manuals are not available for this model. How much disassembly is involved to replace this seal? Do I need to gain access to the shaft from inside the housing pump assembly (drain sump)?


... GE Dishwashers

The water dispenser inside the unit doesn't seem to be rotating properly and I am not getting a proper water flow during the wash cycle. can I repair this error myself or will it require a professional? is there a part replacement available from the company?


The water level should come just below the heater. Also check your spray arms and make sure the holes in them are not plugged. Remove the bottom spray arm and check to make sure mineral deposits such as calcium and llime are not built up and blocking ... Dishwashers

Hi I am in an emergency situation with an ikea whirlpool dishwasher. I have no idea what model it is since it's built in and I can't find the manual in my rental apartment. The machine works normally until the part where it's supposed to pump the water out after rinsing. At this point it starts to beep, once, and then 3 times. On and on and on. If I open it, there is water stagnated there. If I try to turn it off and back in, it will go through a whole new program and then I get the same problem


Can you feel the pump operate during the last wash cycles? if not either theres a bad pump motor or lack of power to the pump during that cycle,if this is ok,then remove the drain hose to the main drain to see if this is plugged up with food debris ... Whirlpool GU2400XTP Built-in Dishwasher

The door on my built in Frigidaire dishwasher is falling open. it seems like a spsring or something has broken. I am looking for a repair manual, possibly an exploded diagram so that I can see what parts i might need. Thank you, Brenda


Here is the way the springs hook up.\015\012\015\012\015\012Here is the break down.\015\012 ... Frigidaire Dishwashers

Hi , My Bosch dishwasher SHX46A05UC/30 fills up with clean water after sitting a while. Ive read posts and think the problem is the water inlet valve . Where can i find the exact part number or Bosch repair manual on how to fix it.thx. Bosch have no tech support help


... Bosch 24 in. SHX46A05UC Built-In Dishwasher

Have Whirlpool dishwasher Gold Series, Model GU9805CGB1 which stops part way through wash cycle with the led indicator blinks on the normal cycle.....if we ope nthe door and shut ...it continues until part way through rinse cycle...stops again....led indicator blinks again.....we open the door & shut and it continues....but then continues to run through the normal wash cycle continuously.....until we open the door again.....what's wrong???


Sounds like the door is losing contact with the door switch, first thing i would check is the door strike.Metal strike plate located on the tub itself that the door latch catches as it closes. its a spring metal striker, i would try bending it down ... Dishwashers

The spring or balance in the door on my dishwasher Zanussi DW917 is no longer working, so that the door just drops unless held manually. How do I get to it to replace or where can I get a service manual with this information please?


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1327 seconds