Having problems with your LG Dishwashers ?

I get an E1 error code. If I check the water level it is low so if I put in about two quirts of water it runs for only that water cycle, then I have to put in another quirt for the next cycle. The water comes to the same level every time. Can you point me in the right direction?


Answers :

Excessive RPM of washing motor happened during wash cycle due to water \015\012leakage.\015\012Possible cause: Water leakage in hose connections,water is leaked by \015\012damages. The motor water seal leakage of sump assembly. The height of \015\012drain hose connection ( sink drain hose ) is not over 20". Impeller of \015\012the washing pump is worn away.

Replace the connections of hose. Check the point of damages and repair \015\012or replace the related parts. Correct drain connections. Replace the \015\012impeller of the washing pump.
Repair Help & Product Troubleshooting for LG Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I get an E1 error code. If I check the water level it is low so if I put in about two quirts of water it runs for only that water cycle, then I have to put in another quirt for the next cycle. The water comes to the same level every time. Can you point me in the right direction?


Excessive RPM of washing motor happened during wash cycle due to water \015\012leakage.\015\012Possible cause: Water leakage in hose connections,water is leaked by \015\012damages. The motor water seal leakage of sump assembly. The height of \015\012 ... LG Dishwashers

Model FDB4315LFC2 Serial TH80658596 It is only 20 months old but Does not load with water. I have checked water line into white valve and water is flowing, but it does not come into the dishwasher. If I manually put water in the bottom of the dishwasher it works fine through the cycle until it is time to pump in more water. There is a sound but no water comes through the valve.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. As you have already checked the water line for clogs/obstructions and the water is flowing but wont fill ... Frigidaire Dishwashers

ZANUSSI Da 6341 dishwasher, Flooding in middle of cycle. Sometimes at start of cycle (5-10 mins) washers floods and water comes out of front. If i move timer to end of cycle pump works and water is pumped to sewer. This doesn't happen every time. Sometimes cycle works perfect and after that doesn't


... Zanussi 24 in. DA6141 Built-in Dishwasher

My lxi dishwasher drains more water than it fills during a cycle so after about three cycles the water level becomes to low. No error messages come up but I have to turn it off and refill it all the time. water pressure at the machine guages shows about 20psi when rinsing


There are two different styles of lxis one style has a drain diverter valve probably messed up some how something stuck in it not diverting the water to the wash arms and instead pumping right down the drain I am guessing this is your problem.There i ... Hobart 24 in. LXIH-3 Built-in Dishwasher

Water coming out front of dw at start of wash cycle. I leveled the unit. no luck. if you open the door during fill cycle the water does not shut off. also, may be a problem with float shut off working properly. what should I try next? Kenmore Elite 16579


Hi \015\012Check float to insure that it is free to move, it sounds like the dishwasher is over filling. That is assumed that you have not changed the type or amount of detergent being used.Also there is a probability tha ... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

I have the Bosch SGS43A2GB27 Dishwasher. Today suddenly it has stopped working. 1st problem i faced was that water was coming out from the dishwasher. Then i cleaned the filters . Then i restarted the dishwasher again. Now the problem i am facing is that the dishwasher is not workign. Whatever cycle i put....the time remains the same. If i put econoy wash...nad time is for 40 min. It stays for 40 min even after 20 min. Please help . I recently called a technician...culd not afford technician aga


... Dishwashers

I have a Bosch dishwasher, model #SHU43C02UC/14, which has stopped working - no water enters the inside nor is there any drain cycle - just nothing. At the same time, I had to have the new control board put in as part of the Bosch recall. The tech comes out, puts in the new board - still nothing. He says something is wrong with the board even though the problem existed before the new board was installed. He takes everything back to his shop and tells me he's trying to contact Bosch tech support


... Bosch Dishwashers

Component failure Actually a Kuppersbusch IGV 645.2 Dishwasher There is a plastic conduit which takes water from the base of the machine to the upper spray arm. This now comes adrift from its connection at the base (behind the lower spray arm) on every cycle, resulting in poor or incomplete washing. It can be replaced easily and seems firmly inserted when done but is always adrift again by the end of the next cycle. Anyone any ideas?


Put a bead of silicone on the tube connection and let it set up good before running. If the tube is in good shape and only comes loose this should be an easy fix. ... Whirlpool GU2400XTP Built-in Dishwasher

Bosch SHU43 My Bosch SHU43C dishwasher stopped washing, turns out the impella came free from the motor, I repairded impella and put it back together and now the dishwasher washes great however now it is stuck in a wash rinse drain cycle. Display counts down but the unit never stops running when it reaches 0. Also, the water level is higher than normal and I there is a kind of thumping sound repeatedly every 15 seconds " use to make that sound only once at the start of a cycle before the impella


Sounds like the control module is out -- cost about $100 (I am on my third). I got a "lifetime" warranty when buying my second one. If you are handy, you can replace it yourself. You can call Bosch to confirm this (I did). It mounts inside the door. ... Bosch 24 in. SHU53 Built-in Dishwasher

Hobart LXIC under counter comerical dishwasher. Delime lled keeps comeing on every time power up. Checked sensors on bottom in the water drain area senser on right (there are 2 next to each other on this unit I think other is water temp) the wire had wire burn completely off. I reconnected the wire and started to burn up the wire again. Question: 1) Is this sensor for the Delime sensor? 2) does it sond like the sensor is shorted to you? or sending wrong voltage to sensor? 3) If no


... Hobart 24 in. LXIC-5 Built-in Dishwasher

I have a bosch millennium series SHU9905UC. There is still water at the bottom of the dishwasher from the last time it was run. I think it may not have completed the cycle as a few bowls were still dirty. Now when I try to put the washer on and press a cycle, no light is coming on at all. It seems dead. Is there anything I can try before calling in service people?


... Dishwashers

First 2 weeks ago i put an electric control module into the upper section. what comes on is the green flashing light for clean. in checking connections i found the paper for trouble shouting. i did what they said to do. they said hit the time saver - high temp - time saver - high temp. from there all the lights went on & the wash cycle started and ran. then it just stopped & the green light for clean just flashes. the water is still in the bottom & won't drain.


The error indicates that the machine has taken too long to drain the water. Do the following.\015\012 \015\012\015\012Switch off the machine, unplug or disconnect the ma ... Kenmore 16874 Built-in Dishwasher

GE GHDA485N 10CS Dishwasher that has standing water in the bottom after the cycle completes. I pulled it out and reconnected power and ran a rinse cycle. I could see that water was pumping out the clear drain pipe but there was still about an inch of standing water in the bottom. Any thoughts as to what part has failed. Does the system use a water level switch or a timed drain cycle to determine when the water has pumped out. If it is a timed cycle could a slow drain cause the problem. Thank you


... GE Dishwashers

I have an INDESIT LS12-EVO3 dishwasher and the "rince aid indicator light" doesn't come on no matter how many washing cycles we have done. Also as I have noticed there is hardly any consumption of rince aid liquid. The level almost remains the same in the dispenser. At the same time I have not noticed any water spots on the plates, etc. Can you help me in this?


... Indesit 24 in. D63 Free-standing Dishwasher

My old Neff dishwasher S4132 is constantly taking in water even when switched off! I can drain it ( every hour!) by putting it to drain cycle but have to turn off the mains supply when leaving it even for a short time. Awaiting a plumber as the tap to isolate the supply has broken but am interested to know if a new aqua stop will solve this problem or could it be something else??


... Dishwashers

Hi - bought this dishwasher 1 year ago yesterday (it figures). Discovered last night that it hadn't drained properly the last time I used it (maybe 5 days before). There was about 2" of soapy-feeling water in the bottom of the cabinet. I put it through another cycle and the same thing happened. I only run it maybe every couple weeks. Can you tell me how to fix it?


Hi,Let me offer you a solution in 2 parts. A generic one needs you to investigate each and every aspect from Point 1 till End :-\015\012\015\012\015\012\015\012\015\012Drain line/air gap\015\012\015\012A\015\012clog in ... Dishwashers

Brand new haier hdc1804tw wont start. i press the power button unit beeps once and power light comes on but i cannot select cycles. unit will then beep every five minutes. i have made sure there's water and unit is level. i have left it unplugged for over five minutes with same resulting issue.


... Haier HDC1804TW Dishwasher

I have a ESF1600 model of an Electrolux dishwasher and at present it works sometimes and then not at other times. When you put it on a cycle it does not allow water in the power light comes on and the dial moves but it does not fill up. Could you tell me where to get a manual from for this brand and let me know what the problem may be.


If you remove the bottom panel under the door, and look for the water inlet valve, I think you might find that the wires going to it are either not completely seated, or something like that.While down there, check and make sure the wires ... Electrolux Dishwashers

Hi I have a Blanco dishwasher BFDw8 which is having poor wash results in the top tray I have tried all the trouble shooting things in manual. Investigated further by opening door during wash cycle several times and discovered the top arm is not moving although water is still coming out of the arms. I did get a split pea particle out of the arm approx 2mm and have since had a mildly better wash and have used superior wash powder and rinse aid to try and help. Also have put a cleaner through di


\015\012\015\012Check the water temperature. Should be 125 to 140 F. \015\012\015\012Check pump re-circulation., Listen, see if it sounds like it is spraying the water around with enough pressure. ... Dishwashers

I Have 3 problems with my dishwasher, my dishes are always coming out with food and grit. I've tried numerous soaps and powders, the motor makes a very loud loud every time it's used. and the latch works but I can opent the door mid cycle it doesn't stop water sprays everywhere


Regarding the problem about dishes coming with food and grit - it is possible the wash water is getting contaminated with stuff that should normally be sucked out by the drain pump up in the dishwasher. This is linked to the accumulator and chopper p ... Admiral 24 in. DDB1501AWW Free-Standing Dishwasher

I have a Proline DWI 5212p dishwasher about 2 years old. Every time I turn it on it starts beeping and the first three lights start flashing. It is draining because if I put water in the bottom it goes when I turn it on but it won't start the wash cycle.


... Dishwashers

Kenmore Dishwasher model 665.1675592 doesn't seem to wash as well as it used to. Seems to have a low water level. Filler valve works, allows water in, but never seems to fill enough. No spray reaches top shelf, I think due to insufficient water level. It's like the timer doesn't stay on long enough for it to fill. Also cycle time seems WAY up, but if the timer is slow, how does it time out filling so fast? Looks like it would be slow all the time. Suggestions?


... Kenmore Dishwashers

Dishwasher will not fill with water, dishwasher sat unused for some time. it worked fine for 4 times, then it backfilled with water from the garbage disposal unit, and leaked out through the floor. When I start a cycle we hear what it sounds like a pump draining and then going to cycle without water coming in. It's a bum.


... Bosch 24 in. SMU40 Built-in Dishwasher

Inglis MOD#IPU58460 Dishes not cleaned properly...thought that enough water was not being filled into tub because more water added manually and washes great! I checked inlet water valve operation and lines for possible lime buildup and timed "fill" time. All was good and time right to spec! Water level after fill is just to bottom of mesh screens. Under further trouble shooting I held door open slightly while holding door switch closed to observe wash cycle and found as pump starts water shoots


The sprayer arm may be clogged with debris.Here's a step-by-step troubleshooting guide. ... Dishwashers

Doesn't put water into every cycle


It sounds like the solenoid for your incoming water is going bad. ... GE Nautilus 24" Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2212 seconds