Having problems with your LG Dishwashers ?

My LG washing machine is dead. It is in my summer home and it worked before we left. The electric outlet is fine and the water supply ok. What could be wrong? Is there a fuse somewhere in the machine that can be checked? Model # WM2277HS Thank you fro your assistance


Answers :

The control board is probably dead and there is no serviceable parts. There is a fuse in the board but it's encased in acrylic for moisture protection. You will have to order a replacement control board. Good luck.
Repair Help & Product Troubleshooting for LG Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My LG washing machine is dead. It is in my summer home and it worked before we left. The electric outlet is fine and the water supply ok. What could be wrong? Is there a fuse somewhere in the machine that can be checked? Model # WM2277HS Thank you fro your assistance


The control board is probably dead and there is no serviceable parts. There is a fuse in the board but it's encased in acrylic for moisture protection. You will have to order a replacement control board. Good luck. ... LG Dishwashers

Need a service/repair manual for a Bosch SGS0905AU/01. The machine is completely dead (no display) after a burnt smell came from it. On the pump motor is a broken/melted brown attachment with a broken ceramic(?) disc inside which looks like some type of capacitor. I really need to know what this is/was so I can replace it. Also, need to know whether there is another fuse somewhere in the machine as that has most likely blown as well. TIA


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012While I can provide a overall Bosch service manual if you post an email address, Based on your description I'd say the issue actually with the motor start relay and consiquently the control...as ... Bosch Dishwashers

I'm not sure exactly what has happened, I washed a load of dishesand everything seemed fine, but when I went to wash a load yesterday, my Kenmore Ultra Wash III, Model # 1677990simply would not turn on and I found water in the bottom. I checked the house circut breaker and it is fine, is there a fuse or breaker on the machine somewhere? Please help!!!


... Kenmore 24 in. 15932 Built-in Dishwasher

No power to for the controls power is to the machine what to check next. someone told me there is a fuse somewhere?


Hello, welcome to FixYa.Based on your brief description, I'd suggest you likely have a faulty thermal fuse in the control board, but it is not resettable u ... KitchenAid 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

I started working with the Karcher KB4040 pressure washer and all was well for 1-2mins, then it sputered a bit and all power died. All hoses were still attached properly, it hadn't blown a fuse in my house and the fuse in the plug of the washer is working fine.When I switch it on I get nothing. Do you think the motor has packed in? I borrowed the machine from my neighbour who's away on holiday, so don't know much about age of the machine. Any advice much appreciated.


If the water is in anyway impeded, like kink in hose the unit turns off and goes into protection mode. That it it shuts down for a pewriod of time depending on how hot it may have got.\015\012When its rested try it again ensuring you definitely ... Karcher 1750 psi Electric Pressure Washer

The fuse in the plug stopped working during a wash cycle i replaced the fuse and now the washing machine wont continue with the cycle and the drum has water in it, what can i do 2 restart the machine???


On those hold down the start and reset button for a while, until you here the water draining out. ... Dishwashers

Neff dishwasher will not switch on , checked fuses etc and positive that power is going to the machine but will not switch on,is there any safety feature such as blockage or otherwise stopping machine from switching on, red lights not coming on, machine 4 years old and very little use? can u help


Just went through this myself. It could be a latch switch. Open the door undo the screws that holds on the inside door panel remove the latch. The 2 black boxes with wires attached are the switches. Take them out (use your camera so you know how to p ... Neff 24 in. S4443 Built-in Dishwasher

How do i check if i have a blown fuse. my machine wont start and first trouble shooting question states i might have a blown fuse. Where can i find it


... Frigidaire FGHD2433KF Builtin Dishwasher

Thermal fuse Dishwasher konked out mid-cycle and now no power to control pad. We've already had the thermal fuse replaced once (machine is only 2 years old!) and this appears to be the same issue. I tried to open the front and I think I can see where it is but not sure how to get it out and replace it AGAIN. I wasn't able to get the inside panel completely apart from the front of the unit so I was somewhat limited. I'd rather save the service charge if I can and there's n


Http://www.partselect.com/MultiModels.aspx?ModelNum=KUDS35FXSS&SearchTerm=fuse&RefineSearch=0Maybe this link will help ... KitchenAid KUDS35FXSS Dishwasher

OUr ASEA Cylinda dishwasher doesn't seem to have any power. The manual suggests the fuse might be blown. THe circuit breaker is fine. Is there a fuse on the machine that can be replaced?


You need to trace the power cord into the machine to confirm this case. It will lead you into the circuit and if power is not present to the controller section there can be a fuse before the circuit.Remove power to the machine and remove panel to ... Dishwashers

Hi, I have a Hotpoint Aquarius DWF31 Dishwasher. The dishwasher was put on last night and this morning although it looks liked it as cleaned is has not drained. But now there is no power at the machine. I have checked the fuse at the plug which is ok and also there is power at the socket. Is there a fuse inside the dish washer or any thing else i can check


... Hotpoint Dishwashers

The fuse in the plug keeps blowing. Initially it would run for a while - sometimes 3 or 4 cycles - before blowing. It now blows the fuse the second that I plug in to the socket, even with the on/off button on the front of the dishwasher set to off.I'm keen to take it apart, but it's full of water as it blew mid-cycle. Is there a clever way to empty the machine without the power being on, or do I need bits of hose and sponges?A schematic blow up would also be extremely helpful.


Lower the outlet hose into a washing up bowl, it should then Drain. Check the heater to see if it is earthing you get to it by removing the right hand side panel. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a LG model LD-14AT3 dishwasher that will not start when you push the power button.There is power to the machine. Does the machine have its own fuse or reset button.


... LG Dishwashers

Stopped mid-cycle by blowing fuse. Cannot remove water from machine. Every time I switch on it blows the trip again. I tried leaving it for a while in case water had got into the electrics but after about one second the fuse went again.


Can be the drain valve/ drain pump is faulty and so since it is in this cycle the drain current is too much for the fuse to blow.\012So recheck by disconnecting the valve and putting fuse in , if the fuse stays then it is confirmed. if not the ... Miele 24 in. G645SC Plus Free-standing Dishwasher

Our cuisina dishwasher keeps tripping a trip on our main fuse box, the fuse on the plug does not blow however, this is happening every time i try to turn the machine on. it stopped half way through a cycle and wont restart.


... Dishwashers

We have an Hotpoint FDW70 Dishwasher that for some time has had an A10 fault which although stops the machine some times 70% of the time it does a full cycle. However it is now tripping out the electric at the mains. It is not RCD protected, but does not blow it's own 13amp fuse or that of the fused extention lead it is pluged in to. Tends to blow after about 5 minutes. I know about the fault code A10 being 'Fill Valve Triac' but as not an engineer what is that? and what parts are needed and or


Hi the fill valve triac is the plastic vlave that the inlet hose connects to you can get them for about £10 you reset the machine after replacing it by switching it on, pressing the power button leaving it off for about a minute then switching ... Dishwashers

Hi, I have a Dishlex dishwasher. It's an electronic model, from about 92 I think. The model I thought was B8557WW. It is very hard to see the model number because it's almost washed away. Is the model number maybe located anywhere else on the machine? Could there be a manual or circuit diagram hidden somewhere on (in) the machine? The fault is that it wont start. It reacts to some of the front buttons, and beeps, but not all, and not the start button. Before it stopped working completely, some o


... Dishwashers

Washing machine Simpson top loader Model 805 No power/lights nothing, did test power point with another apliance and is ok. Has machine an inbuilt fuse? John.


Hi,\015\012\015\012\015\012\015\012\015\012No power\015\012\015\012Check\015\012to see whether power is getting to the washing machine. Is it plugged\015\012in? Has a fuse blown or is a circuit breaker tripped?\015\012\ ... Dishwashers

Model ADG 332 SAV Just after switching on, after rinse water filled up, a big cloud of acrid smoke billowed out of the machine, without fusing it. Cycle then stopped. I switched off the machine, and on restarting nothing further, just an occasional mechanical bleep. Is this terminal or an weasy fix?


Hi,This could be a control panel failure or a timer switch has a problem, you may need to check this controls with a VOM meter to test if the panel is still functioning properly. You have to unplug the unit after doing this and you may ne ... Whirlpool Dishwashers

When switched on the machine trips the power. Changed fuse in plug and tried different socket but still same problem? took bot of machine no visable burn or soot marks? any ideas


Is it tripping the breaker in the breaker box? If so you have a short to ground. Could be A bad spot on the dishwasher cord. Turn power off and pull dishwasher out and check the power cord all the way back to the dishwasher terminals ... Dishwashers

Hello I just borrowed a k archer k 2.87 water blaster from a friend and forgot to turn water on before starting motor. Motor stopped after a few seconds and now won't start. Online guide says to change fuse but nz version doesnt have fuse in plug. Do i have to take machine apart?HELP Please!


Most of the time it is the GFCI on the end of the plug that goes bad. If it were me I would cut off the GFCI and wire in a standard 120v plug. If it still doesn't work after that then there is a good chance that something electric internally has gone ... Karcher PSI Electric Pressure Washer

Hi, I got this Kelvinator dishwasher kd75. . . it switches on but doesnt seem to "take" in any water . . . I dont know how it should be used ie switch it on, turn the knob to ???? . . please assist me with some kind of manual on this machine. On the left hand side there is 2 buttons . . first one has an "E" on top and the second one is where you switch the machine on . . . Tnx!


... Dishwashers

White knight dishwasher dw1260WA will not power up. The light doesn't come on either. Machine was in the middle of a programme but stopped with water left in it. at that time the light was working but even the light doesn't come on now. I also removed all the excess water out of the machine...I've also checked the fuse and it is fine. Any suggestions?


... Dishwashers

Water pressure? I read somewhere that low pressure of the incoming water will make it so that the items on the top drawer will not be as clean. I don't see how this can be the case, as I thought that the way the washer worked was that the washer filled (at whatever speed) and then the machine itself pumped the water through the system at the appropriate pressure. Please clarify.


Mom...not true. The water fills the machine which then uses its own pump to spray the dishes with the water/detergent. If your dishes are not getting clean, use the recommended amount of detergent. Hard water will require a spot treatment like Jet ... KitchenAid KUDR01TJ Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0851 seconds