Having problems with your LG LDF6810 Built-in Dishwasher ?

OUR LG MODEL#6810BB WONT DO ANYTHING BUT TURN ON....FIRST, PROBLEM WAS THE DISHES WOULDNT DRY...SO THE HEATER COIL WAS REPLACED....AND THEN 2ND THE MOTOR WAS REPLACED....AND NOW IT WONT EVEN DO A THING...OTHER THAN TURN ON...


Answers :

HOW OLD IS YOUR DISHWASHER?
Repair Help & Product Troubleshooting for LG LDF6810 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

OUR LG MODEL#6810BB WONT DO ANYTHING BUT TURN ON....FIRST, PROBLEM WAS THE DISHES WOULDNT DRY...SO THE HEATER COIL WAS REPLACED....AND THEN 2ND THE MOTOR WAS REPLACED....AND NOW IT WONT EVEN DO A THING...OTHER THAN TURN ON...


HOW OLD IS YOUR DISHWASHER? ... LG LDF6810 Built-in Dishwasher

Maytag DWU6402AAB dishwasher hums but motor does not run. I've taken the inside apart down to the disk-shaped impeller. It turns freely so the pump and motor are not stuck. When control knob is turned motor hums at the places where it normally should run. The water valve & heating coil seem to be operationg normally. i assume the next step is to test the motor &/or motor relay. Is this correct and how do I do that?


... Dishwashers

Upper & bottom arms are not turning even though the motor seems OK, pump for draining seems OK too. rcently I changed the pump kit plus some gasket and seals. My Maytag is about 14 yold and was very good for me untill I changed the parts. Could it be a weak motor pump. The water splashes very much in the machine but no arm turning!? Help me thank you Ben


Hi Ben, had the motor impellor shattered in the old pump ie-chunks broken off ? if so there is every possibility that these pieces have lodged in the wash delivery pipework at an elbow or indeed at the arm boss itself -i would try to check as much of ... Dishwashers

I have an avanti dw 18 dishwasher . the problem i am having is the when i turn the on button on the motor goes on however no water fills up. The motor is only humming. But; when i press down the float from inside the machine the water fills up and the machine starts to work. after the water drains again the motor continues to run and hum and the dial does not move. when i manually move the dial nothing seems to change . the motor continues to only hum. Even when the dial is in the stop position


... Avanti Dishwashers

I have a kenmore 15951793 it refuses to drain. I've metered the drain line into the motor and it is there but it will attempt to run but seems to trip a thermal breaker. the motor doesn't turn at all but the motor shaft is free, so I'm assuming bad coil. Any thoughts??


... Kenmore 24 in. 15932 Built-in Dishwasher

GSD2200G00WW. When starting washer, part of the time the machine will not start, other times if machine has been running for a while and you open the door and try to restart the machine it will not restart. You can hear the motor humming as if it wants to go but it will only restart if you turn the motor shaft even just a little. I am wondering if the electric motor is dying??


... GE GSD2200G Built-in Dishwasher

My Asko Dishwasher (5 year old) motor won't stop, only if I turn the power off from the wall. The motor continues to run even if I open the door. Any suggestions on what i need to do to get it working again please?


... Asko 24 in. D3121XL Free-standing Dishwasher

I have a F and P 603 dishwasher with a similar problem as to a recent post here. My top drawer doesn't turn on and my bottom drawer does. Well it just has after I swapped the "blue" motor inside from my top one. Now, I have tried and opened as far as the translucent "X" plastic from the bottom of my bottom drawer showing the motor and it looks fine. I have even swapped the control board from my top drawer to try and see if it works and it actually does. So, problem persists. Top drawer do


Alright, open up the outer panel of the machine. Note the positions of the wires on the switches and\015\012remove them, unclip the switch housing from the base panel. The\015\012switch housing contains one switch for each drawer. The switches are\01 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Last night I turn on my dishwasher adl 945. It started to work but after few minutes i noticed that the dishwasher stoped and it looks like in the middle of program. Now the dishwasher wont even to turn on. Do you perhaps know what is wrong? .


... Dishwashers

The dishwasher washes the dishes but continues to run. I had to turn off the main switch. Turning is back on causes the motor to start up again even though the door with open.


... Thermador DWHD64EP Built-in Dishwasher

Karcher hds 501c motor wont turn


Never try to turn it on unless you squeese the trigger at the same tme it cant activate the pressure bypass unless it is running you will get ahumming noise and if you leave it on like that you will burn the motor out try that first if still no ... Pressure Washers

Motor wont turn when I try to pull


... Psi Blue Max 2200 High Pressure Gas Power Washer

My Whirlpool Dishwasher ADP931 has stopped working. It stopped in the middle of the cycle with 2 to 3 inches of water on the floor of the compartment. I mopped out the water and tried to restart the dishwasher. The green "on" light now comes on when I press the start button. but nothing happens (no motor comes on,no water enters).Repeating the above action several times does not help the washer to restart even though the other function lights will come on when the knob is turned. saturn1914


Hi,Whenever you see such symptoms, Time for you to investigate it properly. Check the below guide :-\015\012\015\012\015\012\015\012\015\012Power from the house\015\012\015\012Is\015\012there power getting to the dishwa ... Dishwashers

Kenmoore Quiet quard 3 Model #665.74363K1 Serial #FS3502091 The unit will not drain properly. When in drain mode, it will drain slowly when diconnected from the disposal and lowerd to floor, and drains even slower at disposal level, or hooked to disposal. Disposal nipple is clear. I removed the hose and flushed it out with high pressure, found no blockages, hose flows freely and did not fix the problem. The motor is turning and seems to pump water fine, all wands are truning with powerfull spray


... Kenmore Dishwashers

Dishwasher will not empty the motor just keeps running even if I turn it off.


... Zanussi 21 in. DCE5655 Free-standing Dishwasher

I have a 5 year old kenmore 665 15689 dish washer that wont come on at all . No lights no nothing . Before it stopped working the lights on the desplay were not coming on but it seamed to be washing normaly . I checked the breaker and even turned the power off for 5 min.


Theres a fuse in the back of the panel. ... Kenmore 24 in. 15689 Built-in Dishwasher

Electric motor makes a split second noise and wont turn on.


... Earthwise 1850 PSI Electric Pressure Washer

Wont turn off runs everytime door is closed even when switched off


... Stoves 23 in. Q60DW Built-in Dishwasher

Hi weve put a shop brand cleaner through it suds came out all over the place now it wont turn off its on drain all the time even when door is opened


... Zanussi 18 in. DCS12W Free-standing Dishwasher

Whirlpool dishwasher wont drain even on cancel/drain but motor hums


We had this same problem, and after we looked in to it, it was the connection between the drainage tube and the garbage disposal. The plug between the disposal was not punched out prior to the dishwasher being hooked up. \015\012\015\012Y ... Whirlpool DU1055XTS Built-in Dishwasher

My electrolux diswasher displays a code PF it wont reset even if i turn it off at the wall ??


... Electrolux Dishwashers

I've got a GE model GLD4408R00WW front load dishwasher, which was not filling, even though you could hear the motor running. Tried resetting it by turning off the power at the wall switch, and then from the breaker itself, but now, see the "Normal" wash cycle and Heated dry lights blinking when power is returned...


Hi,\012Here is a tip that will help you to find out why water will not come into the dishwasher... Dishwasher Tr ... GE Dishwashers

Normal wash cycle- tub fills (?), then comes a loud hummmm and nothing happens. I noticed water level didn't reach heater coil and added water until limiter switch clicked. Still just a loud hummmm. Machine was well into its regular cycle when this first occurred, but now, won't even get past initial fill. Pushing the "Cancel/drain" button activates motor and pump: they work fine.


You are an expert enough reading this. But with a terrible complicated dishwasher. First clear the waterlevel problem.\015\012Rest is a result. You do not need me, join us. Next time buy something more plain. ... Dishwashers

My dishwasher keeps blinking the "clean" light and will not start. I have tried turning off the breaker to reset the machine but it still wont start even after pushing all the buttons.


... Kenmore 24 in. 16049 Built-in Dishwasher

Dishwasher is reading "overfilling", but no water is in unit. Door can open, noise of motor or pump continues and will not shut off even with the Power switch. Only way to stop noise is to turn off the circuit breaker at the electrical panel. What does this sound like to you?


HI- The flood switch has been tripped. It is located under the unit and is not really accessible except by a Tech. The most likely cause it poor draining; if there is a little water left over from each part of the cycle then eventually the water ... Asko 24 in. D3530FI Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1114 seconds