Having problems with your LG LDF6810 Built-in Dishwasher ?

Hi i have just purchased a hoover HEDS 668-80 dishwasher. Unit all plumbed in and salt rinse aide etc added. Go to turn unit on and all four lights flash with a alarm tone bleeping. The manual says - overfilled / too much inlet water. can anyone help with this problem as my dishes are now stacking up! many thanks jon


Answers :

Turn down the house water valve. So not so much pressure is going through.
If this doesn't help, which I believe it should, then I would take it back or have the water inlet valve on the machine checked to make sure it doesn't have a bad solenoid or other problems.
Hi
\015\012\015\012
\015\012\015\012
\015\012\015\012Thanks for\015\012using FixYa. If the dishwasher is overfilling its\015\012water-inlet valve issue. This valve is usually at the bottom left or right of\015\012the dishwasher, behind the lower access panel. It's the device with the main\015\012water line from the house, a rubber tube to the dishwasher, and two wires\015\012attached to it. When a water-inlet valve is defective, you may hear the sound\015\012that's usually referred to as "water hammer." If the water-inlet\015\012valve is defective, you need to completely replace it. If its brand new then it should be replaced completely to avoid future issues. Please do accept the\015\012solution if the issue is resolved or else revert for further assistance.
\015\012
\015\012
\015\012Thanks
\015\012Rylee

Repair Help & Product Troubleshooting for LG LDF6810 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi i have just purchased a hoover HEDS 668-80 dishwasher. Unit all plumbed in and salt rinse aide etc added. Go to turn unit on and all four lights flash with a alarm tone bleeping. The manual says - overfilled / too much inlet water. can anyone help with this problem as my dishes are now stacking up! many thanks jon


Turn down the house water valve. So not so much pressure is going through.If this doesn't help, which I believe it should, then I would take it back or have the water inlet valve on the machine checked to make sure it doesn't have a bad solenoi ... LG LDF6810 Built-in Dishwasher

I have an ADP6000IX Whirlpool dishwasher which is comming up with a Fault code Err4. The manual indicates overfilled and possible cause "too much inlet water", however there is no water sitting in base of machine, and have unloaded all dishes and Err4 still comes up. I have switched unit on and off at wall but has not re-set. I have disconnected water pipe from tap and reconnected.Is there anything further I can do?


Hi, \015\012\015\012You can solve this by cleaning and de-greasing the filter frame, basket and sensor Also there might be a low threshold for oils/greases/debris of any kind, so you have to rinse and load. By removing outflow tube ... Whirlpool Dishwashers

Got a hoover hed 6612/80 been working fine today all four lights flashing and beeping. manual says too much water inlet. one soltion on here says to check water inlet sensor. How do i do this. please help.


... Hoover Dishwashers

Hi there, The error code 'strong and economy light flicker fleetly' is showing. the manual says that this means too much inlet water. We have drained the machine, cleaned waste pipe and tried to operate with a reduced flow from the inlet pipe but it's still not working. I filled the base of the dishwasher with water to see if it drains properly. It seems to be draining, but also leaking out of the base as well..? Any ideas?.


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... Baumatic Dishwashers

I have an LDS5811 and I just started getting an IE error. The manual says its a water inlet problem. I have not moved the unit since installing 3 years ago and have not disturbed the water supply. I checked the inlet tube and all appears OK. Any other suggestions?


I have had this error occur often due to faulty flow meter -remove left hand side panel, there is a large plastic component with three wires(red, white, black), these wires go up and connect onto main control board. Check these three thin wires for b ... LG Dishwashers

Hotpoint hda 3420 dishwaher. when turning, on the motor hums and doesn't kick in like usual. manual says caused by non use. "must keep the seal moist" put water in the unit, thinking it might get the seal moist. bottom filled and unit has not worked for days. assuming it's this seal: where is it? how do i get at it? what is replacement difiiculty? how much is the part? thanx ron [email protected] or [email protected]


Hi,Before thinking about replacement... pour a couple of cups of water in the dishwasher and let them soak the seal for overnight...Then if it don't go give the motor a spin...just to make sure it will go...if that don't work ... Dishwashers

How to fixerr 4 its saying overfilled. to much inlet water


Hi\015\012\015\012 \015\012\015\012Thanks for\015\012using FixYa. If the dishwasher is overfilling it's caused\015\012because of water-inle ... Whirlpool Dishwashers

Candy csd-68-80 all four lights on front panel lit, started flashing within few seconds of switching dishwasher on, no previous problems,dishwasher not overfilled, checked manual which said too much inlet water unsure what this means or how to check it. do all usual cleaning,salt,arms etc. had dishwasher about 14 months and use it every day never had any problem before


... Candy Dishwashers

My dishwasher is making a buzzing sound, sounds like its coming from the undersided of the machine. Maybe while pumping water? It is pretty much a constant noise, subsided briefly relatively early in the cycle. In the manual, on page 21, it says under noises that it could be in the wash module and will stop when the object is ground up. Is that possible on this unit?


... Dishwashers

My whirlpool adp 750 has error code 4, the manual says it's maybe overfilled and there may be a problem with the water inlet,but even when I reset the machine, the error stays and the machine is b


... Dishwashers

Dishwasher sounds as if it starts cycle, then stops, bleeps, and Fat and prewash lights come on. Manual says to turn off machine, turn off tap, wait 30 seconds and turn it all back on, but it doesn't make any difference. Manual says 'If the above does not solve the problem, check that the water feed pipe is not blocked' however, it doesn't say where this is, or how to do it. Please help!


Hi.You need to check the water inlet hose, that is the hose connected to house water faucet at the back of the dishwasher.Checck for blockage in the hose and ensure that the inlet hose is not blocked or kinked.If t ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Overfilling fault I have an Asko D3530 reporting an overfilling fault. I checked the outlet hose and found a blockage. I cleared the blockage and the unit pumped the water clear. The unit however continues to opperate the pump with the message "Overfilling" diplayed. The manual indicates "call for service" Does anyone have any idear how to clear the fault? Thanks Steve


I believe the washer has had a flood type situation.there is normally a flood switch in the very bottom of the dishwasher right at the very floor,if water get into the bottom tray it floats a piece polystyrene foam wich triggers a little micro switch ... Asko 24 in. D3530FI Built-in Dishwasher

Need a parts manual and preferably a repair manual for a Stihl high pressure washer model RE250K. It has a water leak and previous owner donated unit to me saying he has spent enough money on it and now it has this leak. I am a qualified automotive mechanic amongst other things and would like some guidance; otherwise I will go in blind. Thanks. Bob Hudson Sydney Australia.


... Pressure Washers

My five year old Viking dishwasher won't fill ...no water. Motor runs. No problem with water supply. the manual says check filter inlet valve. Where is that? thank you.


Hello, Yes your problem is going to be with the inlet valve. Remove the panel at the front bottom of the dish washer, turn the water and power off. You will see the inlet valve normally on the left side underneath your dishwasher (sometimes on right) ... Dishwashers

My Viking under the counter dishwasher will not fill with water. No problem with water supply; hose is not kinked. manual says to check filter inlet valve. Where is that?


There is a water valve usually located at the front left under the unit . this could be bad or water pressure could also be a problem , make sure you have a good sized hose suppling the water. ... Dishwashers

Hi my Candy dishwasher model CDI 1012/2 is filling with water then after a few minutes if bleeps and the error code meaning according to the manual is "Longer inlet time. possible cause Faucets is not open" The tap is fully open and the dishwasher is now full of dirty water. Could you please suggest an alternative cause?


... Candy Dishwashers

New hoover HED 6612-80 dishwasher all indicator lights staying on, manual says due to overfilling with water which is confirmed by water leaking on to floor, how do i solve this problem


Hi, i have same problem with my hoover dishwasher same model as your own, did you ever find out how to fix the problem. your help would be really welcomed. thanks lesley ... Hoover Dishwashers

Dishwasher error Hi we have a Andi dishwasher with an error mess E4 which means its ''Overfilled'' Too much inlet water... There is no water in the machine, how do we solve this? Any ideas would be great. Cheers, Matt & Michele


... Dishwashers

Have installed a new heating element into the idw604 dishwaster - but now an (E4- overfilled)problem has occured possible cause "too much inlet water" any suggestion on how to solve this problem ?


Replace water valae ... Belling 24 in. IDW603 Built-in Dishwasher

Hoover dishwasher model HED 6612/1-80. Has all lights lit up and beeping. Error code in manuel says "too much inlet water" What does this mean and how can i correct this. Thank you


... Hoover Dishwashers

It is actually a fagor FI 48W model. The dishwasher maintains its water giving off a smell. the manual says that it has a drain pump. SHould the unit drain after use in normal circomstances? Please advise


... Fagor FI-200 Dishwasher

INTENSIVE LIGHT KEEPS FLICKERING IT IS NOT OVERFILLED AND THERE IS NOT TOO MUCH INLET WATER


... Kelvinator Dishwashers

I have a Bosch SHU53513UC/U12 dishwasher. My initial problem is that the washer smells bad after a cycle and I've noticed some water sitting in the bottom of the unit. After running a diagnostic test, it results in a "2" heating fault. I followed your advice and used a current coil to and attached it to the GYBK-a1-3 hot wire on the control board. After running the test again, it only gets as high as 1.15A and manual says it should reach 11A. What should I do next?


Hello,Welcome to FixYa. ... Dishwashers

The second and forth lights are flashing at the end of a cycle, it says in the manual water load solenoid. Can this be fixed without to much trouble


Yes, if you know what you're doing. Try a dishwasher cleaner first though. ... Dishwashers

Asko model 1485 Type, DW 95.3. No water supply. Inlet valve needs replacement? Where can I find a parts repair manual for this unit?


I have an ASKO 1485. It overfilled and know it will not stop flashing the lights on the panel. I have manually removed the water ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1826 seconds