Having problems with your LG LDF6810 Built-in Dishwasher ?

Hi, We have an LG LDF6810BB model dishwasher which is now leaking at the bottom. What would be causing it and how is it fixed. Thanks Bill


Answers :

Repair Help & Product Troubleshooting for LG LDF6810 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi, We have an LG LDF6810BB model dishwasher which is now leaking at the bottom. What would be causing it and how is it fixed. Thanks Bill


... LG LDF6810 Built-in Dishwasher

Ace model 1000-1 garbage disposal , what would cause a water leak to come from inside the electric access panel on the bottom of the disposal? Is this repairable?


The motor shaft seal has worn out. If it's still under warranty, check the details for repairs, otherwise go for a replacement. ... Ace Hardware Ace 1/3HP Food Disposer 1000

Frigidaire dishwasher model GLD2250RDC0 leaks from the bottom of the door. Just replaced the bottom gasket. Not helping. Noticed that the foam insulation on the bottom of the door is soaked. So, if it's not coming through from the gasket, what's causing the leaking on the inside of the door and through the foam insulation? Thanks for any help you can provide.


You may want to check the door alignment itself. Many people open and close the door improperly and when they load it sometimes they put pressure on the door in one corner or the other. Check to make sure the door is completely shut and shut proper ... Dishwashers

Dishwasher leak I have a General Electric Potscrubber Mobile Maid dishwasher (model GSC720?) that hasn't been used in some time, but appears to still work OK. It has a leak from the left hand vent opening in the bottom of the door when operating. The seal around the door appears intact and doesn't leak. Can you suggest a probable cause, and remedy? Thanks, Bob.


With dishwasher empty and disconnected, find the screws around the area of the "vent",you may need to open it from the bottom. There will be a hose that has either ruptured or just needs the clamp tightened with a screw driver. I think that the hose ... Dishwashers

I have the two drawer model dish-drawer system. In the past the top seal leaked and since has been replaced with a new seal. Worked well for several years after but then the top drawer quit running. So we started to use the bottom drawer. That was fine for awhile althought it would pump waste water into the top drawer. Now neither drawer will work. The bottom drawer starts up and shuts down. I pulled the lower drawer and it is dry.


If your model has got an LCD display are you able to record what shows up on the display when the bottom drawer shuts down. If no display then are you able to note down the LEDs which are on inside the top of the drawer lid. It is likely there is no ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Hi ..I have an Excell gas pressure washer model no. Exwgv2121-3 with Faip 2100 psi 2 gpm vertical shaft pump..the problem is that there is water leaking from every weep hole at the bottom of the pump when running. Oddly enough,the pump still puts out significant pressure but less than it should due to the leaking water. What is the most likely cause of this?..is it the high pressure water seal(s)? If so,how do I repair it?


... Pressure Washers

During circulation, top drawer seems to leak water through the rubber seal, located on the lid assembly. What would commonly cause this problem. Would it be the actuator, yoke, seal, etc... Please answer only if you've seen enough of this problem, with this model, in particular. Will provide monetary full rating if you can provide both, what part and why... and of course, if it resolves the problem :)


... Fisher and Paykel DD605I Dishwasher

During circulation, top drawer seems to leak water through the rubber seal, located on the lid assembly. What would commonly cause this problem. Would it be the actuator, yoke, seal, etc... Please answer only if you've seen enough of this problem, with this model, in particular. Will provide monetary full rating if you can provide both, what part and why... and of course, if it resolves the problem :)


Lid seal not sitting properly can be due to several reasons as you have eluded to.\015\012\015\012The simplest is that the actuator is not getting any power. But if you hear the actuator operate at Start then this is not a problem. Howeve ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

I have a 12 year old Kenmore Ultrwash Model #665.15951790. I recently replenished the rinse aid dispenser and am experiencing an oversuding problem. It was oversuding to the point that suds were coming out the bottom of the door. Did notice that the blue rinse aid seemed to have leaked into the dishwasher due to a puddle of blue rinse aid at the bottom of the dishwasher. Have run a "quick rinse" cycle 4 times with no dishwasher soap added and still have sudsing. Can the rinse aid cause oversudin


... Kenmore 15129 Built-in Dishwasher

Just purchased a kenmore dishwasher model 665 13152K701, Serial # FU 5002219. There is water in the bottom of the dishwasher at the end of athe cycle. What would cause this and how do I correct it?


... Kenmore 24 in. 15689 Built-in Dishwasher

Our diswasher was leaking the other night from the bottom left hand side of the diswasher door. What would cause this?


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012\012sdjgfo ... Maytag 24 in. MDB5601AWS Stainless Steel Built-in Dishwasher

Hi...I have a Westinghouse Freestyle 921 Dishwasher...9 years young...Model SB921SG...that has recently been leaking from the bottom right hand side front corner of the door when performing its usual heavy duty cycle...It appears that the main door seal has significantly perished and is causing the problem...Therefore I have purchased a new Door Gasket part no.0208400069 from a recommended spare parts agent in Brisbane and after several attempts to re-fit this gasket/seal to the door...I still h


... Dishwashers

I have a Kitchen Aid model#KUDS25SHBL1 and it leaks through the bottom of the door. What is the cause and how do I fix it?


Hi,There are two things that could cause this issue. The first and most common is a cracked feed tube. The feed tube is the plastic pipe that sits under the upper rack and feeds water to the middle spray arm. If this tube breaks or cracks ... KitchenAid 24 in. KUDS02FR Built-in Dishwasher

I have a GE potscrubber Dishwasher Model # GSD3630ZZ3WW it has been leaking from the bottom for about a week. I took the bottom off tonight and ran the dishwasher so that I could see where it is leaking from. It is not a hose but the leak seems to be coming from the back of the motor or pump fan where it goes into that plastic housing that attaches to the bottom of the dishwasher seems to be leaking in the very center of that housing where the motor shaft enters the housing. Water is just spray


... Dishwashers

I would like to know how old this dishwasher is? Mod HDA2000Z05WH and serial is SV826876Y. Would the wheels coming off bottom rack cause the motor to burn up causing washer to not work. There is a hard cap over something in the left corner on the bottom . Imwould like to know what is under that cap?


... Hotpoint 24 in. HDA2000Z Built-in Dishwasher

Kenmore Model Ultra Wash Model 665- 45955 Problem: Dish washer leaks at bottom intitially during sudding cycle only...first 5-10 min... then no leaks/drips thereafter thru balance of clean/rise cycle. Whats up....Thought possible seak around washer door is bad but no leaks at bottom or elsewhere after the sudding cycle is completed. Please provide complete resolution reply if possible Tx


Hi\015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If you have water leaks around the base of your dishwasher,\015\012you may be using a detergent that is causing too much suds. Cut ... Kenmore Dishwashers

Model # PLD2850RDC2 has a leak at the bottom of the door. i have replaced the gasket in the vent. Had to remove door cover and seal at bottom of door. Had difficulty replacing bottom seal. How do I replace seal correctly? It is still leaking. Could it be something else?


The side baffels are bad. look on each side on the bottom in the corners and that is were their at just pull them out and get new ones ... Dishwashers

I have a Whirlpool Gold GU3600XTSY0 Model. There is slow water leak from the right side bottom front of the dishwasher. It looks like the water is leaking from a sensor on the bottom. The sensor has a pin protruding that can push up and down...almost like an on/off switch. I am wondering if there is any way to fix this. Water is leaking on my hardwood floors.....


That is your overflow water switch, that tube goes up to the washer, that switch is defective..water from the machine will come thru that hole ... Dishwashers

Leaks my dishwasher was working great .. and then it started to leak at the bottom of the door when it would cycle into the wash mode .. I cleaned out the bottom trap and put the unit back . and now it will not cycle at all .. and there is water in the bottom of the as if it is not draining .. any ideas


Hello Emmitt White - Try unplugging the dishwasher or flipping the household circuit breaker off first. Wait approximately ten minutes and turn the unit back on. If the issue persists, it could possibly be a few things: faulty door switch, drain p ... Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

We are having water leak from the bottom of our Roper Dishwasher door. THe model # is RUD5750DG3. I have taken the inside door frame off and found a small white rubber seal had dislodged inside. i placed it back in the only sopt it fits but water is still leaking. I have checked to make sure the water is not leaking from any where else on the dishasher. This occurs when the water inside is spraying and eventually fills up on the bottom. We no longer have our manual as the dishwasher cam


Try to fix the rubber seal which has come out by fixing it through super glue or apoxy seal which will stop the water spill and leakage.\015\012Please give more details of you dwasher ..... the Make and model so that i can send you the manual f ... Dishwashers

Turn water on then actuate wand trigger. Pressure washer leaks when wand trigger is actuated and has very low pressure/flow output. After releasing trigger the pressure cycles on - off at approx 1 second interval. I suspect that the plasstic oulet tube is leaking causing low pressure leak out of bottom when trigger is actuated and causes pressure switch to cycle when the trigger is released. Any Help? This pressure washer is approx 18 months old!


You gave a very close solution yourself for the problem. But other leakages can cause such symtoms.Forexample a leaking head or a leaking chemical inlet. These can be caused because the spill valve (pressure control valve) is stuck. When this valve s ... Karcher PSI Electric Pressure Washer

My 14 yr old Magic Chef Model DU4K seems to be leaking (it is dripping into the basement just under where the dishwasher is located). it started when the arm at the bottom of the dishwasher did not seem to be moving so my husband took off the bottom "grill" to see if maybe there was something under there preventing it from spinning. It started to leak when he put it all back together (the bottom arm is still not spinning)


Being 14 years old I dought if spares are still available for this machine personally at 14 I would rather replace the unit if you are not in a possition to replace it you could advise from your local appliance repairs as to weather parts are availab ... Dishwashers

Maytag model mdbtt70aww. After the end cycle. open the door and found detergent tab on the bottom and the main wash cover is opened. Maytag diswasher model MDBTT70AWW. Put dishes and so forth in the dishwasher. Put detergent tab and jet-dry rinse agent in the pre-wash section. and close the cover. Start wash cycle after done over door and found the detergent tab on the bottom new the heater. The cover to the main wash is opened. Dishes are are clean. Wish someone would tell me


... Dishwashers

I don't have a model number right now, but the front door on my Admiral dishwasher is leaking at the bottom. I have changed the gasket inside the door panel at the bottom but it still leaks. This is a rental property and the renters did a job on this dishwasher. I was wondering if they may have pulled another lower gasket off that I didn't know existed. Something like a windshield wiper. The seal I changed was a foam strip 3 x 22 approx. Thanks for your time, Joan


It may not be the door that is leaking if this is an older admiral or whirlpool dishwasher the lever that holds the soap door closed has a little rubber seal that after time will let water in during the wash cycle it the runs down the inside of the d ... Admiral Dishwashers

I have a GE Dishwasher Model GSD 5500 GOOWW that leaks out the bottom LH and RH bottom sides of the door. I also found loose 2 Baffle Tub Corners in the inside water. Will replacement fix the leak? Thanks, Greg Britcher 239 267 6123 Ft. Myers, FL


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1481 seconds