Having problems with your LG LDF6810ST Stainless Steel Built-in Dishwasher ?

2H accures in digital read out. NO Cycles start, just a humming

\015 Water in the bottom of the dishwasher, no cycle has completed, or maybe not even started. Could this be pump problem or electronic problem.\015

Answers :

Do you own an LG LDF6810ST dishwasher? If not, please reply with the manufacturer name, model and serial number.\015\012
\015\012Are you saying that the display that normally shows the time is displaying an code of 2H? On an LG, that means 2 Hours, (120 minutes) and is not an error code.\015\012
\015\012On an LG with a symptom like this, I would arrage to replace the main processor card (PCB). You would be getting an error message if the motor (wash or drain) had failed.
Repair Help & Product Troubleshooting for LG LDF6810ST Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2H accures in digital read out. NO Cycles start, just a humming


Do you own an LG LDF6810ST dishwasher? If not, please reply with the manufacturer name, model and serial number.\015\012\015\012Are you saying that the display that normally shows the time is displaying an code of 2H? On an LG, that means 2 H ... LG LDF6810ST Stainless Steel Built-in Dishwasher

Dishwasher hums I have a 2003 Kenmore Elite Ultra Wash Dishwasher model #665.17469300. I started the wash today. The water came in the unit and started washing then I heard it stop and it just started making a humming noise. I was afraid it was going to overheat or something so I cancelled the washed and it drained out. I started the unit up on a different cycle and the water came in the unit but did not wash it just hummed so I cancelled and drained it again. I did that on all cycles and the sa


... Kenmore Dishwashers

I have a bosch SHU6802UC dish washer. Recently the cycles were getting very long (3+ hours) and now when you press power/start, the unit turns on and you can hear the rather loud hum (pump?) of the cycle starting but it does not do anything else, just continues the loud hum. No cycle, does not fill with water, nothing. I ran the diaognostic and it immediately came up "7" on the display. Any thoughts or direction would be greatly appreciated. FYI, I did thuroughly clean it which made no di


There are a few possibities...if you remove the lid and take the two t20 screw off the left side panel at the front you could check the pressure chamber and its hose are not blocked. Use the link and go to page 4, part 263834 and 361113. You ca ... Dishwashers

Dishwasher was making a loud hum. I turned it off and started it this morning. Seemed to be working fine, but after about 5 minutes it started making the same loud hum. The first time it seemed to be between cycles with no water, this time there water moving as normal except for the loud hum.


... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

My whirlpool quiet partner II is not quiet at all. When I start the cycle it starts humming and a little vibrating and I open it up and no water. I close it and wait it out every 10 minutes I open it back up and no water. The heating element is hot and stinky since there's no water. But once the wash cycle is over the rinse cycle works and theres water. What's the issue?


... Whirlpool GU2400XTP Built-in Dishwasher

GE diswasher hums but will not start cycle and starts to smell ho


Hi, Have your freind check and see if the water supply line under the sink has been turned on. The hum you are hearing could be the inlet valve. Please let me know if this has been helpfull or if I can assist you further.\015\012\015\012T ... General Electric CDW9380N Built-in Dishwasher

SMEG pL312 Dishwasher started cycle, partially filled with water then stopped working. Attempts to reset and start cycle again are met with humming sound and no action.


... Dishwashers

Hello I hope someone can help me. I have a Siemens Hydrosensor Dishwasher that when I start it up in runs for a while and shuts off. I need to open and close the door several times then it may run for a short while, 15 seconds to a couple minutes and then shut down again. Finally, it will run through the rest of the cycle. The issue generally occurs when the digital timer is between 85 and 78. If I just leave it go once it shuts down it does eventually start up and will complete the washing cycl


It sounds like the door switch is at fault, it will cause the symptoms you stated. ... Dishwashers

I have a whirlpool gold gu2500xtps7 and it fills up with water but the cycle doesn't start. It sounds like the motor or pump to start cycle just hums


... Stainless Steel Whirlpool Gold 24 in BuiltIn Dishwasher w Adaptive Wash Cycle Dishwasher

Hi I have a Neff built in dishwasher s5453X1GB/70 about 4 years old. Never had a problem before. Came downstairs last night to find the kitchen floor flooded. Water also still in machine. But must have been near end of cycle as plates all clean. I have read other links and opened pump compartment in centre of machine and syringed out all water and cleaned fan. When i switch on machine it is still making odd humming noise (emptying cycle?) I have read about anti -flood valve etc. Any more tip


... Dishwashers

Fills with water, sounds like it starts to pump water then stops, then start again. It attempts to start pumping water 3 or 4 times them turns off leaving the water in the tub. I have read about the water needing to heat up for the cycle to advance. When I check the water that is left in the tub it is warm but not hot. The heating element is not hot either. I did a continuity test on the heating element and it seems to check out ok. I also did a continuity test on the red wire from the heating e


You have a wash pump problem. can be 1 of 3 things. most likely something is caught in the pump impelor if not the wash pump motor may be faulty or ceized or it could be the capacitor for the wash pump motor is faulty. you can try removing the wash p ... Maytag MDB7100AWB Dishwasher

Machine starts fills Ok but when it clicks on to start the wash pump, nothing happens, I can hear a faint hum. When cancelling wash and starting new wash it pumps out ok too. After rinse cycle it indicates a completed wash, but no water has been pumped through washer arms.


Sounds like your main circulation pump is not working, if it is humming when it is supposed to start, sounds like it is getiing power, so probably not the control circuits, can you measure voltage to pump?if you are getting 120 there, probably pu ... Asko D1876 Dishwasher

Maytag dishwasher Model MDBF550AWB--Start4 water cycle, fills. When wash cycle is to begin, water shuts off, wash cycle does not start. Soap does not open. Low hum.


... Maytag Dishwashers

CI am having a problem getting our Miele G575 dishwasher to run through a wash cycle. It definitely has power, the water is on and there is no water in the bottom of the dishwasher. When you turn the dial to start a cycle, it hums but doesn't fill with water and doesn't progress through any cycle. We have tried all positions of the dial and have had no luck? Any ideas??


You said it does not progress...meaning the dial does not eventually move? it may be waiting on a water level sensor to be tripped. The dishwasher is just not filling. The water valve solenoid may be stuck or defective. or a wire may have come of ... Dishwashers

Dishwasher Fault Hi, My dishwasher is a Diplomat ADP8322 (which i think is a rebadged whirlpool unit) & has been playing up recently. When you start a cycle it is fine for a minute or so then it starts beeping, the rinse light comes on & the light next to the start button flashes 11 times, pauses then repeats. I have read online that this flashing relates to what the fault is, but i cannot find out what fault the 11 flashes relate to. The first time this happened i cleaned out all of the filters


... Dishwashers

Whirlpool dishwasher model DUB700XB has quit cycling. Fills with water but will not start wash cycle. Making intermittent humming noise unless the door is open to disengage the switch, even when on stop. No LEDs lighting when rotating the dial through the various cycles. Unit is old and wondering if it's better to buy a new one rather than fix this and have something else go wrong in the not to distant future. Thanks in advance


... Dishwashers

Own a KitchenAid dishwasher, model KDC-21AD. Unit stopped shortly after startup cycle began. When cycling thru the various wash cycles, I hear a slight hum when selector switch is at the "pots/pan" selection. About 2" of water is standing in base of dishwasher and it will not start. Checked the KitchenAid site and they do not list my dishwatcher. Would like to be able to repair myself or have it done at reasonable price.


... KitchenAid Dishwashers

Zanussi Integrated Dishwasher ZDT6244 - the cycle doesn't seem to end. Whenever I reprogramme a new cycle, it just hums and then said "cycle has ended" - even when I leave all 4 lights on, (neutral mode), it still starts again, advising it has finished??? Can anyone help at all?


... Zanussi 23 in. ZDI6041 Built-in Dishwasher

I have a Bosch dishwasher model SHU9915 that is 8 years old. It just give a ''hum'' when it tries to go into the wash cycle. It stops humming after a few seconds, like it overheats or overloads, then after a minute or so it tries to start the motor again and ''hums''. It continues this as long as you wish to watch it. Does it sound like the pump has gone out or just a capacitor or something small?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. You are right the issue is with\015\012the motor; don’t think it’s related to a capacitor. The hum ... Bosch Dishwashers

Baumatic (BKD62SS or BKD62W .3) Dishwasher will not do a normal load but will run in a strange start up mode I found. When I press the power button, select a cycle, then press start the dishwasher will no longer do anything. 5 seconds after pressing start it will make a light hum noise, a little like heating water. After about a minute the dishwasher won't have done anything. It will then beep 30 times with the third led on the set of four (don't know what it means) will flash a lot. The beeps t


... Dishwashers

The dishwasher hums before it starts. It stops before the cycle is complete and it does not discharge all the water


... LG LDS4821WW 24 in. Built-in Dishwasher

I have the Kitchen aid KUDS01DL dishwasher. It was working fine until last week. When starting a cycle, the washer fills with water. Once filled, the motor makes a humming noise and does not circulate the water. I end up stopping the cycle and the discharge pump empties the water. I took apart and cleaned the basin this morning. I did find some random garbage but it did not seem blocked. Do you have any ideas?


... KitchenAid 24 in. KUDS01DLSS Built-in Dishwasher

My GE Potscrubber dishwasher won't start. I close the door tightly, lock it and when I turn the timer knob I just hear a humming noise, but it does not start to cycle. Does this mean I need a new timer mechanism?


... GE Dishwashers

KITCHENAID DISHWASHER MODEL KUDS24SE WILL NOT START. WHEN NORMAL (OR OTHER) CYCLE IS SELECTED, CLEAN LIGHT COMES ON AND DW JUST HUMS. DOES NOT FILL OR START.


... KitchenAid KUDS24SE Built-in Dishwasher

My GU 120 stops mid cycle and the indicator light starts blinking a humming whirring sound preceeds the ctcle stop nad light blinking. Pressing the button for 5 seconds causes the flashing light to extinguish but the sound continues untill the unit stops. It does not complete the full cycle. Your help would be appreciated. Tony


... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1000 seconds