Having problems with your LG LDF6810ST Stainless Steel Built-in Dishwasher ?

I'm getting an "LE" code also, and the dishwasher will not drain.

\015 This dishwasher flooded my kichen a few weeks ago because of a sharp turn in the drain pipe inside the dishwasher cabnet. Anouther apparent design flaw in this product. LG will not be getting my money on any product again..\015

Answers :

\015\012LE is a Motor error\015\012
\015\012\015\012Wiring connection is OK?\015\012The Impeller of Washing Pump is\015\012locked.\015\012The rotor of Washing Motor is\015\012locked.\015\012The Blade is locked.\015\012
\015\012\015\012Check the wiring connection.\015\012Replace the cause of restriction.\015\012Replace the Washing Motor.\015\012Replace the PCB
Repair Help & Product Troubleshooting for LG LDF6810ST Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I'm getting an "LE" code also, and the dishwasher will not drain.


\015\012LE is a Motor error\015\012\015\012\015\012Wiring connection is OK?\015\012The Impeller of Washing Pump is\015\012locked.\015\012The rotor of Washing Motor is\015\012locked.\015\012The Blade is locked.\015\012\015\012\015\01 ... LG LDF6810ST Stainless Steel Built-in Dishwasher

Getting error code 0E on LD-14AW3 model dishwasher after 2 minutes. Checked drain hose and water seems to be coming out but won'y go any further in cycle Also makes a loud humming noise when running.


To little info, but looks like pipe is much to low. Not getting the opportunity to fill up properly.Raise it higher.(Im asuming that you can hear the drain pump run and water is being pumped out as wall. ... Dishwashers

I have a Whirlpool DU810SWLQ0 that will not drain. I've pulled the unit out, snaked the drain tube, pulled the motor/pump, and pipe assemblies, and cleaned the food trap, which I also removed. I've run the dishwasher with a bit of bleach, and the water will pump in, get processed by the agitator, and be heated. When the rinse cycle comes, dishes get covered in food, and are never clean. Waste water was being used for a clean rinse. I've run the dishwasher with the drain dangling in a bucket,


Refer the wash system assembly dwg. Check if the ball (item 21) is sitting correctly. If it is out of ali ... Dishwashers

We just installed a Fisher & Paykel DD603 dishwasher. Intially it would not drain correctly. And, proceeded to flood the bottom and set off the F1 error code. I dried out the bottom to get the F1 code to stop, which it did. After adjusting the leveling the dishwasher drained both drawers correctly, once. A few minutes after the rinse cycle had finished and the drawers were empty of water the F1 code started again. Now it will not go away unless I unplug the machine. I dried out the bottom very w


HI. The original code(f1) is in reference to a overfill condition. This may be a clogged drainage Assembly. This condition will usually cause the control sector to short out if not corr ... Dishwashers

I have a G E Nautilus dishwasher that has been in storage for 2 years. Every thing works but the Drain. When the cycles are finished I' m left with a dishwasher full of water and it dont drain. I checked the bottom as u said in a previos question I see not obstacles, trash etc. How else4 can I get it to unplug? Also where can I get a owners manual? I can be contacted at [email protected] if needed. Thanks ahead of time for the help.


Hello. Here is the link to a free manual http://kitchen.manualsonline.com/manuals/mfg/ge_appliances/ge_ap ... Dishwashers

I have a Bosch dishwasher that was working just fine until I spilled a bag of uncooked pasta. I sent the pasta down the drain and ran the garbage disposal, subsequently clogging the pipes. I had to get a plumber to fix the drains, but he wouldn't unclog the dishwasher. I have tried myself to go under the sink and drain some hoses, but it didn't work. I also put some baking soda and vinegar into the drain, but no luck. What can I do?


It may simply be where the dishwasher drain attaches to your garbage disposal. There should be a hose clamp and can easily be taken off. If the clog's not right at the connection, chances are it's far. If there is an air gap, it will be within a f ... Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher

My Bosch dishwasher, model SHE58C did not completely drain. We were eventually able to use the cancel cycle/drain procedure to get the machine mostly drained, but now all the lights are lit on the panel, and the count down display is 11. I haven't figured out how to reset. I have tried to hit "Cancel drain" and turn on the machine to get into diagnostic mode, but I can't figure out what the codes & light combinations mean because my model is not in any of the online sources I've found


I have managed to pick up typical diagnostic error codes for a bosch dishwasher - these are\015\012\015\0120 = No faults detected 2 = Heating fault 8 = NTC (temperature sensor) fault\015\0121 = Aqua Se ... Bosch Evolution 800 SHE58C05UC Stainless Steel Built-in Dishwasher

My bosch dishwasher wont dry. The model number is she44c02uc/47. I don't know what codes i need to see to get it to heat. I've tried to hold the cancel drain buttons in to change the code. I get a C1. what does that mean. Thanks for your help. john


... Bosch Dishwashers

My dishwasher will not drain. it goes through the first 10 minutes of a program then i get the OE error code. i have checked my hose for kink or clogged-there is none, i have made sure it was level. i would like to get the filter off but it looks like i would have to take the drain pump out from the bottom to check if any thing is plugging it. was just wondering if anyone has any tips that would help. thanx


1)check the drain pump working\015\0122)check any block from drain pump to drain hose. ... LG LDF6810 Built-in Dishwasher

Dishwasher problems I have a counter top dishwasher and it's not cleaning things like it used to i think its clogged but i cant get to the drain because it is in the bottom i tried draino but it didn't work i also tried unscewing the bottom but i cant get that part out i think there is somthing stuck in there.


First thing to check water hose that connect at back of machine. pull the screen out and clean it. use a pliers. I run my under water then use a q-tip if its clog to clean the rest.\015\012\015\012Then pour a cup of vingar in machine and ... Danby 22 in. DDW396 Free-standing Dishwasher

Hi there, The error code 'strong and economy light flicker fleetly' is showing. the manual says that this means too much inlet water. We have drained the machine, cleaned waste pipe and tried to operate with a reduced flow from the inlet pipe but it's still not working. I filled the base of the dishwasher with water to see if it drains properly. It seems to be draining, but also leaking out of the base as well..? Any ideas?.


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... Baumatic Dishwashers

I have a Bosch SGE63E05UC dishwasher that keeps intermittently showing an "E:25" error code. Occasionally it will get all the way through a cycle without going into error, but more often than not it will error and stop. So far the main control module in the front panel and drain pump have been replaced and the problem persists. All hoses have been checked and are clean (unit is only 1 year old) and drains well, when it does drain. Any suggestions?


... Bosch SGE63E05UC 24 in Builtin Dishwasher

My kudpo1ilbt6 kitchenaid dishwasher clean light flashes 7 times, then pauses, then repeats. Cannot break out of this mode and get dishwasher to start. Reset circuit breaker also. Is this a diagnostic code? How to put controller into diagnotic mode?


... KitchenAid Dishwashers

DELONGHI DISHWASHER HI, we just purchased a Delonghi dishwasher DW67S/W and it reads Error code 4 which says that the inlet has been overfilled. How do we drain it or get it working? It wont allow us to do anything more. The store we purchased it from is closed so i cant ask them. Thanks for your help. Chocy


... Dishwashers

I have a Hotpoint FDW80 Dishwasher. The drain pump runs continuously, even though there is no water inside, I poured water in with a kettle and it does drain correctly. After a short while fault code AL01 appears. I have removed the base tray to check the "anti-flood" swithch and that is OK, even with the switch disconnected, I still get AL01. Any ideas?


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Having trouble with Bosch dishwasher (SHE44C06UC) .. stinks when it turns on, also getting soap residue on the dishes .. i checked the drain system/pipe and it's clear. cycle times also seem to be quite erratic (says 10 min left but goes for another 60 min)... any ideas?


Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

The main problem is the dishwasher will not drain after the cycle indicator shows finished. There is water left in the reservoir that needs manually drained and dishes are soaked. Also, the "sanatized" light has not lit up at all. Our code is: SHE43F15UC/61 FD900700314 / SN9G5B.thanks


... Bosch SHU9915UC Dishwasher

Hi I have a Kelvinator KD12ww/mm dishwasher. I have noticed that my glasses and other plates often do not get cleaned properly. I do use the setting for glasses etc. I also tried to add salt once in a while and after every wash I clean the filters. I tried to drain the water etc and have no other solution. The dishwasher is just over a year old. Any other ideas would be appreciated. Thank you Natascha


... Kelvinator Dishwashers

Have a Kenmore Freestanding Dishwasher that was working when hooked up to the sink. When we plumbed it in and connected the electrical directly, we now get an "F4" flashing on the panel with a beeping noise and the pump sounds like it wants to drain but just get a sucking noise. I've tried putting water in it to prime the pump, but still doesn't want to work. Do the codes mean anything, or point to a specific part?


... Kenmore 24 in. 16332 / 16334 / 16339 Free-standing Dishwasher

Hi I have a GE Dishwasher model gsd2200g -03 and I am getting C1 & C2 error codes but it seems to be working fine. I disconnected the drain hose and the water appears to be draining properly


Hello there: if you have installed a new garbage disposal make sure the knock out has been removed if removed then check the drain valve in the pump hope this helps you out sincerely D.Jones ... GE Profile PDW9880NSS Stainless Steel Dishwasher

Have a Bosch shy56a05uc dishwasher that suddenly stopped working to a point. I believe it is related to the door latch switch, because I don't feel the door securely latch shut when I close it, and I also don't get any cycle lights or times registered on the LED readout. If I depress the on switch, the drain pump will start even with the door open, and, depending on how long I leave the switch on, water will start to fill in the dishwasher, open or not.


Does your dishwasher electronic control or mechanical timer? if mechanical timer, I encounter a similar problem n change the mechanical timer. that problem solved.\015\012\015\012Prince P ... Dishwashers

I think I need to check the water pump/motor on my Bosch SHU43C dishwasher. It seems the water enters at the start of the wash cycle but then there is silence through the remainder of the cycles. Water will not spray. The drain appears to work ok to drain most of the water out. I have the washer out and upside down. Any hints on removing the base to get access to the pump? Should AI be looking at the control panel also for a fault? (the cycles seem to count down ok)


Click below;\015\012Latest Bosch Dishwasher Use and Care Manual\015\012\011\011\011\011May 4th, 2008 by Samurai Applian ... Bosch Dishwashers

Dishwasher not draining E25 error code (Bosch exxcel) . I have cleaned filters & removed pump inspection cover to check / clean debris I have also checked the waste water pipe is not kinked, it runs for 1hr 15 mins last time and then cut out with the error code displayed.


Gr8 stuff klaudi & Nypmh - rocking it back 45% worked a treat. Bloody BonzaShell XX ... Bosch Dishwashers

My dishwasher is not draining unless I hit the cancel drain buttons. I also noticed that when time gets down to 1 minute it stays there and keeps running


Most likely it is not completely level. This will stop the cycle every time. The drain/cancel just overrides the sensor, but you need to level it up completely, this should solve the problem ... Dishwashers

Dishwasher wont fill with water. just before it stopped filling i was turning the dial (a lot) between the wash cycles back and forth to attempt to get it to fill and drain (I didn't let it go through a cycle). We also removed the hose from the machine as it had split and replaced it and we had the machine tilted on it's side. the dial still clicks round but it sounds like the pump is going and it doesn't seem to be filling with water. Help


Hi. I suspect that the timer mechanism will be the culprit here, but i recommended to inspect and test the water inlet valve, before replacing the timer. The valve is a known problem area, as well. Follow the valve inspection procedure below, careful ... Fisher DS603W / DS603B / DS603I Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1984 seconds